AF反应器对芳香族化合物反硝化降解特性研究

以苯、联苯和萘为模型化合物,研究了厌氧滤池（AF）反应器在反硝化及连续运行条件下对含这几种芳香族化合物模拟废水的处理效果,并以葡萄糖为补充碳源,考察了不同C/N对有机物反硝化降解特性的影响.结果表明,在长期连续流运行及反硝化条件下,AF反应器对废水中几种典型芳香族化合物具有良好地去除效果,当进水COD浓度约为1?000mg/L,苯、联苯和萘总浓度为60mg/L时,出水COD去除率可达到90％,芳香族化合物的去除率可达到84％.苯比萘和联苯更易于反硝化降解.C/N在5～30范围内,苯的降解率均达到90%,C/N对苯的降解没有明显影响;COD、萘和联苯去除率受C/N影响较大,C/N为15时,COD、萘和联苯去除率最大,分别为90%、78%和82%.     

Sludge concentration dynamic distribution and its impact on the performance of UNITANK

UNITANK is a biological wastewater treatment process that combines the advantages of traditional activated sludge process and sequencing batch reactor, which is divided into Tank A, B and C. In this study, the sludge distribution and its impact on performance of UNITANK were carried out in Liede Wastewater Plant （WWTP） of Guangzhou, China. Results showed that there was a strong affiliation between Tank A and B of the system in sludge concentration distribution. The initial sludge concentration in Tank A could present the sludge distribution of the whole system. The sludge distribution was mainly influenced by hydraulic condition. Unsteady sludge distribution had an impact on variations of substrates in reactors, especially in decisive reactor, and this could lead to failure of system. Settler could partially remove substrates such as COD and NO3-N, but there was adventure of sludge deterioration. The rational initial sludge concentration in Tank A should be 4000-6000 mg/L MLSS.     

Anaerobic tapered fluidized bed reactor for starch wastewater treatment and modeling using multilayer perceptron neural network

Anaerobic treatability of synthetic sago wastewater was investigated in a laboratory anaerobic tapered fluidized bed reactor(ATFBR) with a mesoporous granular activated carbon(GAC)as a support material.The experimental protocol was defined to examine the effect of the maximum organic loading rate(OLR),hydraulic retention time(HRT),the efficiency of the reactor and to report on its steady- state performance.The reactor was subjected to a steady-state operation over a range of OLR up to 85.44 kg COD/(m~3.d).The COD removal efficiency was found to be 92% in the reactor while the biogas produced in the digester reached 25.38 m~3/(m~3·d) of the reactor. With the increase of OLR from 83.7 kg COD/(m~3.d),the COD removal efficiency decreased.Also an artificial neural network(ANN) model using multilayer perceptron(MLP)has been developed for a system of two input variable and five output dependent variables. For the training of the input-output data,the experimental values obtained have been used.The output parameters predicted have been found to be much closer to the corresponding experimental ones and the model was validated for 30% of the untrained data.The mean square error(MSE)was found to be only 0.0146.     

Application of 1D and 2D MFR reactor technology for the isolation of insecticidal and anti-microbial properties from pyrolysis bio-oils

Valuable chemicals can be separated from agricultural residues by chemical or thermochemical processes. The application of pyrolysis has already been demonstrated as an efficient means to produce a liquid with a high concentration of desired product. The objective of this study was to apply an insect and microorganism bioassay-guided approach to separate and isolate pesticidal compounds from bio-oil produced through biomass pyrolysis. Tobacco leaf (Nicotianata bacum), tomato plant (Solanum lycopersicum), and spent coffee (Coffea arabica) grounds were pyrolyzed at 10°C/min from ambient to 565°C using the mechanically fluidized reactor (MFR). With one-dimensional (1D) MFR pyrolysis, the composition of the product vapors varied as the reactor temperature was raised allowing for the selection of the temperature range that corresponds to vapors with a high concentration of pesticidal properties. Further product separation was performed in a fractional condensation train, or 2D MFR pyrolysis, thus allowing for the separation of vapor components according to their condensation temperature. The 300–400°C tobacco and tomato bio-oil cuts from the 1D MFR showed the highest insecticidal and anti-microbial activity compared to the other bio-oil cuts. The 300–350 and 350–400°C bio-oil cuts produced by 2D MFR had the highest insecticidal activity when the bio-oil was collected from the 210°C condenser. The tobacco and tomato bio-oil had similar insecticidal activity (LC₅₀ of 2.1 and 2.2 mg/mL) when the bio-oil was collected in the 210°C condenser from the 300–350°C reactor temperature gases. The 2D MFR does concentrate the pesticidal products compared to the 1D MFR and thus can reduce the need for further separation steps such as solvent extraction.     

