溶解氧和温度对地下水除铁、锰效果的影响

研究锰砂滤层去除铁、锰过程中温度、溶解氧两个因素对去除效果的影响,为生物法除铁、锰的实际运行提供了参考依据。从经济性和微生物角度考虑,原水DO维持在3mg／L左右即可满足运行要求,采用跌水曝气的方式去除效果优于管道混合器。当铁锰共存时最适宜的处理环境温度为20℃。     

Pool evaporation: Experimental tests at medium-scale with gasoline

Pool evaporation is a major source of flammable vapour clouds. Predicting the evaporation rate of a liquid hydrocarbon pool is therefore a key issue of dispersion modelling for safety concerns. This paper presents small- and medium-scale experiments of pool evaporation carried out with liquid hydrocarbons (pentane, heptane), hydrocarbon “gasoline-like” mixtures and gasoline. Liquid mass loss was measured and the evaporation rate deduced with its evolution in time. Other observations are highlighted, regarding the evolution of liquid temperatures, mixture compositions, and scale effects like the influence of pool length on surface evaporation rate. Comparisons with well-known correlations are then shown. The authors finally suggest a new semi-empirical correlation with a set of parameters fitted on the performed experiments.     

基于响应曲面法的遗煤自燃分析与研究*

为研究高瓦斯易自燃煤层不同供风量、高抽巷抽采流量、低抽巷抽采流量3因素对采空区自燃“三带”分布影响规律,选取阳煤五矿8406工作面为研究对象,在数值模拟研究基础上,采用Design Expert软件进行Box Behnken试验设计,构建采空区氧化升温带宽度在3因素、3水平条件下的二次回归响应曲面模型,并对不同条件下采空区氧化升温带宽度进行预测与分析。结果表明:二次回归方程P值为0.001 6,预测模型显著,模型的失拟项为0.606 3,不显著,回归方程具有统计学意义;当供风量为1 500~2 000 m3/min,低抽流量为450~650 m3/min,高抽流量为100~200 m3/min时,对氧化升温带宽度一次项重要度排序为C（高抽巷抽采流量）>A（供风量）>B（低抽巷抽采流量）,二次项重要度排序为AC（供风量和高抽巷抽采流量）>AB（供风量和低抽巷抽采流量）>BC（低抽巷抽采流量和高抽巷抽采流量）,且AB,AC,BC之间均无交互作用。     

煤对CO2，N2和CH4的吸附速率经验公式与异同性研究*

为了解决吸附速率拟合公式缺乏而解吸经验公式众多的问题,通过替换解吸参数、定性和对比分析各经验公式对煤吸附CO₂,N₂,CH₄吸附速率的适用性,选取4种不同煤质的煤样在0.5,1.0和2.0 MPa下进行定温吸附实验,分析压力和煤质对吸附速率的影响规律。研究结果表明:时间函数式对3种气体在不同压力和煤质下的吸附速率拟合效果最佳;压力和煤质对3种气体吸附速率的影响既存在共性又具有差异性,气体吸附速率与压力符合指数函数关系,与挥发分呈现出二次函数关系,并且压力升高会导致最低吸附速率趋向于较高变质程度煤样;CH₄和N₂的吸附速率随压力升高而升高,而CO₂的吸附速率因煤样而不同,且在同压下,不同气体的最高和最低吸附速率煤样的变质程度也不同。     

Experimental research of LNG accidental underwater release and combustion behavior

Evaluating potential hazards caused by accidental LNG release from underwater pipelines or vessels is a significant consideration in marine transportation safety. The aim of this study was to capture the dynamic behavior of LNG jet released under water and to analyze its vapor dispersion characteristics and combustion characteristics on the water surface during different release scenarios. Controlled experiments were conducted where LNG was jet released from a cryogenic storage tank. The dynamic process of LNG being jet released from orifices of different sizes and shapes, as well as the rising plume structure, were captured by a high-speed camera. The leakage flow rate and pipeline pressure were recorded by a flow meter and pressure gauge, respectively. The concentration distribution that emanated from the water surface was measured utilizing methane sensors in different positions with various wind speeds. The flame combustion characteristics of LNG vapor clouds, which immediately ignited upon the enclosed water tank, were also recorded. Additionally, the mass burning rate of the flame on the water surface was evaluated, and a new correlation between the ratio of flame length and width was established. The results indicated a large dimensionless heat release rate (Q*) and a continuous release flow rate in a limited burning area. This study could provide greater understanding of the mechanisms of LNG release and combustion behavior under water.     

