Visible leaf injury in young trees of Fagus sylvatica L. and Quercus robur L. in relation to ozone uptake and ozone exposure. An Open-Top Chambers experiment in South Alpine environmental conditions

An Open-Top Chambers experiment on Fagus sylvatica and Quercus robur seedlings was conducted in order to compare the performance of an exposure-based (AOT40) and a flux-based approaches in predicting the appearance of ozone visible injuries on leaves. Three different ozone treatments (charcoal-filtered; non-filtered; and open plots) and two soil moisture treatments (watered and non-watered plots) were performed. A Jarvisian stomatal conductance model was drawn up and parameterised for both species and typical South Alpine environmental conditions, thus allowing the calculation of ozone stomatal fluxes for every treatment. A critical ozone flux level for the onset of leaf visible injury in beech was clearly identified between 32.6 and 33.6 mmolO3 m(-2). In contrast, it was not possible to identify an exposure critical level using the AOT40 index. Water stress delayed the onset of the leaf visible injuries, but the flux-based approach was able to take it into account accurately.     

Implementation of a windblown dust parameterization into MODELS-3/CMAQ: Application to episodic PM events in the US/Mexico border

Windblown dust is known to impede visibility, deteriorate air quality and modify the radiation budget. Arid and semiarid areas with unpaved and unvegetated land cover are particularly prone to windblown dust, which is often attributed to high particulate matter (PM) pollution in such areas. Yet, windblown dust is poorly represented in existing regulatory air quality models. In a study by the authors on modeling episodic high PM events along the US/Mexico border using the state-of-the-art CMAQ/MM5/SMOKE air quality modeling system [Choi, Y.-J., Hyde, P., Fernando, H.J.S., 2006. Modeling of episodic particulate matter events using a 3D air quality model with fine grid: applications to a pair of cities in the US/Mexico border. Atmospheric Environment 40, 5181–5201], some of the observed PM₁₀ NAAQS exceedances were inferred as due to windblown dust, but the modeling system was incapable of dealing with time-dependent episodic dust entrainment during high wind periods. In this paper, a time-dependent entrainment parameterization for windblown dust is implemented in the CMAQ/MM5/SMOKE modeling system with the hope of improving PM predictions. An approach for realizing windblown dust emission flux for each grid cell over the study domain on an hourly basis, which accounts for the influence of factors such as soil moisture content, atmospheric stability and wind speed, is presented in detail. Comparison of model predictions with observational data taken at a pair of US/Mexico border towns shows a clear improvement of model performance upon implementation of the dust emission flux parameterization.     

Sensitivity analysis of a parameterization of the stomatal component of the DO3SE model for Quercus ilex to estimate ozone fluxes

A sensitivity analysis of a proposed parameterization of the stomatal conductance (g(s)) module of the European ozone deposition model (DO(3)SE) for Quercus ilex was performed. The performance of the model was tested against measured g(s) in the field at three sites in Spain. The best fit of the model was found for those sites, or during those periods, facing no or mild stress conditions, but a worse performance was found under severe drought or temperature stress, mostly occurring at continental sites. The best performance was obtained when both f(phen) and f(SWP) were included. A local parameterization accounting for the lower temperatures recorded in winter and the higher water shortage at the continental sites resulted in a better performance of the model. The overall results indicate that two different parameterizations of the model are needed, one for marine-influenced sites and another one for continental sites.     

有机物对UF膜过滤通量的影响

采用截留分子量为30000的聚醚砜超滤膜进行膜过滤试验,研究有机物的特性,如亲疏水性以及相对分子质量对超滤膜通量的影响.试验结果表明,过滤亲水性组分时膜通量明显高于过滤疏水性组分.对2种不同水源的试验表明,尽管有机物含量相同,但由于亲疏水性的比例不同,造成的膜通量下降不同.疏水性越大的原水,其膜通量下降也越大.因此,疏水性组分是造成通量下降的主要因素.试验还表明,相对分子质量较大的有机物并非通量下降的主要因素,有机物的分散性可能是影响通量的主要因素.     

