Vapour pressures, aqueous solubility, Henry's law constants and air/water partition coefficients of 1,8-dichlorooctane and 1,8-dibromooctane

New data on the vapour pressures and aqueous solubility of 1,8-dichlorooctane and 1,8-dibromooctane are reported as a function of temperature between 20 °C and 80 °C and 1 °C and 40 °C, respectively. For the vapour pressures, a static method was used during the measurements which have an estimated uncertainty between 3% and 5%. The aqueous solubilities were determined using a dynamic saturation column method and the values are accurate to within ±10%. 1,8-Dichlorooctane is more volatile than 1,8-dibromooctane in the temperature range covered (p_sat varies from 3 to 250 Pa and from 0.53 to 62 Pa, respectively) and is also approximately three times more soluble in water (mole fraction solubilities at 25 °C of 5.95 × 10⁻⁷ and 1.92 × 10⁻⁷, respectively). A combination of the two sets of data allowed the calculation of the Henry’s law constants and the air water partition coefficients. A simple group contribution concept was used to rationalize the data obtained.     

The role of humic substances in chromium sorption onto natural organic matter (peat)

To elucidate mechanisms of Cr³⁺ sorption onto the unaltered solid natural organic matter, the comparative studies of this ion binding from a solution at pH 4.0 onto three selected particle size fractions: 2000–1000 μm, 630–200 μm and 63–20 μm of markedly different HS content and structure, separated by a wet sieving from an overall sample of peat (Brushwood Peat Humus) were carried out. Comparable patterns of COOH groups and CEC_t confirmed that for cation exchange capacity were responsible mainly cations connected with COO⁻ functional groups. It was though found that aliphatic acids in the solid state did not take part in Cr³⁺ binding, thus the finest studied fraction 63–20 μm of the highest contents of functional groups showed the lowest sorption capacity for Cr³⁺, while similar patterns of sorbed Cr³⁺, soluble HS content and base CEC₀ indicated that these parameters were directly interrelated. The base ion exchange processes determined by CEC₀ (with Ca²⁺ as a predominant exchangeable cation) appeared to be not the major mechanisms responsible for Cr³⁺ sorption. For this metal, strong binding to insoluble large molecular weight organic pool two- to threefold prevailed over the ion exchange processes. Very low acid desorption indicated generally low mobility of Cr³⁺-organic compounds.     

A/DAT-IAT生物膜法处理高含盐废水

以含盐量为60 000mg/L(以NaCl计)的模拟工业废水为研究对象,利用A/DAT-IAT生物膜反应器,研究A/DAT-IAT工艺对投加悬浮填料后高含盐废水的处理,并以CODCr、NH4 -N、PO43--P等作为指标评价处理效果.试验结果表明,在总水力停留时间(HRT)为13 h、pH=7,5、25℃条件下,进水ρ(CODCr)、ρ(NH4 -N)和ρ(PO43--P)分别为907.4～1 210.0 mg/L、86.2～99.7 mg/L和3.6～5.1 mg/L.CODCr、NH4 -N和PO43--P的平均去除率分别为73.9%、38.6%和93.5%,平均出水SS为198 mg/L,其中CODCr和PO43--P的去除效果较好.研究表明,A/DAT-IAT生物膜法较其他活性污泥法有了较大的提高.     

Perfluorinated Surfactants in Surface and Drinking Waters (9 pp)

