模拟车用工况下5kW燃料电池尾气净化系统

模拟了车用工况下燃料电池发动机脉冲式排氢的特点,设计开发了一套质子交换膜燃料电池的尾气净化系统,并以5 kW燃料电池的尾气排放为例,研究其净化效果。研究了电池阳极排放氢气缓冲前后尾气中氢气浓度的变化,以及不同空速条件下氢气的去除效果。结果表明：电堆阳极排放氢气经过缓冲处理后,尾气中氢气浓度趋于平稳,大部分工况下处在2%以下,达到了安全处理的要求;尾气中氢气的去除效果与空速密切相关。对自制的整体式催化剂而言,当空速低于20000 h^-1时,氢气的去除率能达到约95%,而当空速达到39270 h^-1时,氢气的去除率仅为10.9%。鉴于这一问题,提出通过采用尾排空气的分流手段调整催化燃烧反应器对空速的要求,以提高尾气中氢气的去除率。     

Reclamation and revegetation of fly ash disposal sites - Challenges and research needs

Coal-fired power generation is a principal energy source throughout the world. Approximately, 70-75% of coal combustion residues are fly ash and its utilization worldwide is only slightly above 30%. The remainder is disposed of in landfills and fly ash basins. It is desirable to revegetate these sites for aesthetic purposes, to stabilize the surface ash against wind and water erosion and to reduce the quantity of water leaching through the deposit. Limitations to plant establishment and growth in fly ash can include a high pH (and consequent deficiencies of Fe, Mn, Cu, Zn and P), high soluble salts, toxic levels of elements such as B, pozzalanic properties of ash resulting in cemented/compacted layers and lack of microbial activity. An integrated organic/biotechnological approach to revegetation seems appropriate and should be investigated further. This would include incorporation of organic matter into the surface layer of ash, mycorrhizal inoculation of establishing vegetation and use of inoculated legumes to add N. Leaching losses from ash disposal sites are likely to be site-specific but a sparse number of studies have revealed enriched concentrations of elements such as Ca, Fe, Cd, Pb, and Sb in surrounding groundwater. This aspect deserves further study particularly in the longer-term. In addition, during weathering of the ash and deposition of organic matter during plant growth, a soil will form with properties vastly different to that of the parent ash. In turn, this will influence the effect that the disposal site has on the surrounding environment. Nevertheless, the effects of ash weathering and organic matter accumulation over time on the chemical, physical and biological properties of the developing ash-derived soil are not well understood and require further study.     

变电站建设中的电磁防护及环境和谐发展问题

随着我国经济水平的发展所带来的用电负荷的激增,变电站落户市区已是经济发展的必然结果。随即对变电站建设中的电磁防护提出了更高的要求;并全面考虑周边人类的生存环境。本文总结了变电站在规划建设中的电磁防护及如何与环境和谐发展的问题,并针对具体问题一一列举了所需采取的措施,包括抵御变电站电磁和噪声环境的防护措施,变电站二次系统抵御电磁骚扰源的措施以及变电站规划与景观的协调、最终将实现变电站建设与环境的和谐发展。     

循环流化床锅炉掺烧高炉煤气的应用

介绍了高炉煤气的主要燃烧特性,分析了高炉煤气在循环流化床锅炉中掺烧时对炉膛换热、过热蒸汽温度、锅炉负荷、热效率、分离装置以及环境的影响,并提出了消除不良影响的相应措施。     

吨量煤体的自燃过程实验模拟研究

为更好地弄清矿井实际的煤自然发火规律,利用装煤量达5吨的大型实验台对两种烟煤分别进行了自燃模拟实验。大煤量的实验能够很好地模拟煤矿中煤低温氧化和传热传质共同作用导致的发火过程,实验得到的自然发火期与煤矿实际发火期也是一致的。实验中煤样从缓慢氧化变为快速氧化的临界温度为100～110℃。当煤温低于,临界温度时,煤样的升温受到空气流带走热量和向外界散热的影响很大,因此夹层水的保温作用就很关键。当煤温超过临界温度后,反应加快,温度急剧上升,散热的影响明显降低,反应主要受限于氧气的供应情况。     

Fenton氧化法深度处理抗生素废水二级出水

采用Fenton氧化法对青霉素和土霉素混合废水二级处理出水进行深度处理,通过正交和单因素实验研究了废水初始反应pH值、H2O2投加量、Fe2+/H2O2摩尔比及反应时间等因素对废水处理效果的影响。实验结果表明,Fenton氧化法处理的最佳反应条件为:初始pH值4、H2O2(30%)投加量50 mL/L、Fe2+/H2O2摩尔比1/20和反应时间60 min,处理后出水COD小于120 mg/L,COD去除率在75%以上,急性毒性(HgCl2毒性当量)小于0.07 mg/L,满足《发酵类制药工业水污染物排放标准》(GB21903-2008)表2标准要求。     

