部分亚硝化-厌氧氨氧化耦合工艺处理污泥脱水液

在缺氧滤床+好氧悬浮填料生物膜工艺中实现部分亚硝化,然后进行厌氧氨氧化(ANAMMOX),考察其对高含氮、低C/N污泥脱水液的处理能力.结果表明,亚硝化反应器在15~29℃、DO 6~9mg/L条件下,通过综合调控进水氨氮负荷(ALR)、进水碱度/氨氮、水力停留时间(HRT)等运行参数,可以调节出水(NO2--N)/(NH4+-N)的比率,能够较好地实现部分亚硝化反应以完成厌氧氨氧化.当进水ALR为1.16kg/(m3·d),进水碱度/氨氮为5.1时,出水(NO2--N)/(NH4+-N)在1.2左右,(NO2--N)/(NOx--N)大于90%,进入ANAMMOX反应器的氮物质去除率达到83.8%.     

填充新型抗菌PVA小球的固定柱床的应用

通过优化的PVA-H₃BO₃包埋法制备了抗菌PVA小球,并用新制备的小球填充柱床进行水处理研究. 结果表明:抗菌PVA小球具有良好的杀菌性能,在杀生剂添加量为m(杀生剂)∶m(PVA)3∶2时,杀菌率达到(92±2)%;扫描电子显微镜显示,包埋了杀生剂的抗菌PVA凝胶小球是一种多孔性的球形颗粒,结构较密实,并且包埋效果理想. 随着填充高度的升高、处理液与抗菌材料接触时间(停留时间)的延长、处理液出口端流量的减小, 填充柱的杀菌性能逐渐升高;对于30mm×300mm的填充柱,当填充高度≥20cm, 停留时间≥0.5 h,出口端流量为2.7 mL/s时, 杀菌效果较好. 对于50mm×500mm的填充柱,在填充高度为10 cm,停留时间为0.5 h,出口端流量为2.7 mL/s时,其杀菌率为(93±1)%.      

手喷漆清洗剂的研制

为了有效地清除城市小广告以及街头涂鸦,研制了一种针对热塑性丙烯酸树脂类手喷漆的乳液型脱漆剂。采用单因素实验法研究了有机溶剂的种类、用量,主、助溶剂的质量比,表面活性剂的种类、用量,甲酸的用量,对脱漆效率的影响。实验结果表明:脱漆剂的最佳组成为以乙酸丁酯为主溶剂,苯甲醇为助溶剂,十二烷基苯磺酸钠和OP-10复配为表面活性剂,甲酸为促进剂,石蜡为挥发抑制剂。当乙酸丁酯为27 g,苯甲醇为9 g,十二烷基苯磺酸钠为1 g,OP-10为1 g,甲酸为2 g,石蜡为6 g时脱漆效率最高。在最佳实验配方及其用量的条件下,1 mL脱漆剂所能擦除漆膜的面积为70.65 cm2。并且脱漆剂中水含量超过50%,其余组成部分均为低毒、挥发性不大的物质,易于生物降解,市售常见,成本低廉,符合绿色化学"高效、洁净、经济、环保"的要求。     

CTMAB-膨润土去除水中有机物的性能及机理

用溴化十六烷基三甲铵（CTMAB）改性膨润土,研究了CTMAB膨润土去除水中苯、甲苯、乙苯、硝基苯、苯胺、苯酚、对硝基苯酚的性能、机理及影响因素。结果表明,CTMAB-膨润土去除水中有机物的能力远大于原土;CTMAB-膨润土对苯、甲苯、乙苯的等温吸附曲线呈线性;对水中苯酚、对硝基苯酚的等温吸附曲线呈非线性;对苯胺、硝基苯的等温吸附曲线基本呈线性。CTMAB-膨润土吸附水中有机物的性能及机理与有机物的水溶性或辛醇－水分配系数有关。     

环保型脲醛树脂胶粘剂的合成研究

介绍了聚乙烯醇(PVA)、三聚氰胺在脲醛树脂胶粘剂合成过程中所起的改性作用,研究了反应温度、反应体系pH、甲醛与尿素摩尔比、PVA和三聚氰胺用量对脲醛树脂胶粘剂性能的影响。试验结果表明,在反应温度为80℃、反应体系pH为5．0、甲醛与尿素摩尔比为1．5、PVA和三聚氰胺用量分别为尿素与甲醛溶液总质量的1．0％和5％的条件下,合成的脲醛树脂胶粘剂的剪切强度为2．99MPa,游离甲醛的质量分数由传统工艺生产产品的0．6％～0．8％降低至0．063％,耐沸水时间为108min,且贮存稳定性好,达到了HJBZ-1998国家环境标志产品技术要求。     

