基于虚拟现实技术的喷射火事故三维动态仿真及应用

基于Shell模型的原理和计算方法,把喷射火焰视为近似倒立圆台形,构建了不同风向影响下的喷射火三维模型,运用虚拟现实技术和三维可视化技术对喷射火事故进行模拟与仿真。以Delphi和OpenGL/GLScene为开发工具,实现了喷射火三维模型的程序化与三维场景绘制,同时引入粒子特效系统,实现了喷射火焰燃烧的实时动态仿真,完成了喷射火三维动态可视化软件系统的开发。最后,利用该系统进行实例分析。应用表明:虚拟现实技术与事故后果模拟相结合,使整个系统实现实时性和形象性的统一,虚拟现实技术在化工行业具有广泛应用前景,也为事故后果预测评估提供科学依据。     

济南市大气水平能见度与环境污染相关性分析

利用济南市2011年1月1日至12月31日大气水平能见度在线监测小时数据和对应细颗粒物(PM2.5)、PM2.5中碳组分(EC和OC)、挥发性有机物(VOC)及气象参数资料,分析污染物、气象参数等对能见度的影响。结果显示,相对湿度和PM2.5是影响能见度的主要因子,能见度与相对湿度及PM2.5浓度主要呈指对数关系。结合相对湿度条件对PM2.5浓度与能见度关系进行综合分析,得到相关经验模型公式,并利用2010年6月1日至11月30日的相应数据资料进行实例关系验证,结果表明,建立的经验模型公式有较好的实际应用价值。     

不同粒径炉渣对磷的静态吸附

研究了不同粒级炉渣对含磷废水的静态等温吸附性能,为其在污水处理领域的有效利用和合理级配提供理论依据。经筛分得到<0.2 mm、0.2~0.45 mm、0.45~0.9 mm、0.9~2 mm、2~4 mm、4~6 mm、≥6 mm的7个粒级的供试炉渣,其中0.9~4 mm粒级占总量的64.54%。XRD、XRF分析显示,各粒级炉渣物相组成相似,<0.2 mm粒级炉渣中活性铝含量最高。静态吸附实验表明,炉渣对磷素的最大吸附量为4 021 mg/kg,最佳吸附时间为24 h;Langmuir和Freundlich吸附等温线可较好地拟合各粒级炉渣对溶液中磷素的吸附,而小于0.9 mm粒级炉渣具有更高的拟合度;炉渣粒径越小,吸附能力越强,<0.2 mm粒级炉渣的理论饱和吸附容量达14 084 mg/kg,≥6 mm粒级炉渣吸附磷素能力差;受粒径、溶液含磷浓度等因素影响,炉渣的平均理论吸附容量为1 142.4 mg/kg。     

筛分法和显微镜法对矿化垃圾粒径分布的比较

为寻求合理有效的矿化垃圾粒径分布分析方法,分别采用筛分法和显微镜法两种测量手段对其进行比较研究。结果发现,两种方法所得的粒径分布结果差异较大,筛分法可能由于颗粒间静电吸附、聚合成团等因素影响而对小粒径颗粒区分能力较差,主要适用于大粒径颗粒的粒径分布测量(dp>100μm);显微镜法能够直观地观察到颗粒的显微图像,但测量时只是随机选择区域进行局部颗粒的测量,不宜分析粒度范围宽的样品,更适用于测量粒径较小的颗粒(dp<20μm)。     

内电解—Fenton氧化—絮凝沉淀预处理焦化废水

采用内电解—Fenton氧化—絮凝沉淀的化学集成技术预处理焦化废水,优化了各工段的运行参数。实验结果表明：在钢铁铁屑与活性炭的体积比为1∶1的条件下,内电解工段的优化参数为进水pH 2.6~3.1、HRT=1.0 h;Fenton氧化工段的优化参数为Fe2+加入量200 mg/L、H2O2加入量1 000 mg/L、进水pH 3.0左右、反应时间1.0 h;絮凝沉淀工段的设定参数为进水pH 9.5~10.0、聚丙烯酰胺加入量1 mg/L、静置沉降0.5 h。在上述工艺条件下,该集成技术对废水的总COD去除率大于55%,处理后的废水BOD5/COD大于0.28,不添加稀释新水即可进入后续生化处理系统。该工艺占地面积小、系统结构简单、易于工业化,废水预处理成本为4~5元/t。     

Particulates and Metallic Elements Monitoring at Two Sampling Sites (Harbor,Airport) in Taiwan

