基于轮廓似然函数的PM_(10)极值浓度分析

以R软件为分析工具,选择GEV(generalized extreme value distribution)模型拟合四川省泸州市2003～2007年期间PM10每月最高日平均浓度数据,采用极大似然法估计模型的3个参数即位置参数、尺度参数、形状参数,利用所得的参数估计值计算得出某一标准值(如GB3095—1996)的重现期;进一步利用参数估计值计算轮廓似然函数,估计某一段固定时间间隔的PM10浓度的重现值以及其置信区间。结果表明,GEV模型能很好地拟合泸州市PM10数据,利用轮廓似然函数估计的不同时间间隔的重现值准确度高,统计结果可以为环境主管部门发布污染状况预警信息提供参考。     

基于ACF-AMDF的气井环空液面回波特征提取方法

为了精确有效地提取声波法检测气井环空液位的回波周期,在分析环空中测试波的传播特征及基音周期检测的基础上,提出1种基于检测信号短时自相关函数(ACF)及平均幅度差函数(AMDF)的液面回波周期提取方法;利用自主搭建的室内模拟实验系统开展了不同初始环空压力下环空液位检测实验;对检测信号进行中心削波处理并计算ACF/AMDF,提取出液面回波周期并与理论计算值对比分析;同时分析了现场环空液位检测信号,提取其回波周期。研究结果表明:提出的新方法能有效地用于提取环空液面回波周期;室内实验中,该方法最大误差绝对值为1.54%;该方法能够有效抑制液面回波信号中的随机噪声及接箍反射波等,处理后的信号曲线在回波周期处峰值更加突出、集中,而在其他位置更加平滑,提高了对液面回波周期特征的辨识能力。     

不同煤层煤氧化自燃性实验分析

为研究不同煤层煤自然发火特征的异同性及规律,以淮南矿区1号、3号、6号、13号煤层为研究对象,通过自然发火实验,对不同煤层煤的自然发火期周期、煤样70℃时放热强度和R70值进行分析。研究结果表明:4个不同煤层煤样自燃性由强到弱依次为:3煤>6煤>1煤>13煤;变质程度相近的4个煤层,3煤自然发火期最短,这与煤体中硫分和水分含量高有关;13煤变质程度较高,且前期放热强度、耗氧速率增长缓慢,其自燃性较弱;4个不同煤层煤的耗氧速率、CO,CO2产生率,以及C2H4/C2H6值随煤温升高具有相似的变化规律;煤中CH4气体大量解吸出现于煤温60℃之前,煤中灰分在80~120℃开始逐渐吸热融化,解析和融化均会抑制煤氧接触并且减小煤氧反应放热总量。     

两株壬基酚和双酚A高效降解菌株的筛选和降解特性

以桂林市上窑污水处理厂污泥脱水车间剩余污泥、上窑堆肥厂的堆肥堆料和桂林雁山镇森林土壤为菌源进行驯化,分离纯化并筛选得到2株能分别以壬基酚(NP)和双酚A(BPA)为唯一碳源和能源生长的降解菌株N-1和B-1。通过对菌株的16S r DNA序列同源性分析,初步鉴定N-1和B-1菌分别为Cupriavidus(贪铜菌属)、Acinetobacter(不动杆菌属)。通过两菌株分别降解NP和BPA的单因素实验,确定了降解动力学以及时间、温度、p H值对降解过程的影响。研究结果表明,细菌N-1,B-1的最佳初始目标污染物质量浓度为5~10 mg/L,降解40 h,N-1去除率可达49.63%,B-1去除率可达62.34%。细菌N-1对NP的去除半衰期t1/2为41.44~48.02 h;B-1对BPA的去除半衰期t1/2为35.23~37.33 h。细菌N-1,B-1的最佳降解温度均为30℃,最佳p H值均在6.5~7.5之间,即两种细菌在中温、中性条件下对NP和BPA降解效果最佳。     

开展建设项目施工期的环境管理与环境监测

分析了建设项目施工期的环境影响，阐述了开展施工期环境管理与环境监测的必要性，介绍了施工期环境管理的实施手段，施工单位的环境管理制度，施工期环境监测的主要内容及对环境监测部门的要求，建议将施工期的环境管理与环境监测纳入正常的环保管理渠道之中，实现建设项目的全过程环境管理。     

混凝-超滤短流程工艺处理北方水库原水简

采用混凝-超滤膜短流程工艺对大伙房水库原水进行处理,考察其除污染性能和膜污染情况,并对该短流程工艺参数进行优化。结果表明,当利用超滤膜直接过滤原水时,膜污染较重,并且对污染物质的去除率较低;而采用混凝-超滤短流程工艺时,膜污染得到一定程度上的缓解;当絮凝剂投加量为7 mg/L、膜清洗周期为30 min时,对浊度、COD_Mn和UV₂₅₄的去除率分别为95.61%、40.42%和37.12%,出水水质能够满足生活饮用水卫生标准。     

