成都市污染边界层高度的演变特征分析

基于2014年1月21日至2月5日成都市人民南路四段逐时PM_(2.5)质量浓度、大气能见度资料以及同期Mie散射激光雷达探测数据,遵循消光系数与细颗粒物质量浓度之间的关系,探讨污染边界层高度的演变特征。结果表明:污染时段内的污染边界层高度偏低,平均为221m;污染边界层高度与地面PM_(2.5)浓度的变化具有明显相关性,但污染边界层高度改变在前,地面PM_(2.5)浓度响应在后;污染边界层高度的日变化表现为单峰单谷型,峰值和谷值分别出现在08:00时和14:00时前后。     

MDEA水溶液膜法天然气脱硫的试验研究

以新配和含有一定H_2S的MDEA溶液为吸收液,以聚偏氟乙烯(PVDF)膜组件为接触器,通过对操作参数的调节和改变膜孔大小等方法对脱硫率和总传质系数进行研究。结果表明:气液压力差以及膜孔孔径的增加均有利于脱硫率和总传质系数的提升,即均有利于脱硫。降低进气流量和低气液比均对H_2S传质有积极作用。     

一种多介质层波形潜流人工湿地处理重污染河水试验

我国河流污染严重,城市黑臭水体的比率日益增加。人工湿地作为一种高效低耗能的绿色处理技术,已被广泛应用于污染河水的治理。通过对比分析分层装填复合填料的多介质层波形潜流人工湿地和单一砾石填料的普通人工湿地处理重污染河水的效果,研究了特种基质填料强化脱氮除磷作用以及不同水力负荷条件的影响。试验结果表明:在水力负荷为0.2 m~3/(m~2·d)时,普通湿地对COD、NH3-N、TN和TP的去除率分别达到55.95%、77.85%、39.80%和54.94%;多介质层湿地对COD、NH3-N、TN和TP的去除率分别达到58.52%、75.99%、67.08%和57.31%。在水力负荷为0.5 m~3/(m~2·d)时,普通湿地对COD、NH3-N、TN和TP的去除率分别达到68.46%、90.73%、42.13%和53.70%;多介质层湿地对COD、NH3-N、TN和TP的去除率分别达到69.61%、89.94%、77.58%和68.63%,其脱氮效果明显好于普通湿地。以复合填料包分层装填的波形潜流人工湿地系统具有良好的脱氮除磷效果,有很好的推广应用价值。     

Contribution of precursor compounds to the release of per- and polyfluoroalkyl substances (PFASs) from waste water treatment plants (WWTPs)

Per-and polyfluoroalkyl substances(PFASs) are ubiquitous in sludge and water from waste water treatment plants, as a result of their incorporation in everyday products and industrial processes. In this study, we measured several classes of persistent PFASs,precursors, transformation intermediates, and newly identified PFASs in influent and effluent sewage water and sludge from three municipal waste water treatment plants in Sweden, sampled in 2015. For sludge, samples from 2012 and 2014 were analyzed as well.Levels of precursors in sludge exceeded those of perfluoroalkyl acids and sulfonic acids(PFCAs and PFSAs), in 2015 the sum of polyfluoroalkyl phosphoric acid esters(PAPs) were 15–20 ng/g dry weight, the sum of fluorotelomer sulfonic acids(FTSAs) was 0.8–1.3 ng/g,and the sum of perfluorooctane sulfonamides and ethanols ranged from non-detected to 3.2 ng/g. Persistent PFSAs and PFCAs were detected at 1.9–3.9 ng/g and 2.4–7.3 ng/g dry weight, respectively. The influence of precursor compounds was further demonstrated by an observed substantial increase for a majority of the persistent PFCAs and PFSAs in water after waste water treatment. Perfluorohexanoic acid(PFHxA), perfluorooctanoic acid(PFOA), perfluorohexane sulfonic acid(PFHxS), and perfluorooctane sulfonic acid(PFOS)had a net mass increase in all WWTPs, with mean values of 83%, 28%, 37% and 58%,respectively. The load of precursors and intermediates in influent water and sludge combined with net mass increase support the hypothesis that degradation of precursor compounds is a significant contributor to PFAS contamination in the environment.     

Tissue distribution of perfluoroalkyl acids and health status in wild Mozambique tilapia (Oreochromis mossambicus) from Loskop Dam, Mpumalanga, South Africa

This study examined concentrations of 15 perfluoroalkyl acids (PFAAs) in tissues from male Mozambique tilapia (Oreochromis mossambicus) collected at Loskop Dam, Mpumalanga, South Africa in 2014 and 2016. Nine of the 15 PFAAs were detected frequently and were included in statistical analysis and included two of the most commonly known PFAAs, perfluorooctanesulfonic acid (PFOS) (median, 41.6 ng/g) and perfluorooctanoic acid (PFOA) (median, 0.0825 ng/g). Of the tissues measured, plasma (2016 and 2014 median, 22.2 ng/g) contained the highest PFAA burden followed by (in descending order): liver (median, 11.6 ng/g), kidney (median, 9.04 ng/g), spleen (median, 5.92 ng/g), adipose (median, 2.54 ng/g), and muscle (median, 1.11 ng/g). Loskop Dam tilapia have been affected by an inflammatory disease of the adipose tissue known as pansteatitis, so this study also aimed to investigate relationships between PFAA tissue concentrations and incidence of pansteatitis or fish health status. Results revealed that healthy tilapia exhibited an overall higher (p-value < 0.05) PFAA burden than pansteatitis-affected tilapia across all tissues. Further analysis showed that organs previously noted in the literature to contain the highest PFAA concentrations, such as kidney, liver, and plasma, were the organs driving the difference in PFAA burden between the two tilapia groups. Care must be taken in the interpretations we draw from not only the results of our study, but also other PFAA measurements made on populations (human and wildlife alike) under differing health status.     