屋顶形状对街道峡谷内污染物扩散的影响

采用Spalart-Allmaras湍流模型,通过求解二维连续性方程,Navier-Stokes方程及污染物输运方程,模拟了具有不同屋顶形状的街道峡谷的流场及交通污染物浓度场.计算结果与风洞试验结果总体趋势一致.由于屋顶形状的不同,峡谷内的流场会形成顺时针或逆时针方向的旋涡,从而影响建筑物迎风面与背风面污染物浓度分布.在各种屋顶形状的街道峡谷中,壁面污染物浓度的相对大小与其附近的速度分布有直接关系.通过对街道峡谷建筑屋顶高度处垂直方向污染物通量的计算和比较,说明了不同屋顶形状的街道峡谷平均流扩散和湍流扩散的强弱,污染物湍流扩散通量值有可能为正或为负;同时,峡谷内剩余污染物浓度的大小表明了屋顶形状对污染物扩散出街道峡谷难易的影响.      

湖泊沉积物中磷化氢的释放动力学初探

采用柱状芯样模拟法,研究了太湖沉积物-水界面磷化氢的释放动力学.结果表明:当沉积物-水界面磷化氢的释放达到动态平衡时,水界面中磷化氢的浓度基本不再增大,大约在0.34 pg·l-1左右,此时磷化氢的释放通量约为0.008 pg·dm-2·h-1.根据室内模拟结果,太湖沉积物每年的磷化氢释放量在13.81-49.62 g之间,从而使磷化氢在湖水中的平均浓度达到0.16 pmol·l-1.     

不同小叶章湿地H2S和COS的排放通量研究

利用静态箱/气相色谱法,观测了小叶章沼泽化草甸和小叶章典型草甸两种湿地类型中H2S和COS在生长季(5-9月)的释放动态,结果表明:在两种小叶章湿地中,H2S和COS的排放通量均具有明显的季节和日变化规律.在小叶章沼泽化草甸中H2S和COS的平均释放通量分别为0.34μg·m-2·h-1和-0.29μg·m-2·h-1;小叶章典型草甸H2S和COS的平均释放通量分别为0.14μg·m-2·h-1和-0.20μg·m-2·h-1;小叶章沼泽化草甸H2S和COS的平均释放通量均高于小叶章典型草甸.在生长季两种小叶章湿地均能向大气释放H2S,对COS则表现为从大气中吸收.小叶章的生长过程对H2S和COS的排放影响显著,在小叶章生长旺盛期,H2S出现排放峰值,COS出现吸收高峰.     

污水处理过程中膜故障分析与防治对策

膜分离作为一门新型的高效分离、浓缩、提纯和净化技术,是支撑循环经济和可持续发展的重要技术.详细分析了污水处理过程中膜故障产生机理,并给出了相应的防治对策.     

膜表面形貌对厌氧膜生物反应器膜污染影响的试验研究

在厌氧膜生物反应器处理高浓度食品废水的试验中,借助原子力显微镜分析了四种表面形貌不同的聚醚砜超滤膜的通量衰减规律.结果表明,超滤膜表面形貌愈粗糙,膜通量的衰减速率愈快,且化学清洗后恢复愈困难.     

太湖水土界面氮磷交换通量的时空差异

利用原柱样静态释放实验及间隙水分子扩散模型对太湖典型草型湖区(东太湖)及藻型湖区(梅梁湾)的氮磷释放通量进行了逐月研究.原柱样氮磷静态界面交换通量(F_i)在同一湖泊不同生态类型湖区有差异性,东太湖氨态氮和可溶性磷酸盐的年平均交换通量分别为(44.9±21.9)mg·(m²·d)^-1(平均值±标准偏差)和(2.06±1.71)mg·(m²·d)^-1,梅梁湾为(16.2±12.0)mg·(m^-1·d)^-1和(0.53±0.52)mg·(m²·d)^-1.2湖区的分子扩散通量(F_m)同样表现为这样的差异,但是其绝对值与静态释放通量相比有数量级的差异,该模型不能用于太湖这样风浪显著且底栖生物活性较高的湖泊水土界面氮磷营养盐交换通量的估算.仅从不同生态类型的湖区比较结果看,草型湖区比藻型湖区有更高的氮磷交换通量.F_i/F_m比值作为1种反映底栖生物活性的指标反映出东太湖有更高的底栖活性.在水体溶解氧水平通常保持在较高的水平,即好氧状态下,氮磷界面交换通量与溶解氧水平(DO)无显著相关.同样,在现有浓度水平下,其水土界面交换通量与水体氮磷浓度无显著相关.东太湖较高的释放通量与相对较低的水体营养盐负荷的差异来自于大型水生植被的消浪促沉降及其本身的吸附吸收作用,这是恢复水生植被以重建健康水生生态系统的重要理论依据.