干法加氨脱除SO2中的温度效应

研究了在ＮＨ３参与下，干法脱除ＳＯ２中的温度效应，实验结果表明，在ＳＯ２与ＮＨ３的热化学反应中，反应程度随温度上升呈线性下降，然而，在脉冲电晕条件下，ＳＯ２脱率却随温度上升呈现非线性变化，通过测定不同温度下的产物组成，揭示了在脉８冲电晕放电条件，干法脱除ＳＯ２存在两条平反应途径；（１）先成盐后氧化；（２）先氧化后成盐，在较高温度下反应主要按第（２）条途径进行。     

湿法烟气脱硫应用中的几个问题探讨

对火电厂应用石灰石 石膏法烟气脱硫中遇到的几个实际问题进行分析和讨论 ,重点讨论分析了湿法烟气脱硫和烟气温度、烟气抬升高度、烟气扩散的关系 ,并分析了湿法烟气脱硫对烟囱产生的腐蚀影响     

试用平炉尘制备中温变换催化剂

利用钢铁厂平炉尘制备中温变换催化剂,制备成本低,工艺简单,活性达到部颁标准,具有明显的经济效益.     

Effects of alternating temperatures on development and reproduction of the armyworm,Mythimna separata (Walker)

Effects of cycling and constant temperature on development and reproduction of the armyworm, Mythimna separata (Walker) were investigated by rearing the insects on the artificial diet under temperatures covering low(16-24℃ vs. 20 ℃ ), medial(20-28℃ vs. 24℃ ) and high(24-32 ℃ vs. 28 ℃) regions. In the low region, all the immature stages of the insect developed significantly faster under alternating temperatures than at corresponding constant temperatures. For the medial region, their development was little affected by variable temperatures. For the high region, developmental durations tended to be longer under cycling temperatures except egg stage.Mean fecundities of the adult moths markedly increased under cycling temperatures as compared with those at respective constant temperature in all regions.Possible reasons for effect of alternating temperatures on insect development are discussed in some details.     

深度平均的应力-通量代数全场模型及其验证

提出了深度平均的应力—通量代数全场模型，用来模拟热水侧向排入大水体的各向异性的输移扩散规律。应用有限体积法对控制方程进行离散，利用ＳＩＭＰＬＥ法进行数值模拟。通过该模式的模拟计算给出了速度场、温度场的分布。所得的回流区形状及温度场分布与深度平均的ｋ－ε模型及实验资料对比，本文的计算结果与实测值符合得较好     

海水环境下玻璃纤维增强复合材料力学性能演化规律研究

目的 研究海水环境下海流能发电机组叶片用玻璃纤维复合材料力学性能的变化规律.方法 在实验室内通过海水浸泡试验、拉伸试验、弯曲试验以及剪切试验,测定叶片用玻璃纤维树脂基复合材料的吸水特性,以及在人工海水介质中各项力学性能参数的演变规律.结果 随着浸泡时间的增加,玻璃纤维树脂基复合材料吸水率先逐步增大、后趋于稳定,总吸水率约0.075％.抗拉强度呈先降低、后提高、又降低的趋势,抗拉强度最高可超过1100 MPa,最小值约为940 MPa.弹性模量和弯曲强度呈逐渐降低的趋势,弹性模量降幅约9.5％,弯曲强度降幅约为30％.弯曲模量变化起伏不定,变化幅度在15％以内.材料剪切强度呈先增大、后降低的趋势,最小值为189 MPa,较初始值高10 MPa.剪切模量呈先降低、后提高的现象,在浸泡28 d时,剪切模量最小,为16.4 GPa.结论 玻璃纤维增强树脂基复合材料经过长期海水浸泡后,拉伸及抗剪切性能略有降低,但降幅不大,抗弯性能下降明显,需要在叶片结构设计和强度计算时,充分考虑抗弯性能衰减的负面影响.     

