A detailed field-based evaluation of naphthenic acid mobility in groundwater

An anaerobic plume of process-affected groundwater was characterized in a shallow sand aquifer adjacent to an oil sands tailings impoundment. Based on biological oxygen demand measurements, the reductive capacity of the plume is considered minimal. Major dissolved components associated with the plume include HCO₃, Na, Cl, SO₄, and naphthenic acids (NAs). Quantitative and qualitative NA analyses were performed on groundwater samples to investigate NA fate and transport in the subsurface. Despite subsurface residence times exceeding 20 years, significant attenuation of NAs by biodegradation was not observed based on screening techniques developed at the time of the investigation. Relative to conservative tracers (i.e., Cl), overall NA attenuation in the subsurface is limited, which is consistent with batch sorption and microcosm studies performed by other authors. Insignificant biological oxygen demand and low concentrations of dissolved As (< 10 µg L^− 1) in the plume suggest that the potential for secondary trace metal release, specifically As, via reductive dissolution reactions driven by ingress of process-affected water is minimal. It is also possible that readily leachable As is not present in significant quantities within the sediments of the study area. Thus, for similar plumes of process-affected groundwater in shallow sand aquifers which may occur as oil sands mining expands, a reasonable expectation is for NA persistence, but minimal trace metal mobilization.     

低压稳流过滤器的研制及在油田污水处理中的应用

为了解决大庆油田现有核桃壳、石英砂过滤器反冲洗憋压、跑料和滤料再生困难等问题,在对原有过滤装置分析的基础上,根据反冲洗特性,对过滤器进行了改造,开发出低压稳流核桃壳过滤器和低压稳流石英砂过滤器。经现场测试,核桃壳过滤器反冲洗压力由原来的0.15～0.5 MPa降低到0.03～0.08 MPa,石英砂过滤器反冲洗压力由原来的0.27～0.46 MPa降低到0.17～0.20 MPa,且均能实现罐群水反冲洗。改造后核桃壳过滤器出水油平均含量13.4 mg/L,平均去除率为78.1%;出水悬浮物平均含量20.5 mg/L,平均去除率为55%。改造后石英砂过滤器出水油平均含量5 mg/L以下,平均去除率达到75%以上;出水悬浮物平均含量为9.8 mg/L,去除率达到80%以上。为了进一步提高过滤效果,在二级滤前投加絮凝剂形成微絮凝过滤工艺,出水悬浮物可达到3 mg/L,通过两级过滤达到特低渗透地层回注水标准。     

Water Quality Modeling of Municipal Discharges from Sea Outfalls,Mumbai

The island city of Mumbai with a population of about 10 million generates about 2000 million liters per day (mld) of sewage from the seven service areas of the city sewerage network and discharges it into the adjoining west coast and the two creeks in the Arabian Sea. This has resulted in degradation of coastal water quality, contamination of the adjoining beaches and seafronts. The Municipal Corporation of Greater Mumbai has therefore, undertaken the task of delineating appropriate sewage disposal system to achieve cleaner marine ecosystem through marine outfalls at specific locations. This paper presents the results of the mathematical simulations on the impacts of discharge is-a-vis the length of the outfall and level of land treatment apriori. The results of the simulation indicate the level of bacterial pollution to be higher near the diffuser locations as compared to nearshore regions. 48 hsimulation result analysis shows that FC counts nearthe diffuser location will be in the range of 2000–8000 counts per 100 ml.     

Mechanical and toxicological evaluation of concrete artifacts containing waste foundry sand

The creation of metal parts via casting uses molds that are generally made from sand and phenolic resin. The waste generated after the casting process is called waste foundry sand (WFS). Depending on the mold composition and the casting process, WFS can contain substances that prevent its direct emission to the environment. In Brazil, this waste is classified according to the Standard ABNT NBR 10004:2004 as a waste Class II (Non-Inert). The recycling of this waste is limited because its characteristics change significantly after use. Although the use (or reuse) of this byproduct in civil construction is a technically feasible alternative, its effects must be evaluated, especially from mechanical and environmental points of view. Thus, the objective of this study is to investigate the effect of the use of WFS in the manufacture of cement artifacts, such as masonry blocks for walls, structural masonry blocks, and paving blocks. Blocks containing different concentrations of WFS (up to 75% by weight) were produced and evaluated using compressive strength tests (35 MPa at 28 days) and toxicity tests on Daphnia magna, Allium cepa (onion root), and Eisenia foetida (earthworm). The results showed that there was not a considerable reduction in the compressive strength, with values of 35 ± 2 MPa at 28 days. The toxicity study with the material obtained from leaching did not significantly interfere with the development of D. magna and E. foetida, but the growth of the A. cepa species was reduced. The study showed that the use of this waste in the production of concrete blocks is feasible from both mechanical and environmental points of view.     

