烟草下脚料发酵制取乙醇

通过单因素实验考察了硫酸浓度、固液比和水解时间对硫酸水解的影响。结果显示最优条件为:硫酸浓度为50%(w/w),固液比为10%(w/v),时间为100 min。烟草下脚料在最佳硫酸水解条件下,经5倍稀释,中和pH值至5～6。取经过滤后的水解液(FH)用酿酒酵母(Sacchharomyces cerevisiae)发酵产生乙醇,最大的乙醇浓度和乙醇产量分别为1.09g/L和54.5 g/kg。未过滤水解液(UFH,包括水解残渣)加入纤维素酶(70 U/100 mL)和酿酒酵母(Sacchharomyces cerevisiae)进行发酵,最大的乙醇浓度和乙醇产量分别为1.23 g/L和61.5 g/kg。     

北京和上海典型复合包装废物处置环境影响比较

采用生命周期评价法研究比较了北京和上海两地纸塑铝复合包装处置阶段的环境影响。通过现场和资料调研的方式获得此阶段的能量物质的输入输出和环境外排数据。结果表明:北京和上海两地纸塑铝复合包装处置阶段的环境影响潜值分别为-0.428 Pt和9.776 Pt,其主要集中在气候变化、土地占用和无机物对健康的损害三方面;每提高10%的回收率,其环境影响潜值北京和上海可分别降低5.446 Pt和5.799 Pt;上海地区纸塑铝复合包装处置阶段对环境的影响在任何同回收率的情况都要高于北京地区,其主要原因是上海地区填埋产生的温室气体释放量过大和再生企业距离打包点较远。     

脱硫灰与钾矿石复合生产钾钙硅镁硫肥料研究

对脱硫灰与钾矿石复合生产钾钙硅镁硫肥的研究意义、反应原理、生产流程、环境安全性能以及施肥方法等进行了介绍和评估,并对其应用前景进行了展望。研究结果表明:利用脱硫灰与钾矿石复合生产钾钙硅镁硫肥在理论上可行;生产出的产品中硫酸钾的含量达10.34%～12.0%,枸溶氧化钙19.06%～32.28%,枸溶二氧化硅10.98%～14.46%,枸溶氧化镁1.46%～1.82%。产品的pH值从原脱硫灰的10.65下降到9.60。重金属含量低于农用粉煤灰国家标准,生产过程中不会产生SO2等有害气体污染。肥料的生产成本低于350元/t,该肥料不但可以增加土壤中钾、钙、硅、镁和硫等中微量元素的含量,而且可以提高或改善农作物的产量和品质。达到变废为宝,促进循环经济发展之目的。     

剩余污泥减量化工艺条件优化研究

运用超声处理连续流活性污泥系统中不同种类的污泥,并将其回流至原系统中,研究其剩余污泥减量化效果。按正交实验设计并进行试验,确定最优工艺条件。结果表明:当声能密度为0.6 W/mL,作用时间为5 min,超声污泥为混合污泥,回流比为7∶120时,减量效果最佳。且在该条件下经一周期的运行,污泥减量效果达到96.24%,COD由进水的830 mg/L降至44 mg/L,NH4+-N和TN分别由进水的62.43 mg/L和103.19 mg/L,降解到2.31 mg/L和6.52 mg/L,达到《城镇污水处理厂污染物排放标准》(GB18918-2002)一级排放标准。     

危险废物处理技术进展及若干建议

较系统地论述了国内固体废物的目前状况、产量,分析了一些典型危险废物处理过程中存在的主要问题和解决方法,提出了深人开展危险废物处理与资源化研究的方向,并给出了环保部门应对危险废物进行处理的建议。     

The importance of context for effective public engagement: learning from the governance of waste

This paper takes a new look at the importance of context – institutional and political – in effective public engagement processes. It does so through a rare comparative opportunity to examine the effectiveness of processes of public engagement in two UK waste authorities, where the same waste company was involved as both the primary contractor for the delivery of the waste management service (including new energy-from-waste facilities) and, furthermore, the same staff delivered the public engagement. Interrogating these cases affords the opportunity to place flesh on the bones of the sometimes ‘abstract’ skeleton of context. While engagement processes support effective local governance in an era of partnerships and deliberative democracy, the paper identifies that the methods adopted cannot be played out devoid of detailed understanding and response to local context, including the strength of partnership working between the public and private sector, the degree of political support for engagement, and the extent to which a traditional institutional paternalism still dominates.     

城市生活垃圾焚烧发电的现状及发展对策

分析了城市生活垃圾焚烧处理的国内外现状和意义,针对近年来新建和在建的垃圾焚烧发电项目或多或少面临的被抵制局面,提出了对策。     

Localization of hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX) and 2,4,6-trinitrotoluene (TNT) in poplar and switchgrass plants using phosphor imager autoradiography

Phosphor imager autoradiography is a technique for rapid, sensitive analysis of the localization of xenobiotics in plant tissues. Use of this technique is relatively new to research in the field of plant science, and the potential for enhancing visualization and understanding of plant uptake and transport of xenobiotics remains largely untapped. Phosphor imager autoradiography is used to investigate the uptake and translocation of the explosives 1,3,5-trinitro-1,3,5-triazine (RDX) and 2,4,6-trinitrotoluene within Populus deltoides × nigra DN34 (poplar) and Panicum vigratum Alamo (switchgrass). In both plant types, TNT and/or TNT-metabolites remain predominantly in root tissues while RDX and/or RDX-metabolites are readily translocated to leaf tissues. Phosphor imager autoradiography is further investigated for use in semi-quantitative analysis of uptake of TNT by switchgrass.     

污泥热解残渣制备聚合氯化铝的实验研究＊

含铝污泥热解或焚烧残渣制备聚合氯化铝的研究,有利于实现污水处理过程投加的铝盐絮凝药剂的回收与高效循环利用,减少污染物排放和资源消耗。针对辽河油田欢三联稠油污水处理污泥的热解残渣具有较高铝含量的特点,开展采用盐酸进行铝溶出及制备聚合氯化铝的实验研究。结果表明:焙烧温度为700～750℃,焙烧时间控制在1h即可。将经过焙烧活化的残渣在常温下进行酸溶,酸溶时间为2～5h,选用25%～30%盐酸,氧化铝与盐酸的摩尔比为1∶1.0～1∶1.2为宜。将溶出的铝溶液制备聚合氯化铝,在常温下采用CaO粉末来调节pH值为3.5,聚合反应时间为1d,即可得聚合氯化铝溶液。     

医疗废物焚烧处理核心技术的开发及应用

国内已建成的医疗废物焚烧设施目前普遍存在进料系统不稳定、玻璃结渣和高浓度HCl气体的排放的问题。这些技术难点已成为医疗废物焚烧处置行业发展的瓶颈。本文介绍了可解决上述问题的"可调节医疗废物恒流量进料技术"、"医废焚烧防玻璃结渣技术"和"含高浓度氯化氢医废尾气处理技术"三项医疗废物焚烧处理核心技术的主要特点及技术指标与应用实例。