温度对复合厌氧折流板膜生物反应器处理生活污水效能的影响简

将新型CAMBR反应器（厌氧折流板反应器（ABR）与膜生物反应器（MBR）优化组合）用于处理生活污水,研究温度对该反应器处理效能的影响。实验水力停留时间7.5 h,混合液回流比设置为200%,pH值为6.5~8.5,溶解氧3 mg/L左右。控制3个温度梯度：高温（32~37℃）,中温（20~25℃）,低温（5~10℃）,每个温度运行35 d。结果表明,在高温条件下,系统出水COD、NH₄⁺-N、TN和TP平均浓度分别为25、0.5、12.5和0.7 mg/L。在中温条件下,系统出水COD、NH₄⁺-N、TN和TP浓度分别30、1.2、12.5和0.4 mg/L。在低温条件下,COD和TP分别经过15 d和20 d调整适应,出水可恢复至35 mg/L和1 mg/L。由于低温（10℃以下）对硝化细菌产生强烈抑制,出水NH₄⁺-N去除率最终稳定在35%,TN去除率为40%。低温条件下,该反应器应用于污水处理中需注意适当保温,以保证出水水质。     

城市污泥微波干化工艺及干化特性研究

采用微波和烘箱结合及全程烘箱2种方式对城市污泥干化进行对比研究,考察了不同粒径、微波干化预处理、预处理时间及烘箱温度对污泥干燥特性的影响。结果表明,同一温度条件下,微波预处理时间越长,污泥干化速率越快。最优条件下,全程烘箱污泥达到最大干化速率的含水率为77%。微波干燥污泥具有时间短、干燥速率大的特点,微波和烘箱结合对比全程烘箱干化速率高且能耗低。     

基于电力结构调整的上海市电力行业大气污染物排放总量研究

基于上海市能源与电力统计数据,参考政府间气候变化专门委员会(IPCC)及国内发电企业污染物排放相关研究报告,设定不同发电方式的装机比例,分析核算不同装机比例下SO2、NOX以及CO2的排放量与减排量。结果表明,装机比例提升10.0%,相比煤电装机,天然气装机的SO2、NOX及CO2的排放量分别降低90.2%、91.3%与99.9%,减排效果显著。新能源装机比例由5.0%提升至10.0%,SO2、NOX及CO2分别削减3.0×103、3.8×103、3.6×107 t。     

市政污泥与生活垃圾混烧技术验证

对市政污泥与生活垃圾混烧进行了验证研究。结果表明,与生活垃圾单独焚烧相比,污泥与生活垃圾混烧后烟气中NOx、CO和HCl的浓度没有出现明显变化,而SO2浓度出现了下降（从82～93mg／m3下降至41～70mg／m3）;Hg、Pb、Sn、Cr和Zn的浓度均表现为不同程度的上升,但仍然符合GB[g485;二恶英从0．0087μgTEQ／m3降至O．0047μgTEQ／m3。掺烧半干污泥比例为10％、12％和15％时,吨物质的发电量分别为311．8kWh／t、306．7kWh／t和296．1kwh／t。混烧污泥在一定程度上降低了系统的发电量,因此建议混烧污泥的比例不应大于15％。测算的污泥混烧成本约209元／t（80％含水率）。     

分段进水SBR短程生物脱氮过程中N_2O产生及控制

利用SBR,控制曝气量为60 L/h,利用在线pH曲线控制曝气时间,成功实现了短程生物脱氮过程,并考察了不同进水方式下SBR运行性能及N2O产量。结果表明,分段进水能够有效降低短程生物脱氮过程中外加碳源投加量。在原水进水碳氮比较低时,采用递增进水量的进水方式,能够有效降低生物脱氮过程中NO-2积累量,从而降低系统N2O产量。1次进水、2次等量进水和2次递增进水方式下,生物脱氮过程中N2O产量分别为11.1、8.86和5.04 mg/L。硝化过程中NO-2-N的积累是导致系统N2O产生的主要原因。部分氨氧化菌（AOB）在限氧条件下以NH＋4-N作为电子供体,NO-2-N作为电子受体进行反硝化,最终产物是N2O。     

污泥活性炭的表征及其对Cr（Ⅵ）的吸附特性

以城市污水处理厂污泥为原料,采用磷酸活化一微波热解法制备得到污泥活性炭,并将其用于吸附水溶液中的Cr（Ⅵ）。分别采用元素分析仪（VarioELcube）、比表面积孔径分布测定仪（ASAP2020）、扫描电镜（SEM）和傅里叶红外光谱（FT—IR）等仪器对原污泥及污泥活性炭的表面组成和结构进行表征,探讨污泥活性炭的孔隙结构参数和表面化学性能。通过静态吸附实验,考察了溶液初始pH,接触时间,初始Cr（Ⅵ）浓度对污泥活性炭吸附Cr（Ⅵ）效果的影响,并探讨了污泥活性炭去除Cr（Ⅵ）的机理。实验结果表明,pH越低吸附效果越好,吸附平衡时间为100h。不同温度下吸附过程均符合Langmuir等温吸附模型,30℃时最大吸附容量为27．55mg／g;吸附动力学过程符合准二级速率方程（R2〉0．99）;污泥活性炭对Cr（Ⅵ）的去除是一个吸附-还原耦合的过程。     

