气体二氧化氯对葡萄表面细菌杀菌规律研究

研究气体二氧化氯杀灭金黄色葡萄球菌、大肠杆菌、李斯特单增菌和腐生酵母菌4种葡萄表面的危险致病菌的杀菌规律。在实验范围内,随着气体二氧化氯浓度的增加和杀菌时间的延长,杀菌效果明显增加。当杀菌时间超过12min,杀菌量级几乎不再增加。杀菌效率随温度的增加而减小,在实验温度条件下,只有大肠杆菌的杀菌效果减少了5.38～6.09log量级,其他3种菌均减少了6log量级以上,杀菌作用温度在实验条件下对杀菌效果影响不大。研究表明,当气体二氧化氯的杀菌浓度为25mgl-1、杀菌时间12min、杀菌温度25℃的条件下,金黄色葡萄球菌、李斯特单增菌和腐生酵母菌均减少了6.4log量级以上,而大肠杆菌达到5.76log量级;同时表明二氧化氯气体的杀菌保鲜功能也是食品安全技术非热杀菌手段。     

The role of periodic boundary forcing in plankton pattern formation

We consider one and two-dimensional minimal models in plankton dynamics. The influence of oscillating boundary forcing functions as agents for triggering pattern formation is discussed. In particular it is found that in these conditions population waves arise for one dimensional models, while for two dimensional models, different amplitudes and frequencies in the boundary forcing generate definite patterns, mimicking the boundary term. This happens even though the model we investigate is very simple. The emergence of these features is an interesting metaphor for the fundamental biological problem of how pattern formation processes may be inevitable in natural heterogeneous ecosystems.     

分子筛生产废水中悬浮物的絮凝与回用

对分子筛生产废水进行了絮凝沉降分离试验，确定了絮凝剂、助凝剂及絮凝敢分离条件。试验结果表明，絮凝沉降所得到的絮凝物料的化学组成、结构、性能与絮凝前原废水中的悬浮物基本一致，可返回原生产工序中使用。     

含氟废气对农业环境的影响

叙述了某厂氢氟酸生产过程排出的含氟废气对厂区周围水稻和蔬菜的污染及其与气象条件的关系，并提出了防止农业环境氟污染的措施。     

O／W型乳化液的处理

采用药剂破乳－电解破乳工艺处理Ｏ／Ｗ型乳化液，药剂破乳选用聚合硫酸铁为破乳剂，破乳时最佳ＰＨ为８，聚合硫酸铁的最佳投量为１５００ｍｇ／Ｌ，电解破乳选用铁作阳极，铝作阴极，电流密度０．８６Ａ／ｄｍ＾２，极距２５ｍｍ，电解时间３ｈ。在上述条件下，破乳效果良好，出水清澈透明，ＣＯＤ总去除率可达到９６－９７％。     

火灾发生率空间分异及影响因素研究

为了探究我国火灾空间聚集特征与影响因素的空间异质性,采用全局莫兰指数、局部莫兰指数、逐步回归模型、地理加权回归模型、地理探测器方法对我国地级市单元进行研究。研究结果表明:我国火灾发生率具有显著的聚集性;我国火灾发生率较低的“冷点”区域有1个,火灾发生率较高的“热点”区域有4个;人均GDP、城镇居民人均可支配收入、人口密度、年平均气温4 个因素的影响效应具有空间异质性。人均GDP与火灾发生率为正相关,另外3影响因素对火灾发生率的作用表现出正负2种相关关系;2因素交互作用要比单因素作用于火灾发生率时影响力更显著,各影响因素的交互作用类型有非线性增强型和双因子增强型2种。     

Before the crash: A systematic analysis of police narratives to determine the prevalence of pre-crash factors in fatality road transport crashes

Abstract

Objectives: The objectives of this study were to identify the prevalence of pre-crash factors that were present in fatal road transport crashes for the deceased and counterpart road user.

Methods: The study is a retrospective population-based case series study of transport-related deaths reported to coroners in Australia from 2013 to 2016. Data was extracted from the National Coronial Information System.

