Natural gas engine driven heat pump system – a case study of an office building

ABSTRACT

An eQUEST model was developed to conduct a simulation study of a natural gas engine-driven heat pump (GEHP) for an office building in Woodstock, Ontario, Canada. Prior to the installation of the GEHP, the heating and cooling demands of the office building were provided by rooftop units (RTUs), comprising of natural gas heater and electric air conditioner. Energy consumption for both GEHP and RTUs were monitored for operation in alternating months. These recorded energy consumptions along with weather data were used in the regression analysis. The developed eQUEST models were validated and calibrated with the regression analysis results with respect to the ASHRAE Guideline 14–2014. The eventual models were then applied to investigate the potential annual energy consumption, greenhouse gas (GHG) emission and energy cost savings achieved by using the GEHP in Woodstock, and other cities in Canada, particularly in Ontario.     

Effect of pipes in heat pump system on electric vehicle energy saving

ABSTRACT

Refrigerant pressure drop and temperature change in pipes are normally ignored in the thermodynamic analysis of traditional vehicle air conditioning system, this will result in serious errors. In this Paper, pressure drop and temperature difference are simulated in different pipes of electric vehicle (EV) heat pump system to analysis the effects of pipes in the actual EV heat pump system. The results indicate that the greater the mass flow, the faster pressure drop increases, the temperature difference decreases. Pressure drop of saturated liquid refrigerant is smaller than that of saturated gas refrigerant at the same saturation pressure and mass flow rate. The higher the refrigerant pressure (no phase change), the slower pressure drop decreases, the faster the temperature difference decreases. Pressure drop decreases with the increment of bending angle of the pipe. For EV heat pump system, suitable valves and less branches are helpful for energy saving of the system. Shortening the pipe between compressor and condenser can reduce temperature change obviously. Pressure drop per unit length in the pipe between evaporator and compressor is large especially in heating mode because of lower refrigerant density. It even reaches to over 100 times of that in the pipe between condenser and throttle valve in heating mode and has negative effects on the performance of the system. If the evaporator is closer to the compressor and the number of branches is less, then pressure drop will decrease a lot, which will be advantageous for energy saving of the heat pump system.     

Experimental study on the effect of fly ash content in cemented paste backfill on its anti-sulfate erosion

ABSTRACT

In order to study the effect of fly ash content in cemented paste backfill (CPB) on its anti-sulfate erosion, the apparent phenomenon, strength development, and hydration products change the law of CPB with different fly ash content under long-term soaking of 5% sodium sulfate solution were studied by the macrotest and microanalysis, in addition, the mechanism of CPB anti-sulfate attack was analyzed by combining with a scanning electron microscope (SEM). The results indicated that the effect of sulfate environment on the strength of fly ash cemented paste backfill (FCPB) was mainly determined by the hydration products in the FCPB at different soaking times. In the early soaking stage, the formation of ettringite (AFt) in FCPB could improve its compactness, which was conducive to improving the strength of FCPB. In the late soaking stage, there were ettringite-type erosion damage and gypsum erosion-type damage internal of the FCPB with low content fly ash, resulting in microfracture, cracking of the FCPB, and reducing the strength. CPB with an appropriate content of fly ash could improve the internal structure of the FCPB to achieve the purpose of anti-sulfate erosion.     

Risk-based optimal operation of hybrid power system using multiobjective optimization

ABSTRACT

This paper solves an optimal generation scheduling problem of hybrid power system considering the risk factor due to uncertain/intermittent nature of renewable energy resources (RERs) and electric vehicles (EVs). The hybrid power system considered in this work includes thermal generating units, RERs such as wind and solar photovoltaic (PV) units, battery energy storage systems (BESSs) and electric vehicles (EVs). Here, the two objective functions are formulated, i.e., minimization of operating cost and system risk, to develop an optimum scheduling strategy of hybrid power system. The objective of proposed approach is to minimize operating cost and system risk levels simultaneously. The operating cost minimization objective consists of costs due to thermal generators, wind farms, solar PV units, EVs, BESSs, and adjustment cost due to uncertainties in RERs and EVs. In this work, Conditional Value at Risk (CVaR) is considered as the risk index, and it is used to quantify the risk due to intermittent nature of RERs and EVs. The main contribution of this paper lies in its ability to determine the optimal generation schedules by optimizing operating cost and risk. These two objectives are solved by using a multiobjective-based nondominated sorting genetic algorithm-II (NSGA-II) algorithm, and it is used to develop a Pareto optimal front. A best-compromised solution is obtained by using fuzzy min-max approach. The proposed approach has been implemented on modified IEEE 30 bus and practical Indian 75 bus test systems. The obtained results show the best-compromised solution between operating cost and system risk level, and the suitability of CVaR for the management of risk associated with the uncertainties due to RERs and EVs.     

