响应曲面法优化镍转炉渣氧压选择性浸出工艺

为了优化镍转炉渣加压条件下H₂SO₄选择性浸出Co、Ni、Cu,抑制Fe浸出的工艺,采用响应曲面法的中心组合设计原理,建立影响选择性浸出率的二次多项式数学模型,研究浸出温度、c(H₂SO₄)及液固比及上述因素两两交互作用对提高Co、Ni、Cu浸出率及减少Fe浸出率的影响规律. 结果表明:浸出温度和c(H₂SO₄)对浸出率影响最显著,液固比次之. c(H₂SO₄)越高,Co、Ni、Cu和Fe的浸出率越高,而提高浸出温度有利于降低Fe浸出率. 响应曲面法优化获得的最佳工艺条件:浸出温度为210 ℃、c(H₂SO₄)为0.38 mol/L、液固比为4.25 mL/g,在该条件下,Co和Ni的浸出率均大于98%,Cu浸出率大于96%,Fe浸出率小于0.4%. 浸出控制参数优化后提高了有价金属的浸出率,同时也降低了Fe浸出率,实现了镍转炉渣中有价金属的回收及其与Fe的高效分离.      

飞灰添加对沥青铺路烟气PAHs释放的影响

为评估生活垃圾焚烧飞灰替代矿粉生产沥青混合料及其路面浇筑全过程中PAHs的环境风险,采用实验室模拟与实际铺筑过程相结合的方法,改变飞灰添加量(以w计,0、3%、4%和5%)和加热温度(200、165、145和80 ℃),以对PAHs的释放规律进行研究. 结果表明:在实际筑路过程中,PAHs的释放受加热温度的影响较大,ρ(∑₁₆PAHs)随加热温度的下降而降低,其中混合料制备和道路开放使用阶段的ρ(∑₁₆PAHs)分别为249.0～378.0、72.1～95.1 μg/m3;但在路面浇筑阶段ρ(∑₁₆PAHs)有增加的趋势,为254.0～571.0 μg/m3,并且在该阶段内ρ(4环PAHs)降低,低环(2～3环)和高环(5～6环)的PAHs质量浓度升高. 飞灰的添加抑制了PAHs的释放,w(∑₁₆PAHs)在10.4～12.3 μg/kg之间,毒性当量浓度(以TEQ计)在0.011 μg/kg左右. 飞灰的添加抑制了以萘为主的低环PAHs的释放,并且在3%添加量时对PAHs的抑制效果最好;在飞灰添加量为3%、4%和5%时,w(萘)分别降低了42.7%、32.2%和35.3%.      

高蛋白有机废弃物厌氧消化系统稳定性及其耐氨氮机制解析

病死及自然灾害产生的大量畜禽尸体的不恰当处理处置会带来较为严重的环境卫生和公众安全隐患.本研究利用厌氧消化技术对畜禽尸体这类高蛋白有机废弃物的无害化处理进行尝试,旨在探索其适宜的有机负荷条件、系统的稳定性及潜在的氨抑制风险.研究表明高蛋白有机废物(以猪肉作为实验样品)作为厌氧消化基质时,系统稳定运行的有机负荷能够达倒(4.76±0.41)kg·m~(-3)·d~(-1);同时,VS降解率、单位体积沼气产率、单位添加VS沼气产率、单位降解VS沼气产率以及甲烷含量分别能达到95%、(3.72±0.21)L·L~(-1)·d~(-1)、(0.78±0.02)m~3·kg~(-1)、(0.82±0.02)m~3·kg~(-1)以及65%.在该条件下,TAN和FAN的浓度与系统产气性能没有直接线性关系,且在浓度高达5700 mg·L~(-1)和700 mg·L~(-1)时未呈现对系统的明显抑制作用.454高通量焦磷酸测序法对系统内古菌种群相对密度的分析结果表明,系统中氨抑制问题得到一定程度的缓解或者消除的原因可能为甲烷八叠球菌属(Methanosarcina)的优势地位并未受到明显影响,以及整个产甲烷菌种群在系统运行过程所得到的明显驯化.     

热解析-脉冲低温等离子体集成系统脱汞研究

热解析-脉冲低温等离子体集成处理系统是专门针对典型含汞废物安全处置而开发的,可以同时有效控制汞等多种复合气体污染物。通过检测热解炉后烟气中和等离子体反应器入口、出口气体中Hg0和Hg2+浓度,研究汞的价态转化及添加剂对脱汞效果的影响。结果表明:热解烟气中Hg2+/HgT为17%~45%,Hg0/HgT为55%~83%,热解温度主要影响汞价态分布,WMC添加量主要影响汞浓度值;加入添加剂会促进汞的脱除,但添加剂过量不利于汞的氧化;热解炉中添加50 g WMC和5 g升华硫添加剂时,反应器内Hg0氧化率和总汞损失率分别可达55%和42%。该研究可以为探索新型含汞废物处置工艺,实现含汞废物深度净化提供新思路。     

Waste‐to‐energy recovery potential: A case study at Jaipur railway station

A study was conducted at the Jaipur railway station in Jaipur, India, to give the perspectives of the actual waste management practices there. Required information was collected from the stakeholders by means of semi‐structured questionnaires, individual and group interviews, and recorded, official data regarding waste generation, collection, transportation, and disposal. Further quantitative and compositional analyses were performed by means of surveys and measurements. Field visits were made for collection of waste samples for quantification and for the study of its management. The field data were compiled and analyzed by sorting the waste into different components. It was found that 1.8 tons of solid waste is collected per day, and a considerable percentage of it comprises paper, plastic, and glass. Excluding the inerts, which are irrelevant from the point of view of energy saving and recovery potential, the average moisture content was found to be 3.38%. From the perspective of life cycle analysis, the option of composting or recycling would give savings of 28.33 gigajoules (GJ) per day over landfilling, while combustion would give savings of 2.97 GJ per day in comparison to landfilling. Analysis based on a compositional model gives a heat value of 8,157.87 kilojoules per kilogram, which amounts to 14.68 GJ of energy per day.     