屏蔽服冷却系统对人体表面温度影响的研究*

为科学有效地论证多种方式组合的冷却屏蔽服在不同环境条件下对人体表面温度控制的效果,需要对冷却系统及人体敏感部位发热量进行客观评估。通过对5名健康男性的高温测试,探究人体在不同环境温度下体表温度的变化,得出胸部、背部及额头为热量最高部位,并构建以“人体-降温屏蔽服-外界环境”为主体的冷却系统数值模型,对不同环境中的屏蔽服冷却效果展开研究,分析穿戴冷却屏蔽服时人体躯干部分的温度分布及影响。结果表明:在屏蔽服中靠近胸部、背部部位引入相变材料和风扇,均可帮助人体降低体温,提高舒适度。     

不同边沿高度油池火燃烧行为的实验和数值模拟研究

采用实验和FDS数值模拟相结合的方法,探讨了边沿高度对油池火燃烧特性的影响。在实验部分,研究了燃烧速率和表观火焰高度随边沿高度的变化趋势,并分别分析了各个阶段的热反馈机制。在实验获得不同尺度、边沿高度正庚烷油池火燃烧速率的前提下,建立相应尺度的不同边沿高度油池火的Fire Dynamics Simulator(FDS)计算模型以针对火焰高度进行了数值模拟研究,分析了实际火焰高度、火焰下探高度随边沿高度的变化趋势,并提出了相关的无量纲拟合式。     

Safe speed limits for a safe system: The relationship between speed limit and fatal crash rate for different crash types

Objective: The objective of this article is to provide empirical evidence for safe speed limits that will meet the objectives of the Safe System by examining the relationship between speed limit and injury severity for different crash types, using police-reported crash data.

Method: Police-reported crashes from 2 Australian jurisdictions were used to calculate a fatal crash rate by speed limit and crash type. Example safe speed limits were defined using threshold risk levels.

Results: A positive exponential relationship between speed limit and fatality rate was found. For an example fatality rate threshold of 1 in 100 crashes it was found that safe speed limits are 40 km/h for pedestrian crashes; 50 km/h for head-on crashes; 60 km/h for hit fixed object crashes; 80 km/h for right angle, right turn, and left road/rollover crashes; and 110 km/h or more for rear-end crashes.

Conclusions: The positive exponential relationship between speed limit and fatal crash rate is consistent with prior research into speed and crash risk. The results indicate that speed zones of 100 km/h or more only meet the objectives of the Safe System, with regard to fatal crashes, where all crash types except rear-end crashes are exceedingly rare, such as on a high standard restricted access highway with a safe roadside design.     

固定化包埋亚硝酸菌短程脱氮与同步除磷工艺研究

为实现常温下低碳源城市生活污水的低能耗脱氮除磷,采用固定化技术和厌氧/好氧/缺氧(AOA)工艺耦合与游离组进行了对比实验研究。在温度为25±1℃、pH为8.0±1、DO为1±0.5 mg/L和HRT为9 h的条件下,两组运行结果表明,固定组具有较高的硝化效率和较强的适应能力,亚硝氮的积累率可以稳定维持在70%以上,对NH4+-N、COD和TP的去除率分别为92.2%、87.2%和81.3%,明显优于游离组。     

HRT对固定床厌氧反应器运行效果的影响

为了考察水力停留时间(HRT)对炭纤维载体固定床厌氧反应器运行效果的影响,在进水COD分别为20 000~25 000 mg/L和40 000~45 000 mg/L2个浓度范围下,研究了不同HRT对反应器运行效果的影响。结果表明,通过HRT的调整,在达到相同有机负荷(OLR)下,进水COD为20 000~25 000 mg/L的COD去除率和产气量,明显比进水COD为40 000~45 000 mg/L的运行效果好;进水COD为20 000~25 000 mg/L,HRT为14 h,相应的OLR为41.09 kgCOD/(m3.d)时,COD去除率仍然维持在68%以上,沼气容积产气率达到14.55 m3/(m3.d)。炭纤维载体固定床厌氧反应器具有较高的COD去除率、产气效率以及抵抗低pH、高负荷冲击的能力,运行过程中没有发生反应器堵塞的现象。