Enhancing treatment efficiency of swine wastewater by effluent recirculation in vertical-flow constructed wetland

Introduction Livestock w astew ater contains highly concen- trated pollutants, including suspended solids (SS), organics, nutrients and bacteria. In C hina, w astew ater generated by concentrated farm s is com m only stored in anaerobic lagoons and partia…     

Performance of a novel vertical-flow settler: a comparative study

By increasing particle concentration and G value （root-mean-square velocity gradient） to enhance flocculation, a novel vertical-flow settler was designed to increase sedimentation effectiveness, and to simultaneously improve operational stabilization. Due to the gradual decrease in upward flow-rate of raw water, a floes blanket would form and suspend in the middle section of the settler, not at the bottom as in a conventional clarifier. Enough large floes, resulted from flocculation or fltration, would continuously settle out of the floes blanket, and simultaneously, the floes in raw water or those forming above the blanket would ceaselessly enter the floes blanket. As a result, the floes concentration in the blanket could keep a dynamic balance. The hydrodynamic shear in the blanket was improved by flow separation, which was induced by the abrupt change in flow channel. Due to the floes blanket and improved hydrodynamic shear, flocculation would be enhanced, which was helpful for removing fine particles in raw water. A comparative study showed that the novel vertical-flow settler had a much better performance in the removal of the particles in raw water than a conventional one, when they treated kaolin suspensions of different concentrations （500, 100 and 50 mg/L, respectively） coagulated by polyaluminum chloride（PAC1） at the up-flow rates of 1 and 2 mm/s, respectively.     

大型原油储罐热喷涂防腐蚀技术的应用

金属热喷涂技术是一种有效的长效防腐蚀手段,常用于金属结构的腐蚀防护。从钢结构腐蚀及热喷涂长效防护的角度,阐述了在大型原油储罐建设中使用热喷涂防腐蚀技术的可行性和经济性,并对其热喷涂防腐蚀工艺作了简要说明。     

基于粒子群-支持向量机(PSO-SVM)的苯储罐泄漏事故风险预测

将支持向量机(SVM)模型运用于事故前苯储罐泄漏事故风险预测,为使模型性能最优, 用粒子群算法PSO优化SVM模型参数,建立了PSO-SVM风险预测模型。为验证模型风险预测性能,分别采用遗传算法(GA)和网格搜索法(GS)优化SVM参数,并比较测试集与PSO-SVM、GA-SVM、GS-SVM三种模型预测结果的均方误差及相关系数。然后进一步探讨模型中权重调整方式、种群规模对PSO-SVM模型预测性能的影响。研究发现,权重线性递减所建PSO-SVM预测值与测试集相关系数更高、均方误差更小、预测效果更好,种群规模没有影响PSOSVM模型预测值但会影响计算时间,这为危化品泄漏事故的风险预测提供了一种新的方法。     

基于疲劳累积破坏机制的储罐结构动力可靠度分析

针对随机风载荷作用下储罐结构动力可靠性问题,以300 m3的中小型立式低温储罐为研究对象,利用AR模型进行数值模拟得到风载荷的脉动风速时程与脉动功率谱密度函数。采用ANSYS建立储罐三维有限元模型,并对储罐进行动力学分析,计算出储罐结构的随机响应,进而求出随机风载荷作用下储罐结构动力可靠性所需全部数字特征,最后利用疲劳累积损伤机制计算得到储罐的动力可靠度。结果表明:假设结构强度不随时间退化,前5 a动力可靠度基本保持不变,随着使用年限的延长,动力可靠度下降速度明显增大。研究方法可为储罐的动力可靠性及寿命预测提供一定的理论依据。     

Study on the dynamic response of polyurea coated steel tank subjected to blast loadings

Steel tanks are widely used in the storage of various chemical liquids, and the blast resistance of the tanks is very important because of the explosiveness of these liquids. To explore a feasible method to improve the blast resistance of steel tanks, the effect of polyurea coating on the blast resistance of steel storage tank is investigated in this paper. The responses of monolithic steel tanks and polyurea coated tanks under blast loads are studied by field blast experiments using TNT explosive, and the results shows that the polyurea layers are effective in reducing the maximum and residual displacements of the tank. Numerical simulations are performed and validated, and the deformation process and stress and strain distribution of the tanks are analyzed accordingly. The increase on the bending moment of the plastic hinge lines of the tanks and the increase of the area density of the cylindrical shell induced by the polyurea layers are believed to be the two main factors contributing to the displacement reduction effect of polyurea in this paper. The validated numerical model is used to study the influence of polyurea layer's thickness on the deflection of the tank, and a nearly inversely proportional relationship between the thickness and the maximum displacement is found. Three deformation modes of the tanks are identified when subjected to blast load with varying intensity and it is found that the displacement reduction effect of polyurea varies in different deformation modes.     