亚铵法麦草浆黑液的回收与污染治理新技术的研究

通过对亚铵法麦草浆黑液性质的研究 ,提出了蒸发浓缩 +生物活性有机肥生产的新技术路线 ,并结合生产实践对该技术加以研究、归纳 ,并进行了经济分析。实践证明 ,运用该技术不仅能实现亚铵法麦草浆黑液的回收和污染治理达标 ,而且能为企业带来可观利润 ,使企业走上可持续发展之路。     

An efficient resin for solid-phase extraction and determination by UPLCMS/MS of 44 pharmaceutical personal care products in environmental waters

• A hydrophilic resin (GCHM) was facile synthesis and characterized. • Average absolute recovery of GCHM (75.6%) performs better than Oasis^® HLB. • Detection limits of method (SPE-UPLC-MS/MS) ranged between 0.03 and 0.6 ng/L. • 22 PPCPs were determined in environmental waters ranging from 0.5 to 1590 ng/L. In this study, a hydrophilic resin named GCHM was fabricated based on poly(N-vinyl pyrrolidone-co-divinylbenzene), characterized, and applied as a solid-phase extraction (SPE) material. Up to 44 pharmaceuticals and personal care products (PPCPs) belonging to 10 classes were recovered in environmental water samples. Different variables affecting extraction, such as adsorbent amount, sample pH, and loading speed, were optimized. Under optimal conditions, the average absolute recovery of 44 PPCPs was 75.6% using GCHM, indicating a better performance than the commercial Oasis^® HLB. SPE with home-made hydrophilic polymeric sorbent followed by ultra-performance liquid chromatography and tandem mass spectrometry was validated, and the method achieved good linearity (r²>0.991, for all analytes). In addition, the method detection limits of target compounds ranged from 0.03 to 0.6 ng/L. The developed method was applied to determine PPCPs in 10 environmental water samples taken from the Yangtze River, Huaihe River, and Taihu Lake, 1 groundwater sample from Changzhou in Jiangsu Province, 1 wastewater sample from Xiamen and 2 seawater samples from the Jiulong River in Fujian Province, China. In these samples, 22 compounds were determined at levels ranging from 0.5 to 1590 ng/L.     

树脂吸附法处理硝基苯和硝基氯苯生产废水的研究

研究了用ＣＨＡ－１１１树脂吸附处理硝基本和硝基氯苯生产废水的最佳工艺条件，当废水中硝基苯类化合物含量为６３９ｍｇ／Ｌ时，ＣＨＡ－１１１树脂的工作吸附容量为１２６ｍｇ／ｍＬ，处理水量为１９０ＢＶ，处理后硝苯类化合物的浓度〈５ｍｇ／Ｌ，去除率〉９９％；采用异丙醇作脱附剂；表明该树脂的吸附与脱附性能良好。     

硫酸盐型厌氧氨氧化的反应机理及启动过程影响因素综述

硫酸盐型厌氧氨氧化(S-ANAMMOX)可将废水中的氮硫元素同时去除,避免了氨氮、硫酸盐分别处理时过程不稳定、去除效率低等不足,且不产生二次污染。但该反应的启动耗时长以及机理不明确影响了其应用。本文在探讨S-ANAMMOX反应机理的基础上,对反应器、污泥源、填料、碳源及运行条件等启动过程影响因素进行了阐述,并对今后的研究做出了展望。指出:应在量化反应产物的基础上深入对反应机理和功能微生物特性的研究;分析反应器、污泥源等启动因素的差异性;促进S-ANAMMOX在实际废水处理中的应用。     

A spatial-temporal system for dynamic cadastral management

A practical spatio-temporal database (STDB) technique for dynamic urban land management is presented. One of the STDB models, the expanded model of Base State with Amendments (BSA), is selected as the basis for developing the dynamic cadastral management technique. Two approaches, the Section Fast Indexing (SFI) and the Storage Factors of Variable Granularity (SFVG), are used to improve the efficiency of the BSA model. Both spatial graphic data and attribute data, through a succinct engine, are stored in standard relational database management systems (RDBMS) for the actual implementation of the BSA model. The spatio-temporal database is divided into three interdependent sub-databases: present DB, history DB and the procedures-tracing DB. The efficiency of database operation is improved by the database connection in the bottom layer of the Microsoft SQL Server. The spatio-temporal system can be provided at a low-cost while satisfying the basic needs of urban land management in China. The approaches presented in this paper may also be of significance to countries where land patterns change frequently or to agencies where financial resources are limited.