水力冲孔技术在大倾角薄煤层中的应用

针对矿井现有防突措施的不足,介绍了水力冲孔技术的设备、工艺流程及现场试验情况.研究表明,在大倾角薄煤层应用水力冲孔技术,可有效地消除激发突出的应力,大幅度地释放煤体中的瓦斯,能明显提高瓦斯的抽采效果,很好地起到了综合防突的作用,且石门揭煤周期缩短为2个月.     

强化浅基质层干植草沟对道路径流的脱氮效果

搭建6个不同结构和介质组成的浅基质层干植草沟模拟柱,在基质层添加较多发酵木屑,利用进水期的脱氮作用,并设置饱水层提高设施落干期脱氮能力,从而强化设施全周期脱氮效果.以半人工道路径流作为进水,考察各模拟柱运行效果,并结合分层取样水质检测结果和模拟柱内体积含水率、ORP的变化过程,分析氮素在不同模拟柱内的去除机制.结果表明:在运行参数相对实际应用环境更为不利的条件下,设置饱水层的模拟柱的TN去除率在67%～78%; TN去除过程主要发生在进水期,且在含较多发酵木屑的基质层即被大量去除;设置饱水层不仅可提高落干期设施脱氮能力,还可保证较浅的基质层在进水期快速达到适宜反硝化的缺氧条件,从而保证进水期设施的脱氮效果;设置持水性过渡层并在其中放置有机质可以有效平衡饱水层碳源补给并控制有机质淋失的问题.     

液压振动台时域建模与仿真

基于Matlab/Simulink建立了液压振动台系统时域仿真模型,模型包括信号给定、油泵、溢流阀、蓄能器、伺服阀、控制器、液压缸、位移测量等模块。针对大流量动圈伺服阀,按物理规律和常见因素建模,特别考虑了瞬间油液回流情况。仿真算例结果表明,仿真获得的振动位移、速度、加速度响应波形及其他相关波形与实际振动台波形有良好的相似性。建模时考虑了尽可能多的因素,仿真获得了真实的波形特征,可为振动台系统设计提供较好参考。     

滨海生态景观河道对污水处理厂出水净化效果研究

为了探讨天津滨海泰达生态景观河道对污水处理厂出水深度净化的效果,2009年对该河道水体进行监测分析,结果表明该河道对氮、磷营养盐具有良好的可持续净化能力,河道出水达到景观环境用水的再生水水质标准,出水TN、NH3-N、TP和PO43-平均浓度分别为1.49mg/L、0.75mg/L、0.16mg/L和0.01mg/L,相应去除率分别达到93.38%、41.13%、88.09%和98.16%;沿程水体COD和TDS变化规律不明显,去除效果不理想;河道中端与出水端水体水质相近,建议在今后相似工程中可以适当提高河道式湿地的水力负荷。     

Hydraulic characteristics of an anaerobic baffled reactor as onsite wastewater treatment system

The feasibility of using anaerobic baffled reactor(ABR)as onsite wastewater treatment system was discussed.The ABR consisted of one sedimentation chamber and three up-flow chambers in series was experimented under different peak flow factors(PFF of 1 to 6),superficial gas velocities(between 0.6 and 3.1 cm/hr)and hydraulic retention times(HRT)(24,36 and 48 hr).Residence time distribution(RTD)analyses were carried out to investigate the hydraulic characteristics of the ABR.It was found that the PFF resulted in hydraulic dead space.The dead space did not exceed 13% at PFF of 1,2 and 4 while there was 2-fold increase(26%)at PFF of 6.Superficial gas velocities did not result in more(biological)dead space.The mixing pattern of ABR tended to be a completelymixed reactor when PFF increased.Superficial gas velocities did not affect mixing pattern.The effects of PFF on mixing pattern could be minimized by higher HRT(48 hr).The tank-in-series(TIS)model(N=4)was suitable to describe the hydraulic behaviour of the studied system.The HRT of 48 hr was able to maintain the mixing pattern under different flow patterns,introducing satisfactory hydraulic efficiency.Chemical oxygen demand(COD)and total suspended solids(TSS)removals under all flow patterns were achieved more than 85% and 90%,respectively.The standard deviation of effluent COD and TSS concentration did not exceed 15 mg/L.     