This study characterized the dry deposition flux and dry deposition velocity (Vd) of metallic elements attached on particulate matter. Specifically, large particles (>10 μm), coarse particles (10 μm～2.5 μm), and fine particles (<2.5 μm) were studied at the Gong Ming Junior High School (Taichung Airport) and Taichung Harbor sampling sites in central Taiwan. Ambient air samples were collected to determine total suspended particulate matter (TSP), dry deposition plate (DDP), Vd, coarse particulate matter (PM_2.5–10) and fine particulate matter (PM_2.5), and metallic elements concentrations at the Airport and Taichung Harbor sites between June 17, 2013, and November 14, 2013. The results revealed that the average TSP, DDP, Vd, PM_2.5–10, and PM_2.5 particulate at the Airport were 54.55 (μg/m³), 902.25 (μg/m²-min), 17.11 (m/sec), 0.003 (μg/m³), and 0.010 (μg/m³), respectively; while these values at Taichung Harbor were 63.66 (μg/m³), 539.69 (μg/m²-min), 9.94 (m/sec), 0.003 (μg/m³), and 0.014 (μg/m³), respectively. In addition, the results showed that the average Cu and Pb concentrations were higher than Cr, Ni, and Cd for both the airport and harbor sampling sites. Furthermore, Cr, N, Cu, Cd, and Pb had the highest average concentrations versus those reported for other study areas, with one exception: The results obtained in Kacanik, Kosovo, during 2005. The average metallic elements concentrations order was Cu > Pb > Cr > Ni > Cd.     

火电厂降低PM2.5排放措施研究

简要介绍了几种新型实用的火电厂降低PM2.5排放的控制技术,为火电厂最大限度的降低PM2.5排放提供系统的设计方案。     

Fuel from waste tyres and particulate matter emitted from the process

The interest in obtaining alternative fuels from waste sources and at the same time diminishing the impact of waste disposal has drawn attention to scrap tyres' carbon recovery. In order to thermally degrade used tyre rubber, a laboratory pyrolysis system was developed in this work. The installation devised focused on the production of liquid pyrolysates, where shredded rubber was supplied as the feedstock and nitrogen used as the carrier gas to provide an oxygen-free atmosphere. The variables affecting the performance of the process were investigated, including target temperature, heating rate and total residence time. Characterization of the volatile matter released was conducted by means of mass spectrometry to determine the composition of products, and particulate matter analysis to ascertain the aerosol content in the gas stream. The reproducibility of experiments, the influence of the temperature and time, and differences between the vapours before condensation and the exhaust gases are discussed. This work identified that the larger hydrocarbon fragments condense to constitute the oils, whereas the lighter molecules remain as non-condensable gases. This work also identified that the total number of nano-scale particles carried by the exhaust stream varies with temperature; significant changes in the composition of products and particle content were reported at approximately 400°C. The high number of nano-scale solid particulate matter present in the exhaust gases suggests that a thorough treatment for that stream would be required to avoid human health hazards.     

Removal potential of anti-estrogenic activity in secondary effluents by coagulation

Anti-estrogenic activity in wastewater is gaining increased attention because of its endocrine-disrupting function. In this study, the level and removal efficiency by coagulation of anti-estrogenic activity in secondary effluents of domestic wastewater treatment plants were studied. Anti-estrogenic activity was detected in secondary effluent samples at a tamoxifen (TAM) equivalent concentration level of 0.38–0.94 mg-TAM L⁻¹. Dissolved organic matters (DOM) with the molecular weight (MW) less than 3000 Da in hydrophobic acids (HOA) and hydrophobic neutrals (HON) fractions of the secondary effluent were the key fractions related to anti-estrogenic activity. Coagulation with FeCl₃ and polyaluminium chloride (PAC) can remove the anti-estrogenic activity of the secondary effluents, but the removal efficiency was limited. The removal efficiency using FeCl₃ coagulant was higher than that induced by PAC. Dissolved organic carbon was continuously removed with increased coagulant dose (0–120 mg L⁻¹ FeCl₃ or 0–60 mg L⁻¹ PAC). However, the removal of anti-estrogenic activity was not enhanced further when the coagulant concentration was beyond a critical value (30 mg L⁻¹ FeCl₃ or 10 mg L⁻¹ PAC). The highest removal of anti-estrogenic activity was about 36% by FeCl₃ and 20% by PAC. Size exclusion chromatography results indicated difficulty in removing DOM with MW less than 3000 Da in the secondary effluent during coagulation even at a high coagulant concentration, which led to low removal efficiency of anti-estrogenic activity.     

Persistence of hexaconazole,a triazole fungicide in soils

Abstract

Persistence of hexaconazole (2‐(2,4‐dichlorophenyl)‐l‐(lH‐l,2,5‐triazol‐l‐yl) hexan‐2‐ol) was studied in alluvial, red and black soils under flooded and nonflooded conditions. This fungicide was more persistent in all soils under flooded conditions than under nonflooded conditions and at 27°C than at 35°C. Degradation of hexaconazole in sterilized and nonsterilized soils proceeded at identical rates indicating a minor role of micro‐organisms in its degradation. The soil persistence of hexaconazole was not affected by the addition of wheat straw both under flooded and nonflooded conditions.