废旧线路板中主要有价金属的生物反应器浸出研究

为探讨可供实际生物浸出应用的反应器规模废旧线路板中有价金属浸出特性和工艺条件,通过设计序批式生物浸出反应器,采用分离到的氧化亚铁硫杆菌Z1作为菌种资源,在考察废旧线路板中有价金属的浸出特性的基础上,确定了反应器运行的最佳工艺条件.结果表明,反应器运行的最佳工艺条件为曝气量1L/min、停留时间30h、搅拌速率300r/min以及粉末投加量12g/L.在此条件下,经过101h可以浸出90.24%的铜.同时,经197h的浸出,可以溶出93.06%的镁、92.00%的锌、85.59%的铝和64.51%的镍.因此,生物浸出反应器能有效回收废旧线路板中的有价金属,为该技术的实际应用提供了实验证据.     

控制ORP实现连续流反应器部分亚硝化稳定运行

利用ORP在线监控设备,研究了控制ORP值实现连续流部分亚硝化反应器稳定运行的可行性,并使出水水质满足厌氧氨氧化需求.结果表明,在亚硝氮与氨氮比值、温度和pH值恒定的条件下,反应器内ORP值波动主要由于DO浓度波动引起.在稳定的亚硝化系统中,当ORP值大于250mV左右时,反应器出水亚硝氮与氨氮比值大于2.1;当ORP值控制在150mV左右时,反应器出水亚硝氮与氨氮比值稳定在1.2~1.3之间.ORP值控制在120mV时,反应器出水亚硝氮与氨氮浓度比值为0.9~1.06.将ORP值控制在150mV时,随着进水氨氮浓度由300mg/L提高至813mg/L,反应器出水亚硝氮与氨氮比值基本维持在1.1~1.3之间.但随之增加的游离氨浓度易导致亚硝化菌活性抑制.因此,在低氧环境下ORP作为连续流部分亚硝化反应器亚硝化程度的控制指标,其灵敏度和精度明显优于DO监测设备.     

基于HPR在线监测控制SBR曝气历时实现短程脱氮

应用新型自动呼吸-滴定测量仪在线测量pH值、HPR等信号,进行了在SBR内实现短程脱氮的研究.采用SBR处理人工合成废水,COD和NH4+-N浓度分别为360,40mg/L,温度稳定在20℃,DO低于2mg/L,基于HPR在线监测控制SBR曝气历时.运行约60d后,亚硝酸盐积累率达到88%,COD和NH4+-N去除率均在90%以上,稳定实现了短程硝化反硝化.应用HPR估计硝化过程的NH4+-N浓度发现,NH4+-N实测值与基于HPR的计算值间存在良好的线性关系,相关系数为0.9722;计算值整体低于实测值,主要是由曝气初期的滴定启动滞后所致.     

HABR系统实现固相异养与单质硫自养集成反硝化试验

采用连续流运行方式,将含NO₃--N的原水依次通过HABR(复合式厌氧折流板反应器)内添加木屑(第1系统)和硫磺颗粒(第2系统)的2个系统,在温度为(25±1)℃的条件下,将NO₃--N容积负荷由72g/(m3·d)逐渐提高至80和96g/(m3·d),在不需投加传统型外加碳源的条件下实现了固相异养与单质硫自养的集成反硝化. 结果表明:进水NO₃--N容积负荷为96g/(m3·d)时,系统NO₃--N总去除率达到99.0％,第1系统和第2系统对NO₃--N的去除率贡献各为50.0％;系统出水ρ(COD_Mn)为5.74～10.05mg/L,ρ(SO₄2-)为405～870mg/L,并且没有NH₄+-N和NO₂--N的积累. 第1系统产生的碱度能部分中和第2系统内产生的酸,进水、第1系统、第2系统出水pH分别为7.5、7.5～7.6、6.5～7.2,使硫自养反硝化系统呈现出较强的pH平衡能力,不需外加石灰石调节碱度即可为反硝化细菌提供较适宜的中性生存环境. 系统在pH平衡能力和NO₃--N去除效果2个方面均表现出良好的协同作用,并且通过集成反硝化作用弥补了2个系统单独运行时反硝化过程效率低的缺点,较传统异养型生物反硝化降低了运行成本.      

Removal of Novacron Golden Yellow dye from aqueous solutions by low-cost agricultural waste: Batch and fixed bed study

The present work describes the removal of Novacron Golden Yellow (NGY) dye from aqueous solutions using peanut hulls. The experiments were performed with native, pretreated and immobilised forms of peanut hulls. The effect of various operational parameters (pH, biosorbent dose, initial dye concentration and temperature etc.) was explored during batch study. NGY showed maximum removal at low pH and low biosorbent dose. High initial dye concentration facilitated the biosorption process. Maximum dye removal with native, pretreated and immobilised biomass was found to be 35.7, 36.4 and 15.02 mg/g respectively. The experimental data were subjected to different kinetic and equilibrium models. The kinetic data confirmed the fitness of pseudo-second-order rate law for NGY biosorption. The equilibrium modelling was carried out by Freundlich, Langmuir and Temkin models. The isothermal data of NGY removal were best described by Freundlich adsorption isotherm. Negative values of Free energy change (Δ G⁰) for NGY with native and pretreated biomass depicted the spontaneous nature of biosorption process. In column mode, the effects of bed height, flow rate and initial dye concentrations were optimised. Maximum NGY biosorption (7.28 mg/g) was observed with high bed height, low flow rate and high initial concentration in continuous mode. Bohart–Adams model best fitted to the data obtained from column studies. The results indicated that the peanut hulls could be used effectively for the removal of dyes containing wastewater.     

