An approach to optimise nutrient management in environmental sanitation systems despite limited data

The material flow analysis method can be used to assess the impact of environmental sanitation systems on resource consumption and environmental pollution. However, given the limited access to reliable data, application of this data-intensive method in developing countries may be difficult. This paper presents an approach allowing to develop material flow models despite limited data availability. Application of an iterative procedure is of key importance: model parameter values should first be assessed on the basis of a literature review and by eliciting expert judgement. If model outputs are not plausible, sensitive input parameters should be reassessed more accurately. Moreover, model parameters can be expressed as probability distributions and variable uncertainty estimated by using Monte Carlo simulation. The impact of environmental sanitation systems on the phosphorus load discharged into surface water in Hanoi, Vietnam, is simulated by applying the proposed approach.     

Dairy washwater treatment using a horizontal flow biofilm system

In Ireland, dairy farmyard washwater commonly comprises farmyard run-off and dairy parlour washings. Land-spreading is the most widely used method for treating this wastewater. However, this method can be labour intensive and can cause, in some cases, the degradation of surface and ground waters, mainly due to nitrogen contamination. In this study, a horizontal flow biofilm reactor (HFBR) with step-feed was constructed and tested in the laboratory, to remove organic carbon and nitrogen from a agricultural strength synthetic washwater (SWW). The HFBR had an average top plan surface area (TPSA) of 0.1002 m(2) and consisted of a stack of 45 polystyrene horizontal sheets--15 sheets embedded with 25 mm deep frustums above 30 sheets with 10 mm deep frustums. The frustums acted as miniature reservoirs. The sheets were alternately offset to allow the wastewater to flow horizontally along each sheet and vertically from sheet to sheet down through the reactor. Biofilms developed on the sheets and treated the wastewater. During the 212-d study, the total hydraulic loading rate based on the TPSA of the sheets was 35 l m(-2) d(-1). SWW was pumped for 10 min each hour, in a step feed arrangement at a rate of 23.33 l m(-2) d(-1) on to the top sheet during Phases 1 and 2, and 11.67 l m(-2) d(-1) onto Sheet 16 during Phase 1 (days 1-92) and onto Sheet 30 during Phase 2 (days 93-212). The substrate loading rate during Phases 1 and 2 was 94.8 g total chemical oxygen demand (COD) m(-2) d(-1) and 10.5 g total nitrogen (TN) m(-2) d(-1), based on the TPSA. At steady state in Phase 2, the unit achieved excellent carbon removal of 99.7% 5-day biochemical oxygen demand (BOD(5)) and 96.7% total COD, equivalent to TPSA removal rates of 67.5 g BOD(5)m(-2)d(-1) and 91.7 g COD m(-2) d(-1). The nitrogen removal percentages were 98.3% total ammonium-nitrogen (NH(4)-N(t)) and 72.8% TN, which equated to TPSA removal rates of 4.8 g NH(4)-N(t) m(-2) d(-1) and 7.6g TN m(-2) d(-1). No sloughing of solids or clogging of media occurred during the study. The unit was simple to construct and operate, with little maintenance.     

Measuring bed shear stress along vegetated river beds using FST-hemispheres

The measurement of the bed shear stress along vegetated river beds is essential for accurately predicting the water level, velocity and solute and sediment transport fluxes in computational hydroenvironmental models. Details are given herein of an experimental and theoretical study to determine the bed boundary shear stress along vegetated river beds introducing a novel field measuring method, namely the FliessWasserStammtisch (FST)-hemispheres. Although investigations have been conducted previously for sedimentary channels using the FST-hemispheres, this preliminary study is thought to be the first time that such hemispheres have been used to investigate the bed shear stresses in vegetated channels. FST-hemispheres were first developed by Statzner and Müller [1989. Standard hemispheres as indicators of flow characteristics in lotic benthos research. Freshwater Biology 21, 445-459] to act as an integrated indicator of the gross hydrodynamic stresses present near the bed. Test and validation data were found to be at least of the same order of magnitude for the stresses predicted from literature for sedimentary channels, with this study establishing the commencement of a database of calibrated FST-hemisphere laboratory data for vegetated channel beds. In a series of experiments, depths ranging from 0.1 to 0.28m were considered, equating directly to comparable conditions in small rivers or streams. The results of this study provide a basis for enabling the FST-hemispheres to be used to evaluate the boundary shear stress for a wider range of applications in the future, including vegetated river beds.     

