基于CVM的荆州市稻田生态系统的景观休闲旅游价值评价

采用条件价值评估法（Contingent Valuation Method,CVM）调查了荆州市居民对稻田生态系统景观休闲旅游功能的认知程度和支付意愿,对受访者的社会经济特征与支付意愿进行了相关性分析,并对荆州市稻田景观休闲旅游功能的价值进行了货币化评估。结果表明,居民对稻田景观休闲旅游功能的认知程度很低,对其十分了解的仅占3.5%,并且更侧重于旅游这一目的,达到61.1%。同时,78.7%的受访者认为稻田景观休闲旅游是赋有乡愁情感的。对影响受访者支付意愿的诸多因素进行相关性分析显示,稻田景观休闲旅游功能的支付意愿与受访者的文化程度（P=0.000）和月收入（P=0.004）呈极显著正相关。运用Logistic回归分析得出,文化程度对支付意愿的敏感性较大。按人均支付意愿计算,荆州市稻田生态系统景观休闲旅游的总价值约为4.43亿元     

Research on the transmission mechanism of low-carbon policies: an empirical study of agricultural companies

Companies bear primary responsibility for low-carbon economy, thus relevant low-carbon policies should be set properly to guide them and to ensure their low-carbon production effectively. To solve the problems generated during low-carbon development, this article verifies the existence of the transmission path and strength. This verification includes mediating variables of companies’ willingness and capacity to conduct low-carbon production, a transmission mechanism through incentive path and resources protection, and questionnaire data of agricultural companies. Conclusions show that the low-carbon policies have obvious positive effects on willingness of corporation; the basic service-oriented policy has a significantly promoting effect on low-carbon production capacity; and low-carbon production performance is positively influenced by willingness as well as capability. Aiming at a better transmission path, some corresponding recommendations have been put forward in the end.     

气候变化背景下人类活动对承德接坝区植被净初级生产力的影响

承德接坝区位于农牧过渡区,对气候变化和人类活动极为敏感.以植被净初级生产力(NPP)作为评价指标,基于Thornthwaite Memorial模型计算潜在NPP和MODIS NPP遥感影像获取实际NPP数据,利用潜在NPP与实际NPP间的差值衡量人类活动作用下NPP的大小,运用Slope趋势和变异系数法分析实际NPP、潜在NPP和人类活动作用下NPP的变化趋势及稳定性分布,并采用相关系数法分析实际NPP与年降水量和年均气温间的相关性,最终量化气候变化和人类活动对该区域植被变化的影响.结果表明,潜在NPP自西北向东南递增,其变化趋势和稳定性均为自西向东递增.实际NPP与年降水量和年均气温呈正相关区域面积占比分别是99.87%和91.66%.该区域99.85%的植被得到改善且变化稳定,主要是由气候因素和人类活动共同主导(99.71%),而植被退化完全是由人为因素所导致(0.15%).     

常温下加装脱硫装置的MCAnMBR处理高硫酸盐有机废水试验

研究了加装脱硫装置的沼气循环厌氧膜生物反应器对含高硫酸盐有机废水的处理效能.在26~34℃的室温下,历时63d成功地启动了加装脱硫装置的MCAnMBR反应器.调试初期,通过调节气路平衡和采用甲醇驯化的方法有效解决了MCAnMBR反应器在处理高硫酸盐有机废水时存在的跑泥和pH上升问题.结果表明,当控制HRT为120 h,有机负荷(以COD计)为3.61~4.36 kg·(m~3·d)~(-1),pH为7.18~7.61时,在23.3~25.4℃的室温下,对含SO_4~(2-)浓度为650~5 800 mg·L~(-1)的有机废水处理效果极佳,出水COD浓度最低可至23 mg·L~(-1),COD总去除率稳定在96.23%~99.77%,SO_4~(2-)还原率可达83.83%~95.51%.说明加装脱硫装置可有效解决硫化物的次级抑制作用问题,且通过梯度试验发现本反应器处理高硫酸盐有机废水的上限为:COD浓度18 000~21 000mg·L~(-1)、SO_4~(2-)浓度9082~9600 mg·L~(-1),COD/SO_4~(2-)为2.     

清洁生产审核在电解铝企业的应用研究

在对某电解铝企业进行清洁生产审核过程中,通过对比中国电解铝行业清洁生产水平指标,运用清洁生产审核的方法,发掘企业清洁生产潜力,针对性的提出并实施了四项中高费方案和26项无低费方案。这些方案实施后,提升了电解生产的控制水平,增加了电流效率;优化了阳极配方工艺,降低了阳极的吨铝消耗;阳极生产改用天然气燃料,减少了大气污染;优化了电解槽工艺,降低了铝电解能耗,取得了良好的环境和经济效益,为今后电解铝企业的清洁生产审核积累了经验。     

