模拟黑水的生物处理

针对以糖蜜配制的半人工黑水生物处理时除磷效率下降和污泥膨胀的现象,利用序批式反应器(SBR)进行了实验分析,比较了以蔗糖和糖蜜为主要碳源时除磷效果的差异,并探讨了污泥膨胀发生的原因。研究表明,以糖蜜为主要碳源配制模拟黑水时的除磷效果比蔗糖为碳源时差,主要是由于GAOs的竞争性代谢所致。以糖蜜为碳源的条件下,污泥的胞外聚合物含量是正常活性污泥的一倍以上,导致污泥沉降性能变差;糖蜜碳源时的夏季高温条件下丝状菌大量生长也是导致污泥膨胀的重要原因。     

Novel Organisms: Comparing Invasive Species, GMOs, and Emerging Pathogens

Invasive species, range-expanding species, genetically modified organisms (GMOs), synthetic organisms, and emerging pathogens increasingly affect the human environment. We propose a framework that allows comparison of consecutive stages that such novel organisms go through. The framework provides a common terminology for novel organisms, facilitating knowledge exchange among researchers, managers, and policy makers that work on, or have to make effective decisions about, novel organisms. The framework also indicates that knowledge about the causes and consequences of stage transitions for the better studied novel organisms, such as invasive species, can be transferred to more poorly studied ones, such as GMOs and emerging pathogens. Finally, the framework advances understanding of how climate change can affect the establishment, spread, and impacts of novel organisms, and how biodiversity affects, and is affected by, novel organisms.     

超声前处理强化活性炭吸附活性艳红X-3B染料废水

探究了超声前处理活性艳红X-3B染料废水强化活性炭吸附降解性能及不同超声参数的影响规律,包括超声功率和超声时间。研究结果表明,超声前处理活性艳红X-3B染料废水可通过空化效应使有机大分子裂解为小分子易于被活性炭吸附,同时可强化其到活性炭微孔中传输,提高了活性炭吸附降解性能,最佳超声功率为320 W。浓度越高,所需超声时间越长,当超声达到一定时间后,继续超声不会影响染料分子的吸附。超声前处理虽然不会改变吸附平衡时间,但可有效增加活性炭处理活性艳红X-3B染料废水的饱和吸附量。     

物化-生物组合工艺处理TNT红水

采用酸析+微电解+混凝沉淀+减压蒸馏+固定化微生物滤池+活性焦吸附组合工艺处理兵器八○五厂(襄樊分部)的TNT红水,出水中的硝基化合物浓度多小于0.8 mg/L,且多次未检出;COD最高值为76 mg/L,平均值为51.6 mg/L;色度为20°;苯胺浓度全部小于1 mg/L,达到了中试方案提出的要求,出水水质指标符合《兵器工业水污染物排放标准火炸药》(GB14470.1-2002)的要求.中试期间设备没有发生堵塞、燃烧等事故,减压蒸馏装置正常稳定运行,证实了减压蒸馏法处理TNT红水的安全可靠性.     

紫外辐照-催化湿式过氧化氢氧化技术处理酸性大红GR染料废水

采用自制的负载型CuO-ZnO-CeO2/γ-Al2O3催化剂,常温常压下通过紫外辐照-催化湿式氧化技术处理酸性大红GR模拟染料废水。考察了催化剂加入量、H2O2加入量、废水pH、反应时间、初始酸性大红GR质量浓度等对废水脱色率的影响。实验得到最佳工艺条件为初始酸性大红GR质量浓度200mg/L,催化剂加入量10.0g/L,H2O2加入量2.0mL/L,废水pH4,反应时间2h。最佳工艺条件下废水脱色率达99.33%。     

Effects of C60 nanoparticle exposure on earthworms (Lumbricus rubellus) and implications for population dynamics

Effects of C₆₀ nanoparticles (nominal concentrations 0, 15.4 and 154 mg/kg soil) on mortality, growth and reproduction of Lumbricus rubellus earthworms were assessed. C₆₀ exposure had a significant effect on cocoon production, juvenile growth rate and mortality. These endpoints were used to model effects on the population level. This demonstrated reduced population growth rate with increasing C₆₀ concentrations. Furthermore, a shift in stage structure was shown for C₆₀ exposed populations, i.e. a larger proportion of juveniles. This result implies that the lower juvenile growth rate due to exposure to C₆₀ resulted in a larger proportion of juveniles, despite increased mortality among juveniles. Overall, this study indicates that C₆₀ exposure may seriously affect earthworm populations. Furthermore, it was demonstrated that juveniles were more sensitive to C₆₀ exposure than adults.     

赤泥协同Fenton法处理焦化废水的研究

采用赤泥吸附协同Fenton法处理焦化废水,两者协同处理对COD的去除率高于其单独处理之和.考察了赤泥投加量、初始pH值、反应温度、H2O2浓度和Fe2+浓度等因素对降解效果的影响,实验结果表明,在20 g/L的赤泥、初始pH=3、80 mmol/L的H2O2、224 mg/L的Fe2+的最佳条件下,经过120 min...     

拜耳法赤泥粒径分级预处理的研究

赤泥是从铝土矿中提取氧化铝的过程中产生的工业废渣.分析了拜耳法赤泥的粒径分布,以及主要化学组成和矿物组成在不同粒径赤泥中的变化规律.在此基础上,提出先将赤泥粒径分级预处理,然后根据粗细粒径赤泥的差异分别进行回收利用的思路.研究结果表明,赤泥中粒径大于0.075 mm的粗颗粒以铁、硅、钙为主,实践证明可以通过磁选或重选工...     

高压脉冲放电等离子体处理活性红X-3B染料废水

采用高压脉冲放电等离子体技术对活性红X-3B染料废水进行处理,考察了废水电导率、脉冲电压、脉冲频率、针板间距以及曝气量对处理效果的影响。实验结果表明,当废水电导率为200μS/cm、脉冲电压为34kV、脉冲频率为60Hz、针板间距为15mm、曝气量为12L/h、处理时间为60m in时,活性红X-3B染料废水脱色率能达到98.6%。     

赤泥制备含钛聚硅酸铝铁及亚甲基蓝溶液的混凝脱色

以拜耳法赤泥为原料、Na Cl为助溶剂,采用酸浸法溶出赤泥中的铁、铝元素,再与硅酸钠、硫酸氧钛反应制备出高效混凝剂含钛聚硅酸铝铁(T-PSAF),并将其用于模拟亚甲基蓝印染废水的脱色。实验结果表明:在硫酸浓度为8 mol/L、液固比(硫酸体积与干赤泥质量之比)为14 m L/g、酸浸温度为80℃、酸浸时间为80 min、Na Cl加入量为0.10 g/g(以干赤泥计)的优化酸浸条件下,铁、铝的浸出率分别为88.25%和73.21%;在n(Fe+Al)∶n(Ti)∶n(Si)=0.3∶0.3∶1、熟化p H为4~5、熟化时间为2 h、混凝剂加入量为25 m L/L的优化混凝条件下,初始亚甲基蓝质量浓度为10 mg/L的废水的脱色率可达87.1%,而当初始亚甲基蓝质量浓度增至150~200 mg/L时废水脱色率可达99%以上。