Background, Aim and Scope In this paper recent results are provided of an investigation on the discovery of 12 perfluorinated surfactants (PS) in different surface and drinking waters (Skutlarek et al. 2006 a, Skutlarek et al. 2006 b). In the last years, many studies have reported ubiquitous distribution of this group of perfluorinated chemicals, especially perfluorooctane sulfonate (PFOS) and perfluorooctanoic acid (PFOA) in the environment, particularly in wildlife animal and human samples (Giesy and Kannan 2001, Houde et al. 2006, Prevedouros et al. 2006). Perfluorinated surfactants (e.g. PFOS and PFOA) have shown different potentials for reproductory interference and carcinogenity in animal experiments as well as partly long half-lives in humans (Guruge et al. 2006, FSA UK 2006a, FSA UK 2006b, 3M 2005, OECD 2002, Yao and Zhong 2005). They possess compound-dependent extreme recalcitrance against microbiological and chemical degradation and, in addition, they show variable potentials for bioaccumulation in animals and humans (Houde et al. 2006). Materials and Methods: Surface and drinking water samples were collected from different sampling sites: - Surface waters: samples taken from the rivers Rhine, Ruhr, Moehne and some of their tributaries. Further samples were taken from the Rhine-Herne-Canal and the Wesel-Datteln-Canal. - Drinking waters: samples taken in public buildings of the Rhine-Ruhr area. After sample clean-up and concentration by solid-phase extraction, the perfluorinated surfactants were determined using HPLC-MS/MS. Results: All measured concentrations (sum of seven mainly detected components) in the Rhine river and its main tributaries (mouths) were determined below 100 ng/L. The Ruhr river (tributary of the Rhine) showed the highest concentration (94 ng/L), but with a completely different pattern of components (PFOA as major component), as compared with the other tributaries and the Rhine river. Further investigations along the Ruhr river showed remarkably high concentrations of PS in the upper reaches of the Ruhr river and the Moehne river (tributary of the Ruhr) (Ruhr: up to 446 ng/L, Moehne: up to 4385 ng/L). The maximum concentration of all drinking water samples taken in the Rhine-Ruhr area was determined at 598 ng/L with the major component PFOA (519 ng/L). Discussion: The surface water contaminations most likely stem from contaminated inorganic and organic waste materials (so-called 'Abfallgemisch'). This waste material was legally applied to several agricultural areas on the upper reaches of the Moehne. Perfluorinated surfactants could be detected in some suchlike soil samples. They contaminated the river and the reservoir belonging to it, likely by superficial run-off over several months or probably years. Downstream, dilution effects are held responsible for decreasing concentrations of PS in surface waters of the Moehne and the Ruhr river. In analogy to the surface water samples, PS (major component PFOA) can be determined in many drinking water samples of the Rhine-Ruhr area where the water supplies are mainly based on bank filtration and artificial recharge. Conclusions: The concentrations found in drinking waters decreased with the concentrations of the corresponding raw water samples along the flow direction of the Ruhr river (from east to west) and were not significantly different from surface water concentrations. This indicates that perfluorinated surfactants are at present not successfully removed by water treatment steps. Recommendations and Perspectives: Because of their different problematic properties (persistence, mobility, toxicity, bioaccumulation), the concentrations of specific perfluorinated surfactants and their precursors in drinking waters and food have to be minimised. Therefore, it is of utmost importance to take the initiative to establish suitable legal regulations (limitations/ban) concerning the production and use of these surfactants and their precursors. Furthermore, it is indispensable to protect water resources from these compounds. A discussion on appropriate limit values in drinking water and foodstuffs is urgently needed. Concerning the assumed soil contamination, the corresponding regulation (Bioabfall-Verordnung 1998 – Regulation on Organic Waste 1998) should be extended to allow the control of relevant organic pollutants.     

环境空气中痕量挥发性有机硫监测分析方法研究

采用预浓缩系统与GC MS联用,建立了环境空气中痕量挥发性有机硫的分析方法,该法用苏玛罐或Tedlar袋采集空气样品在预浓缩系统中经液氮于-160℃冷冻浓缩后,进入GC MS进行分析。甲硫醇、乙硫醇、甲硫醚、乙硫醚、二甲二硫的最低检出限分别为2 0、1 0、1 0、1 0、0 5μg m3。经6次的重复测定,其相对标准偏差小于9 0%。该方法已用于环境空气的测定,取得了令人满意的结果。     

Pipeline leakage detection and isolation: An integrated approach of statistical and wavelet feature extraction with multi-layer perceptron neural network (MLPNN)

Leakage diagnosis of hydrocarbon pipelines can prevent environmental and financial losses. This work proposes a novel method that not only detects the occurrence of a leakage fault, but also suggests its location and severity. The OLGA software is employed to provide the pipeline inlet pressure and outlet flow rates as the training data for the Fault Detection and Isolation (FDI) system. The FDI system is comprised of a Multi-Layer Perceptron Neural Network (MLPNN) classifier with various feature extraction methods including the statistical techniques, wavelet transform, and a fusion of both methods. Once different leakage scenarios are considered and the preprocessing methods are done, the proposed FDI system is applied to a 20-km pipeline in southern Iran (Goldkari-Binak pipeline) and a promising severity and location detectability (a correct classification rate of 92%) and a low False Alarm Rate (FAR) were achieved.     