重金属铜对萝卜种子发芽性能指标的影响研究

重金属铜是植物生长发育所必需的一种微量元素,但是当浓度过高时对作物会造成一定毒害。因此,对高等植物进行重金属毒理试验就尤为重要。目前已建立的高等植物毒理试验有三种方法,即1．根伸长试验;2．种子发芽试验;3．早期植物幼苗生长试验。本实验所研究的就是在不同浓度的重金属铜的影响下,萝卜的生长状况。通过所做的根的伸长实验、发芽实验和叶绿素实验,对重金属对植物的影响问题,做了一个早期的、比较完整的分析。     

接种比例对酒糟与餐厨垃圾混合厌氧发酵产沼气的影响

采用酒糟与餐厨垃圾作为混合发酵物料,并接种消化污泥进行厌氧干式发酵,比较接种比例(inoculum to substrate ratios,ISRs)(VS质量比)分别为0.5、0.8、1.0、2.0时的甲烷产率和产量、体系VFA、碱度、游离氨等指标。结果表明:接种比例的提高可有效提高甲烷产生速率,缩短发酵周期,减弱较高浓度VFA引起的抑制作用。当ISRs=1.0时产甲烷效果较好,累计产甲烷率为222.58mL/g,VS去除率达83.4%,继续增加接种比例对发酵效果影响不显著。此外,试验中适宜的VFA/碱度值为0.3～1.2,过大或过小都有可能抑制产甲烷过程。     

Carbon dioxide capture using polyethylenimine-loaded mesoporous carbons

A high efficiency sorbent for CO2 capture was developed by loading polyethylenimine (PEI) on mesoporous carbons which possessed well-developed mesoporous structures and large pore volume. The physicochemical properties of the sorbent were characterized by N2 adsorption/desorption, scanning electron microscopy (SEM), thermal gravimetric analysis (TG) and Fourier transform infrared spectroscopy (FT-IR) techniques followed by testing for CO2 capture. Factors that affected the sorption capacity of the sorbent were studied. The sorbent exhibited extraordinary capture capacity with CO2 concentration ranging from 5% to 80%. The optimal PEI loading was determined to be 65 wt.% with a CO2 sorption capacity of 4.82 mmol-CO2 /g-sorbent in 15% CO2 /N2 at 75°C, owing to low mass-transfer resistance and a high utilization ratio of the amine compound (63%). Moisture had a promoting effect on the sorption separation of CO2 . In addition, the developed sorbent could be regenerated easily at 100°C, and it exhibited excellent regenerability and stability. These results indicate that this PEI-loaded mesoporous carbon sorbent should have a good potential for CO2 capture in the future.     

Modeling the current-voltage characteristics of thin-film silicon solar cells based on photo-induced electron transfer processes

Power conversion efficiency of p-i-n type microcrystalline silicon (c-Si:H) solar cells has been analyzed in terms of sequential processes of photo-induced electron transfer. The effect of the excitonic state on the charged carrier generation has been studied compared to a conventional scheme in which only charged carriers are taken into account for the operation of the solar cells. A numerical model has been developed to calculate current-voltage characteristics of solar cells on the basis of two types of charged carrier generation processes (exciton process and charged carrier process). The light trapping effect due to a textured back surface reflector (BSR) was embedded in the numerical model by using the effective medium theory in combination with the matrix method in the field of the electromagnetic theory of light. As an application of this modeling, it was found that the reported data of the power conversion efficiency were not explained by the conventional charged carrier process model and that the combined model of the charged carrier process with the exciton process well explains the performance of the p-i-n type c-Si:H solar cells. In this way, the typical power conversion efficiencies were estimated to be 10.5% for the device (i-layer thickness: 1.8 m) with the BSR (period: 600 nm; height: 250 nm) and 8.6% for the device with the flat reflector under the condition that the fractions of the exciton process and charged carrier process were 60% and 40%, respectively.     

Modeling the current-voltage characteristics of thin-film silicon solar cells based on photo-induced electron transfer processes

Power conversion efficiency of p-i-n type macrocrystalline silicon (µc-Si:H) solar cells has been analyzed in terms of sequential processes of photo-induced electron transfer. The effect of the excitonic state on the charged carrier generation has been studied compared to a conventional scheme in which only charged carriers are taken into account for the operation of the solar cells. A numerical model has been developed to calculate current-voltage characteristics of solar cells on the basis of two types of charged carrier generation processes (exciton process and charged carrier process). The light trapping effect due to a textured back surface reflector (BSR) was embedded in the numerical model by using the effective medium theory in combination with the matrix method in the field of the electromagnetic theory of light. As an application of this modeling, it was found that the reported data of the power conversion efficiency were not explained by the conventional charged carrier process model and that the combined model of the charged carrier process with the exciton process well explains the performance of the p-i-n type μc-Si:H solar cells. In this way, the typical power conversion efficiencies were estimated to be 10.5% for the device (i-layer thickness: 1.8 μm) with the BSR (period: 600 nm; height: 250 nm) and 8.6% for the device with the flat reflector under the condition that the fractions of the exciton process and charged carrier process were 60% and 40%, respectively.