阶式生物接触氧化对富营养化太湖水源水中溶解有机物的去除性能研究

构建阶式生物接触氧化反应器处理富营养化太湖水源水,对其净水效能进行研究。结果表明,在优化工况条件下,阶式生物氧化反应器的三阶对太湖水源水中DOC的累积去除率分别为34．4％、40．2％和47．5％,对BDOC的总去除率为68．4％,除生物降解外,填料拦截、生物吸附絮凝等物理、化学作用对去除原水中的DOC仍有重要作用。DOC分子量分级表明,太湖源水中含量最大的是分子量〈500Da的DOC,含量最小的是分子量在5k～500Da间的DOC。阶式生物接触氧化反应器对分子量〈500 Da的DOC的去除率在60％以上,而出水中5k～500 Da区间的DOC含量相比原水增加近1倍。     

曝气生物滤池Biostyr处理微污染水源

采用曝气生物滤池Biostyr对浙江省T市某水厂微污染水源水进行生物预处理,现场试验研究表明:在气水比为2∶1,滤速6m/h,水温24～32℃的运行条件下,其对水中各污染物的平均去除率为:高锰酸盐指数24.1%,氨氮81.7%,亚硝酸盐氮79.9%,浊度49.0%。完全能达到生物预处理目的。     

Concentrations of inorganic elements in 20 municipal waters in Sweden before and after treatment – links to human health

The water chemistry of 20 municipal water treatment plants in southern Sweden, representing various bedrock situations, and water qualities, were investigated. Four water samples, raw and treated, were collected from each plant and analyzed by predominantly ICP-OES and ICP-MS at four occasions from June to December, 2001. The concentrations of Ca, Mg, K, Na, HCO₃ and a number of micronutrients, varied considerably in treated waters from the studied plants (ranges; Ca: 9.1–53.7 mg L⁻¹, Mg: 1.4–10.9 mg L⁻¹, K: 1.1–4.8 mg L⁻¹, Na; 5.4–75.6 mg L⁻¹, HCO₃: 27–217 mg L⁻¹). The elimination of Fe and Mn from raw water was efficient in all treatments investigated, giving concentrations in treated waters below the detection limits at some plants. Softening filters gave waters with Ca-concentrations comparable to the softest waters in this study. Adjustment of pH by use of chemicals like lye, soda or lime, modified the consumer water composition significantly, besides raising the pH. It was estimated that drinking water contributed to approximately 2.2–13% of the daily Ca uptake, if the gastrointestinal uptake efficiency from food and water was estimated to be around 50%. The corresponding figures for Mg was 1.0–7% and for F 0–59%. None of the studied elements showed any significant time trends in raw or treated waters during the follow-up period. The concentrations of potentially toxic metals such as Al, Pb and U were low and did not indicate risks for adverse health effects (ranges; Al: 0.5–2.3 μg L⁻¹, Pb: 0–0.3 μg L⁻¹, U: 0.2.5 μg L⁻¹).     

Enterotoxin production and antimicrobial susceptibility in Staphylococci isolated from traditional raw milk cheeses in Serbia

This study was undertaken to determine the prevalence of coagulase positive staphylococci (CPS) by examining a total of 71 raw milk cheeses. Additionally, enterotoxigenicity, antimicrobial susceptibility and the presence of mecA and mecC genes in the staphylococcal isolates were investigated. The isolation and enumeration procedure of CPS followed the International Organization for Standardization (ISO) standard. The presumptive staphylococci were identified by matrix-assisted laser desorption ionization-time of flight mass spectrometry (MALDI-TOF MS) using the VITEK MS system. VIDAS® Staph enterotoxin II assay was used for the detection of classical enterotoxins. Antimicrobial susceptibility testing (AST) was accomplished performing the disk diffusion method. All suspected methicillin resistant staphylococci were investigated for the presence of mecA and mecC genes by PCR assay. A high prevalence (87.32%) of CPS was detected in the cheeses at contamination levels up to 5.58 log CFU g^?1. Among 47 staphylococcal isolates screened for enterotoxin production, only one isolate, identified as S. hyicus, was confirmed as being enterotoxigenic. Resistance to penicillin (63.70%) was the most common resistance among the tested Staphylococcus aureus isolates. The dominant phenotypic resistance patterns in coagulase negative staphylococci (CNS) were resistance to ofloxacin and fusidic acid. All CNS isolates were susceptible to the clinically important antibiotics clindamycin, chloramphenicol, gentamicin, linezolid, rifampicin and trimethoprim-sulfamethoxazole. The mecA and mecC genes were not detected. To the best of our knowledge, this is the first study concerning evaluation of the presence of methicillin resistant staphylococci (MRS) in dairy products in Serbia.     

