纳米TiO2添加剂对DMDF发动机大负荷燃烧及PM排放影响的试验研究

在一台电控增压中冷四缸柴油机的进气道上加装一套电控喷射装置,使其运行柴油/甲醇双燃料(DMDF)模式.研究了甲醇中Ti O_2添加剂的添加量及同一添加剂添加量在不同甲醇分散系喷射量时对发动机大负荷工况的燃烧和颗粒物(PM)排放的影响.结果表明,在甲醇中添加适量(30和100 mg·kg~(-1))的纳米Ti O_2能够使爆发压力升高,对燃烧有一定的促进作用,但添加过量(100 mg·kg~(-1))会对燃烧产生不利影响.加入纳米Ti O_2后,干炭烟烟度排放和积聚态颗粒数明显降低,在添加剂添加量为1000 mg·kg~(-1)时,最大降幅分别达到26.8%和29.4%,而核态颗粒物排放变化不大.在相同添加剂添加量下,增加甲醇分散系替代率R_m会使放热始点后移,放热更加集中,爆发压力增大,干炭烟烟度和颗粒物排放均大幅度降低.在添加剂添加量为100 mg·kg~(-1)时,与R_m=10%相比,R_m=40%时爆发压力增加0.94 MPa,放热率峰值增加53.5%,烟度、核态颗粒数、积聚态颗粒数和颗粒物总数的降幅分别达66.9%、42.3%、67.0%和58.0%.     

金华地区PM2.5中的极性有机示踪物

用GC/MS,对金华地区3个采样点、四个季节,225个PM_(2.5)样品中10种极性有机示踪化合物进行了分析,包括天然源:3个异戊二烯SOA示踪物、1个α-蒎烯SOA示踪物和2个真菌孢子示踪物,和人为源:1个甲苯SOA示踪物、3个生物质燃烧示踪物.结果表明,异戊二烯SOA示踪物浓度为3.41~48.50 ng·m~(-3),α-蒎烯SOA示踪物浓度为2.45~25.40 ng·m~(-3),甲苯SOA示踪物为4.75~39.80 ng·m~(-3).各SOA示踪物均有明显的季节变化,其中,异戊二烯SOA示踪物呈夏季秋季≈春季冬季,α-蒎烯SOA示踪物夏季春季≈秋季冬季,甲苯SOA示踪物秋季夏季春季冬季.估算得出甲苯SOC对OC的贡献为3.03%~24.50%,而来源于生物质燃烧的有机碳对OC的贡献可以达到1.23%~42.80%.表明人为源排放前体物的二次转化以及生物质燃烧是金华地区大气细颗粒物污染的重要来源.     

成都市城区大气细颗粒物水溶性离子污染特征

为了解成都市城区大气细颗粒物水溶性离子污染特征,在成都市城区四季采集PM2.5有效样品共计102个,测得颗粒物质量浓度以及水溶性离子质量浓度(NH4+、Ca2+、Na+、Mg2+、K+、F-、NO3-、SO42-、Cl-),并分析其浓度变化特征,重点关注二次无机离子的污染特征及形成影响.结果表明,成都市城区水溶性离子与...     

北京地区PM10与秸秆燃烧排放单颗粒对比分析

采用场发射带能谱扫描电镜(FESEM/EDS)法分析北京怀柔地区PM10与秸秆燃烧排放颗粒的形貌特征和成分差异.结果显示:秸秆燃烧后排放颗粒物多为大粒径颗粒,成分上都含S、Cl和K元素.含有生物质燃烧标志元素K的PM10颗粒物多为含Si、Al和Na元素的燃煤飞灰和矿物颗粒,与秸秆燃烧排放颗粒组成化学元素差异明显.据此推...     

锌精炼铅塔燃烧系统烟气温度模糊控制研究

针对锌精馏铅塔动态过程中的非线性、非最小相位特征、不稳定性、时滞和负荷干扰,基于模糊控制策略下给出了锌精馏铅塔燃烧系统新的控制方法.运用模糊控制系统对锌精馏铅塔的烟气温度进行仿真研究和实时控制结果表明,该研究所设计的模糊控制器能够克服许多干扰因素,产生了良好的控制效果.     