西安市2013年PM_(2.5)浓度变化分析研究

全面分析2013年西安市13个国控环境空气质量自动监测子站PM2.5监测数据。结果表明:2013年西安市环境空气中PM2.5年均值为105μg/m3,超过《环境空气质量标准》(GB 3095—2012)二级要求(35μg/m3)200.0%,污染较严重;西安市各子站PM2.5月均值总体呈两边高、中间低的"V"型趋势,全市及各子站PM2.5月均值分别为44~206、32~275μg/m3;采暖期(上半年采暖期为1—3月,下半年采暖期为11—12月)、非采暖期(4—10月)PM2.5平均值分别为156、70μg/m3;上、下半年采暖期PM2.5平均值分别为178、124μg/m3;西安市气象风力以微风为主,雨天集中在5—9月,期间PM2.5月均值小于80μg/m3。     

垃圾填埋场甲烷氧化菌及甲烷通量的研究

采用静态箱法、滚管计数法和气相色谱法,对6个不同封场时间填埋区的甲烷通量、覆土层甲烷氧化菌数量和甲烷氧化速率的变化趋势进行了测定,并分析了它们与封场时间、植被覆盖率等因素之间的相关性。结果发现6个填埋区甲烷通量的变化范围在-0.34～5.31 mg/(m2.h)之间;覆土层甲烷氧化菌的数量范围为3.10×107～20.77×107 cfu/g干土,甲烷氧化速率在1.65×10-8～4.34×10-8mol/(h.g)之间。覆土层甲烷氧化菌的数量与甲烷氧化速率呈正相关,但前者并不是后者的决定性因素;甲烷通量高时可刺激甲烷氧化菌数量及氧化速率的提高,且三者均与封场时间呈显著负相关,与植被覆盖率呈负相关;当含水率大于15%时,随着覆土层含水率的增加,甲烷氧化速率呈下降趋势;覆土pH、有机质和铵态氮与甲烷氧化速率等无明显相关性。提高覆土层的甲烷氧化速率可有效减少垃圾填埋场的甲烷排放。     

Measurements of surface contamination of spray equipment with pesticides after various methods of application

Abstract

A traditional method to determine operator dermal exposure is to quantify the amount of pesticide coming into contact with specific body regions and then to integrate the deposition density values with the total body surface. It is known that extremely high deposition values may occur in the hand region; however, the source of contamination is generally assumed to be direct splash or contact with the pesticide container. One of the parameters affecting operator/pilot exposure could be the transfer of pesticide residue, particularly in the case of pesticides with a longer half‐life, from contaminated surfaces of spray equipment by direct contact over extended periods. If the rate of skin absorption of pesticide is readily known, the expected values of daily dose for an operator or pilot may significantly rise due to the extended contact period. This study produced field data on the surface contamination of spray equipment used for ground and aerial applications. If field data on precise work practice (time‐motion) observations are incorporated, it may be possible to estimate the potential exposure of operator/pilot due to hand contact with contaminated surfaces.     

Simulation of a Hazardous and Noxious Substances (HNS) spill in the marine environment: Lethal and sublethal effects of acrylonitrile to the European seabass

Despite the extensive maritime transportation of Hazardous and Noxious Substances (HNS), there is a current lack of knowledge on the effects posed by HNS spills on the marine biota. Among the HNS identified as priority, acrylonitrile was selected to conduct ecotoxicological assays. We assessed the acute and subletal effects of acrylonitrile in seabass, followed by a recovery phase to simulate the conditions of a spill incident. The work aimed at testing a broad range of biological responses induced by acrylonitrile. Sublethal exposure to the highest two doses increased the fish mortality rate (8.3% and 25% mortality in 0.75 and 2 mg L⁻¹ acrylonitrile concentrations), whereas no mortality were observed in control and 0.15 mg L⁻¹ treatments. Additionally, important alterations at sub-individual level were observed. Acrylonitrile significantly induced the activities of Catalase– CAT and Glutathione S-Transferase – GST; and the levels of DNA damage were significantly increased. Conversely, Superoxide Dismutase– SOD – activity was found to be significantly inhibited and no effects were found on Lipid Peroxidation– LPO and ethoxyresorufin O-deethylase – EROD – activity. Following a 7 d recovery period, the levels of CAT, GST and EROD fell to levels at or below those in the control. In the 2 mg L⁻¹ group, SOD remained at the levels found during exposure phase. This study has gathered essential information on the acute and subletal toxicity of acrylonitrile to seabass. It also demonstrated that 7 d recovery allowed a return of most endpoints to background levels. These data will be useful to assist relevant bodies in preparedness and response to HNS spills.