碳纳米管界面改性超滤膜的抗污机理解析

以碳纳米管(CNT)为核心改性材料,采用喷涂法对聚醚砜(PES)超滤膜进行界面改性,研究改性膜的抗污染性能.结果表明:改性膜经聚乙烯醇交联稳定后,呈现微弱的通透性降低和明显的亲水性提升,CNT交织网状层提高了界面粗糙度;在牛血清白蛋白(BSA)污染试验中,CNT-10改性膜的抗污性能最好,在20mg/L BSA试验后,...     

转盘式光催化燃料电池处理染料废水

采用阳极氧化法制备转盘式TiO_2阳极,设计并开发了转盘式光催化燃料电池(PFC),探讨了圆盘转速对PFC中染料降解效果的影响。实验结果表明:随着圆盘转速的提高,污染物和光电界面反应产物的传质作用得以强化,罗丹明B降解率提高;在圆盘转速为1 600 r/min、反应时间为60 min的条件下,罗丹明B降解率达90.8%,是圆盘转速为0 r/min时的8.5倍;光电流也随着圆盘转速的提高而提高,但提高幅度远小于罗丹明B降解率的提高幅度;同时,加强传质作用后再外加电压对PFC催化降解性能的提高作用有限。     

生产性四级转盘生物膜活性的测定与分析

本文以处理生物制品废水的生产性四级转盘的生物膜为材料,在监测转盘对废水污染指标(BOD_5、COD_(cr)、挥发酚)降解性能的同时,测定了各级转盘生物膜的挥发性固体(VS)、活性微生物数目(AMN)以及TTC-脱氢酶活性(TTC-DHA)等活性参数,并分析讨论了VS、AMN、TTC-DHA与转盘级数的关系以及TTC-DHA与VS的相关性等问题。结果表明,TTC-DHA可能将会成为测定转盘生物膜活性的有效参数。     

电化学法直接快速测定COD初步研究

对一种全新的方法—电化学法测定COD进行了初步研究。制备出析氧超电位很大的铂基α PbO2 和 β PbO2 双镀层电极 ,并用以电解产生羟基自由基直接氧化废水中有机物。在本研究确定的条件下 ,COD标液在 0～ 30 0mg L呈良好的线性关系 ,一次测定仅需 30s。     

活性艳蓝X-BR的电化学行为及机理研究

采用循环伏安法、线性扫描伏安法及微分脉冲伏安法研究了活性艳蓝X BR在0 1mol·l- 1 KCl HCl溶液中的电化学行为 .研究发现 ,在 - 0 45V— 1 0VvsSCE电压范围内的循环过程中出现两对氧化还原电流峰 ,通过考察峰电压随溶液pH值的变化 ,提出了可能的电极反应机理 :阳极区的电极反应是属于失 1质子和 2电子的氧化反应 ,而阴极区的电极反应则是蒽醌基团被还原加氢成为氢醌基团的反应     

抛石环境中铝合金阳极性能评价及其对海底隧道钢壳保护效果评估

目的 解决埋覆介质中牺牲阳极电化学性能评价的不确定性,实现非匀质介质中牺牲阳极电容量测试结果的评价和对比.方法 模拟沉管隧道埋覆的环境介质,对铝合金牺牲阳极的电容量和溶解形貌进行评测.为区别于现有的海水等匀质介质中阳极的检测方法,建立非匀质介质中铝阳极电化学性能评价方法.另外,在上述埋覆介质中,测定阳极和阴极的极化曲线,修正仿真计算的边界条件,有利于模拟这种高电阻率介质环境下阴极保护电位分布.结果 测试箱所测电阻率与商用便携式电导率仪测定精度相当.A1阳极在低电阻率的海水中(25～40?·cm)性能稳定,电容量稳定在2500 A·h/kg,溶解性能良好;在40?·cm海淡水+回填石的混合介质中,电容量测试值数据波动大,重现性差.B1阳极在海水(25～40?·cm)中的电容量和A1阳极相当,未见到差异,在40?·cm海淡水+回填石混合介质中,电容量数值分散性小,电化学活性高.结论 混合介质中的评价试验体现了海淡水、混合介质电阻率和回填石对阳极溶解产物阻滞的综合效应,提高了抛石环境中铝阳极寿命评估的准确性,尤其适用于沉管隧道钢壳用铝合金阳极电化学性能评价和牺牲阳极保护效果评估.     