Status and Environmental Impact of Emissions from Thermal Power Plants in India

The main emissions from coal combustion at thermal power plants are carbon dioxide (CO₂), nitrogen oxides, sulfur oxides, chlorofluorocarbons (CFCs), and airborne inorganic particles such as fly ash and soot; CO₂, methane, and CFCs are greenhouse gases. These emissions are considered to be partially responsible for harmful global climate change. This review summarizes the status of thermal power plants in India and their various types of emissions that directly or indirectly produce harmful effects on the environment and human health. Moreover, it focuses on various types of preventive measures used to avoid/minimize emissions.     

市政污泥深度脱水药剂优化研究简

污泥含水率高影响污泥后续处置。利用化学药剂对污泥进行深度脱水处理可使污泥减量化、稳定化。为提高深度脱水效果,对添加剂进行了种类和添加量的优化研究（石灰、工业石灰、粉煤灰、硅藻土、十二烷基磺酸钠和飞灰;5%、10%、15%、20%、25%和30%）,另外,还进行了复合投加实验。研究结果表明,石灰、工业石灰、粉煤灰的深度脱水效果最好;复合添加中,25%石灰+5%粉煤灰,20%石灰+10%粉煤灰,10%石灰+20%粉煤灰的深度脱水效果最好。5%的石灰或者工业石灰的添加剂量使干化污泥pH值达到12.25,粉煤灰、硅藻土、十二烷基磺酸钠和飞灰的添加对干化污泥pH值影响相对要小。     

Analysis of methanol and organometallic MnO2 fuels as alternative fuels in a diesel engine

In this study, methanol and organometallic MnO₂ fuels were used to improve the properties of diesel fuel. In addition, the effect of methanol fuel on engine oil and a piston ring was also examined experimentally in a four-cylinder, direct injection diesel engine running at 200 bar. Three different diesel fuels were prepared by adding 5, 10 and 15% methanol to diesel fuel. In order to prevent phase separation, 1% dodecanol was added to the mixture. Organometallic compounds of manganese were synthesised to prepare the solutions. The most effective amount and performance of anti-freeze were determined. From the results, it was observed that carbon monoxide emissions decreased and NOx emissions increased with the increase in the amount of methanol. On the other hand, organometallic MnO₂ increased the cetane number and decreased the freezing point, viscosity and flame temperature.     

Mobility of dimethoate residues from spring broccoli field

Dimethoate [O, O-dimethyl-S-(N-methylcarbamoyl-methyl) phosphorodithioate] is a broad-spectrum systemic insecticide currently used worldwide and on many vegetables in Kentucky. Dimethoate is a hydrophilic compound (log K_OW = 0.7) and has the potential of offsite movement from the application site into runoff and infiltration water. The dissipation patterns of dimethoate residues were studied on spring broccoli leaves and heads under field conditions. Following foliar application of Dimethoate 4E on broccoli foliage at the rate of 0.47 L acre^?1, dimethoate residues were monitored in soil, runoff water collected down the land slope, and in infiltration water collected from the vadose zone. The study was conducted on a Lowell silty loam soil (pH 6.9) planted with broccoli under three soil management practices: (i) soil mixed with municipal sewage sludge, (ii) soil mixed with yard waste compost, and (iii) no-mulch rototilled bare soil. The main objective of this investigation was to study the effect of mixing native soil with municipal sewage sludge or yard waste compost, having considerable amounts of organic matter, on off-site movement of dimethoate residues into runoff and infiltration water following spring rainfall. The initial deposits of dimethoate were 6.2 and 21.4 μ g g^?1 on broccoli heads and leaves, respectively. These residues dissipated rapidly and fell below the maximum residue limit of 2 μ g g^?1 on the heads and leaves after 10 and 14 d, respectively, with half-lives of 5.7 d on broccoli heads and 3.9 d on the leaves. Dimethoate residues detected in top 15 cm of soil (due to droplet drift and wash off residues from broccoli foliage) one day (d) following spraying, were 30.5 ng g^?1 dry soil in the sewage sludge treatment, and 46.1 and 134.5 ng g^?1 dry soil in the yard waste and no mulch treatments, respectively. Water infiltration was greater from yard waste compost treatment than from no mulch treatment, however concentrations of dimethoate in the vadose zone of the three soil treatments did not differ.