Toxic metals in sewage sludge-amended soils: has promotion of beneficial use discounted the risks?

Land application of contaminated waste products has been defended as beneficial use by some scientists and regulators, based on the premise that the behavior of any toxins accumulated in soils from this practice is reasonably well understood and will not have detrimental agronomic or environmental impacts into the foreseeable future. In this review, I use the case of toxic metals in sewage sludges applied to agricultural land to illustrate that metal behavior in soils and plant uptake is difficult to generalize because it is strongly dependent on the nature of the metal, sludge, soil properties and crop. Nevertheless, permitted agricultural loadings of toxic metals from sewage sludges are typically regulated using the sole criterion of total metal loading or concentrations in soils. Several critical generalizing assumptions about the behavior of sludge-borne metals in soil-crop systems, built into the US EPA risk assessment for metals, have tended to underestimate risks and are shown not to be well justified by published research. It is argued that, in the absence of a basic understanding of metal behavior in each specific situation, a more precautionary approach to toxic metal additions to soils is warranted.     

机械强化污泥回流式一体化活性污泥法的运行机理研究

活性污泥通过机械搅拌强化污泥内循环回流,提高了污泥的活性,并且使污泥浓度可达到4.5kg/m3,用该机械强化污泥回流式一体化活性污泥法处理小区生活污水,当水力停留时间为3h,溶解氧为2.2mg/L,机械搅拌速度为250r/min时,CODcr、氨氮去除率均可达到83% 以上,出水达到国家污水排放一级标准.该一体化活性污泥法简单易行,运行成本低,投资小,操作维护方便,是生活小区生活污水适宜的处理工艺技术.     

A／O-化学除磷工艺中DMBR动态膜成膜条件研究

根据动态膜原理，将0．1mm孔径无纺布为膜材的动态膜反应器（Dynamic Membrane BioReactor，DMBR）应用于A／O-化学除磷工艺之中，在动态膜反应器内完成泥水分离。试验测试了曝气强度、初始膜通量和污泥浓度对动态膜成膜的影响。结果表明，曝气强度和初始膜通量是影响成膜的关键性参数。当曝气强度≥60m^3／m^2·h或初始膜通量≥70L／m^2·h，2h内均不能形成截留性能良好的动态膜。在VSS／SS较低的污泥系统中，适宜的成膜条件为：曝气强度≤40m^3／m^2·h；初始膜通量≤40L/m^2·h。     

油气田开发与炼化企业硫化氢危害分析与预防

分析了油田开发和炼油化工生产过程中H2S的分布区域、特点及危害.通过对66起H2S中毒事故的分析,指出在设备及管线的吹扫、堵漏、拆卸、安装作业过程中较易发生H2S中毒事故;事故主要是由于违章及误操作以及对H2S的毒害认识不够、安全意识差引起的.从管理措施、技术支持、人员培训、应急救援等方面提出了预防H2S中毒的措施.     

膜生物反应器处理印染废水技术研究

采用小试规模(148L/d)的厌氧-好氧膜生物反应器处理印染废水.当水力停留时间为14小时,进水COD、色度分别为208.54～2592.00mg/l、32～256倍,通过水解酸化-体式膜生物反应器试验,系统对COD、色度的去除率分别达到了80%～90%、87.5%.出水水质浓度或指标分别为21.80～363.20mg/l、8倍,具有良好的处理效果.厌氧-好氧膜生物反应器工艺处理印染废水技术可行、操作简单、易于管理、可为工业规模应用提供技术参考.     