A summary and synthesis of procedural regulations and standards—Informing a procedures writer's guide

Well-written procedures are an integral part of any industrial organization for safe operation, managing risks, and continuous improvement. Regulatory bodies around the world require industries to have current, accurate, and appropriate procedures for most processes. Although the importance of procedures is recognized by all industries in general, significant incidents still occur due to procedural breakdowns. Some of the procedural breakdowns come from obvious problems such as the procedure not being available or the procedure being wrong. However, some incidents have occurred when correct procedures were available and the operator used those procedures. In these instances, the reason workers do not follow procedures correctly may be attributable the procedure being presented or designed in a manner that does not sufficiently communicate the information in a manner that is easily and quickly understood. This indicates that procedure writers may need more guidance on how to write and design procedures so they accomplish this. To effectively manage risk, procedures need to be technically correct (and regulatory compliant) and usable. As part of this, the current work is focused on developing a systematic approach to a procedure writer's guide that includes a regulatory compliant component. The work presented here consists of an effort to identify procedure-writing practices necessary to ensure regulatory compliance by summarizing a large sample of regulations and standards from several industries. The regulations and standards were organized to reflect common ideas and the implications in terms of human factors needs for procedure design were identified. This information will be used as part of the development of a writer's guide that accounts for human factors (HF) that includes explanations of HF implications and empirical support for each of the guidelines. The novelty of the method and information presented here is in the idea of leveraging the cumulative information available regarding procedures in regulations and standards. Incorporating this information into a procedure's writers guide in this manner may not only facilitate procedure being regulatory compliant for facilities in different geographies of the world, but could also support their being written with considerations for human performance.     

厌氧-好氧活性污泥法处理高浓度甲醇废水

介绍了厌氧一好氧活性污泥法处理电管厂高浓度甲醇废水的动态试验结果。试验结果表明：该方法处理高浓度甲醇废水,可以克服甲醇废水厌氧处理容易酸化的问题．运行稳定．抗负荷冲击性强．处理效果良好。     

富勒烯甘氨酸铜盐的制备及表征

以富勒烯和甘氨酸为原料合成富勒烯甘氨酸,再与硝酸铜反应得到富勒烯甘氨酸铜盐。通过单因素方法探讨了反应温度、反应时间、反应物物料比对目标物富勒烯甘氨酸铜盐中铜质量分数的影响。获得最佳工艺条件为:富勒烯甘氨酸和硝酸铜的摩尔比1∶5,反应时间2.0 h,反应温度35℃。此时富勒烯甘氨酸铜盐中铜质量分数为17.8%。同时用FT-IR、MS、元素分析及原子吸收等方法表征了产物的结构。用差热仪测试了富勒烯甘氨酸铜盐的热稳定性,表明产物具有良好的热稳定性。     

而今迈步从头越——《安全生产法》征求意见稿学习体会和修改建议

首先分析了我国《安全生产法》的发展沿革,且认真学习了目前发布的《安全生产法》征求意见稿,归纳了征求意见稿还应实现四个重点突破:必须体现以人为本的执政理念;职业危害防治应列为《安全生产法》的重要条款之一;安全生产执法监察应与公共安全及行政管理分离;应对工伤保险预防机制作出明确要求。此外,建议通过《安全生产法》的进一步修订实现我国安全生产的制度化建设:建议逐步建立安全生产分级监察管理体制;推进风险管理制度,对企业实行风险分级与分级监管;逐步提出建立安全生产监察员专业化制度;建立与国际接轨的生产安全事故统计报告系统;强化城市建设土地使用规划的风险管理和安全许可;生产安全事故应急管理应强化应急准备工作;建立独立生产安全事故调查机构和公开公正调查程序;应在《安全生产法》中明确"安全生产委员会"的组织形式和功能;生产安全事故责任追究应与激励政策相结合。