Comparative on Causes and Accumulation of Selenium in the Tree-rings Ambient High-selenium Coal Combustion Area from Yutangba, Hubei, China

Toxic trace elements emitted during coal combustion are the main sources of air pollution. They are released into the atmosphere mainly in the forms of fine ash, smoke and flue, and thus adversely affect plant, animal and human health. Selenium is one of toxic and the most volatile in coal. Large amount of atmospheric emission of selenium, as well as selenium present and scrubber stockpiles in ash may create serious environmental problems. In the paper, on the basis of investigating the abundance and distribution of selenium in plant-rings during recent 20 years, the bioaccumulation of selenium is explained that selenium in plant, which were collected from the village of selenium-rich coal combustion, is much higher than that in plants collected away from the village of selenium-rich coal combustion. The main origins of selenium are selenium-rich coal combustion and high-selenium rock weathered. The selenium recycle by food chain and selenium will accumulate and redistribute in environments.     

Study of Trace Elements and Soot in Aerosols from a Coal-Fired Power Plant in Northern Vietnam

Two measurement campaigns were conducted in two sampling sites, An Thinh and Duy Minh, in northern Vietnam during the months of November–December 2000 and November 2001–February 2002 in order to investigate the extend of the particulate air pollution from the Pha Lai coal fired power plant. Fine particle samples were analyzed by Energy Dispersive X-Ray Fluorescence spectrometry and soot samples were analyzed by reflectometer. The result showed that high concentration of soot and elements mostly coincided with the air masses originating from the power plant. Sea spray aerosol was found to be the major source of chlorine at both sites. Ratios of specific elements and principal component analysis (PCA) revealed that coal combustion was the main contributor to the air pollution at both sites. PCA also indicated that there were other sources responsible for the elements emission, probably the influence of long distance transport and Asian Brown Cloud.     

Results of An Indoor Size Fractionated PM School Sampling Program in Libby, Montana

Libby, Montana is the only PM_2.5 nonattainment area in the western United States with the exceptions of parts of southern California. During January through March 2005, a particulate matter (PM) sampling program was conducted within Libby’s elementary and middle schools to establish baseline indoor PM concentrations before a wood stove change-out program is implemented over the next several years. As part of this program, indoor concentrations of PM mass, organic carbon (OC), and elemental carbon (EC) in five different size fractions (>2.5, 1.0–2.5, 0.5–1.0, 0.25–0.5, and <0.25 μm) were measured. Total measured PM mass concentrations were much higher inside the elementary school, with particle size fraction (>2.5, 0.5–1.0, 0.25–0.5, and <0.25 μm) concentrations between 2 and 5 times higher when compared to the middle school. The 1.0–2.5 μm fraction had the largest difference between the two sites, with elementary school concentrations nearly 10 times higher than the middle school values. The carbon component for the schools’ indoor PM was found to be predominantly composed of OC. Measured total OC and EC concentrations, as well as concentrations within individual size fractions, were an average of two to five times higher at the elementary school when compared to the middle school. For the ultrafine fraction (<0.25), EC concentrations were similar between each of the schools. Despite the differences in concentrations between the schools at the various fraction levels, the OC/EC ratio was determined to be similar.     

军用集成电路质量控制方法分析与探讨

集成电路是军用电子设备最重要的器件之一,集成电路的质量直接影响到军用装备的质量。从集成电路的选择、二次筛选和破坏性物理分析(DPA)这几个方面探讨了军用集成电路的质量控制方法。实践证明通过质量控制筛选得到的集成电路整批使用可靠性都有明显的提高。     

Characterization of coffee residues pellets and their performance in a residential combustor

Spent coffee grounds (SCG) and coffee husks (CH) were evaluated as biofuels, after densification, for energy production. CH represent a specific problem for the coffee industry due to a low calorific value, high ash content, and a very low bulk density. Hence, the energetic potential of SCG (95 wt%)/CH (5 wt%) blend and pure SCG (100%) were examined. The blend of SCG and CH was limited to 5 wt% of CH because of the low bulk density of CH. Therefore, physicochemical and energetic characterizations of the produced pellets were performed. Thermogravimetric analyses were performed under nitrogen and air atmospheres to evaluate the CH behavior in the blend. Characterization study shows that both produced pellets could reach the French Agropellets standard (AQI). Thermal degradation showed that the mean reactivity of the SCG/HC pellets was higher than pure SCG. Then, combustion experiments were performed in a domestic combustor, after modification of the boiler power in order to improve its energetic performances. The presence of CH led to a rise of CO, NOx, VOC’s, and particle emissions. Nevertheless, the performances of the biofuels are almost in agreement the NF EN 12809 standard.