USSB厌氧反应器-好氧工艺处理生活污水

对上流式分段污泥床(Upflow Staged Sludge Bed)反应器与好氧组合工艺处理生活污水进行了试验研究。结果表明：当生活污水中COD、氨氮和总磷(rP)质量浓度分别在100～580mg／L、13．4～33．6mg／L和1．6～10．8mg／L2之间变化时。经该组合工艺处理后,三者的去除率分别在77％、53．4％和51．4％以上,出水中COD和Nng—N浓度达到GB8978—1996一级排放标准,即浓度也基本达到GB8978—1996二级排放标准,取得了良好的运行效果。     

生物脱氮除磷机理及技术进展

生物脱氮除磷技术一直是污水处理领域所关注的重点。笔者介绍了传统生物脱氮除磷机理及其相关进展,并从反应器和机理两方面介绍了几种高效、经济、实用的生物脱氮除磷工艺。     

上流式厌氧污泥反应器在石化高浓度废水预处理中的应用

为了更加有效地处理己内酰胺高浓度废水,在原A/O处理系统前采用上流式厌氧污泥反应器先对高浓度己内酰胺废水进行预处理.工业应用结果表明:由于己内酰胺高浓度废水中含有大量的硫酸盐、磷酸盐和硝酸盐等无机酸盐,因此必须严格控制反应系统进水的pH值在5.5～6.5之间,以有效保证系统平稳运行,防止酸化;当COD控制在8000～12000mg/L时,COD的去除率可达到55%以上,达到了处理后的水质要求.     

Metallic wastewater treatment by sulfate reduction using anaerobic rotating biological contactor reactor under high metal loading conditions

An-RBC reactor is highly suited to treat metallic wastewater. Metal removal is due to sulfide precipitation via sulfate reduction by SRB. Cu(II) removal was the best among the different heavy metals. Maximum metal removal is achieved at low metal loading condition. Metal removal matched well with the solubility product values of respective metal sulfide salts. This study was aimed at investigating the performance of anaerobic rotating biological contactor reactor treating synthetic wastewater containing a mixture of heavy metals under sulfate reducing condition. Statistically valid factorial design of experiments was carried out to understand the dynamics of metal removal using this bioreactor system. Copper removal was maximum (>98%), followed by other heavy metals at their respective low inlet concentrations. Metal loading rates less than 3.7 mg/L?h in case of Cu(II); less than 1.69 mg/L?h for Ni(II), Pb(II), Zn(II), Fe(III) and Cd(II) are favorable to the performance of the An-RBC reactor. Removal efficiency of the heavy metals from mixture depended on the metal species and their inlet loading concentrations. Analysis of metal precipitates formed in the sulfidogenic bioreactor by field emission scanning electron microscopy along with energy dispersive X-ray spectroscopy (FESEM-EDX) confirmed metal sulfide precipitation by SRB. All these results clearly revealed that the attached growth biofilm bioreactor is well suited for heavy metal removal from complex mixture.     

不同基质条件下厌氧氨氧化SMBBR启动特性研究

通过接种某城市污水处理厂好氧池生物膜,采用NH₄⁺-N+NO₂^--N （SMBBR-1）和NH₄⁺-N+NO₃^--N+HAc （SMBBR-2）两种进水基质启动厌氧氨氧化序批式移动床生物膜反应器（Sequencing Moving Bed Biofilm Reactor,SMBBR）,研究不同基质条件下反应器的启动特性.结果表明,两反应器在运行100 d后均成功启动并稳定运行,在进水负荷分别为0.83和0.32 kg·m^-3·d^-1（以N计）的条件下,氮去除率分别达到81.82%±1.20%和66.35%±4.79%.活性测定结果显示,SMBBR-1和SMBBR-2中Anammox活性分别达到6448.32和1980.32 mg·m^-2·d^-1,表明Anammox菌被成功富集.高通量结果显示,SMBBR-1和SMBBR-2中启动成功后的Anammox菌由Ca.Brocadia和Ca.Jettenia组成,其中,Ca.Brocadia占比分别为11.02%和7.57%,Ca.Jettenia占比分别为2.07%和0.56%.除Anammox菌外,SMBBR-2中还包括Thauera（2.84%）和Flavobacterium菌（0.66%）,其为部分反硝化菌的主导菌属.本研究表明,虽然两种不同基质的启动办法各有利弊,但其均能实现厌氧氨氧化SMBBR的启动,可为主流系统内的Anammox菌快速富集培养提供技术支撑.