Visible leaf injury in young trees of Fagus sylvatica L. and Quercus robur L. in relation to ozone uptake and ozone exposure. An Open-Top Chambers experiment in South Alpine environmental conditions

An Open-Top Chambers experiment on Fagus sylvatica and Quercus robur seedlings was conducted in order to compare the performance of an exposure-based (AOT40) and a flux-based approaches in predicting the appearance of ozone visible injuries on leaves. Three different ozone treatments (charcoal-filtered; non-filtered; and open plots) and two soil moisture treatments (watered and non-watered plots) were performed. A Jarvisian stomatal conductance model was drawn up and parameterised for both species and typical South Alpine environmental conditions, thus allowing the calculation of ozone stomatal fluxes for every treatment. A critical ozone flux level for the onset of leaf visible injury in beech was clearly identified between 32.6 and 33.6 mmolO3 m(-2). In contrast, it was not possible to identify an exposure critical level using the AOT40 index. Water stress delayed the onset of the leaf visible injuries, but the flux-based approach was able to take it into account accurately.     

A new tracer technique for monitoring groundwater fluxes: the Finite Volume Point Dilution Method

Quantification of pollutant mass fluxes is essential for assessing the impact of contaminated sites on their surrounding environment, particularly on adjacent surface water bodies. In this context, it is essential to quantify but also to be able to monitor the variations with time of Darcy fluxes in relation with changes in hydrogeological conditions and groundwater - surface water interactions. A new tracer technique is proposed that generalizes the single-well point dilution method to the case of finite volumes of tracer fluid and water flush. It is called the Finite Volume Point Dilution Method (FVPDM). It is based on an analytical solution derived from a mathematical model proposed recently to accurately model tracer injection into a well. Using a non-dimensional formulation of the analytical solution, a sensitivity analysis is performed on the concentration evolution in the injection well, according to tracer injection conditions and well-aquifer interactions. Based on this analysis, optimised field techniques and interpretation methods are proposed. The new tracer technique is easier to implement in the field than the classical point dilution method while it further allows monitoring temporal changes of the magnitude of estimated Darcy fluxes, which is not the case for the former technique. The new technique was applied to two experimental sites with contrasting objectives, geological and hydrogeological conditions, and field equipment facilities. In both cases, field tracer concentrations monitored in the injection wells were used to fit the calculated modelled concentrations by adjusting the apparent Darcy flux crossing the well screens. Modelling results are very satisfactory and indicate that the methodology is efficient and accurate, with a wide range of potential applications in different environments and experimental conditions, including the monitoring with time of changes in Darcy fluxes.     

塔克拉玛干沙漠和青藏高原地区沙尘气溶胶光学特性及其加热率的时空分布特征

沙尘不同的垂直分布对大气的加热作用不同,通过卫星观测结合数值模拟,可以更清楚地了解沙尘辐射加热作用,有利于理解沙尘对该地区大气热结构的影响机制.因此,本研究利用CALIPSO气溶胶产品和SBDART模式,分析了2007—2020年塔克拉玛干沙漠和青藏高原沙尘气溶胶及其短波加热率的时空分布特征.结果表明,塔克拉玛干沙漠和青藏高原的年平均沙尘气溶胶光学厚度（DAOD,532 nm）分别为0.300～0.350和0.086～0.108,平均值分别为0.328和0.097.塔克拉玛干沙漠季节平均DAOD的最大、最小值分别出现在春季和冬季,而青藏高原的最大、最小值分别出现在夏季和秋季.塔克拉玛干沙漠和青藏高原的沙尘消光系数（σD）最大值分别出现在春季和夏季.2007—2020年,两地的σD在春季均呈增加趋势,而在秋季则呈减小趋势.春季和夏季的短波沙尘加热率（SW DHR）均大于其它两个季节,其中春季最大,塔克拉玛干沙漠上空冬季最弱,青藏高原上空秋季最弱.春夏季,青藏高原北坡存在较强沙尘加热层,其顶部高于5 km,其强度及高值区从春季到冬季逐渐减小.从年变化来看,春季短波加热率呈加强趋势,秋季呈减...     

广州市居民家庭室内灰尘中传统和新型阻燃剂与塑化剂的污染特征及健康风险评估

近年来,随着阻燃剂多溴联苯醚(PBDEs)和以邻苯二甲酸酯(PAEs)为代表的传统型塑化剂(LPs)的逐步禁用或限用,有机磷系阻燃剂(PFRs)等新型阻燃剂及替代型塑化剂(APs)的生产和使用呈逐年增长的趋势,其环境污染特征和人体暴露健康风险值得引起广泛关注.目前,灰尘已广泛用于室内环境中PBDEs、PFRs和LPs等半挥发性有机污染物(SVOCs)的污染特征评估,而关于室内灰尘中APs的污染特征则鲜有报道.本研究以广州市42户普通居民家庭为研究对象,采集家庭室内灰尘并分析了PFRs、PBDEs、LPs和APs的含量及组成特征.结果表明,PFRs、PBDEs、LPs和APs在室内灰尘中均有广泛检出,其含量分别为593.28～11531.56、13.45～27029.13、40494.83～1154497.16和15365.19～1013352.51 ng·g^-1.大多数家庭中,PFRs和部分APs在灰尘中的含量呈现高于PBDEs和LPs的特征,PFRs和APs等新型污染物的人体暴露健康风险需引起高度关注.采用暴露模型评估人体经灰尘摄入和皮肤接触对目标污染物的日均暴...     