胶合竹材GluBam甲醛释放影响因素的气候箱实验与分析

胶合竹材GluBam的甲醛释放情况是现代竹结构住宅环保性的一个重要方面,也是竹结构住宅推广中最受关注的指标之一。采用1 m3气候箱对温度、相对湿度和封边情况与GluBam的甲醛释放量和释放速率的相关关系进行了测试,并以一阶单衰减模型为基础提出了GluBam的甲醛释放分析模型。测试和分析结果表明:GluBam板材在各模拟条件下甲醛浓度峰值均小于规范要求;初始甲醛释放量E0和衰减率常数k可以用来评价GluBam的甲醛释放特征;GluBam的醛释放量和释放速率随环境温度和湿度增加而显著增大,且温度因素的影响更大;封边处理可以有效降低GluBam板材的甲醛释放量。     

Accurate sampling of PCDD/F in high temperature flue-gas using cooled sampling probes

In a laboratory-scale combustion reactor, flue-gas samples were collected at two temperatures in the post-combustion zone, 700 °C and 400 °C, using two different water-cooled sampling probes. The probes were the cooled probe described in the European Standard method EN-1948:1, referred to as the original probe, and a modified probe that contained a salt/ice mixture to assist the cooling, referred to as the sub-zero probe. To determine the efficiency of the cooling probes, internal temperature measurements were recorded at 5 cm intervals inside the probes. Flue-gas samples were analyzed for polychlorinated dibenzo-p-dioxin and dibenzofurans (PCDD/Fs). Samples collected at 700 °C using the original cooling probe showed higher concentrations of PCDD/Fs compared to samples collected using the sub-zero probe. No significant differences were observed between samples collected at 400 °C. The results indicated that artifact formation of PCDD/Fs readily occurs during flue-gas sampling at high temperatures if the cooling within the probe is insufficient, as found for the original probe at 700 °C. It was also shown that this problem could be alleviated by using probes with an enhanced cooling capacity, such as the sub-zero probe.Although this may not affect samples collected for regulatory purposes in exit gases, it is of great importance for research conducted in the high-temperature region of the post-combustion zone.     

铁及铁铜氧化物对臭氧氧化酸性红B的催化效能

采用自蔓延溶胶凝胶法分别制备了铁氧化物和铁铜复合氧化物催化剂,以酸性红B为降解对象,对比了单独臭氧氧化、铁氧化物和铁铜复合氧化物催化臭氧氧化对酸性红B的降解效果,考察了磁力搅拌速度(500～1 640 r/min)、溶液pH(3～11)、臭氧投加速率(3.55～28.4 mg/min)对铁铜复合氧化物催化性能的影响。结果表明,与单独臭氧氧化比较,铁氧化物和铁铜复合氧化物均能加速酸性红B的降解,促进色度和COD的去除,结合催化剂的表征结果,推断催化剂表面羟基促进臭氧分解产生.OH是其氧化性能较好的主要原因,另外,催化剂的吸附能力对催化性能也有一定影响。随着磁力搅拌速度、溶液pH、臭氧投加速率的增大,铁铜复合氧化物催化臭氧氧化酸性红B的效果越好。     

MnxCe1-xO2／γ-Al2O3催化剂的制备及其催化甲苯的燃烧性能

以γ-Al2O3为载体,以MnxCe1-xO2为催化活性组分,采用浸渍法制备了一系列负载型MnxCe1-xO2／γ-Al2O3催化剂（x=0、0．2、0．4、0．6、0．8、0．9、1）,在固定床反应器中评价了催化剂对甲苯的催化燃烧性能。结果表明,MnxCe1-xO2／γ-Al2O3催化剂的催化活性与催化剂的焙烧温度、活性组分MnxCe1-xO2的负载量以及Mn、Ce摩尔比有显著关系,其中焙烧温度550℃、负载量为20％、Mn、Ce摩尔比为4：1时,即MnxCe1-xO2／γ-Al2O3催化剂对甲苯的催化性能最佳,反应温度为180℃时,甲苯的转化率达到95％。并在连续100h的稳定性操作后,催化剂的活性基本无变化。采用XRD、BET以及SEM等分析测试手段对催化剂的结构以及表面进行了表征。