Effects of Flow Augmentations in the Snake River Basin on Farms Profitability1

Abstract: For over 10 years, several species of salmon have been identified as either threatened or endangered in the Snake River Basin of Idaho. The United States Bureau of Reclamation, in cooperation with the National Marine Fisheries Service, has proposed a variety of plans to increase stream flows in the Snake River Basin to facilitate movement by juvenile salmon smolts to the ocean. This research examines two of the flow augmentation plans proposed by the Bureau of Reclamation as well as two alternative plans, one founded purely on existing priority‐based water rights and another geared toward minimizing the effects of flow augmentations on farms profitability. Results from a basin‐wide model of agricultural production in the Snake River Basin, the Snake River Agricultural Model, present evidence that (1) older water rights are used towards production of less valuable crops, (2) flow augmentation scenarios have unequal effects on farms profitability across agricultural regions within the basin, and (3) irrigation water is valued from US$4 to US$59 an acre‐foot.     

Characterizing Storm Hydrograph Rise and Fall Dynamics With Stream Stage Data1

Abstract: Storm‐flow transients (i.e., hydrograph rise and fall dynamics) may represent an important aspect of understanding streamflow dynamics. However, little is known about how temporal resolution of transient data and climate variability may color these potential indicators of hydrologic pattern or condition. Warm‐season stream stage and rainfall were monitored continuously (5 min) during the 2002 water year in eight tributaries of the Little Miami River (Ohio), which drain 17‐58 km² catchments. Rise rates generated using 5‐min data were different than those generated with mean daily data [calculated with the Indicators of Hydrologic Alteration (IHA) software], though fall rates were similar for fine and coarse temporal data. This result suggests that data with low temporal resolution may not be adequate to fully represent the dynamics of storm rise rates. Conversely, fall rates based on daily stage data (via IHA) were similar to those based on the 5‐min data, and so daily mean data may be appropriate for characterizing fall rates. We next analyzed the possible correlations between rainfall variability and storm‐flow stage dynamics. We derived rise and recession rates from storm stage hydrographs by assuming exponential rise and decay of a runoff peak. We found that raw rise rates (R_raw) were correlated with both the maximum rainfall rate and the time to the centroid of a rain event. We subsequently removed the trend based on these rainfall characteristics, which yielded new representations of rise rates abbreviated as R_rate and R_tcent, respectively, and that had lower variability than the uncorrected (raw) data. Fall rates were found to be independent of rainfall characteristics. Due to the predominant influence of stream hydrology upon aquatic biota and nutrient fluxes, our work suggests that these stage data analysis protocols can refine or otherwise reduce variability in these indices by accounting for relevant factors such as rainfall forcing. These protocols for derivation of transient indices should be tested for their potential to improve correlations between stream hydrology and temporally aligned biotic data and dissolved nutrient fluxes in streams.     