北京城区冬季道路灰尘粒度特征分析

对2013年1月于北京城区采集的40组道路灰尘样品用激光粒度仪进行粒度测定。结果表明:北京城区冬季道路灰尘频率曲线呈单峰态或双峰态分布,单峰型峰值粒径为112~237μm,双峰型第一峰值粒径为189~286μm,第二峰值粒径为42~57μm。道路灰尘平均粒径为183μm,分选性差,呈极不对称的极正偏宽峰态到窄峰态,属砂土。道路灰尘是局地灰尘和区域灰尘的混合物,且主要为跃移或短时悬浮颗粒物,对大气悬浮颗粒污染物的贡献量不大。研究4种不同道路类型灰尘发现,平均粒径从大到小顺序为快速路支路次干路主干路,分选系数与偏度为快速路主干路次干路支路,峰度无较大区别,细颗粒含量主干路次干路(支路、快速路)。主干路灰尘污染贡献率更高,对大气环境和人体健康的危害潜力不容忽视。     

“十一五”期间新疆大气降尘量时空分布特征及影响因素分析

通过对"十一五"期间新疆134个大气降尘监测点位数据进行统计分析发现,"十一五"期间,全疆年均降尘量维持在22.2~24.6 t/km2.月,变化幅度小于10%。一年内降尘主要集中在3~6月份,占全年降尘量的51%。在空间分布上,新疆年均降尘量呈现明显的南疆高于北疆的特征,南疆五地、州的总降尘量占全疆总降尘量的70.2%,为新疆降尘的主要集中区。特殊的气象、生态环境是决定新疆大气降尘时空分布特征的主要因素。     

金属粉尘湿法处理系统的设计和除尘效果分析

为改善金属抛光操作人员的工作环境、降低抛光金属粉尘的爆炸风险,设计一种金属粉尘湿法处理系统,并通过建立多相流动数值模型,探究其内部流场特征与金属粉尘运动规律,分析金属粉尘湿法处理系统的除尘效率。研究结果表明:大粒径的金属粉尘直接重力沉降至水槽中;小粒径(PM10)的金属粉尘易随气流进入风道,进而通过水雾脱除;采用洁净进气源,可以有效降低工人操作环境的粉尘浓度;增加细水雾,可以有效提高金属粉尘湿法处理系统的除尘效率,对PM10的除尘效率从30%提升至82%。     

水平管内不同煤质煤尘爆炸火焰传播特性实验研究

为研究水平管道空间不同煤质煤尘爆炸火焰传播特性,选取褐煤、长焰煤、不粘煤、气煤4种煤尘,对爆炸火焰焰峰特性、火焰加速传播特性、火焰传播距离与持续时间展开研究。研究结果表明:褐煤在500 ms内焰峰的形状由尖锐向平滑再向钝化不断演变,长焰煤与不粘煤在375 ms时焰峰前端出现明显焰体分离现象,分析认为这与管体冷壁效应、空间尺度效应及空间氧气消耗直接相关;气煤在375 ms时焰峰出现大面积火焰碎纹,说明气煤爆炸火焰猛烈传播的持续时间相对较短,整体爆炸强度相对较弱;褐煤与长焰煤爆炸火焰存在2次间断性加速,分析认为这与管体空间受限、常温管壁散热、局部助燃氧气瞬间不足等因素有关;褐煤在爆炸后400～600 ms内火焰2次加速完全,火焰传播距离达740 mm,明显大于长焰煤、不粘煤与气煤,说明低变质褐煤爆炸火焰持续时间更长,火焰传播距离更远且传播更剧烈;虽然气煤火焰最远传播距离比长焰煤大30 mm,但由于气煤火焰在375 ms左右出现大片火焰碎纹,因此气煤整体的爆炸强度小于长焰煤。     

钢铁企业大型低位料仓汽车卸料的粉尘控制

某钢企大型低位料仓为汽车卸料,料仓厂房内空高,跨度大,料仓上部贯通,物料落差大,卸料中产生大量粉尘,环境污染问题典型突出。通过对低位料仓汽车卸料产尘特性分析,采取加强生产管理、组织汽车有序卸料、料仓厂房有效密闭、合理设计捕尘方式和布袋除尘系统等措施,能够有效地控制粉尘污染。除尘系统具有投资及运行费用少,除尘效果明显的优点。     

浙江省工业烟粉尘总量控制研究

通过对浙江省工业烟粉尘排放总量和排放源现状进行分析,提出工业烟粉尘减排治理对策,对工业烟粉尘4个重点行业(水泥制造行业、火力发电行业、钢铁行业(包括炼钢、钢压延加工和黑色金属铸造行业)、纺织染整行业(包括棉印染精加工、化纤织物染整精加工和棉织造加工行业)排放源的烟粉尘减排途径和潜力进行分析测算,研究提出工业烟粉尘总量控制措施和建议。