Results: In total, 6,137 fatality crashes occurred during the study period. Police reports were available for 5,523 crashes (89.9%). The most frequently reported pre-crash factors reported behaviour specifically drivers (e.g., driving without a license or while license was disqualified). Presence of intoxicating substances were also reported in the deceased and counterparts. Analyses of toxicology reports are continuing to determine if rates are comparable to level of use in community.

Conclusions: Coronial report provide detailed information that may be pertinent to understanding and potentially preventing crashes. Also emerging from the data is the extent of pre-crash factors that relate to illegal or deviant behavior and whether these are contextual or contributory factors.     

Forensic Evaluation of Metals (Cr,Cu, Pb,Zn), Isotopes (δ13C and δ15N), and C:N Ratios in Freshwater Sediment

A forensic approach was used to evaluate sediments from Portão Stream, including analysis of metals, carbon (C) and nitrogen (N) stable isotopes, and C:N ratios. Samples collected at various points located along the stream were tested in order to investigate a possible illegal leachate input. The studied stream is heavily impacted by sewage and industrial discharges from two cities along its course. Among the metals analyzed, chromium (Cr) was noticeably the main pollutant, showing the highest levels, above regulatory limits, downstream from some potential sources of effluents enriched with this metal. Isotope analyses revealed a general trend of depletion in the heavier isotope along the stream for C and N. The exception was one point near a hazardous waste landfill, where relatively more enriched δ¹³C and δ¹⁵N values were found. The isotope and metal analysis results indicated that this site was affected by a particular source, demonstrating the combination of these parameters could be used for the discrimination of sources in a heavily polluted stream. Nevertheless, further investigations are necessary to provide a comprehensive evaluation of the biogeochemical processes involved in the incorporation of leachate in sediments to use this analysis as evidence for the illegal leachate discharge.     

Using multivariate regression modeling for sampling and predicting chemical characteristics of mixed waste in old landfills

Municipal solid waste landfills pose a threat on environment and human health, especially old landfills which lack facilities for collection and treatment of landfill gas and leachate. Consequently, missing information about emission flows prevent site-specific environmental risk assessments. To overcome this gap, the combination of waste sampling and analysis with statistical modeling is one option for estimating present and future emission potentials. Optimizing the tradeoff between investigation costs and reliable results requires knowledge about both: the number of samples to be taken and variables to be analyzed.This article aims to identify the optimized number of waste samples and variables in order to predict a larger set of variables. Therefore, we introduce a multivariate linear regression model and tested the applicability by usage of two case studies. Landfill A was used to set up and calibrate the model based on 50 waste samples and twelve variables. The calibrated model was applied to Landfill B including 36 waste samples and twelve variables with four predictor variables.The case study results are twofold: first, the reliable and accurate prediction of the twelve variables can be achieved with the knowledge of four predictor variables (Loi, EC, pH and Cl). For the second Landfill B, only ten full measurements would be needed for a reliable prediction of most response variables. The four predictor variables would exhibit comparably low analytical costs in comparison to the full set of measurements. This cost reduction could be used to increase the number of samples yielding an improved understanding of the spatial waste heterogeneity in landfills.Concluding, the future application of the developed model potentially improves the reliability of predicted emission potentials. The model could become a standard screening tool for old landfills if its applicability and reliability would be tested in additional case studies.     

Chemical oxidation of sulfadiazine by the Fenton process: Kinetics,pathways, toxicity evaluation

This paper investigated sulfadiazine oxidation by the Fenton process under various reaction conditions. The reaction conditions tested in the experiments included the initial pH value of reaction solutions, and the dosages of ferrous ions and hydrogen peroxide. Under the reaction conditions with pH 3, 0.25 mM of ferrous ion and 2 mM of hydrogen peroxide, a removal efficiency of nearly 100% was achieved for sulfadiazine. A series of intermediate products including 4-OH-sulfadiazine/or 5-OH-sulfadiazine, 2-aminopyrimidine, sulfanilamide, formic acid, and oxalic acid were identified. Based on these products, the possible oxidation pathway of sulfadiazine by Fenton's reagent was proposed. The toxicity evaluation of reaction solutions showed increased antimicrobial effects following the Fenton oxidation process. The results from this study suggest that the Fenton oxidation process could remove sulfadiazine, but also increase solution toxicity due to the presence of more toxic products.