大豆蛋白粉喷雾干燥塔尾气余热的回收与利用

针对大豆蛋白粉生产过程中喷雾干燥塔尾气温度较高,有回收利用价值的现实,也针对目前的节能需求,对现有的喷雾干燥塔的尾气排放部分进行改造,设计一个片状空气预热器,以利用高温的尾气与系统的进气做热交换,实现热量再利用,降耗和提高蛋白粉产率的目的,并对投资收益进行了分析。     

从粉煤灰中提取多种微细氧化物的研究

将粉煤灰与Na2CO3按一定的比例混合后焙烧,采用酸碱联合法提取粉煤灰中氧化硅、氧化铝和氧化铁,分析了工艺条件对粉煤灰中氧化物提取率的影响。实验结果表明,从粉煤灰中提取氧化物的最佳条件是:碳酸钠与粉煤灰的比例0.6∶1.0,焙烧温度850℃、盐酸浓度4 mol/L,氢氧化钠浓度2.6 mol/L,浸取时间约6 h。在此条件下得出微细氧化硅、氧化铝、氧化铁的晶体,其平均粒度分别为氧化硅1.107μm,氧化铝1.334μm,氧化铁0.783μm。     

Relation of hepatic EROD activity and cytochrome P4501A level in Sebastiscus marmoratus exposed to benzo[a]pyrene

This study was designed to investigate the in vivo effects of benzo[a]pyrene （BaP） on hepatic ethoxyresorufin-O-deethylase （EROD） activity and its correlation with cytochrome P4501A （CYP1A） protein levels in Sebastiscus marmoratus, which were exposed through a water column to BaP （10, 100, 1000 ng/L, respectively） or were treated with intraperitoneal injections of BaP （0.5, 1, 5, 10 mg/kg, respectively） every 7 d. The results showed that after 25 d of waterborne exposure to 1000 ng/L BaP, fish hepatic CYP1A levels and EROD activity were significantly induced. In contrast, EROD activity was not altered 7 d after second intraperitoneal injections, whereas, CYP1A protein levels were increased. Dose-dependent increase of biliary BaP metabolites demonstrated that the catalytic activity of CYP1A was induced by treatment with BaP. The lowest observable effect concentration with regard to biliary BaP metabolites （100 ng/L） was much lower than that with reference to EROD activity （1000 ng/L）. The results suggest that biliary polycyclic aromatic hydrocarbon （PAH） metabolites were shown to better reflect the contamination gradients of PAHs than EROD activity. It appeared to be necessary to measure CYP1A protein levels to complement the EROD activity in relevant toxicological assessments.     

漂白粉用于治理石化企业硫化氢恶臭气体的研究

实验采用填料吸收塔对漂白粉用于石化企业硫化氢恶臭的治理进行了初步研究,系统研究了漂白粉投加量、硫化氢浓度、进气流量、吸收氧化温度、液气比等因素对处理效果的影响。结果表明：室温下,漂白粉投加量为0．2g／100mL,液气比20L／m^3,进气浓度控制在7800mg／m^3以内,调整适宜的进气量,对硫化氢恶臭的去除率可以达到99％以上。漂白粉吸收氧化硫化氢恶臭气体不仅技术可行,而且费用低廉,操作方便,可以进行深入的研究,进行工业化放大。     

Bradford法测定土壤球囊霉素相关蛋白的影响因子

土壤球囊霉素相关蛋白(glomalin-related soil protein,GRSP)是评价土壤健康的重要指标。研究了土样粒径、贮存条件和高温提取后离心延误时间3个影响因子对采用Bradford法测定GRSP含量的作用效果。结果表明,土样粒径对易提取GRSP(EEG)的提取测定影响显著,过0.074 mm孔径筛土样中提取出的EEG含量高于过0.149、0.25、1 mm孔径筛的土样;总GRSP(TG)含量的测定结果对土样粒径的变化没有明显响应,测定TG含量可采用过1 mm孔径筛的土样。贮存条件影响EEG和TG含量的测定,有机质含量低的土样室温保存18个月条件下测得的EEG含量低于-20℃保存条件下;有机质含量高的土样室温保存条件下测得的EEG含量高于-20℃保存条件下;室温保存条件下3个有机质含量水平的土样TG含量均高于-20℃保存条件下。不同样品保存方式间3个有机质含量水平的土样EEG或TG含量差异均显著。为减小有机质降解等的影响,宜低温保存土样。提取后延误离心将导致EEG含量测定值降低,因此延误时间以控制在1 h之内为宜;离心延误2 h内不同延误时间之间测得的TG含量无显著差异。     

摩托车防盗器遥控引燃黑火药的实验研究

根据2013型铁将军牌摩托车防盗器工作原理,分析了连接左转向灯、起动继电器及电门锁的5条导线遥控引燃黑火药的方式.利用GOS-620型示波器,测得防盗器在设防、寻车、起动、振动1次、连续振动、解锁时这5根导线两两之间的电压.从60种组合中筛选出10种可能引燃黑火药的方式.通过引燃实验,验证了这10种引燃方式.以左转向灯...     