石英砂滤料表面润湿改性

采用硅烷偶联剂、钛酸酯偶联剂和铝酸酯偶联剂对石英砂进行表面改性,以制备亲油疏水性滤料。研究得出,钛酸酯偶联剂改性石英砂的最佳工艺条件为:偶联剂用量15%,反应温度90℃,搅拌时间15 min;硅烷偶联剂和铝酸酯偶联剂改性石英砂的最佳工艺条件均为:偶联剂用量15%,反应温度110℃,搅拌时间15 min。水对钛酸酯偶联剂改性石英砂滤料的润湿重量由改性前的1.5589 g降低到0.0282 g,水对硅烷偶联剂改性石英砂滤料的润湿重量降低到0.0607 g,水对铝酸酯改性石英砂滤料的润湿重量降低到0.2664 g。静态吸附实验表明,硅烷偶联剂、钛酸酯偶联剂和铝酸酯偶联剂改性石英砂滤料对油的吸附容量分别增加了33.67%、42.87%和22.30%。XPS和FT-IR分析表明,偶联剂均以化学键的方式包覆在石英砂滤料表面,结合稳定。     

山东半岛蓝色经济区海洋生态旅游发展研究

发展海洋生态旅游是实现山东半岛蓝色经济区战略的重要途径之一。在SWOT分析的基础上,指出在山东半岛蓝色经济区发展海洋生态旅游必须明确其动力机制,坚持统筹发展战略,从生态保护、社区参与、区域统筹和产业协同四个方面采取具体的对策。     

环境试验设备参数测量──沙尘试验设备

沙尘试验设备参数的测量,目前没有相关的标准和指导文件。本文给出沙尘试验设备参数测量的一般方法,主要介绍了一种沙尘浓度测量方法。     

海上平台采油工艺设计浅析

文章通过实例,简要阐述了滩海、浅海、深海三种开发模式的特点、主要工艺及其适用性。指出各自存在的问题,并提出相应的建议,为海上勘探开发提供借鉴。     

Impact of Sea Level Rise on Groundwater Salinity in a Coastal Community of South Florida1

Guha, Hillol and Sorab Panday, 2012. Impact of Sea Level Rise on Groundwater Salinity in a Coastal Community of South Florida. Journal of the American Water Resources Association (JAWRA) 48(3): 510-529. DOI: 10.1111/j.1752-1688.2011.00630.x Abstract: Freshwater resources of coastal communities in the United States and world over are threatened by the rate of sea level rise. According to recent estimates by various governmental agencies and climate researchers, the global sea level rise is likely to be between 0.6 and 2.1 m by the year 2100. South Florida is a coastal community and much of its coastline is subject to sea level rise and potential impacts to wetlands and the water resources of the area. To understand what the impact of sea level rise would cause to the groundwater level and salinity intrusion, an integrated groundwater and surface water model was developed for North Miami-Dade and Broward Counties of South Florida. The model was calibrated against daily groundwater heads, base flows in canals, and chloride concentrations for a period of one year and six months. Three separate sensitivity analyses were conducted by increasing the sea level by 0.6, 0.9, and 1.22 m. Results of the simulations shows increase of groundwater heads in some areas from 4 to 15%; whereas the average relative chloride concentrations increased significantly by 100-600% in some wells. The increase in groundwater elevations and chloride concentrations varies from location of the wells and its proximity to the coast. The model results indicate that even a 0.6 m increase in sea level (which is the conservative estimate) is likely to impair the vital freshwater resources in many parts of South Florida.     

Self-inhibition can limit biologically enhanced TCE dissolution from a TCE DNAPL

Biodegradation of trichloroethene (TCE) near a Dense Non Aqueous Phase Liquid (DNAPL) can enhance the dissolution rate of the DNAPL by increasing the concentration gradient at the DNAPL-water interface. Two-dimensional flow-through sand boxes containing a TCE DNAPL and inoculated with a TCE dechlorinating consortium were set up to measure this bio-enhanced dissolution under anaerobic conditions. The total mass of TCE and daughter products in the effluent of the biotic boxes was 3-6 fold larger than in the effluent of the abiotic box. However, the mass of daughter products only accounted for 19-55% of the total mass of chlorinated compounds in the effluent, suggesting that bio-enhanced dissolution factors were maximally 1.3-2.2. The enhanced dissolution most likely primarily resulted from variable DNAPL distribution rather than biodegradation. Specific dechlorination rates previously determined in a stirred liquid medium were used in a reactive transport model to identify the rate limiting factors. The model adequately simulated the overall TCE degradation when predicted resident microbial numbers approached observed values and indicated an enhancement factor for TCE dissolution of 1.01. The model shows that dechlorination of TCE in the 2D box was limited due to the short residence time and the self-inhibition of the TCE degradation. A parameter sensitivity analysis predicts that the bio-enhanced dissolution factor for this TCE source zone can only exceed a value of 2 if the TCE self-inhibition is drastically reduced (when a TCE tolerant dehalogenating community is present) or if the DNAPL is located in a low-permeable layer with a small Darcy velocity.