Risk Assessment of 26 Polycyclic Aromatic Hydrocarbon (PAH) Compounds in Parkıng Garages

The aim of this study was to determine the level of 26 polycyclic aromatic hydrocarbons (PAHs) at parking garages and to provide the necessary annual information based on occupational inhalation exposure and non-occupational inhalation exposure, which carry risks for the environment. For this purpose, 22 samples were collected continuously from both gas and particulates phase PAHs from two parking garages at Konya City Center, Turkey. The exposure-based risk of these samples was evaluated using concentrations of the carcinogenic PAH compounds. None of the 26 PAHs measured had values exceeding the recommended exposure limits (RELs) standard values for inhalation rate recommended by the World Health Organization (WHO). Exposure levels of gas and particulate PAHs for the occupational group and the public (children and adults who spend time in shopping centers) were found to be 0.07–28.24 μgm^?3 and 0.05–5.753 μgm^?3, respectively, representing levels two to four times higher than those at the control site. Maximum daily inhalation of B[a]Py was estimated at 1.33 ngd^?1 for exposure of the public and as 274 ngd^?1 for the occupational group. It is believed that traffic makes a substantial contribution to the PAH profile, which had relatively high concentrations of naphthalene (Napth) and coronene (Coro). Highly carcinogenic dibenzo(a,l)pyrene (B[al]Pyre) was found in the ambient air at two parking garages. Napth and phenanthrene (Phen) were the main compounds found in nearly all the tested samples. In this study, benzo[e]pyrene (B[e]Py) was used as a reference for PAHs because its concentration is stable and does not change seasonally. Considering the importance of these compounds in relation to human health, the aim of this work was to characterize and quantify the more toxic PAHs in parking garages. Conducting PAH sampling and their chemical analysis is very costly and labor intensive. This study produced data that can be a powerful tool for environmental forensics.     

腐殖酸修饰凹凸棒对U(Ⅵ)的吸附性能及机理

采用腐殖酸(HA)修饰凹凸棒(ATP)制备得到腐殖酸/凹凸棒(HA/ATP),用于去除废水中的U(Ⅵ).通过静态吸附实验,研究了溶液初始pH、投加量、吸附时间和初始浓度对吸附的影响,并用扫描电镜(SEM),X射线能谱图(EDS),傅里叶红外光谱仪(FITR)分析吸附机理.实验结果表明,去除率随时间的增大而增大,在120 min内可以达到平衡;吸附剂投加量越大,溶液pH =6左右时越有利于U(Ⅵ)的去除;HA/ATP能多次重复使用,且经过5次吸附解吸后对U(Ⅵ)的去除率仍能达到96％.吸附过程均符合Langmuir和Frendlich等温方程.较之准一级动力学,准二级动力学模型能更好地拟合实验数据.SEM-EDS、FITR分析结果表明,U(Ⅵ)被成功地吸附到了HA/ATP的表面,吸附机理为络合作用.     

微生物絮凝剂M-C11处理高岭土悬浊液的响应曲面优化

采用响应曲面法对微生物絮凝剂M-C11处理高岭土悬浊液的过程参数进行优化,选取中心复合实验设计(CCD),以p H、M-C11投加量和Ca Cl2投加量等因素为自变量,以处理后的高岭土悬浊液絮凝率(Fr)为响应值,并借助扫描电镜对絮凝剂的作用机理进行初步探讨。结果表明,微生物絮凝剂M-C11可显著改善高岭土悬浊液的絮凝性能,且选取的3种单因素水平均可影响絮凝剂活性。经多元回归拟合分析,在M-C11投加量为2.56 m L,Ca Cl2投加量为0.37 g/L的最优条件下,微生物絮凝活性实验值可达92.37%,接近模型预测值(92.30%)。Ca Cl2投加量对絮凝效果的影响高于M-C11投加量(PCa Cl2相似文献   

中型污水处理厂中药物和个人护理品的分布与去除

为了解15种药物及个人护理用品(PPCPs)在中小型污水处理厂中的分布及其去除效果,采用液相色谱-串联质谱(LC-MS/MS)技术对3座A2/O工艺的污水处理厂水样进行分析研究。结果显示,除普萘洛尔、吉非罗平和吲哚美辛在3座中小型污水处理厂各个工艺单元中均未被检出外,其余12种目标化合物的检出频率在90%~100%之间。进水水样中PPCPs的平均检出浓度为2 285.4 ng/L,其中咖啡因(CF)的平均检出浓度最高为973.3 ng/L,酮洛芬(KP)的平均检出浓度次之为844.7 ng/L,两者之和占进水水样中PPCPs平均含量的79.5%,表明污水处理厂的主要污染物为CF和KP。3座污水处理厂对CF的去除效果最为显著,平均去除率为95.3%,对15种PPCPs总去除效率在39.3%~82.8%之间。     