明清苏浙沿海台风风暴潮灾害序列重建与特征分析

在系统搜集、整理明清苏浙沿海潮灾记录基础上,建立风暴潮频率辨识方法,复原台风风暴潮灾害750次,据此建立逐年风暴潮频率序列。分析显示,1460~1480年、1570~1595年、1715~1745年、1785~1810年、1880~1890年为风暴潮活跃期。明清苏浙沿海风暴潮存在45 a、25 a、14 a三种时间尺度周期,其中45 a周期最为显著。气候跃变分析表明,1402年、1457年、1566年、1624年、1652年、1711年、1846年、1880年风暴潮活动趋于活跃;1444年、1477年、1543年、1634年、1799年、1856年风暴潮趋于平静。与1470年以来温度距平曲线对比显示,气候冷暖与风暴潮发生频率有一定正相关性,全球变暖背景下苏浙沿海可能面临更为严重的风暴潮威胁。苏浙地区明清时期风暴潮灾害空间分布差异明显,大部分风暴潮记载集中于长三角、杭州湾地区,苏北地区风暴潮数量少但影响范围广,浙东地区受地形和经济发展程度影响,风暴潮记载数量少且集中于滨海。     

废液处理新工艺超临界水氧化（SCWO）评述

超临界水氧化是一项对有机废液焚烧处理最有潜力的替代技术,在过去的20多年里,这项技术引起了广泛的关注。然而,作为一项管端技术,超临界水氧化仍存在许多不足,这些不足阻碍了它的工业应用。除了反应器腐蚀和盐析导致的技术问题外,超临界水氧化经常被认为是一项处理所有废液的“通用”技术,然而也是无法实现的“通用”技术。本文介绍了作为管端处理技术的超临界水氧化技术存在的问题,讨论了可能的解决办法,介绍了不同反应器的概念,提出了在超临界水氧化领域里开展进一步研究和发展新工艺流程的建议。此外,评价了超临界水氧化技术涉及到的自身能源供应问题。     

土壤中钙、镁的形态分析及提取序列的研究

本文采用改进的BCR三步连续提取法对河北某食道癌高发地土壤中钙、镁进行了形态分析及提取序列的研究。实验表明：该地区土壤中镁主要以残渣态形式存在（占总量的83.66％-88.36％）,钙则受提取序列的影响很大,在第一提取序列中,以酸溶态为主（74.11％-83.38％）;第二提取序列中,以有机物结合态为主（78.12％-97.17％）;第三、四提取序列中,以氧化物结合态为主（87.49％-103％）。提取剂的加入顺序明显影响到钙的各个形态的真实含量。     

ABR反应器的两种快速启动方法对比

ABR反应器的启动是ABR反应器能否高效稳定运行的关键,其影响因素很多。为了更好地实现ABR反应器的启动,提出了通过2种不同启动方法的对比,即1^#反应器采用好氧预挂膜的方法,2^#反应器采用低负荷启动法,得出的结论为,好氧预挂膜启动法的启动时间短,COD去除率高,出水pH稳定,颗粒状污泥生长情况较好,是一种可推广的启动方法。     

厌氧序批式反应器内挥发性脂肪酸积累特性研究

小试规模的厌氧序批式反应器（ASBR）,通过人工配水,研究了启动3个月时间以及一个运行周期内反应器内挥发性脂肪酸（VFA）的积累情况,并通过分析期间产甲烷活性的变化说明了控制VFA积累的重要性。经过近120 d的运行,乙酸和丙酸的最大比产甲烷活性分别提高了1.8和2.2倍,说明反应器的启动过程即是微生物群落的优化和选择的过程,ASBR的抗冲击的能力较强说明随启动的进行和种群的优化,活性污泥凝聚性能增强,对VFA的降解能力增强。     

Fluoride removal by a continuous flow electrocoagulation reactor

Long-term consumption of water containing excessive fluoride can lead to fluorosis of the teeth and bones. Electrocoagulation (EC) is an electrochemical technique, in which a variety of unwanted dissolved particles and suspended matter can be effectively removed from an aqueous solution by electrolysis. Continuous flow experiments with monopolar aluminium electrodes for fluoride removal were undertaken to investigate the effects of the different parameters such as: current density (12.5-50A/m(2)), flow rate (150-400 mL/min), initial pH (4-8), and initial fluoride concentration (5-25mg/L). The highest treatment efficiency was obtained for the largest current and the removal efficiency was found to be dependent on the current density, the flow rate and the initial fluoride concentration when the final pH ranged between 6 and 8. The composition of the sludge produced was analysed using the X-ray diffraction (XRD) spectrum. The strong presence of the aluminium hydroxide [Al(OH)(3)] in the above pH range, which maximizes the formation of aluminium fluoride hydroxide complex [Al(n)F(m)(OH)(3n-m)], is the main reason for defluoridation by electrocoagulation. The results obtained showed that the continuous flow electrocoagulation technology is an effective process for defluoridation of potable water supplies and could also be utilized for the defluoridation of industrial wastewater.