锰离子催化臭氧液相烟气脱硫实验研究

对Mn2+催化臭氧(O3)液相氧化脱除二氧化硫(SO2)进行了实验研究,以揭示Mn2+对臭氧液相氧化SO2的影响.采用标准碘量法测定了O3浓度曲线.实验比较了添加Mn2+前后吸收液对SO2的脱除效率,并研究了O3与SO2摩尔比([O3]/[SO2])、Mn2+浓度对SO2脱除效率的影响.在[O3]/[SO2]=0.5、未添加Mn2+时O3对SO2的氧化效率为35%,而添加Mn2+后的氧化效率达到70%.随着[O3]/[SO2]的增大,SO2脱除效率逐渐增加,而且脱除效率也随Mn2+浓度的增加而增加,合适的Mn2+浓度范围为1.2×10-2~1.2×10-1mol/L.     

Fabrication of supported acid catalytic composite fibers by a simple and low-cost method and their application on the synthesis of liquid biofuel 5-ethoxymethylfurfural

In this paper, sulfonic groups functionalized annealed bio-based carbon microspheres loaded polytetrafluoroethylene (A-BCMSs-SO3H@PTFE) fibers with high activity, high stability, and easy regeneration were successfully fabricated by a simple method using low-cost raw materials. The characterization results showed that the annealed biomass carbon microspheres derived from waste Camellia oleifera shells were evenly distributed on the polytetrafluoroethylene fibers and the sulfonic groups can be successfully loaded on the surface of annealed biomass carbon microspheres by room temperature sulfonation. Subsequently, the as-prepared A-BCMSs-SO3H@PTFE fibers were applied to the acid-catalyzed synthesis of liquid biofuel 5-ethoxymethylfurfural. The catalytic experiment results indicated that the annealing temperature and time during catalyst preparation have a significant effect on the activity and selectivity of A-BCMSs-SO3H@PTFE fibers. The results of catalytic reaction kinetics showed that the yield of 5-ethoxymethylfurfural can reach more than 60％after 72 h of acid-catalyzed reaction. The stability test showed that the as-prepared A-BCMSs-SO3H@PTFE fibers still maintained a stable acid catalytic activity after four recycles.     

稀土催化剂在环保领域中的研究和应用

综述了稀土材料在催化剂中的作用机理,介绍了稀土催化剂在汽车尾气治理、烟气脱硫脱硝治理、室内空气净化、焦化污水处理以及其他领域的研究与应用进展,展望了稀土催化剂在环保产业中的发展前景。     

Catalytic decomposition of low level ozone with gold nanoparticles supported on activated carbon

Highly dispersed gold nanoparticles were supported on coal-based activated carbon (AC) by a sol immobilization method and were used to investigate their catalytic activity for low-level ozone decomposition at ambient temperature. Nitrogen adsorption-desorption, scanning electron microscope (SEM), and X-ray photoelectron spectroscopy (XPS) were used to characterize the catalysts before and after ozone decomposition. The results showed that the supported gold nanoparticles prepared with microwave heating were much smaller and more uniformly dispersed on the activated carbon than those prepared with traditional conduction heating, exhibiting higher catalytic activity for ozone decomposition. The pH values of gold precursor solution significantly influenced the catalytic activity of supported gold for ozone decomposition, and the best pH value was 8. In the case of space velocity of 120000h⁻¹, inlet ozone concentration of 50mg/m³, and relative humidity of 45%, the Au/AC catalyst maintained the ozone removal ratio at 90.7% after 2500min. After being used for ozone decomposition, the surface carbon of the catalyst was partly oxidized and the oxygen content increased accordingly, while its specific surface area and pore volume only decreased a little. Ozone was mainly catalytically decomposed by the gold nanoparticles supported on the activated carbon.     

用活性填料催化氧化-硝酸吸收法脱除氮氧化物的研究

为了提高硝酸吸收氮氧化物的效率,对活性填料催化氧化-硝酸吸收NOx进行了研究.结果表明:活性填料能明显提高NOx的吸收效率;当NOx中NO2体积百分含量增加,其吸收效率增加;随进气浓度和液气比的增大,NOx吸收效率增加;随NO2浓度的增加,NO的吸收效率先增加后减少,在NO/NO2为3时,NO吸收效率最高;随NO的增加NO2的吸收效率先增加后减少,在NO/NO2为0.6～1之间,NO2的吸收效果较好.     