基于WebGIS的水环境模拟关键技术研究

近年来随着水环境模拟领域的发展出现了较多水环境数学模型,目前日益成熟的WebGIS技术是使模型使用变得简单化和直观化的一大途径.是在通过Flex和ArcGIS Server搭建WebGIS系统平台的基础上,利用PHP进行WebGIS和水环境模拟模型的数据交互,实现系统平台和数值模型的松散耦合.用户在浏览器端进行模型输入条件的设置,模型在远程服务器端进行运行计算,反馈的模拟结果通过RIA在WebGIS中进行多元化动态展示.该方法对一般模型具有适用性,可降低模型使用门槛,提高模拟结果展示和分析能力.     

工业园区综合难降解废水深度处理实验研究

某工业园区综合废水处理厂设计规模5.0×104m3/d,原设计出水执行《城镇污水处理厂污染物排放标准》(GB 18918-2002)一级B标准,需将出水标准提高到一级A排放标准.分别采用混凝沉淀法和高级氧化法深度处理二级生化出水.小试试验结果表明:二级生化出水CODcr在62~75 mg/L左右,PAC、Al2(SO4)3及PFS三种絮凝沉淀药剂处理出水CODcr去除效果均不明显,不能稳定达到一级A排放标准.芬顿催化氧化的pH=5,FeSO4+H2O2投加量为(200+100)mg/L;臭氧氧化的O3投加量33 mg/L,其出水CODcr均能达到一级A排放标准.     

基于质谱技术的在线大气颗粒物来源与污染过程解析研究——以江苏省淮安市为例

通过大气细颗粒物实时在线源解析技术(质谱直接测量法)采集录入淮安市市区部分特征污染源排放成分谱,对淮安市大气细颗粒物进行在线源解析,获取高时间分辨的颗粒物源解析结果,分析颗粒物来源、季度变化和重污染天气的污染过程,评估形成重污染过程的污染影响因子和影响程度,为区域大气污染综合整治提供重要目标指向,同时也为淮安环境空气PM2.5重度污染实时预警与监控、大气污染源减排方案评估、污染事件监控等提供有效的在线监测技术平台.     

光催化降解渗滤液DOM不同组分的相对分子质量变化特征

采用凝胶色谱技术研究了光催化氧化处理过程中垃圾渗滤液DOM 6种组分的分子质量变化规律.结果表明,垃圾渗滤液DOM的相对分子质量大多在104以下,平均在104以上的大分子物质主要是HIB和HIN,仅占渗滤液DOM总量的20%左右.其余组分大多位于(1～10)×103之间,低于500的组分含量很少.说明垃圾渗滤液DOM是以中等相对分子质量的黄腐酸类物质为主,难以生物降解.光催化处理过程中渗滤液DOM的相对分子质量分布范围逐渐变宽,多分散系数D逐渐增大.HOB、HIB、HIA以及HON组分在光催化处理后,相对分子质量显著减小;其中HOB减小最为明显,由初始的(4～25)×103,减小为72 h的(0.4～1)×103之间.而HOA和HIN组分的相对分子质量呈增加趋势,其中HOA增加最为明显,在垃圾原液中分布于(2～20)×103,在72 h光催化处理液中位于(20～50)×103之间.随着处理时间延长,DOM各组分的RID信号均降低,说明其浓度下降.整体上看,渗滤液DOM各组分均发生了明显光催化转化.     

聚合氯化铁-聚(环氧氯丙烷-二甲胺)复合絮凝剂在模拟水处理中的混凝特性研究

制备出一系列具有不同聚合氯化铁(PFC)的碱化度(B)、不同聚(环氧氯丙烷-二甲胺)[P(EPI-DMA)]质量分数[ω(E)]和黏度(η)的PFC-P(EPI-DMA)复合混凝剂,并将其用于模拟染料废水和模拟天然地表水的絮凝脱色处理,对比探讨了ω(E)、η和B对PFC-P(EPI-DMA)中铁的形态分布及其混凝效果的影响,以及混凝作用机制.结果表明,复合絮凝剂中铁的有效形态含量随ω(E)的增大而不断降低;η=850 mPa.s时,复合混凝剂中铁的有效形态含量最高;随B值的增大,Feb含量先增大后减少,而Fec含量逐渐增大.一定程度上使用预水解程度较低、有机成分黏度较大的PFC-P(EPI-DMA)有利于混凝效果的提高,复合混凝剂中有机成分质量分数对混凝效果的影响则与处理对象有关.在模拟水处理中,复合混凝剂依靠电性中和及架桥吸附能力发挥混凝特性.