A／O生物接触氧化系统处理化妆品废水试验研究

采用A／O生物接触氧化法处理化妆品废水的试验研究结果表明：该工艺处理效果良好，在厌氧段和好氧段水力停留时间分别为15h和13h、有机负荷为2．85KgCOD/m^3.d时，不需任何预处理或后续深度处理，废水CODcr值可从1780g／L降至150mg/L以下，去除率达到93．5％以上。     

城市污水的混凝处理及混凝污泥厌氧消化研究

采用聚合氯化铝与有机高分子絮凝剂复合投加的方法,对上海市闵行污水处理厂曝气沉砂池出水进行一级强化处理,研究了其对浊度、COD的去除效果,确定最佳投药量。在确定最佳投药量后,对混凝所产生污泥进行厌氧消化的可行性研究。结果表明:(1)有机絮凝剂与聚合氯化铝复合投加的强化效果明显优于单独投加聚合氯化铝;同时,聚合氯化铝与阳离子型有机絮凝剂复合投加的效果要优于阴离子型,并且可以进一步降低聚合氯化铝的投加量;使用聚合氯化铝与两性型有机絮凝剂复合投加也取得了较为满意的效果,与使用阳离子型有机絮凝剂的效果接近。(2)综合考虑COD、浊度和药剂投加量,当聚合氯化铝投量为30mg/L、阳离子型有机絮凝剂KP1205E投加量为2mg/L时,取得比较理想的效果。(3)被处理水的水质变化对化学一级强化的处理效果有很大影响,被处理水中溶解性的有机物组分越高,处理效果相应越差。(4)采用厌氧消化对混凝污泥进行处理,在投配比为5%时,单位VSS的产气量最大,达到0.76L/g,污泥的可消化性较好。     

VTBR生化反应器＋ME微电解工艺在生活污水处理及回用工程中的应用

VTBR生化反应器 ME微电解工艺是一种新型、高效的污水处理技术。在锦州港300t／d生活污水处理及回用工程中得到应用，出水达到(DB21-59-89)二级标准和建设单位回用要求。     

含硫废水电净化工艺试验研究

对电氧化处理含硫废水的工艺和机理进行了探讨和模拟实验。在容积为１０Ｌ，ｐＨ７０～１００，Ｓ２－浓度５０～１０００ｍｇ／Ｌ，ＣＯＤＣｒ２６０～２７００ｍｇ／Ｌ的无隔离电净化槽液中，温度３０～６０℃，槽压３～５Ｖ，通过电量０８～３６Ａｈ／Ｌ时，脱硫率与ＣＯＤＣｒ去除率分别达９３％和８５％，每ｋｇ硫能耗４９５ｋＷ·ｈ或每污水耗能２００ｋＷ·ｈ。处理成本为氧化脱硫或汽提脱硫的１／３～１／２。     

城市污水一级半处理方法的研究

本文提出了用高负荷生物接触氧化法对城市污水进行一级半处理的方法。采用软性填料接触氧化池处理模拟城市污水的合成污水,在负荷为10—25kgCOD/m~3·d时,有机物去除率为60％—70％,处理程度介于一级与二级处理之间,相当于一级半处理。一级半处理方法可使有机物去除速度大大增加,同时获得含能量较大的生物污泥,为消化产气、能量回收创造条件。     

Prospects for mitigating carbon,conserving biodiversity,and promoting socioeconomic development objectives through the clean development mechanism

Should forest-based climate mitigationmeasures be approved for crediting through the CleanDevelopment Mechanism (CDM), they could offer anopportunity to accomplish three important objectives:cost-effective reductions in carbon emissions andsequestration of atmospheric carbon; conservation andrestoration of forests and their biological diversity;and, the assistance of host countries and communitiesin their socioeconomic development. However,prospective investors in CDM projects, host countriesand other CDM `stakeholders' might be expected toplace widely different priorities on achieving theseobjectives. This paper describes several factors thatwill affect investor interest in CDM projects, thecharacteristics of forest-based CDM projects that willattract investments, and an approach to identifyingprojects that meet the key objectives of multiplestakeholders. This approach entails identifyingsites, such as degraded watersheds, where CDMfinancing for forest conservation and restoration cangenerate readily monetizable local and regionalsocioeconomic benefits, while mitigating carbonemissions in forests with importance for conservingbiodiversity.     

The role of CH4 and N2O emission reductions in the cost-effective control of the greenhouse gas emissions from Finland

The reduction of carbon dioxide (CO₂) emissions may be quite expensive and it is necessary to consider reduction measures for other anthropogenic greenhouse gases, such as methane (CH₄) and nitrous oxide (N₂O) as well. Their contribution to the total GHG emission from Finland is about 15–20%. In Finland most of the CH₄ emissions are due to waste management, agriculture and burning processes. N₂O emissions originate from burning processes, agriculture, industry and atmospheric deposition of nitrogen. The cost-effective reduction of the Finnish GHG emissions has been studied with the EFOM-ENV model, which is a quasi-dynamic linear energy system optimisation model. The target function to be minimised is the total discounted cost for the modelled system. In this study the model has been expanded to cover all well-known anthropogenic CO₂, CH₄ and N₂O sources and reduction measures. The results indicate it is economic to reduce the emissions of CO₂, CH₄ and N₂O in Finland. It is profitable to exploit the economic reduction potential of CH₄ and N₂O, because then the abatement of CO₂ emissions does not need to be as extensive as when the reduction is aimed only at CO₂ emissions. The inclusion of CH₄ and N₂O decreases the annual reduction costs about 20% in the year 2010.     

污水处理中污泥处理技术分析

污水处理产生的污泥中含有不同的有机和无机污染物，其处置以减量化、稳定化和无害化为目的，经浓缩和脱水后，视不同情况采用焚烧、填埋和资源化等处理技术。     

化学氧化—厌氧生物组合工艺处理纸浆废水的研究

研究了Fdenton试剂氧化＋厌氧生物组合工艺处理纸浆废水的可行性，确定了Fenton试剂氧化处理的影响因素并对氧化出水进行了有关厌氧生物处理，结果证明采用化学氧化与生物处理相结合的处理方案是可行的。     

“双高法生物脱酚”在焦化污水处理中的应用

本文介绍了“双高技术”在本钢一铁厂生物脱酚工程中的应用。该方法的除萘，除氰，除油，生化设计，污泥分离方法及无剩余污泥等技术，水平先进，具有特色，可供同行业参考。