Preparation of rare-earth metal complex oxide catalysts for catalytic wet air oxidation

Catalytic wet air oxidation (CWAO) is one of the most promising technologies for pollution abatement. Developing catalysts with high activity and stability is crucial for the application of the CWAO process. The Mn/Ce complex oxide catalysts for CWAO of high concentration phenol-containing wastewater were prepared by coprecipitation. The catalyst preparation conditions were optimized by using an orthogonal layout method and single-factor experimental analysis. The Mn/Ce serial catalysts were characterized by Brunauer-Emmett-Teller (BET) analysis and the metal cation leaching was measured by inductively coupled plasma torch-atomic emission spectrometry (ICP-AES). The results show that the catalysts have high catalytic activities even at a low temperature (80°C) and low oxygen partial pressure (0.5 MPa) in a batch reactor. The metallic ion leaching is comparatively low (Mn<6.577 mg/L and Ce<0.6910 mg/L, respectively) in the CWAO process. The phenol, COD_Cr, and TOC removal efficiencies in the solution exceed 98.5% using the optimal catalyst (named CSP). The new catalyst would have a promising application in CWAO treatment of high concentration organic wastewater. Translated from Techniques and Equipment for Environmental Pollution Control, 2005, 6(2): 40–44 [译自: 环境污染治理技术与设备]     

中国对流层二氧化硫光化学氧化过程的数值研究

利用一个三维非静力区域大气化学输送模式与中尺度气象模式MM5相连接构成一个数值模拟系统，模拟了中国地区对流层臭氧与其前体物的分布以及二氧化硫转化为硫酸盐的过程，模式扬地面源排放、大气输送和扩散、干沉积、气相化学反应和云雨过程。结果表明：日间，O3浓度主要由NOx和NMHC的源排放和光化学反应过程支配，大气辐射是光化学反应强弱的决定因子，其强度可使SO2、O3和SO4^2-的生成浓度呈现不同的日变化和季节变化，结果表明高浓度的O3对二氧化硫转化为硫酸盐的化学过程有很大的促进作用，然而，这种作用受NMHC浓度的影响很大，较高浓度的NMHC使O3浓度上升，但同时增加了对OH等自由基的消耗，使SO2的转化率降低。     

LPWCO method for the treatment of high concentrated organic wastewater

Based on wet air oxidation (WAO) and Fenton reagent, thispaper raises a new low pressure wet catalytic oxidation(LPWCO)which requires low pressure for the treatment of highlyconcentrated and refractory organic wastewater. Compared withgeneral wet air oxidation, the pressure of the treatment(0.1-0.6MPa) is only one of tens to percentage of latter(3.5-10MPa). Inaddition, its temperature is no more than 180℃.Compared withFenton reagent, while H2O2/COD(weight ratio) less than 1.2, theremoval of COD in the treatment is over twenty percents more thanFenton's even the value of COD is more than 14000mg/L. In thispaper, we study the effect factor of COD removal and the mechanismof this treatment. The existence of synergistic effect (catalytic oxidation and carbonization) for COD removal in H2SO4-Fenton reagent system under the condition of applied pressure and heating (0.1-0.6MPa, 104-165℃) was verified. The best condition of this disposal are as follows:H2O2/COD(weight ratio)=0.2-1.0, Fe2+ 0.6×10-3 mol, H2SO4 0.5mol, COD>1×104mg/L, the operating pressure is 0.1-0.6MPa and temperature is 104-165℃. This method suit to dispose the high-concentrated refractory wastewater, especially to the wastewater containing H2SO produced in the manufacture of pesticide, dyestuff and petrochemical works.     

含酚废水治理方法的研究

根据含酚废水的性质，用ClO2氧化除酚，ZL—1和聚丙烯酰胺(PAM)混凝沉降除悬浮物的方法处理该废水。实验结果表明，经处理后废水中的主要污染物酚、焦油和悬浮物等去除率都很高，该水可以满足循环使用的要求。     

微电解-水解酸化/接触氧化工艺处理染化废水的研究

采用微电 解 Ｈ／ Ｏ 工艺对染 料化 工 废水 进行 了 处理 研究 ，结 果表 明 以微 电解 和 水解 酸 化作预处理 ，可使废 水的 Ｂ Ｏ Ｄ５／ Ｃ Ｏ Ｄ Ｃｒ 的比由 ０２５ 提高 到０５ ０ 左 右，平 均 增加 ５０ ％ 。通 过加 酸， 可提高微电 解的去除 效果，在 进水 Ｃ Ｏ Ｄ Ｃｒ 为４ １００ ～４ ３００ ｍ ｇ／ Ｌ，色度 为３ ４００ ～３ ６００（ 倍） 范围内 ，系统对 Ｃ Ｏ Ｄ Ｃｒ 和色度 的去除效 果分别 可达到９７ ５ ％ 和９８３ ％     

两段接触氧化法处理生活污水的工程实例

本污水厂设计规模 70 0 0m3 d ,进水CODCr3 0 0mg L ,BOD515 0mg L ,SS 2 0 0mg L ,采用两段接触氧化法处理工艺 ,运行结果表明 ,出水水质达到GB8978 1996污水综合排放标准中的二级标准     

利用脉冲澄清池补充处理生化后废水的运行结果和分析

通过对脉冲澄清池在综合废水处理中运行效果的跟踪分析,确定出利用脉冲澄清池补充处理生化后废水(悬浮物、COD_(cr)、BOD_5等)的影响程度,为其在综合废水处理工艺中的应用及其局限性,提供了必要的参考依据.     

铁法煤业集团三台子污水处理厂的工艺改造

介绍了将铁法煤业（集团）有限责任公司三台子矿区污水处理工程工艺由以卡鲁塞尔氧化沟为主体的二级生化处理工艺改造为更适宜在北方气候条件下运行的A-O法工艺；同时对系统的启动进行了介绍。     

中水回用工程投建与运行实践

沈阳理工大学学生城中水设施的建设，不仅提高了水资源的重复利用率，创造良好的环境效益和经济效益，同时也为中水回用工作的推广实施积累了经验。尤其是采用比较简单的污水处理工艺达到中水回用的标准，其中最主要的部分是沉淀和生物接触氧化以及最后的过滤和消毒，这样的工艺比较适合中等规模的投资，从回用水的经济效益上看这样的中水回用系统还是比较适合推广。     

车用催化转化器及其对发动机性能影响的研究

本文论述了影响催化转化器性能的主要因素有催化剂，催化剂的中毒失效，催化转化器的结构和排气系统的影响，温度、发动机工作状况等；强调催化转化器的结构与发动机及排气系统匹配的重要性。