北京市昌平区大气环境PM10中多环芳烃的含量及变化趋势

通过采集了2004～2006年北京市昌平区四个季节中大气PM10样品,采用超声抽提方法,使用GC/MS分析了该区PAHs含量和组成.结果显示,三年中四个季度的18种PAHs总量范围分别为21.64～656.39ng/m3、31.94～164.33ng/m3和7.294～209.3ng/m3,其中致癌性极强的苯并[a]芘含量范围为2.69～36.95 ng/m3、1.44～6.6ng/m3和0.256～8.625ng/m1,其变化趋势与PAHs总量有较好的相关性.PAHs的浓度是冬季＞秋季＞夏季＞春季,这与夏季时雨水冲刷和阳光照射强度大导致PAHs光解,冬季时燃煤排放大等影响因素有关.文章还使用多种方法判断昌平区大气PM10中的PAHs主要来源于燃煤和汽车尾气,其它污染源贡献较小.     

渭河干流(宝鸡段)表层沉积物Cu、Zn、Pb污染特征与评价

对渭河干流（宝鸡段）表层沉积物中重金属Cu、Zn、Pb含量进行了调查,用潜在生态危害系数法对其污染水平进行了评价,并与松花江（吉林市段）、淮河（江苏段）、长江（下游）、苏州河、珠江（广州段）5条河流表层沉积物中Cu、Zn、Pb的含量做了对比研究。结果表明,3种重金属元素平均含量均超出相应的土壤背景值,出现了一定程度上的富集;生态危害系数均〈40,属轻微生态危害。重金属含量水平在国内诸河中处于中间位置。     

广州大学城珠江水域多环芳烃的污染特征

利用GC-MS对广州大学城珠江水域的地表水及表层沉积物中多环芳烃(PAHs)的含量进行了分析。结果表明,广州大学城珠江水域及表层沉积物中均可检出PAHs,水体优控PAHs总量在1061.7~6577.8ng/L之间,沉积物中优控PAHs总量分布在896.1~7248ng/g之间。广州大学城珠江水域的PAHs属混合来源,主要有石油类产品的输入(漏油泄油)和化石燃料的燃烧(大气沉降)。     

顶空固相微萃取-色谱质谱联用测定饮用水中二甲基异冰片和土味素

研究了顶空固相微萃取-气相色谱质谱联用测定饮用水中二甲基异冰片和土味素的方法。结果表明,当选用聚二甲基硅氧烷(PDMS)萃取纤维萃取头,萃取温度为60℃,萃取时间为40min时,得到二甲基异冰片标准曲线方程为y=122.59+157.76x,相关系数(R)0.9998;土味素的标准曲线方程为y=14.847+180.99x,相关系数(R)0.9999;检出限为0.1ng/L,相对标准偏差在0.99%～4.05%之间,加标回收率86.4%～109.5%。     

Effective removal of coordinated copper from wastewater using a new dithiocarbamate-type supramolecular heavy metal precipitant

A new dithiocarbamate-type heavy metal precipitant, sodium 1,3,5-hexahydrotriazinedithiocarbamate (HTDC), was prepared and used to remove coordinated copper from wastewater. In the reported dithiocarbamate-type precipitants, HTDC possesses the highest percentage of the effective functional groups. It could effectively precipitate copper to less than 0.5 mg l⁻¹ from both synthetic and actual industrial wastewater containing CuEDTA in the range of pH 3–9. UV–vis spectral investigation and elemental analysis suggested that the precipitate was a kind of coordination supramolecular compound, [Cu₃(HTDC)₂]_n. The toxicity characteristic leaching procedure (TCLP) and semi-dynamic leaching test (SDLT) indicated that the supramolecular precipitate was non-hazardous and stable in weak acid and alkaline conditions. Tests of an anion exchange resin D231 provided a clue to simultaneously remove excess HTDC and residual CuEDTA in practical process of wastewater treatment.     

