植物叶表尘及重金属对城市大气颗粒物污染的指示与评估

城市大气颗粒物污染问题日渐突出,目前主要依靠大气站点的直接观测数据反映污染的即时状况,而植物叶表尘及重金属的监测为评价大气颗粒物阶段性污染状况提供了新的途径.本研究通过分析北京交通带和公园共7个样点的臭椿(Ailanthus altissima)、槐(Sophora japonica)、北京杨(Populus beijingensis)、榆树(Ulmus pumila)、紫叶李(Prunus cerasifera f.atropurpurea)等5种常见绿化树种的叶表尘及重金属Cd、Cr、Cu、Mn、Ni、Pb、Zn含量,并计算尘金属综合累积指数(MAI),进而与邻近站点大气颗粒物观测数据对比并进行统计分析,尝试量化评价植物所处环境的大气颗粒物及尘重金属综合污染状况.结果表明:采用榆树叶表尘可量化评价大气可吸入颗粒物PM10的月均质量浓度,相对误差为1.2%~10.6%;臭椿叶表尘可量化评价大气细颗粒物PM2.5的月均质量浓度和月均空气质量指数(AQI),相对误差分别为0.18%~3.7%和0.26%~5.7%.MAI值可指示大气尘重金属综合污染状况,本研究中京承高速和朝阳公园大气尘重金属综合污染较重,其次为念坛公园、望京公园和玉蜓桥,最轻为岳各庄桥和麋鹿苑.     

混合重金属对硝化颗粒污泥毒性作用的析因实验研究

分别测定了Cu2 、Zn2 和Cd2 对硝化颗粒污泥的单一毒性,采用析因实验研究了二元和三元重金属混合体系对硝化颗粒污泥的联合毒性.结果表明,Cu2 、Zn2 和Cd2 的2 h半抑制浓度EC50分别为95.23、62.11和12.48 mg/L,由析因实验所得的响应曲面模型具有较好的优度(其R2＞0.95),能够对混合体系的联合毒性很好地进行预测,析因实验可以用于环境领域混合体系联合毒性的研究.     

Heavy metal adsorption on the Le An River sediment —The adsorption model

In this study,the surface properties and adsorption properties of the Le An River sediment were modelled via surface complexation approach.The model parameters were determined based on the data of our potentiometric titration experiments and the metal adsorption experiments with the Le An River sediment samples.Consequently,the surface complexation models for the natural sediment,in our case the Le An River sediments,which can interpret the experimental data very well were successfully established.Three typical surface complexation models that is the constant capacitance model,the diffuse layer model and the triple layer model,were considered in this research.This work indicated that the consistency and the interdependency among model parameters together with the selection of the surface adsorbed species should be emphasized.     

疫情下医疗废物的处置现状分析

2019年新冠疫情席卷全球,在疫情环境下,医疗废物大幅增多,全国各大城市纷纷出现医疗废物处置不当的现象。本文对国内外现状分析,在认知、设施、管理和监督四个方面发现存在一定的问题,通过加强教育、加大储备、完善机制和改善监管的建议,为提升医疗废物应急处置能力提供参考。     

Bottom up and top down: analysis of participatory processes for sustainability indicator identification as a pathway to community empowerment and sustainable environmental management

The modern environmental management literature stresses the need for community involvement to identify indicators to monitor progress towards sustainable development and environmental management goals. The purpose of this paper is to assess the impact of participatory processes on sustainability indicator identification and environmental management in three disparate case studies. The first is a process of developing partnerships between First Nations communities, environmental groups, and forestry companies to resolve conflicts over forest management in Western Canada. The second describes a situation in Botswana where local pastoral communities worked with development researchers to reduce desertification. The third case study details an on-going government led process of developing sustainability indicators in Guernsey, UK, that was designed to monitor the environmental, social, and economic impacts of changes in the economy. The comparative assessment between case studies allows us to draw three primary conclusions. (1) The identification and collection of sustainability indicators not only provide valuable databases for making management decisions, but the process of engaging people to select indicators also provides an opportunity for community empowerment that conventional development approaches have failed to provide. (2) Multi-stakeholder processes must formally feed into decision-making forums or they risk being viewed as irrelevant by policy-makers and stakeholders. (3) Since ecological boundaries rarely meet up with political jurisdictions, it is necessary to be flexible when choosing the scale at which monitoring and decision-making occurs. This requires an awareness of major environmental pathways that run through landscapes to understand how seemingly remote areas may be connected in ways that are not immediately apparent.     

