氨对垃圾焚烧飞灰浸出特性的影响及地球化学模拟

垃圾焚烧飞灰可能因为选择性非催化还原法(SNCR)脱硝过程中氨泄漏、垃圾携带的渗滤液受热挥发等原因而吸附氨.本研究中采用人为添加氨水,在pH为3.66～12.44范围内,研究氨对飞灰中溶解性有机碳(DOC)和重金属浸出的影响,并利用地球化学模拟软件Visual MINTEQ从金属化学形态分布上分析氨对飞灰浸出的影响机制.结果表明,DOC在pH>9和有高浓度氨(≥1 357 mg·L-1)存在时,其浸出量大幅增加,而在浸出液中氨的水平不高于537 mg·L-1时则受氨的影响很小;在pH<6时,飞灰中各金属主要以自由态的金属离子和金属-氯络离子形态大量溶出,且受氨的影响较小;而在pH为8～12的碱性环境中和氨浓度较高时(≥3 253 mg·L-1),氨与金属生成了可溶性的金属-氨配合物,能显著增加Cd、Cu、Ni、Zn的浸出,且在pH=9附近时浸出量达到最大值,但氨对Al和Pb的浸出影响甚微;在pH>12时,Cd、Cu、Ni、Zn主要以羟基金属离子形式存在.在氨浓度为3 253 mg·L-1时,通过利用Visual MINTEQ模拟浸出值与试验数据的对比,发现Al、Pb、Zn的浸出主要由溶解/沉淀模型控制,而Cd、Cu、Ni由溶解/沉淀模型和表面吸附反应模型同时控制,且Visual MINTEQ模型能较好地预测飞灰中Al、Cu、Pb、Zn的浸出特性.     

Ethyl thiosemicarbazide intercalated organophilic calcined hydrotalcite as a potential sorbent for the removal of uranium(VI) and thorium(IV) ions from aqueous solutions

This work was conducted to determine the practicability of using a new adsorbent 4-ethyl thiosemicarbazide intercalated,organophilic calcined hydrotalcite(ETSC-OHTC) for the removal of uranium(U(VI)),and thorium(Th(IV)) from water and wastewater.The FTIR analysis helped in realizing the involvement of nitrogen and sulphur atoms of ETSC in binding the metal ions through complex formation.Parameters like adsorbent dosage,solution pH,initial metal ions concentration,contact time and ionic strength,that influence adsorption phenomenon,were studied.The optimum pH for maximum adsorption of U(VI) and Th(IV) was found to be in the range 4.0-6.0.The contact time required for reaching equilibrium was 4 hr.The pseudo second-order kinetic model was the best fit to represent the kinetic data.Analysis of the equilibrium adsorption data using Langmuir,Freundlich and Sips models showed that the Freundlich model was well suited to describe the metal ions adsorption.The K F values were 25.43 and 29.11mg/g for U(VI) and Th(IV),respectively,at 30°C.The adsorbent can be regenerated effectively from U(VI) and Th(IV) loaded ones using 0.01mol/L HCl.The new adsorbent was quite stable for many cycles,without much reduction in its adsorption capacity towards the metals.     

Simultaneous preconcentration of cadmium and lead in water samples with silica gel and determination by flame atomic absorption spectrometry

A new method that utilizes pretreated silica gel as an adsorbent has been developed for simultaneous preconcentration of trace Cd(II) and Pb(II) prior to the measurement by flame atomic absorption spectrometry. The effects of pH, the shaking time, the elution condition and the coexisting ions on the separation/preconcentration conditions of analytes were investigated. Under optimized conditions, the static adsorption capacity of Cd(II) and Pb(II) were 45.5 and 27.1mg/g, the relative standard deviations were 3.2% and 1.7% (for n = 11), and the limits of detection obtained were 4.25 and 0.60 ng/mL, respectively. The method was validated by analyzing the certified reference materials GBW 07304a (stream sediment) and successfully applied to the analysis of various treated wastewater samples with satisfactory results.     

Supercritical water oxidation of polyvinyl alcohol and desizing wastewater：Influence of NaOH on the organic decomposition

Polyvinyl alcohol is a refractory compound widely used in industry. Here we report supercritical water oxidation of polyvinyl alcohol solution and desizing wastewater with and without sodium hydroxide addition. However, it is difficult to implement complete degradation of organics even though polyvinyl alcohol can readily crack under supercritical water treatment. Sodium hydroxide had a significant catalytic effect during the supercritical water oxidation of polyvinyl alcohol. It appears that the OH ion participated in the C-C bond cleavage of polyvinyl alcohol molecules, the CO2-capture reaction and the neutralization of intermediate organic acids, promoting the overall reactions moving in the forward direction. Acetaldehyde was a typical intermediate product during reaction. For supercritical water oxidation of desizing wastewater, a high destruction rate (98.25%) based on total organic carbon was achieved. In addition, cases where initial wastewater was alkaline were favorable for supercritical water oxidation treatment, but salt precipitation and blockage issues arising during the process need to be taken into account seriously.     

呼和浩特地区污水厂能耗评价与碳排放分析

污水处理过程的能耗和温室气体排放方面的研究对于应对能源危机和气候危机具有重要作用。文章利用层次分析法,建立了具有4层15项指标的能耗评价体系。结合城镇污水处理系统的绿色指标体系,选取呼和浩特地区具有代表性、处理规模相近的2座中小型污水厂进行能耗评价。结果表明:处理能力利用率、处理工艺系统稳定性和污水厂高程布置所对应的3项评价指标在所选择的能耗影响因素中所占权重较大,分别为:0.143 0,0.302 4和0.145 6。进一步运用IPCC计算方法对污水处理厂进行碳排放概算,得出A、B污水处理厂的碳排放量分别为:19.401 t CO2/104t、18.378 t CO2/104t。A、B污水处理厂的实际比能耗分别为0.293 kW.h/m3、0.195 kW.h/m3。将碳排放数据与实际能耗情况对比得出:污水处理厂的能耗水平越高,单位碳排放量也越大。     

Application of CGP-cross route process for microstructure refinement and mechanical properties improvement in steel sheets

A modified method of severe plastic deformation (SPD) entitled constrained groove pressing-cross route (CGP-CR) was introduced for imposing a high magnitude of equivalent strain of about 2.32 per pass on the sheet form samples. The major benefit of this improved route compared to previous common route was the more homogeneity of strain in the rolling (RD) and transverse (TD) directions of sheets. In this study, low carbon steel samples were used for examination of evolutions in microstructure and mechanical properties during SPD via CGP-CR process. Mechanical properties improvement were measured by tensile and macro hardness tests. The results indicate that CGP-CR process can effectively improve tensile strength; and also, yield stress and hardness of as-received low carbon steel samples were improved up to about 100% after two deformation passes. Also, high magnitude of inhomogeneity can be observed in hardness distribution through first pass of the process which diminishes in the subsequent passes. Microstructural evolutions during process were monitored by optical microscopy observations and X-ray diffraction analysis. The results demonstrate that initial ferritic microstructure with grain size of about 30 μm was refined to a 225 nm cell structure after two passes of CGP-CR process.     

危险及可操作性分析在LNG汽车加气站的应用

利用危险及可操作性分析(HAZOP)技术对液化天然气(LNG)汽车加气站卸车、调压和加液流程进行系统的危险分析和探讨,并提出建议措施。应用实例表明,HAZOP技术可有效地辨识LNG汽车加气站的风险,可作为LNG加气站风险管理的有效工具之一。