Experimental Study of the Criteria of Flow Laminarization in Two-Dimensional Dense Gas Plumes

Laminarization of flow in a two-dimensional dense gas plume was experimentally investigated in this study. The plume was created by releasing CO₂ through a ground-level line source into a simulated turbulent boundary layer over an aerodynamically rough surface in a meteorological wind tunnel. The bulk Richardson number (Ri_*), based on negative plume buoyancy, plume thickness, and friction velocity, was varied over a wide range so that the effects of stable stratification on plume laminarization could be observed. A variety of ambient wind speeds as well as three different sizes of roughness arrays were used so that possible effects of roughness Reynolds number (Re_*) on plume laminarization could also be identified. Both flow visualization methods and quantitative measurements of velocity and intermittency of turbulence were used to provide quantitative assessments of plume laminarization.Flow visualization provided an overall picture of how the plume was affected by the negative buoyancy. With increasing Ri_*, both the plume depth and the vertical mixing were significantly suppressed, while upstream propagation of the plume from the source was enhanced. The most important feature of the flow revealed by visualization was the laminarization of flow in the lower part of the plume, which appeared to be closely related to both Ri_* and Re_*.Measurements within the simulated dense gas plumes revealed the influence of the stable stratification on mean velocity and turbulence intensity profiles. Both the mean velocity and turbulence intensity were significantly reduced near the surface; and these reductions systematically depended on Ri_*. The roughness Reynolds number also had considerable influence on the mean flow and turbulence structure of the dense gas plumes.An intermittency analysis technique was developed and applied to the digitized instantaneous velocity signals. It not only confirmed the general flow picture within the dense plume indicated by the flow visualization, but also clearly demonstrated the changes of flow regime with variations in Ri_* and Re_*. Most importantly, based on this intermittency analysis, simple criteria for characterizing different flow regimes are formulated; these may be useful in predicting when plume laminarization might occur.     

The varying effects of left–right ideology on support for the environment: Evidence from a Swedish survey experiment

Years of research show that left-leaning individuals are more supportive of environmental policies than right-leaning individuals. The explanation for the lower level of support among right-leaning individuals is their stronger preference for economic growth and lower acceptance of intervention in markets. However, recent cross-national studies have questioned whether the effect of ideology on environmental support is universal. A Swedish survey experiment shows that the effect of ideology varies greatly depending on how individuals think about the environment. Specifically, it demonstrates that if environmental support is contrasted with economic growth, then the effect of ideology is stronger as opposed to when environmental support is not juxtaposed with economic growth. Furthermore, among people who strongly perceive the environment as a left–right issue, there is a larger divide between left and right.     

餐厨垃圾高温厌氧消化产沼气的试验研究

探究了温度、含固率、pH及接种率对餐厨垃圾厌氧消化产沼量的影响,并设计L9(34)正交试验进行厌氧发酵工艺优化研究。结果表明,在温度为55℃、含固率为8%(质量分数)、pH为7.00、接种率为90%(质量分数)时,厌氧发酵累积产沼量为809.0mL/g(以挥发性固体计);各影响因素对产沼量的影响大小为温度pH接种率含固率。     

农药污染地下水的微生物治理及含水层渗透性变化研究

采用了从农药厂阿特拉津生产车间排污口污泥中分离出的菌种AT菌 ,进行了农药阿特拉津污染地下水微生物治理的模拟实验研究 ,在实验条件 (T =10℃ ,pH =7.5 )与野外含水层的条件基本一致情况下 ,难于生物降解的污染质阿特拉津的一次投菌降解率可达 3 1.0 8% ;设计了两种有效细菌的投放方式以模拟野外条件下的菌种投加条件。另外 ,AT菌的作用会造成被治理含水层的渗透性能降低 ,两种投菌方式下 ,实验后含水层的渗透系数分别下降 60 .5 4%和 3 4 5 6%。清水冲洗 10d的渗透性恢复率分别为 48.96%及 81.3 6% ,说明清水渗透恢复的方法效果明显     

低温降解六六六优势菌种的选育研究

通过实验,筛选出低温条件(≤10℃)下降解六六六的优势菌株--1号菌株,同时利用正交实验测得该菌株的最佳降解条件为:pH=5.5、接菌量2 g/L、NH4Cl 0.8 g/L、KH2PO4 0.6 g/L、MgSO4 0.2 g/L.在此条件下,经30 d驯化后的菌株对六六六的降解率由原来的54.71%提高到62.58%     