Comparison of mesophilic and thermophilic anaerobic digestions of thermal hydrolysis pretreated swine manure: Process performance, microbial communities and energy balance

Anaerobic digestion (AD) of swine manure (SM) commonly shows low biogas output and unsatisfactory economic performance. In this study, thermophilic AD (TAD, 50 ± 1 °C) was combined with thermal hydrolysis pretreatment (THP, 170 °C/10 bar), to investigate its potential for maximizing biogas yield, securing successful digestion and microbial diversity, as well as improving energy balance. Four lab-scale continuously stirred tank reactors were operated for 300 days and compared with each other, i.e., reactor 1 (raw SM fed in mesophilic AD: RSM-MAD), reactor 2 (THP-treated SM fed in MAD: TSM-MAD), reactor 3 (RSM-TAD), and reactor 4 (TSM-TAD). The results showed that THP was efficient to increase methane production of SM, TSM-TAD mode led to the highest methane yield (129.8 ± 40.5 mL-CH₄/g-VS/day) among the tests (p < 0.05). Although TAD was more likely to induce free ammonia (> 700 mg/L) or volatile fatty acids (> 6000 mg/L) accumulation compared with MAD in start-up phase, TSM-TAD treatment mode behaved a sustainable digestion process in a long-term operation. For TSM-TAD scenario, higher Shannon–Weaver (3.873) and lower Simpson index (0.061) indicated this mode ensured and enlarged the diversity of bacteria communities. Phylum Bathyarchaeota was dominant (59.3%−90.0%) in archaea community, followed by Euryarchaeota in the four reactors. RSM-MAD treatment mode achieved the highest energy output (4.65 GJ/day), TSM-TAD was less effective (−17.38 GJ/day) due to increased energy demands. Thus improving the energetic efficiency of THP units is recommended for the development of TSM-TAD treatment mode.     

锌镉还原法的海水硝酸盐浓度

按照《海洋调查规范》(1991)中锌镉还原法 ,用三对基体来配制NO3 -标准溶液 :NaCl水 (31gNaCl加纯水至 1L)与无氮东海海水ECS、《海洋调查规范》(1991)人工海水SAS(NaCl水加MgSO4)与ECS和Strick land Parsons(1972 )人工海水SP72 (SAS加NaHCO3 )与ECS。经测定 ,且忽略标准曲线方程的截距 ,纯水与ECS的NO3 -还原率比为 0 .2 6 6 ,NaCl水与ECS的比为 0 .70 6 ,SAS与ECS的比为 0 .90 1,而SP72与ECS的比则为1.0 0 9。显然 ,用ECS和等价的SP72定出的值最接近天然海水中NO3 -的浓度。由《海洋调查规范》(1991)SAS定出的浓度须乘上 0 .90 1～ 0 .95 6后才接近海水中NO3 -浓度。     

基于风险的检验在高温高压管廊蒸汽管道的应用

高含硫天然气净化装置高温高压管廊蒸汽管道由于不能停车,在现有技术条件下无法开展全面检验,存在安全运行的风险。简述了基于风险的检验技术的基本理念。讨论了蒸汽管道开展基于风险的检验的合规性、损伤模式及机理、风险评估方法和程序。通过综合考虑失效可能性和失效后果,制定最优检验策略并实施,解决了高温高压管廊蒸汽管道到期不能检验的问题,及时发现隐患并整改,确保管道合法合规安全运行。研究结果表明,采用基于风险的检验技术,既能节约大量的停车和检验维修费用,又能有效地提高重点设备管线的安全性和管理水平。     

常温空气无焰燃烧中NOx生成的研究

研究了常温空气无焰燃烧中Nox的生成规律.实验研究和计算分析表明,在燃烧器射流对称轴上(300mm×2000mm的空间内),自喷口至炉膛中心处,有一个温度较低的剧烈的燃气与空气扩散混合区,在此区域内,不生成Nox;温度大于1320K的区域,开始生成N2O;在炉膛后部温度大于1810K的高温区,开始生成NO.过量空气系数与容积热负荷对烟气中Nox生成量的影响不大与传统的扩散火焰或预混火焰不同,常温空气无焰燃烧反应发生在一个弥散的宽广区域,在整个炉膛内同时进行,炉膛内高温区面积很小,因而Nox的生成量低,排放稳定.