Effects of operational factors on soluble microbial products in a carrier anaerobic baffled reactor treating dilute wastewater

The effects of feed strength,hydraulic residence time(HRT),and operational temperatures on soluble microbial product(SMP) production were investigated,to gain insights into the production mechanism.A carrier anaerobic batfled reactor (CABR) treating dilute wastewater was operated under a wide range of operational conditions,namely,feed strengths of 300-600 mg/L,HRTs of 9-18 h,and temperatures of 10-28℃.Generally, SMP production increased with increasing feed strength and decreasing temperature.At high temperature (28℃),SMP production increased with decreasing HRT. As the temperature Was decreased to 18 and 10℃.the SMP production was at its peak for 12 h HRT Therefore,temperature could be an important determinant of SMP production along with HRT. A higher SMP to soluble chemical oxygen demand (SCOD) ratio Was found at high temperature and long HRT because of complete volatile fatty acid degradation.SMP accounted for 50%-75% of the SCOD in the last chamber of the CABR.As a secondary metabolite.some SMP could be consumed at lower feed strength.     

Hydraulic model for multi-sources reclaimed water pipe network based on EPANET and its applications in Beijing, China

Water shortage is one of the major water related problems for many cities in the world. The planning for utilization of reclaimed water has been or would be drafted in these cities. For using the reclaimed water soundly, Beijing planned to build a large scale reclaimed water pipe networks with multi-sources. In order to support the plan, the integrated hydraulic model of planning pipe network was developed based on EPANET supported by geographic information system (GIS). The complicated pipe network was divided into four weak conjunction subzones according to the distribution of reclaimed water plants and the elevation. It could provide a better solution for the problem of overhigh pressure in several regions of the network. Through the scenarios analysis in different subzones, some of the initial diameter of pipes in the network was adjusted. At last the pipe network planning scheme of reclaimed water was proposed. The proposed planning scheme could reach the balances between reclaimed water requirements and reclaimed water supplies, and provided a scientific basis for the reclaimed water utilization in Beijing. Now the scheme had been adopted by Beijing municipal government.     

水力坡度对溪流钙华沉积的影响

在有钙华沉积的云南白水台景区引水渠道中,通过水准测量以及导线测量的方法,获得了引水渠道各研究点的相对高程和距离。利用流速仪测定了各研究点的水流流速,通过计算获得了各研究点的总水头和水力坡度。利用水化学记录仪,在短时间内测定了各研究点的电导率、水温与pH值,结合现场滴定以及室内水样分析的结果,计算出各点的方解石饱和指数和二氧化碳分压。发现在方解石饱和指数大于0.8的研究渠段,电导率、Ca2+和HCO3-浓度沿水流方向降低,经成因分析与数学推导,得出Ca2+浓度与总水头呈线性关系,水力坡度与渠段上的钙华沉积量也呈线性关系,这是岩溶作用动力学扩散边界层控制理论的具体体现,也即水力坡度越大,流速越快,扩散边界层越薄,碳酸钙沉积速率越大。     

后曝气池HRT对改进型A_2N工艺脱氮除磷性能的影响

对A2N连续流工艺进行改进,在后曝气池中填加生物膜填料,以生活污水为处理对象,考察了后曝气池水力停留时间(HRT)对后曝气池内同步硝化反硝化(SND)以及对改进后的A2N工艺除磷脱氮性能的影响.后曝气池HRT为1.3h时,总磷(TP)平均去除率为90%,总氮(TN)平均去除率为75%,但平均出水氨氮浓度较高(为8.6 mg.L-1),后曝气池内基本未发现SND现象.后曝气池HRT为2.3h时,TN平均去除率达到80%,TP平均去除率高达95%,出水平均氨氮浓度较低(2.2 mg.L-1),后曝气池内同步硝化反硝化去除的TN量为2.42 mg.L-1.后曝气池HRT为4h、6h时,工艺TP平均去除率逐渐下降至60%,由于可利用的COD值较低,同步硝化反硝化去除的TN并未随HRT延长而有明显增长,TN去除率也逐渐降至接近60%.试验证明在后曝气池内填加生物膜并合理调控HRT,可强化工艺的脱氮除磷效果.     

中试清水池水力条件对氯消毒效率的影响

以枯草杆菌黑色变种芽孢为目标微生物,以紫外线消毒后的炭滤池出水为进水,在中试清水池模型中模拟氯消毒过程,通过改变清水池导流板数目获得不同的水力条件,研究清水池水力条件对氯消毒效率的影响.结果表明,在本试验中,不同水力条件下以Ct10值计算的NaClO对枯草杆菌黑色变种芽孢的灭活系数之间相互一致,而不同水力条件下以CT值计算的NaClO对枯草杆菌黑色变种芽孢的灭活系数之间相差很大,表明Ct10是评价清水池消毒效率的合理指标;在Ct10=(100~300)mg.min/L的范围内,NaClO对枯草杆菌黑色变种芽孢的灭活系数为0.0016 L/(mg.min),与其他研究者的结果具有很好的一致性;清水池水力条件的改善可以提高消毒效率,在CT=(100~700)mg.min/L的范围内,当CT值固定时,随着清水池内导流板数增多,水力条件得到改善,t10增加,目标菌种的灭活率显著提高.