巢湖低温高效聚磷菌的筛选及其特性

采用低温富集培养及混合平板分离技术,从巢湖底泥中分离筛选得到2株在低温下仍具有较高效能的菌株D3、D6,经过厌氧/好氧交替培养,2种菌株在低温下(8℃)的除磷率均达到80%以上。在低温下,研究了p H、微量元素对2株菌株生长及除磷率的影响,实验结果表明,2株菌都具有广泛的温度适应性,适宜其生长和除磷的p H为中性偏碱,微量元素的缺乏对2株菌株的生长和除磷效果有不同程度的不良影响。染色观察显示,厌氧培养时菌体内聚羟基丁酸(PHB)颗粒明显增多,转为好氧培养后异染颗粒增多,为典型的聚磷菌特征。经鉴定,2株菌均属假单胞菌属。     

活性炭涂层电极电容去离子的性能

采用活性炭涂层电极构建电容去离子吸附装置,以氯化钠模拟含盐原水,研究电压、流量、进水浓度等操作参数对活性炭涂层电极脱盐效率和能耗的影响。实验结果表明,去除率和比吸附量随着电压的增大而增加,且比能耗随之增大。流速越小,出水的浓度越低,当对出水的浓度要求较高时,宜采用小流速。当进水浓度低于活性炭涂层电极的饱和吸附量时,比吸附量随着进水浓度呈线性增加;当达到饱和吸附量时,比吸附量不会随进水浓度的增大而发生改变;比能耗随着进水浓度的增加而降低。     

磷酸铵镁碱促(Mg(OH)_2)热解产物氨氮去除性能

磷酸铵镁热解循环技术可以有效降低磷酸铵镁结晶技术的药剂费用。同时,在磷酸铵镁热解过程中添加Mg(OH)2碱促媒介,能阻止磷酸氢镁向焦磷酸镁的转化,并降低热解产物氨氮去除过程中上清液磷酸盐的残留。在Mg(OH)2∶NH+4摩尔比为1∶1,热解温度为110℃条件下,热解产物沉氨效率接近84%,上清液磷酸盐残留量为0.02 mg/L。     

苯并三唑在土壤中的吸附特性

为了解苯并三唑(BTA)在水-土系统中的迁移转化,通过批实验方法研究了BTA在华北平原土样(GSS13)中的吸附,考察了平衡时间、土壤投加量、溶液初始p H以及共存阳离子对吸附的影响。结果表明,在初始阶段,土壤对BTA的吸附速率较快,之后随着吸附点位的减少,吸附逐渐变慢;吸附过程符合准二级反应动力学方程。土壤对BTA的平衡吸附为非线性吸附,吸附等温线为Freundlich型;随着土壤投加量的增大,单位质量土壤吸附BTA的量减少,可能原因是所选土壤对BTA的吸附存在"固体浓度效应"。溶液的p H通过改变BTA的存在形式和土壤表面的带电性而影响吸附,当溶液p H在BTA的p Ka2(8.6)附近时,土壤对BTA的吸附效果最好。此外,溶液中共存阳离子对土壤吸附BTA有不同的影响,Na+对吸附影响不明显,而不同浓度Ca2+对BTA的吸附有不同程度的促进作用。     

硫酸盐还原菌污泥固定化特性

采用玉米芯为碳源,聚乙烯醇(PVA)为包埋载体,饱和硼酸(H3BO3)为交联剂,研究了硫酸盐还原菌污泥(SRBS)、铁屑、麦饭石共固处理合成煤矿酸性废水的最优配比与机理,并分析了固定化过程中小球稳定性及活性的变化规律。实验结果表明,SRBS投加量是影响处理效果的最显著因子,当投加30%SRBS、2%铁屑、3%麦饭石时SO2-4、Mn2+去除率分别为94.13%和84.39%,溶液p H为7.03,未检测出Fe2+;随着交联时间的延长,小球膨胀率及SO2-4还原率分别呈线性与指数下降,从保持小球稳定性与活性角度考虑,可将交联时间设定为4~8 h;该法可为市政污泥的处置以及生物法处理煤矿酸性废水的工程应用提供技术参考。     

密相塔半干法烟气脱硫塔内加湿降温及其对脱硫效率的影响

为了实现密相塔半干法脱硫工艺的精确加湿进一步提高系统脱硫效率,利用推导出的传热传质计算方法,得到烟气温度降低和加水量的关系.结合3组密相塔半干法工程实际数据,发现理论计算值和实测值误差区间仅为2.9％ ～5.4％.通过选取河北某钢厂210 m2烧结烟气密相塔半干法脱硫项目实际在线检测数据,发现循环脱硫灰含湿量为3％的系统脱硫效率整体高于含湿量为5％和4％的样品,最大值达93.56％.通过粒度分析、扫描电镜、X射线衍射及差热-热重对2种不同含湿量的循环脱硫灰进行表征,结果表明,含湿量为3％的循环脱硫灰较含湿量为5％的样品粒径小、比表面积大,无团聚现象,物相分析还证实相对于含湿量为5％样品,其Ca(OH)2和结晶水含量少,几乎都是CaSO4和CaS03干态物质,因此脱硫反应进行彻底,脱硫效率较高.