生物滴滤塔净化挥发性有机废气动力学模型研究

通过对生物滴滤塔净化VOCs废气过程的分析,建立了动力学模型,简化处理后得出了基于生物降解为一级反应动力学和零级反应动力学的污染物浓度沿填料层高度变化的方程,并通过实验数据对方程进行了验证,结果表明基于生物降解一级反应动力学的方程能较好地与实验数据吻合,但常数ξα/Q却随入口浓度Cgi的增大而升高。最后,采用实验数据回归出了ξα/Q随Cg变化的曲线。     

预处理后的活性污泥对锌吸附的研究

剩余活性污泥处理是当今的热点问题,从活性污泥资源化的角度出发,将活性污泥加工成为锌离子的生物吸附剂,比较了8种方法预处理后的活性污泥对锌的吸附效果,分析了这8种方法对污泥吸附能力的影响机理.对经过NaOH和H2O2处理的污泥的吸附特性和影响因素进行了研究,结果表明该吸附过程符合Psemio-seconal Order吸附动力学模型及Freunomch吸附等温模型,低pH不利于吸附,适当提高温度可以增强吸附效果,增加污泥吸附剂浓度可以增加金属离子去除率,但是单位质量吸附剂吸附金属离子的量减小.用红外光谱对比的手段对吸附机理进行了探讨,结果表明污泥颗粒表面一些含氮氧的基团对zn.'的络合作用是主要的吸附机理.该研究在污泥资源化和废水中锌离子的去除方面有重要意义.     

洗相废水中银回收技术研究

采用电解法和离子交换法回收洗相废水中的银.结果表明,电解法对高浓度含银洗相废水的银回收处理是一种行之有效的方法.对于中低浓度洗相废水中的银的回收,采用4%硫酸再生IRA-68离子交换树脂,树脂的交换能力可以增加4倍,再生时由于已交换的银被直接固定在树脂上,结果使得再生剂处置和银回收过程更加简单方便.IRA-68离子交换树脂回收中低浓度洗相废水中银的技术具有银回收效率更高、离子交换运行时间更长和操作更为简便等优点,使得传统的离子交换技术得到极大的改进和提高.     

微波消解-分光光度法测定COD的研究

通过试验研究,提出了测定COD的新方法——微波消解-分光光度法。该方法准确度、精密度符合分析要求,与国标中回流法的测定结果没有显著差异。而且采用该方法测定COD可克服回流法、微波消解-滴定法及HACH-COD测定法的操作复杂、耗时长等缺点。     

湖泊沉积物中磷化氢的释放动力学初探

采用柱状芯样模拟法,研究了太湖沉积物-水界面磷化氢的释放动力学.结果表明:当沉积物-水界面磷化氢的释放达到动态平衡时,水界面中磷化氢的浓度基本不再增大,大约在0.34 pg·l-1左右,此时磷化氢的释放通量约为0.008 pg·dm-2·h-1.根据室内模拟结果,太湖沉积物每年的磷化氢释放量在13.81-49.62 g之间,从而使磷化氢在湖水中的平均浓度达到0.16 pmol·l-1.     

Adsorption thermodynamics and kinetic investigation of aromatic amphoteric compounds onto different polymeric adsorbents

The adsorption behavior of p-aminobenzoic acid and o-aminobenzoic acid onto the different polymeric adsorbents was systematically investigated as a function of the solution concentration and temperature.Experimental results indicated that the equilibrium adsorption data of the four polymeric adsorbents fitted well in the Freundlich isotherm.The adsorption capacity of multi-functional polymeric adsorbent NJ-99 was the highest,which might be attributed to the strong hydrogen-bonding interaction between the amino groups on the resin and the carboxyl group of aminobenzoic acid.The adsorption capacity of o-aminobenzoic acid onto any adsorbent was higher than p-aminobenzoic acid.Thermodynamic studies suggested the exothermic,spontaneous physical adsorption process.Adsorption kinetics results showed that the adsorption followed the pseudo-second-order kinetics model and the intraparticle mass transfer process was the rate-controlling step.     