Investigating the quantitative and qualitative status of effluent in the wastewater treatment plant in Iran Central Iron Ore

The aim of present study was to investigate the quality of the produced effluent from different units of the Iran Central Iron Ore in Bafq city and comparison of effluent with the standards. This study presents the physicochemical and biological parameters data of effluent of three Sequencing batch reactors (SBR) with a capacity of 160 m³?d^?1. Most common parameters include pH, total suspended solids (TSS), total nitrogen (TN), total phosphorus (TP), biochemical oxygen demand (BOD₅), chemical oxygen demand (COD), heavy metals, and total coliforms and fecal coliforms as biological indicators. Then, for each SBR system, the average of each parameter was determined, and results were compared with the standard recommended by the Iranian Environmental Protection Agency. Based on the results, some of the parameters, including BOD₅, COD, and TSS in the wastewater treatment plant (WWTP) effluent, are higher than the permitted amount for discharge to the surface water. Considering the BOD₅, COD, and TSS concentration in WWTPs, the treated wastewater is only suitable for agricultural and irrigation use. Therefore, wastewater produced by Iran Central Iron Ore Co. will need additional treatment to achieve standard quality of water before discharge in surface water and adsorbent well.     

O3/BAF工艺系统中有机物生物降解数学模型

研究臭氧预氧化/曝气生物滤池（O₃/BAF）联合工艺深度处理实际城市污水二级出水过程中,后续BAF系统中有机物的生物降解数学模型。以有机底物浓度、填料层高度两个基本变量为控制条件,研究BAF的总体运行常数和填料特性常数,得出BAF有机物生物降解动力学方程为S_e/S₀=exp(－Kh/qSⁿ₀)。出水与进水COD浓度比值（S_e/S₀）的对数与反应器填料高度（h）之间可表达成一次函数关系。在不同的进水浓度（S₀）下,根据ln（S_e/S₀）~h和关系式m=K/qSⁿ₀,得到方程ln(q_m)=－nln(S₀)+lnK。BAF总体运行常数K和填料特性常数n分别为1.708和0.5063。该模型对BAF工艺有如下指导意义：可以根据设计流量、进水有机物浓度和出水浓度,初步确定BAF的尺寸（如横截面积、高度等）。     

连续流反应器中培养好氧颗粒污泥的运行效能研究

在连续流完全混合反应器(CSTR)中,采用不同进水方式,以乙酸钠作为碳源配制的人工配水作为原水,对好氧颗粒污泥的运行效能进行了试验研究。研究表明,采用不同进水方式运行的2个反应器在颗粒污泥出现后,运行效能差别不大;好氧颗粒污泥反应器运行高效稳定,在水力停留时间为1.5h、COD容积负荷为1.0kg/(m3·d)的条件下,对COD、TP、NH4+-N和TN的去除率分别为90%、85%、95%和60%,并具有明显的脱氮除磷效果;反应器中存在同步硝化反硝化现象。     

Inputs and distributions of synthetic musk fragrances in an estuarine and coastal environment; a case study

Synthetic musks are ubiquitous contaminants in the environment. Compartmental distributions (dissolved, suspended particle associated and sedimentary) of the compounds throughout an axial estuarine transect and in coastal waters are reported. High concentrations of Galaxolide^® (HHCB) and Tonalide^® (AHTN) (987-2098 ng/L and 55-159 ng/L, respectively) were encountered in final effluent samples from sewage treatment plants (STPs) discharging into the Tamar and Plym Estuaries (UK), with lower concentrations of Celestolide^® (ADBI) (4-13 ng/L), Phantolide^® (AHMI) (6-9 ng/L), musk xylene (MX) (4-7 ng/L) and musk ketone (MK) (18-30 ng/L). Rapid dilution from the outfalls is demonstrated with resulting concentrations of HHCB spanning from 5 to 30 ng/L and those for AHTN from 3 to 15 ng/L. The other musks were generally not detected in the estuarine and coastal waters. The suspended particulate matter (SPM) and sedimentary profiles and compositions (HHCB:AHTN ratios) generally reflect the distribution in the water column with highest concentrations adjacent to sewage outfalls.