氮掺杂氧化钛的简易制备及可见光催化活性的研究

为开发对可见光响应的催化剂,以尿素为氮掺杂剂,采用简易溶胶-凝胶法制备氮掺杂氧化钛,并以2,4-DCP的降解检验其光催化活性。XRD、BET、XPS和UV-Vis漫反射光谱分析表明,随着氮/钛原子比（N/Ti)的增大,各催化剂晶粒尺寸减小,比表面积增大,锐钛矿相向金红石相的转变得到抑制,除0#样品出现金红石相外,其他催化剂均只出现锐钛矿相;掺入催化剂的N位于晶格O位点和晶格间隙,替代N和间隙N掺杂使催化剂的光吸收发生明显的红移。荧光光谱分析表明,当N/Ti在0～6范围内增加时,反应体系中·OH自由基的产生速率增加,当N/Ti增大至8时,速率则下降。相似的规律也表现在氮掺杂量对光催化活性的影响。适量氮掺杂能增强氧化钛的可见光催化活性,该改性催化剂可用于有机污染物的太阳光激催化降解。     

基于正交试验响应面法的烟气层概率分布计算

为计算随机参数下火灾烟气层温度和厚度的概率分布,该文提出了基于正交试验响应面的可靠度计算方法。通过正交试验表确定分析计算参数组,并借助火灾动力学分析软件计算不同参数组下烟气层的温度和厚度响应,进一步拟合出输入参数和输出参数的响应面函数,在此基础上结合验算点法计算烟气层温度和厚度的概率分布,算例分析表明该方法具有计算精度高、计算量小的特点。     

Collaborative emergency management: better community organising, better public preparedness and response

Community coordination requires communication and planning of precautions to take when faced with a severe threat of disaster. The unique case of the four Florida hurricanes of 2004--Charley, Frances, Ivan, and Jeanne--is used here to assess community responses to repeated threats of hurricanes. The paper examines how effectiveness in coordinating community disaster response efforts affects future public preparedness. The findings suggest that pre-season planning, open communication between emergency managers and elected officials, and the use of technology all had a significant impact on community responses. The repeated threat scenario indicates that emergency managers must work vigilantly to keep residents informed of the seriousness of a situation. The study describes how emergency managers in Florida countered public complacency during four hurricanes in six weeks. The strategies identified as useful by public managers in the context of hurricanes are applicable to other natural and man-made disasters.     

一种基于预测法的电磁兼容设计方法

文章以数模混合电路设计实践为基础,介绍了一种基于预测法的电磁兼容设计方法。先以电磁兼容测试理论为基础介绍数模混合电路设计中的电磁兼容方法,在以此方法建立电磁兼容设计模型,并通数模混合电路实践来检验和改进设计模型。     

The use of nanovermiculite catalyst in the study of removal of the organic load and degradation of atrazine via ozone process in RPB reactor

Abstract

The main objective of this study is the degradation of a synthetic solution of atrazine by a modified vermiculite catalyzed ozonation, in a rotating packed bed (RPB) reactor. A 0.5?L RPB reactor was used to perform the experiments, using a Central Composite Design (CCD) response surface to construct the quadratic model based on the factors: pH, catalyst concentration and reactor rotation frequency. The response variable was the removal of the organic load measured in terms of Chemical Oxygen Demand (COD). After the complete quadratic model was constructed through the response surface, the COD degradation process had an optimal removal of 41% under the following conditions: pH 8.0, rotation of 1150?rpm and catalyst concentration 0.66?g L^?1.