废弃含汞灯具中荧光粉分析及汞处理

废旧直管型荧光灯、节能灯及高压汞灯等照明灯具所用荧光粉中含有重金属汞,由此带来的汞污染已危及人体健康与生态安全。分析了废弃含汞灯具中荧光粉混合物的粒径分布以及不同粒径筛分物中塑料的组分含量和汞含量,并研究了不同加热时间、加热温度对汞蒸馏效果的影响。结果表明:含汞荧光粉原料中塑料含量占1.00%,粒径大于150μm的玻璃颗粒占72.00%以上,其汞含量仅为9 mg/kg;在恒定氮气量为2L/min的条件下,利用管式炉在700℃的温度下加热240min,汞的蒸馏效果最佳,汞蒸馏效率为61.11%~95.26%。     

Estimating emissions from crop residue open burning in China based on statistics and MODIS fire products

With the objective of reducing the large uncertainties in the estimations of emissions from crop residue open burning, an improved method for establishing emission inventories of crop residue open burning at a high spatial resolution of 0.25°× 0.25° and a temporal resolution of1 month was established based on the moderate resolution imaging spectroradiometer(MODIS) Thermal Anomalies/Fire Daily Level3 Global Product(MOD/MYD14A1). Agriculture mechanization ratios and regional crop-specific grain-to-straw ratios were introduced to improve the accuracy of related activity data. Locally observed emission factors were used to calculate the primary pollutant emissions. MODIS satellite data were modified by combining them with county-level agricultural statistical data, which reduced the influence of missing fire counts caused by their small size and cloud cover. The annual emissions of CO_2, CO, CH_4,nonmethane volatile organic compounds(NMVOCs), N_2O, NO_x, NH_3, SO_2, fine particles(PM2.5),organic carbon(OC), and black carbon(BC) were 150.40, 6.70, 0.51, 0.88, 0.01, 0.13, 0.07, 0.43,1.09, 0.34, and 0.06 Tg, respectively, in 2012. Crop residue open burning emissions displayed typical seasonal and spatial variation. The highest emission regions were the Yellow-Huai River and Yangtse-Huai River areas, and the monthly emissions were highest in June(37%).Uncertainties in the emission estimates, measured as 95% confidence intervals, range from a low of within ±126% for N_2O to a high of within ± 169% for NH_3.     

翻堆频率对厨余垃圾堆肥过程中H_2S和NH_3排放的影响

为研究厨余垃圾堆肥过程中翻堆频率对H2S和NH3排放的影响,以大类粗分后的厨余垃圾为研究对象,玉米秸秆为调理剂,设置4组翻堆频率不同的处理(每周2次,2周1次,2周1次和不翻堆)进行对比研究。结果表明:翻堆频率的变化对H2S的排放影响不大,对NH3的排放有显著的影响,翻堆频率过高会增加NH3的累积排放量,翻堆频率过低虽然能降低NH3的累积排放量,但会影响到堆肥产物的腐熟。综合厨余垃圾堆肥的无害化指标、H2S和NH3的排放以及最终堆肥产品的毒性检验,在实验条件下,翻堆频率设为每周1次在堆料腐熟的基础上对H2S和NH3减排效果最好。     

废弃SCR脱硝催化剂无害化处理的研究进展

鉴于废弃SCR脱硝催化剂中含有多种痕量重金属以及可回收利用物质,从处理工艺包括重金属的去除、有价金属的回收等方面综述了废弃SCR脱硝催化剂无害化处理的现状,总结了现阶段的研究重点以及工业化应用的瓶颈。目前主要关注废弃SCR脱硝催化剂中钒、钨、钛的回收工艺,但工业化成本昂贵,难以实现效益均衡化。根据现行废弃SCR脱硝催化剂的处置规范,烟气飞灰中重金属的存在是废催化剂处置工艺复杂化的关键。研究重金属的去除以及有价金属的回收,方能最终实现针对废弃SCR脱硝催化剂无害化处理工艺的综合研发。     

某生活垃圾处理中心厨余垃圾处理工程实例分析

厨余垃圾作为城市有机生活垃圾的主要成分之一,因其具有高水分、高油脂、高盐分以及易腐发臭、易生物降解等特点,不宜直接填埋和焚烧。对某生活垃圾综合处理厂生物处理中心采用"预处理+酸化水解-厌氧+沼渣脱水后生化处理"组合工艺的厨余垃圾处理工程进行了实例分析。该工艺处理厨余垃圾具有无害化、减量化、资源化程度较高和能耗较低的优势,具有良好的推广潜力。