沿海高速公路风险评价体系构建

沿海高速公路建设面临地质条件复杂,气象灾害多样、工程类型多等困难,针对其风险评估工作多而繁杂的实际情况,以浙江沿海疏港高速公路为工程背景,选择道路工程、桥梁工程和隧道工程为研究对象,在其中筛选提炼出软土路基区、人工海岸区、跨海湾特大桥、水底隧道等作为评价对象,分析了在沿线地质条件及气象条件下,不同评价对象在施工期和运营期可能面临的各种风险因素,选择其中的主要风险因素,构成多级评估对象,搭建了沿海高速公路风险评价的体系,并且说明了所采用的评估方法和评估流程,并介绍了所采用的风险概率和风险后果等级标准。构建沿海高速公路风险评价体系能为我国的类似工程提供了借鉴。     

Combustion characteristics of Malaysian municipal solid waste and predictions of air flow in a rotary kiln incinerator

Malaysia is in dire need of alternatives to landfilling for solid waste management. Recently, landfills have faced the problems of overfilling, overflowing of leachates leading to pollution of water resources, and uncontrolled dust emissions adversely affecting the local environment. With the rising cost of urbanization coupled with the high rate of waste generation, one possible method of waste treatment that is receiving particular attention by the government is incineration. Incineration of solid waste is rather new in Malaysia, with limited usage in handling small sources of waste generation such as the municipal solid waste (MSW) of resort islands; however, its potential in ameliorating the problems associated with solid waste treatment may make it an attractive alternative to landfill. This article presents the results of test runs conducted to investigate the performance of a locally designed and manufactured rotary kiln incinerator (RKI). The test runs were conducted using MSW collected from the Shah Alam municipality. The combustion efficiency was analyzed by looking at the temperature profiles and chemical species concentrations. To complement the combustion characteristics measurements, predictions of the air flow in the incinerator during the process were also investigated. The overall performance of the RKI suggests that it is suitable for treating MSW.     

Elemental Mercury Control by Novel Oxidant and Sorbent in an Entrained-Flow System

An entrained-flow system has been designed and constructed to simulate in-flight mercury capture by sorbents in ducts of coal-fired utility plants. The test conditions of 1.5 s residence time, 140°C temperature, 4.5 ppbv inlet Hg⁰ concentration, and 0–20 lb/MMacf sorbent injection rates were chosen to simulate conditions in the ducts. Novel oxidants developed in previous fixed-bed tests and novel sorbents derived from the novel oxidants were tested for their Hg⁰ capture in the entrained-flow system to examine the possibility of using those sorbents in a full-scale system. Darco-FGD and Darco Hg-LH served as benchmark sorbents with which mercury control capability of the novel oxidants and novel sorbents could be compared. The test results showed that the novel oxidants have remarkable Hg⁰ oxidation capability, and the novel sorbents showed a better performance in Hg⁰ removal than Darco Hg-LH.     

船舶螺旋桨射流对湘江河床底泥扰动影响分析

船舶航行时螺旋桨产生的射流会对河道水流产生扰动,这种扰动是否能引起河床底泥的再悬浮需要更深入的论证分析。通过对比分析螺旋桨射流发展规律的研究成果,以湘江典型河段为研究对象,结合实船测量结果和此段河流地质资料,探讨了螺旋桨射流对湘江长株潭段河床底泥扰动的影响,并对此段河床底泥起动和悬浮条件进行了理论分析。结果表明:在周围环境流速较低的条件下,螺旋桨射流初始速度、河床水深及泥沙粒径是决定泥沙是否运动的主要因素。湘江长株潭河段已基本库区化,大部分河道平均水深远大于航道的标准水深2.8 m,河床泥沙平均粒径大于0.87 mm,其中细颗粒泥沙很少,由于螺旋桨射流断面平均流速小于泥沙起动流速,悬浮指标计算值远大于4,因此可以判断船舶正常航行在该段河流时底泥难以起动和再悬浮。     

利用餐饮业废油脂制造生物柴油

世界的石油产量将会逐渐减少,石化柴油燃烧后所排放的废气是造成的城市空气污染的主要原因,生物柴油是石化柴油很好的替代能源,文章介绍了国外废油脂处理利用和甸餐饮业废油脂的概况,提出了利用餐饮业废油脂制造生物柴油的方法和工艺流程,并讨论了利用餐饮业废油脂制造生物柴油的几个问题。