不同聚合度的聚磷酸铵灭火性能研究*

为考察聚磷酸铵（APP）干粉灭火剂的聚合度对其灭火性能的影响,选用3种不同聚合度的APP,结合其晶体结构、粒度分布及热性能测试,并通过粉体杯式燃烧器进行小尺寸灭火实验,对比3种样品的灭火性能及灭火机理,研究聚合度与其灭火性能的关系。热性能测试结果显示,聚合度的升高会导致APP的热稳定性下降,随着聚合度从80升至1 500,其初始分解温度从326.11 ℃降低至321.54 ℃,失重率从75.21%增加至79.66%。实验结果表明:随着APP聚合度的增加,火焰降温速率升高,最小灭火浓度（MEC）降低,灭火性能增强,当聚合度为1 500时,MEC为118.143 g/m3。聚合度的升高有助于APP在进入火场后更早、更充分地与火焰发生反应,从而使灭火性能得到提升。     

酸化大豆蛋白废水的厌氧处理

对有机质浓度高,成分单一,蛋白质、总氮浓度较高,易酸化,且已酸化程度较高的大豆蛋白废水,确定以新型内循环厌氧反应池为主的处理工艺,在原废水ρ(COD)为11809~15040mg/L时,总出水浓度192~350mg/L,去除率达到96.2%~97.5%。新的内循环厌氧反应池具有高度小、结构简单、污染物去除率高的特征,COD运行负荷达6.0~7.5kg/(m3.d),COD去除率达88%~93%。当COD运行负荷5.0~7.0kg/(m3.d)时,该池内循环管道形成了连续的较强内回流。     

Bioabsorbable Soy Protein Plastic Composites: Effect of Polyphosphate Fillers on Biodegradability

The use of biodegradable polymers made from renewable agricultural products such as soy protein isolate has been limited by the tendency of these materials to absorb moisture. A straightforward approach for controlling the inherent water absorbency of the biodegradable polymers involves blending special bioabsorbable polyphosphate fillers, biodegradable soy protein isolate, plasticizer, and adhesion promoter in a high-shear mixer followed by compression molding. The procedure yields a relatively water-resistant, biodegradable soy protein polymer composite, as previously reported. The aim of the present study is to determine the biodegradability of the new polyphosphate filler/soy protein plastic composites by monitoring the carbon dioxide released over a period of 120 days. The results suggest that the composites biodegrade satisfactorily, with the fillers having no significant effect on the depolymerization and mineralization of the soy protein plastic, processes that would otherwise result in nonbiodegradable composites. Further, the results indicate that the biodegradation and useful service life of these biocomposites may be controlled by changing the filler concentration, making the biocomposites useful in applications in which the control of water resistance and biodegradation is critical.     

Thermal and Mechanical Properties of Plastics Molded from Sodium Dodecyl Sulfate-Modified Soy Protein Isolates

Soybean protein is a potential material for manufacturing of biodegradable plastics. The objective of this investigation was to characterize the thermal and mechanical properties of plastics made from sodium dodecyl sulfate (SDS)-modified soy proteins. Soy protein isolate (SPI) was prepared from defatted soy flour, modified with various concentrations of SDS, and then molded into plastics. The temperatures of denaturation of the modified soy protein increased at low SDS concentration and then decreased at high SDS concentration. At the same SDS concentration, the plastics molded from the modified soy proteins showed a similar temperature of denaturation, but a lower enthalpy of denaturation compared to the modified soy protein. Young's modulus of the plastics decreased as SDS concentration increased, and the tensile strength and strain at break of the plastics reached a maximum value at 1% SDS modification. Two glass transition temperatures were identified corresponding to the 7S and 11S globulins in SPI by dynamic mechanical analysis, and they decreased as SDS concentration increased. The SDS modification increased the water absorption of the plastics.