高级氧化技术强化皮革废水生化处理效果初探

皮革废水中含大量难降解有机物,导致常规好氧生化处理速率低、效果差.实验考察了在Us(超声波)、UV(紫外光)、US/Fenton、UV/Fenton等高级氧化技术强化作用下的生化处理效果,结果表明,在相同水质和实验条件下,废水经Us、UV处理30min后可使后续生化反应速率显著提高,分别反应8h、24h后的COD去除率即可达到直接经微生物处理48h后达到的48%,但延长反应时间至48h对COD去除率没有明显提高;Fenton试剂强化US、UV的处理效果要高于单独Us、UV工艺,经30min预处理,随后在微生物作用下分别反应4h和8h即可达到45%和51%的COD去除率,同时延长反应时间也能使最终COD去除率明显提高,反应48h后,COD去除率可分别提高至64%和72%.     

复合式厌氧反应器处理城市污水试验研究

采用弹性立体填料的复合式厌氧反应器处理城市污水。研究结果表明 ,该装置处理城市污水效果显著 ,当进水COD在 87～32 0mg L范围内 (平均 2 2 7mg L)变化 ,水力停留时间大于 5 .2h ,反应系统的容积负荷小于 0 .86KgCOD m3.d时 ,常温下COD去除率大于60 % ,出水COD平均为 81mg L ,SS去除率大于 77.8% ,出水SS小于 30mg L ;反应系统在试验条件下温度与溶解性COD去除率成正相关。试验还得出了系统处理城市污水溶解性BOD5去除率随HRT变化的降解动力学模式。     

Fulvic acid removal by nanoparticle TiO2 using a submerged membrane photocatalysis reactor

The degradation of fulvic acid（FA） by nanoparticle TiO2 in a submerged membrane photocatalysis（SMPC） reactor was studied. In this reactor, photocatalytic oxidation and membrane separation co-occured. The continuous air supplier provided O2 for the photocatalytical reaction and mixed the solution through an airflow controller. The particle TiO2 could automatically settle due to gravity without particle agglomeration so it could be easily separated by microfiltration（MF） membrane. It was efficient to maintain high flux of membranes. The effects of operational parameters on the photocatalytic oxidation rate of FA were investigated. Results indicated that photocatalyst at 0.5 g/L and airflow at 0.06 m^3/h were the optimum condition for the removal of fulvic acid, the removal efficiency was higher in acid media than that in alkaline media. The effects of different filtration duration on permeate flux rate of MF with P25 powder and with nanoparticle TiO2 were compared. Experimental results indicated that the permeate flux rate of MF was improved and the membrane fouling phenomenon was reduced with the addition of nanoparticle TiO2 catalyst compared with conventional P25 powder. Therefore, this submerged membrane photocatalysis reactor can faciliate potential application of photocatalytic oxidation process in drinking water treatment.     

膜生物反应器膜污染的水力学控制实验研究

叙述了膜污染是影响膜-生物反应器处理技术推广应用的关键因素，采用水动力学方法是控制膜污染的有效方法。在不同污泥浓度条件下。对不同曝气强度下膜污染的发展速率及其形成机理进行了试验研究，研究结果表明：对应于不同污泥浓度均存在一个经济曝气强度，其大小随污泥浓度升高呈线性增加，膜生物反应器在经济曝气强度条件下运行可控制膜污染的发展；并从理论上推导出一个临界污泥浓度，其值为5．15g／L。对应于临界污泥浓度，并且污泥絮体在膜面可形成比较稳定的动态膜，膜过滤压差上升的速率最慢，膜生物反应器在此临界污泥浓度条件下运行膜污染发展最为缓慢。     

兼性生化处理生活污水最佳工况研究

在常温条件下进行兼性生化处理生活污水试验,研究COD去除率与HRT、MLSS、进水有机物浓度和混合液水温的关系。在试验中最佳的水平搭配为MLSS=5500mg/L,进水有机物浓度=180mg/L,HRT=8h和混合液水温=20℃,与回归分析所得出MLSS=5881mg/L,进水有机物浓度=192.7mg/L,HRT=8.9063h和混合液水温=21.3790℃的最佳工艺条件相吻合。最后通过等高线分析得出常温下生活污水兼性生化的适宜范围。