Thermodynamics and kinetics of cadmium adsorption onto oxidized granular activated carbon

Cadmium sorption behavior of granular activated carbon oxidized with nitric acid was systematically studied by sets of the equilibrium and time-based experiments under various conditions.The cadmium adsorption capacity of oxidized granular activated carbon enlarged with an increase in pH,and reduced with an increase in ionic strength.Experimental data were evaluated to find out kinetic characteristics.Adsorption processes were found to follow pseudo-second order rate equation.Adsorption isotherms correlate well with the Langmuir isotherm model and the maximum sorption capacity of cadmium evaluated is 51.02μmol/g.Thermodynamic parameters were calculated based on Van't Hoff equation.Equilibrium constant Kd was evaluated from Freundlich isotherm model constants,Langmnir isotherm model constants,and isotherms,respectively.The average change of standard adsorption heatΔH~0 was -25.29 kJ/mol.NegativeΔH~0 andΔG~0 values indicate the adsorption process for cadmium onto the studied activated carbon is exothermic and spontaneous.The standard entropyΔS~0 was also negative,which suggests a decrease in the freedom of the system.     

The determination and matching analysis of pinch point temperature difference in evaporator and condenser of organic rankine cycle for mixed working fluid

Exergo-economic analysis of the pinch point temperature difference (PPTD) in both evaporator and condenser of sub-critical organic Rankine cycle system (ORCs) are performed based on the first and second laws of thermodynamics. Taking mixture R13I1/R601a as a working fluid and the annual total cost per net output power Z as exergo-economic performance evaluation criterion, the effects of PPTD in evaporator ΔT_e, and the PPTD ratio of condenser to evaporator y, on the exergo-economic performance of ORCs are analyzed. Moreover, how some other parameters influence the optimal PPTD in evaporator ΔT_e,opt and the optimal PPTD ratio of condenser to evaporator y_opt are also discussed. It has been found that the exergo-economic performance of ORCs is remarkably influenced by ΔT_e and y, and there exists ΔT_e,opt and y_opt. In addition, ΔT_e,opt and y_opt are affected by heat transfer coefficient ratio of condenser to evaporator ß, the temperature of working fluid at dew point in condenser T_1a, and composition of R13I1/R601a: larger ß and T_1a lead to lower ΔT_e,opt and y_opt; by contraries, larger mass fraction of R13I1 makes ΔT_e,opt and y_opt increase, and y_opt increases linearly. The effects of the temperature of working fluid at bubble point in evaporator T_3a, mass flow rate of exhaust flue gas m_g, and inlet temperature of exhaust flue gas T_gi on ΔT_e,opt and y_opt are very slight. For comparison, three additional working fluids, namely R601a, R245fa, and 0.32R245fa/0.68R601a, are also taken into account.     

Experimental investigation of a 250-kW turbine organic Rankine cycle system for low-grade waste heat recovery

An organic Rankine cycle (ORC) is generally used for converting low-grade heat into electricity. In this study, an extensive literature survey was conducted to identify current research gaps on experimental ORC systems. Specifically, there is limited experimental data and limited details on thermal and expander efficiencies of ORC systems. In order to address these gaps, the objective of this study included developing a turbine ORC with a power output exceeding 50 kW and thermal efficiency exceeding 8% for a heat source temperature < 120°C. The experimental results indicated that the system achieved a net power output of 242.5 kW and a thermal efficiency of 8.3% (the highest value for a turbine ORC system for the heat source temperature below 120°C). Thus, the study addressed the gaps identified in the research area of ORCs.     

Adsorption studies on coir pith for heavy metal removal

Biosorption efficiency of coir pith, a waste product from coir industry, was investigated in this study for the removal of metallic pollutants such as Ni, Cu and Zn from aqueous solutions. The disposal of coir pith is a major problem associated with the coir industries, especially working in the small-scale sector. The present study explores the effectiveness of utilization of coir pith, an accumulating waste, as a biosorbent for heavy metal removal. Batch mode studies were done to evaluate the efficiency of removal of metals under varying adsorption conditions of pH, metal concentration and contact time. Characterization studies of the biosorbent and SEM analysis were done. Kinetic modelling studies were tried using Lagergren pseudo-first-order and second-order models. Equilibrium studies were done using well-known Freundlich, Langmuir and D–R isotherm models. It was found that all isotherms are fitting well indicating the efficiency of coir pith as an adsorbent of heavy metals. The applicability of all the three isotherms to the sorption processes shows that both monolayer adsorption and heterogeneous energetic distribution of active sites on the surface of the adsorbent are possible. Due to the abundance and low cost of these materials, adsorption technologies developed can act as good sustainable options for the future in heavy metal removal from industrial effluents.