Iron-catalyzed oxidation of s(IV) species by oxygen in aqueous solution: Influence of pH on the redox cycling of iron

Redox cycling of Fe(II)/Fe(III) during the catalyzed aqueous S(IV) oxidation by dissolved oxygen in the presence of Fe(II) and/or Fe(III) at an initial pH_i of 4.4, often observed in atmospheric waters, was studied in detail. It has been found that the reaction rate is not considerably affected by the oxidation state of iron at the start of the reaction. An equilibrium between Fe(II) and Fe(III) was established a few minutes after the start of the reaction, regardless of the oxidation state of iron at the beginning of the experiment. The prevailing oxidation state of iron in a particular phase of the reaction depends on the concentration of S(IV) in the reaction solution. It has been found that the formation of polymerized hydroxo Fe(III) species is also included in the mechanism of the Fe-catalyzed oxidation of S(IV). The formation of these species was confirmed by the on-line measurement of Fe(II) and Fe_reac. The results also clearly demonstrate that the pH_i of the solution is a major factor, controlling the concentration of Fe(III) ions, the form of S(IV) species, and consequently the reaction rate of S(IV) oxidation by oxygen.     

紫外光催化氧化技术处理有机污染物的研究动态

主要介绍了北美先进的紫外光催化氧化技术对有机废水、废气的处理研究与应用，简要介绍三种类型光催化反应器的结构。该技术在国外处于研究阶段，预期应用前景很好，尤其适用于电力充沛地区有机废水、废气的处理，具有应用方便、处理效果好，投资费用低等特点。     

苦杏仁酸、苹果酸、乳酸对Cr(VI)还原作用的比较

不同温度和pH条件下,通过批式试验研究了苦杏仁酸、苹果酸、乳酸还原Cr(Ⅵ)的反应速率.结果表明,这3种α-OH酸还原Cr(Ⅵ)的能力表现为:苦杏仁酸＞苹果酸＞乳酸.苦杏仁酸对Cr(Ⅵ)的还原作用受pH变化的影响较大,而乳酸受温度变化的影响较大.同时研究了Mn(Ⅱ)对3种α-OH酸还原Cr(Ⅵ)反应速率的影响.结果表明,Mn(Ⅱ)对3种α-OH酸还原Cr(Ⅵ)均有催化作用,其中对苦杏仁酸表现更为明显.     

光、电催化氧化降解染料废水的研究

在光催化剂的参与下,光催化产生·OH、·O2-等自由基,电催化产生·OH、OH-等自由基,这些自由基是水系中存在的氧化能力最强的氧化剂.本实验将光、电协同催化应用于直接深兰L废水的处理上,研究了影响染料废水脱色(降解)的有关因素.表明了在电场作用下,光催化氧化的效果将得到加强,从而大大提高了染料废水的降解速率.     

Experimental and mechanism studies on seawater flue gas desulfurization

ＩｎｔｒｏｄｕｃｔｉｏｎＩｎｓｔａｌｌａｔｉｏｎｏｆｓｃｒｕｂｂｅｒｓｏｒｔｈｅｕｓｅｏｆｌｏｗｓｕｌｆｕｒ ｃｏｎｔａｉｎｉｎｇｃｏａｌａｒｅｔｗｏｏｐｔｉｏｎｓｕｓｅｄｂｙｐｏｗｅｒｐｌａｎｔｓｔｏｒｅｄｕｃｅＳＯ2 ｅｍｉｓｓｉｏｎｓ.ＴｈｅｍａｊｏｒｉｔｙｏｆｐｏｗｅｒｐｌａｎｔｓｃｏｎｔｒｏｌＳＯ2 ｅｍｉｓｓｉｏｎｓｕｓｉｎｇｌｉｍｅｂａｓｅｄｓｃｒｕｂｂｉｎｇ ,ａｌｔｈｏｕｇｈｔｈｉｓｄｅｓｕｌｆｕｒｉｚａｔｉｏｎｐｒｏｃｅｓｓｈａｓａｎｕｍｂｅｒｏｆａｄｖａｎｔａｇｅｓ,ｉｔａｌｓｏｈ…