Utilization and degradation of imazaquin by a naturally occurring isolate of Arthrobacter crystallopoietes

A species of bacteria that is capable of utilizing imazaquin as the sole carbon source was isolated from soil with repeated imazaquin applications, and was identified as Arthrobacter crystallopoietes (designated as strain “WWX-1”). This isolate degrades imazaquin as high as 200 μg ml⁻¹, and the estimated dissipation half-lives increased from 1.51 d for the treatment at 50 μg ml⁻¹ to 4.75 d for 200 μg ml⁻¹. Optimal growth of WWX-1 in mineral salt medium with 50 μg ml⁻¹ imazaquin was obtained at 35 °C and a pH of 5.0. Growth of WWX-1 was also observed in mineral salt medium with the addition of other imidazolinone herbicides such as imazethapyr and imazapyr, but not with different classes of herbicides such as metsulfuron-methyl. Two imazaquin metabolites were detected, and spectral analysis with HPLC–MS, ¹H NMR, and IR revealed one metabolite with a molecular weight (MW) of 199 as quinoline-2,3-dicarboxylic anhydride. We propose that A. crystallopoietes (WWX-1) could serve as an efficient biodegradation system for remediation of water and soils that are heavily contaminated with imazaquin or other structurally similar chemicals.     

Enhanced stability of hydrogen peroxide in the presence of subsurface solids

The stabilization of hydrogen peroxide was investigated as a basis for enhancing its downgradient transport and contact with contaminants during catalyzed H(2)O(2) propagations (CHP) in situ chemical oxidation (ISCO). Stabilization of hydrogen peroxide was investigated in slurries containing four characterized subsurface solids using phytate, citrate, and malonate as stabilizing agents after screening ten potential stabilizers. The extent of hydrogen peroxide stabilization and the most effective stabilizer were solid-specific; however, phytate was usually the most effective stabilizer, increasing the hydrogen peroxide half-life to as much as 50 times. The degree of stabilization was nearly as effective at 10 mM concentrations as at 250 mM or 1 M concentrations. The effect of stabilization on relative rates of hydroxyl radical activity varied between the subsurface solids, but citrate and malonate generally had a greater positive effect than phytate. The effect of phytate, citrate, and malonate on the relative rates of superoxide generation was minimal to somewhat negative, depending on the solid. The results of this research demonstrate that the stabilizers phytate, citrate, and malonate can significantly increase the half-life of hydrogen peroxide in the presence of subsurface solids during CHP reactions while maintaining a significant portion of the reactive oxygen species activity. Use of these stabilizers in the field will likely improve the delivery of hydrogen peroxide and downgradient treatment during CHP ISCO.     

Effect of soil moisture dynamics on dense nonaqueous phase liquid (DNAPL) spill zone architecture in heterogeneous porous media

The amount, location, and form of NAPL in contaminated vadose zones are controlled by the spatial distribution of water saturation and soil permeability, the NAPL spill scenario, water infiltration events, and vapor transport. To evaluate the effects of these processes, we used the three-phase flow simulator STOMP, which includes a new permeability-liquid saturation-capillary pressure (k-S-P) constitutive model. This new constitutive model considers three NAPL forms: free, residual, and trapped. A 2-D vertical cross-section with five stratigraphic layers was assumed, and simulations were performed for seven cases. The conceptual model of the soil heterogeneity was based upon the stratigraphy at the Hanford carbon tetrachloride (CT) spill site. Some cases considered co-disposal of NAPL with large volumes of wastewater, as also occurred at the Hanford CT site. In these cases, the form and location of NAPL were most strongly influenced by high water discharge rates and NAPL evaporation to the atmosphere. In order to investigate the impact of heterogeneity, the hydraulic conductivity within the lower permeability layer was modeled as a realization of a random field having three different classes. For six extreme cases of 100 realizations, the CT mass that reached the water table varied by a factor of two, and was primarily controlled by the degree of lateral connectivity of the low conductivity class within the lowest permeability layer. The grid size at the top boundary had a dramatic impact on NAPL diffusive flux just after the spill event when the NAPL was present near the ground surface. NAPL evaporation with a fine grid spacing at the top boundary decreased CT mass that reached the water table by 74%, compared to the case with a coarse grid spacing, while barometric pumping had a marginal effect for the case of a continuous NAPL spill scenario considered in this work. For low water infiltration rate scenarios, the distribution of water content prior to a NAPL spill event decreased CT mass that reached the water table by 98% and had a significant impact on the formation of trapped NAPL. For all cases simulated, use of the new constitutive model that allows the formation of residual NAPL increased the amount of NAPL retained in the vadose zone. Density-driven advective gas flow from the ground surface controlled vapor migration in strongly anisotropic layers, causing NAPL mass flux to the lower layer to be reduced. These simulations indicate that consideration of the formation of residual and trapped NAPLs and dynamic boundary conditions (e.g., areas, rates, and periods of different NAPL and water discharge and fluctuations of atmospheric pressure) in the context of full three-phase flow are needed, especially for NAPL spill events at the ground surface. In addition, NAPL evaporation, density-driven gas advection, and NAPL vertical movement enhanced by water flow must be considered in order to predict NAPL distribution and migration in the vadose zone.     