高含CO2天然气运输管道缓蚀剂的筛选

大多数天然气藏CO2含量为10%~98%,CO2在不同的温度、压力条件下腐蚀极其严重。文章主要针对高含CO2天然气运输管道腐蚀的问题,开展缓蚀剂的筛选,重点开展CO2腐蚀规律研究与实验,评价环境温度、CO2分压、流动速度对腐蚀规律的影响,明确缓蚀剂的影响因素,结合管材的材质,优选评价不同类型的缓蚀剂,缓蚀效率分别为90.53%和92.64%,在管道凝液介质的气相及液相中都有较高的缓蚀效率。通过设计现场加药工艺及制度,监测评价缓蚀剂缓释效果和腐蚀情况,可防止管道运输过程中CO2腐蚀的侵害,长输管线内腐蚀控制良好。     

Environmental pollution,hydropower and nuclear energy generation before and after catastrophe: Bathtub-Weibull curve and MS-VECM methods

In this paper, the life span of hydro and nuclear energy generations and the relationship between hydro and nuclear energy generations, environmental pollution, and economic growth were investigated for Japan covering the period of 1960–2018 by employing the Bathtub-Weibull curve and Markov switching-vector error correcting (MSVEC) method, respectively. According to the Bathtub-Weibull curve analysis, a rising failure rate for nuclear energy was found, indicating that the life of nuclear energy has expired, but a decreasing failure rate for hydroelectric energy has been detected. Then two different MSVEC models were used. The MSVEC method, unlike traditional approaches, determines the relationship between variables under different regimes. The results of MSVEC methods indicate three important points. First, regime-dependent asymmetry and regime changes are crucial for policy recommendations. Second, the shocks to hydropower and nuclear energy generations cause temporary deviations from the long-run growth path in both regimes. Lastly, the increase in hydropower generation leads to a decrease in environmental pollution and an increase in GDP, and an increase in nuclear power generation increases pollution and growth in both regimes.     

The impact of coal and non-coal consumption on China's energy performance improvement

China is the world's largest energy consumer, and coal accounts for a higher proportion of the country's total energy consumption, yet during its 12th five-year plan (2011–2015), the coal share among total energy consumption significantly decreased. Previous studies exploring energy performance typically used energy consumption as an input, but this lacks the analytical capacity for the structure of energy consumption. Thus, this study splits energy input into two different inputs, coal consumption and non-coal energy consumption, and based on their differences with other variables, uses the hybrid dynamic data envelopment analysis model to assess the energy performance of China's provincial industrial sector during the period 2011 to 2015. We then compare coal consumption's and non-coal consumption's rooms for improvement and conclude that provinces in eastern and central China should reduce the amount of coal consumption, thereby improving energy performance. Conversely, provinces in the western region should target a balance between energy utilization efficiency and coal consumption.     

铬污染土壤的导电性、频谱激电性和介电特性的实验结果

研究了铬污染土壤的导电性、激电性和介电性,给出了在不同含水率、不同浓度铬盐污染物的情况下,铬污染土壤样品的电阻率、复电阻率和复介电常数与污染物浓度及含水率变化关系的一些实验观测结果.土样中的观测结果表明,所有污染样品的电阻率、复电阻率幅值均随污染浓度和含水率的增加而减小;但对反映土壤样品容性的复电阻率相位参数而言,则有...     