阳离子型聚合物对低温低浊水的絮凝效果与形态学特性

采用微絮凝-深床直接过滤工艺,以西安市曲江水厂低温低浊水质为原水(水温低于10 ℃,初始浊度低于10NTU),投加阳离子型聚合物(简称CP)作主混凝剂或助凝剂,借助分形数学理论与图像分析技术,对滤料粒径、原水浊度、原水温度、药剂种类、聚合物分子量及投加量、混合强度等因素对处理效果的影响进行了研究,分析探讨了不同药剂处理低温低浊水的作用机理、絮凝形态学特征以及絮体结构的分形特性.结果表明,①当温度低于4 ℃、初始浊度小于4NTU时,不宜单独采用Al2(SO4)3或PAC作为絮凝剂;当温度为4～10 ℃、初始浊度小于10NTU时,如果只投加Al2(SO4)3或PAC作为絮凝剂,宜用细砂滤料过滤;低温低浊条件下,无机混凝剂形成的絮体粒径小、结构松散脆弱、有效质量密度低、沉速慢,但表征絮体分形特性的分维值较高.②CP作絮凝剂能显著改善低温低浊水的絮凝效果与过滤性能,但混合强度需增大,宜用粗砂滤料过滤;③单独用CP作絮凝剂时,宜投加分子量较低的弱阳性聚合物或投加低剂量较高分子量的强阳性聚合物;CP用作助凝剂时,能显著减少主混凝剂用量,但宜投加强阳性聚合物或增加弱阳性聚合物的剂量.④CP兼备电性中和与吸附架桥絮凝作用,能形成粒径较大、吸附性能与过滤性能良好的网状絮体构型,其有效质量密度高,产生的污泥量少,污泥沉降速度快,脱水效果好,但分维值低.⑤各种水处理药剂的处理效果为:Al2(SO4)3(或PAC) CP＞CP＞PAC＞Al2(SO4)3,这种差别由絮体的形态学特性与构型特征各异引起.     

典型进口含铜原料熔炼烟气中重金属的释放特性

为了解我国进口含铜原料熔炼烟气中重金属的释放特性,以近年进口申报的铜精矿、铜锍、铜转炉渣和含铜污泥4种典型含铜原料为研究对象,通过高温管式炉模拟研究不同含铜物料、熔炼温度、熔剂添加比例等条件下,熔炼烟气中重金属的释放特性。结果表明,4种进口含铜原料熔炼烟气中As、Pb质量分数较高,进口铜精矿和含铜污泥熔炼烟气重金属质量分数高于进口铜锍和铜转炉渣;熔炼温度从1 000 ℃升至1 300 ℃时,铜精矿和铜锍熔炼烟气中Zn、Cu、As、Pb等重金属的质量分数随着温度的升高而增加,Mn的质量分数随温度升高变化不大;熔剂添加比例由0增至18%时,铜精矿熔炼烟气中Zn、As的质量分数分别降低了28%、44%,Mn、Cu和Pb质量分数变化不大,进口铜锍熔炼烟气中Zn质量分数减少了85.2%,As的质量分数则随熔剂添加比例的增加而增加。本研究结果可为进口含铜原料熔炼烟气中重金属减排提供参考。     

民用燃煤源中多环芳烃排放因子实测及其影响因素研究

民用燃煤是我国目前关注较多的多环芳烃(polycyclic aromatic hydrocarbons,PAHs)排放源.根据我国民用燃煤所涉及的煤种、燃烧方式和炉灶类型,利用全流稀释采样系统对5种不同成熟度的煤种,分别以散块煤和蜂窝煤形式在3种炉灶类型中燃烧产生的烟气进行了采样和分析,初步获取了我国民用燃煤烟气中PAHs排放因子(EFPAHs)的实测数据.结果表明,烟煤的EFPAHs在块煤燃烧方式下的变化范围为1.1～3.9 mg.kg-1,在蜂窝煤燃烧方式下的变化范围为2.5～21.1 mg.kg-1,无烟煤的EFPAHs在块煤与蜂窝煤燃烧方式下分别为0.2 mg.kg-1与0.6 mg.kg-1.在民用燃煤的EFPAHs的各种影响因素中,煤的地质成熟度起主导作用,不同成熟度煤种的EFPAHs差异幅度高达1～2个数量级.其次是燃烧形态(块煤/蜂窝煤),主要表现为同一种地质成熟度的煤在蜂窝煤燃烧方式下排放的PAHs比块煤高2～6倍.炉灶类型的影响最小.     

硫酸含汞问题的追踪研究

以辽宁省最大的硫酸生产企业（辽西某锌厂）为研究对象,剖析了硫酸含汞问题的来源,论述了该厂原料、中间产品、最终产品、车间内外环境汞的污染状况。并论述了使用该厂硫酸的十大企业的中间产品、最终产品的含汞状况,给出了厂内外环境受汞污染的测定结果,研究表明含汞硫酸污染问题是急待解决的重要问题。     

聚氨脂泡沫填缝剂生产工艺火灾危险性分析与对策

以聚氨脂泡沫填缝剂基本生产原理及其特点为基础,对生产原料进行火灾危险性分析,结果表明:该类生产场所的火灾危险等级应划分为甲类;提出聚氨酯泡沫填缝剂生产中存在的安全问题及原因;运用危险度评价法对聚氨脂泡沫填缝剂生产工艺的火灾危险性进行了定量的安全评价,得出聚氨脂泡沫填缝剂生产工艺的危险程度为高度危险;并从建筑设计、防火管理和生产工艺等方面提出了预防火灾事故发生的对策。     

强化混凝组合工艺处理微污染水源水研究

采用静态烧杯实验考察了强化混凝组合工艺解决某水厂出水COD_(Mn)、色度及铝含量超标的问题。结果表明,高锰酸盐与次氯酸钠联合预氧化,配合使用少量黏土、粉末活性炭混合物强化混凝,可以在氯化物不超标的情况下,使出水COD_(Mn)、色度及铝含量得到有效控制。