Impact of Bioaugmentation with a Consortium of Bacteria on the Remediation of Wastewater-Containing Hydrocarbons (5 pp)

Goals, Scope and Background It has been observed that hydrocarbon treated wastewaters still contain high COD and a number of intermediates. This suggests that the required catabolic gene pool for further degradation might be absent in the system or, that its titer value is not significant enough. By providing the desired catabolic potential, the overall efficiency of the treatment system can be improved. This study aims to demonstrate this concept by bioaugmentation of a lab-scale reactor treating refinery wastewater with a consortium having the capacity to complement the alkB genotype to the available microbial population. Methods Two reactors were set up using activated biomass collected from a refinery treatment plant and operated at a continuous mode for a period of 8 weeks. The feed to both reactors was kept constant. Crude oil was spiked regularly. One reactor was bioaugmented with a consortium previously described for crude oil spill remediation. The efficiency of the bioaugmented reactor was demonstrated by reduced COD. The changes in the microbial population over a period of time were analyzed by RAPD. Catabolic activity of the biomass in both reactors was monitored by PCR. The presence of the catabolic loci was confirmed by Southern Hybridization. Results and Discussion 52.2% removal of COD was observed in the bioaugmented reactor while only 15.1% reduction of COD was observed in the reactor without bioaugmentation. The change in microbial population can be seen from the 4th week, which also corresponds to improved catabolic activity. The presence of the bedA locus was seen in all samples, which indicates the presence of aromatic degraders, but the appearance of the alkB locus, from the 6th week onwards, which was observed only in the samples from the bioaugmented reactor. The results suggest that the gene pool of the bioaugmented reactor has catabolic loci that can degrade accumulated intermediates, thus improving the efficiency of the system. Conclusions In this study, improvement of efficiency of bioremediation was demonstrated by addition of catabolic loci that are responsible for degradation. Bioaugmentation was carried out in biomass that was collected from an ETP (effluent treatment plant) treating hydrocarbon containing wastewater to study the strategies for improvement of the treatment system. Biostimulation, only marginally improved the efficiency, when compared to bioaugmentation. The improved efficiency was demonstrated by COD removal. The presence of the alkB locus suggests the importance of a catabolic gene pool that acts on accumulated intermediates. It is well documented that straight chain aliphatics and intermediates of aromatic compounds after ring cleavage, accumulate in refinery wastewater systems, thereby hindering further degradation of the wastewater. Supplementation of a catabolic gene pool that treats the lower pathway compounds and alkanes will improve the overall efficiency. In this study, results suggest that the alkB locus can also be used to monitor the degradative mode of the activated biomass. Recommendations and Perspective . Pollution from petroleum and petroleum products around the globe are known to have grave consequences on the environment. Bioremediation, using activated sludge, is one option for the treatment of such wastes. Effluent treatment plants are usually unable to completely degrade the wastewater being treated in the biological unit (the aerator chambers). The efficiency of degradation can be improved by biostimulation and bioaugmentation. This study demonstrates the improved efficiency of a treatment system for wastewater containing hydrocarbons by bioaugmentation of a consortium that supports degradation. Further experiments on a pilot scale are recommended to assess the use of bioaugmentation on a large scale. The use of molecular tools, like DNA probes for alkB, to monitor the system also needs to be explored.     

基于人工神经网络理论的建筑物火灾安全评价研究

依据建筑物火灾危险性的影响因素,应用人工神经网络理论及系统安全方法,建立了建筑物火灾危险性的评价指标体系,该方法摆脱了评价过程中的随机性和参评人员主观上的不确定性及其认识上的模糊性等缺点,大大提高了准确性。为了验证评价模型的准确性,将该理论应用到某高校图书馆火灾危险性评价中,快速、准确地得到了安全评价结果,取得了满意效果,为建筑物防火设计以及安全管理提供了可行的依据。