Dechlorination of carbon tetrachloride by the catalyzed Fe-Cu process

The electrochemical reduction characteristics of carbon tetrachloride (CT) were investigated using cyclic voltammetry in this study. In addition, the difference in reduction mechanisms of CT between Master Builders' iron and the catalyzed Fe-Cu process was discussed. The results showed that CT was reduced directly on the surface of copper rather than by atomic hydrogen produced at the cathode in the catalyzed Fe-Cu process. The reduction was realized largely by atomic hydrogen in Master Builders' iron. The entire CT in 350 ml aqueous solution with 320 mgL was reduced to trichloromethane and dichloromethane in 2.25 h when 100 g of scrap iron with FeCu ratio of 10:1 (ww) were used. Moreover, the reduction rate slowed with time. CT could be reduced at acidic, neutral and alkaline pH from solution by Fe-Cu bimetallic media, but the mechanisms were di?erent. The degradation rate was not significantly in?uenced by pH in the catalyzed Fe-Cu process; in Master Builders' iron it clearly increased with decreasing pH. The kinetics of the reductions followed pseudo-first order in both cases. Furthermore, the reductions under acidic conditions proceeded faster than that under the neutral and alkaline conditions. The catalyzed Fe-Cu process was superior to Master Builders' iron in treating CT-containing water and this advantage was particularly noticeable under alkaline conditions. The reduction was investigated in the cathode (Cu) and anode (Fe) compartments respectively, the results showed that the direct reduction pathway played an important role in the reduction by the catalyzed Fe-Cu process. The catalyzed Fe-Cu process is of practical value.     

Effect of Sb dopant amount on the structure and electrocatalytic capability of Ti/Sb-SnO2 electrodes in the oxidation of 4-chlorophenol

Ti/Sb-SnO_2 anodes were prepared by thermal decomposition to examine the influence',of the amount of Sb dopant on the structure and electrocatalytic capability of the electrodes in the oxidation of 4-chlorophenol.The physicochemical properties of the Sb-SnO_2 coating were markedly influenced by different amounts of Sb dopant.The electrodes,which contained 5% Sb dopant in the coating, presented a much more homogenous surface and much smaller mud-cracks,compared with Ti/Sb-SnO_2 electrodes containing 10% or 15% Sb dopant,which exibited larger mud cracks and pores on the surface.However,the main microstructure remained unchanged with the addition of the Sb dopant.No new crystal phase was observed by X-ray diffraction(XRD).The electrochemical oxidation of 4-chlorophenol on the Ti/SnO_2 electrode with 5% Sb dopant was inclined to electrochemical combustion;while for those containing more Sb dopant,intermediate species were accumulated.The electrodes with 5% Sb dopant showed the highest efficiency in the bulk electrolysis of 4-chlorophenol at a current density of 20 mA/cm~2 for 180 min;and the removal rates of 4-chlorophenol and COD were 51.0% and 48.9%,respectively.     

电化学法去除水中氯代有机化合物的研究进展

氯代有机化合物难降解、环境危害性极大,对氯代有机化合物的污染进行治理已成为水污染控制的重要课题。介绍了直接电化学氧化法、间接电化学氧化法、直接电化学还原法和间接电化学还原法用于水中氯代有机化合物处理的机理、研究现状;总结了电化学法去除氯代有机化合物的影响因素,同时指出电化学法在实际应用中存在的问题,并展望了氯代有机化合物电化学处理技术的应用前景。     

含重金属离子废水治理技术的研究进展

介绍了治理含重金属离子废水的物理法、物理化学法、普通化学法、生化法及电化学法等技术的研究进展;论述了电-生物耦合法处理该类废水的最新趋势;指出将不同治理技术加以耦合,充分发挥不同技术的优点、取长补短,并尽量避免它们之问的相互抑制作用,将是该类废水治理技术的发展方向。