Optimizing electron spin resonance detection of hydroxyl radical in water

The parameters affecting the electron spin resonance (ESR) detection of hydroxyl free radical in water are studied and optimized. The hydroxyl radical is generated by the Fenton reaction with iron (II) ammonium sulfate and hydrogen peroxide reacting in a phosphate buffer using N-tert-butyl-alpha-phenylnitron as the spin trap. The concentrations of Fe²⁺, H₂O₂, and phosphate buffer are the parameters studied. The Taguchi method and the orthogonal experiment design were used to evaluate the effects of these parameters on the ESR signal intensity. By the analysis of the signal-to-noise ratio and the analysis of variance, the order of importance of the various parameters on the hydroxyl radical formation is determined for optimal ESR detection of hydroxyl radical. The results will help the development of water purification technologies using hydroxyl free radical as a green oxidant.     

铁炭内电解-厌氧-好氧工艺处理阿维菌素废水的试验研究

血清瓶毒性试验表明 ,AVM对厌氧消化产生强烈的抑制作用。AVM废水经铁炭内电解预处理后 ,COD和AVM的去除率分别达到 19.5 %和 6 8.5 % ,可大大降低废水的毒性。预处理出水再经UASB +生物接触氧化反应器进一步处理 ,当生化系统进水COD为 6 0 0 0— 6 5 0 0mg/L时 ,出水COD为 2 5 0— 2 80mg/L ,总COD去除率达到 95 .6 % ,出水达到生物制药行业排放标准     

三种混凝剂处理煤泥水的对比试验研究

本文介绍了石灰、电石渣及CaCl2 分别与聚丙烯酰胺联用处理煤泥水的对比试验研究结果。结果表明 ,三种方法对煤泥水均有较好的处理效果 ,其中CaCl2 法效果最好 ,但药剂费也最高 ,石灰法和电石渣法处理效果相差不大 ,但电石渣法药剂费较低。     

鱼类、底栖动物和水生植物的不同组合对水质净化效果的原位围隔实验

在野外原位围隔模拟条件下,研究了鱼类、底栖动物和水生植物的不同组合对富营养化水体的净化效果。研究结果表明：鲢鳙鱼比例对水质有较大影响,当鲢鱼（Hypophthalmichthys molitix）与鳙鱼（Aristichthys nobilis）的比例为3：1时,TN和NH3-N的去除率分别为69.26%和66.39%,4：1时,NO3-N的去除率可达73.65%;当鲢鱼与鳙鱼的比例为5：1时,TP和PO43-的去除率可达66.73%;鲴鱼（Plagiognathops Microlepis Bleeker）对水体中磷元素的去除效果显著,TP和PO43-的去除率可分别提高13.89%和7.91%,但不利于氮的去除;150 g·m-2密度螺（Bellamya aeruginosa）和蚌（Hyriopsis cumingii）的投加对TN的去除率可达72.60%,但对其他营养盐的削减效果不佳;水生植物蕹菜实验组与无植物组相比TN去除率提升6.83%,NH3-N提升6.44%,NO3-N提升12.14%,效果优于菱,但却不利于磷的去除。实验结果可为水生生态系统调控和修复提供科学依据。     

同步进出水SBR设备最佳进水方式流态模拟

借助流体计算软件Fluent对某同步进出水SBR设备4种不同进水位置以及3种进水孔排布分别进行流态模拟,根据模拟结果得到最佳的进水方式;同时在该进水方式下对进水流量为0.5、0.7、1.0、1.3和1.5 m3/h时反应器内的流态分布情况进行了数值模拟,最后通过示踪剂实验与模拟结果对比验证。对于实验用SBR(长×宽×高为2 m×2 m×1.2 m),进水流量1.0 m3/h是最佳进水流量,此时反应器内流态稳定,进水区域主要分布于反应器中下部以及远离堰口的池壁附近,死水区面积较小,冲击负荷适中,进水对出水水质影响较小;当进水流量小于1.0 m3/h时,进水主要分布于反应器池底,对角线方向以及远离进水端池壁附近3个区域且彼此相对独立,池内死水区面积较大;当进水流量大于1.0 m3/h时,进水冲击负荷过大,迅速形成短流,影响出水水质。