草甘膦与镉复合胁迫对玉米幼苗抗氧化酶活性及光合作用的影响

为了探讨草甘膦(PMG)与重金属镉(Cd)复合胁迫对作物(玉米幼苗)生长的影响作用机制。通过温室盆栽试验,分别进行了不同浓度的PMG单一处理(浓度分别设计为0、1.25、2.5、5、10、20 mg·kg~(-1))和不同浓度的PMG(浓度分别为0、1.25、2.5、5、10、20 mg·kg~(-1))与浓度5 mg·kg~(-1)Cd2+的复合处理。采用分光光度法和连续激发式荧光仪分别对玉米幼苗抗氧化酶(过氧化物酶POD、过氧化氢酶CAT、超氧化物歧化酶SOD)、丙二醛(MDA)、叶绿素含量、荧光动力学曲线及相关参数进行了测定。结果表明,单一和复合胁迫分别在PMG浓度为1.25~5 mg·kg~(-1)、1.25~2.5 mg·kg~(-1)时,玉米幼苗通过增大抗氧化酶(SOD、POD、CAT)活性,清除积累过多的活性氧自由基,提高叶绿素含量的合成,加大光合作用速率,促进玉米幼苗的生长;单一和复合胁迫分别在PMG浓度为5~20 mg·kg~(-1)、2.5~20 mg·kg~(-1)时,由于玉米幼苗积累了过多的膜脂过氧化物,导致抗氧化系统损坏,阻碍叶绿素含量的合成,同时也损害了PSII的功能(MO、φPO、ΨO、φEO、φDO、ABS/RC、TRO/RC、ETO/RC、DIO/RC、PIABS),导致玉米幼苗光合作用受到抑制,阻碍幼苗的生长。研究表明,草甘膦单一胁迫和与重金属镉复合胁迫,对玉米幼苗酶活性及光合作用的影响,均随处理浓度的升高表现为双阶段性,低浓度促进,高浓度抑制;与同浓度的PMG单一处理相比,Cd2+的存在,加大了PMG单独存在时的损害作用,使得玉米幼苗对PMG胁迫的敏感浓度点从5 mg·kg~(-1)降低到2.5 mg·kg~(-1)。     

Effects of different endogenous fungi on the mass loss and nutrient content of leaf litter of Cunninghamia lanceolata北大核心CSCD

To explore the role of endophytic fungi in the decomposition of litter, the endophytic fungi Penicillium sp. strain CG2 (A), Fusarium flavum strain AY13 (B), and Talaromyces strain AJ14 (C) of Cunninghamia lanceolata were added to experimental pots in different forms (mycelium, sterilized fermentation broth, single fungus, and mixed fungi), and a control treatment (CK) was set up (no fungi added). At 10, 30, 60, 90, and 120 days after litter decomposition, a study on the decomposition dynamics of C. lanceolata litter under different treatments was performed. The results showed that the rate of leaf mass loss was the highest in the sterilized fermentation broth treatment A after 120 days, and that there was a significant difference (P < 0.05) between the mycelium treatment AC and the control treatment after 60 days (23.97% higher than the control group). On day 60, the litter carbon content from the mycelium treatment A was significantly different from that of the control (P < 0.05), showing a 16.74% lower value, whereas the litter carbon content of the mycelium treatment B was 21.13% lower than that of the control after 90 days. The nitrogen content of the litters of most mycelium and sterilized fermentation broth treatments was increased compared to that of the control group; there was significant difference (P < 0.05) between the sterilized fermentation broth treatment A and the control (P < 0.05), with a 17.05% higher value than that of the control. Similar to nitrogen, the litter phosphorus content also increased; there was a statistically significant difference between the mycelium treatment A and the control group, with treatment A showing a 46.67% higher value than the control group. The potassium content was 28% lower than that of the control group under the sterilized fermentation broth treatment C, a result that was significantly different from that of the control group (P < 0.05). After treatment for 90 days, the ratio of carbon to nitrogen was the lowest under the treatments with the mycelium A and the mycelium B, with values 25.54% and 25.11% lower than that of the control group, respectively, and a statistically significant difference from that of the control group (P < 0.05). The ratio of carbon to phosphorus was the lowest under the treatment with mycelium A after 60 days, and the result was significantly different from that of the control (P < 0.05), with a 43.05% lower value than the control. Thus, the three endophytic fungi had different effects on the mass loss rate and nutrient content of the litter. The Penicillium sp. strain CG2 (A) had statistically significant effects on the mass loss and nutrient content of leaf litter, which was within the range of fungi fertilizer reference values for the breeding of C. lanceolata. © 2018 Science Press. All rights reserved.