微波消解-分光光度法测定COD的研究

通过试验研究,提出了测定COD的新方法——微波消解-分光光度法。该方法准确度、精密度符合分析要求,与国标中回流法的测定结果没有显著差异。而且采用该方法测定COD可克服回流法、微波消解-滴定法及HACH-COD测定法的操作复杂、耗时长等缺点。     

低溶解氧和磷缺乏引发的非丝状菌污泥膨胀及控制

针对污泥培养过程中出现的非丝状菌污泥膨胀,分析了发生膨胀后污泥的特征、性状及其降解污染物性能.反应器中低溶解氧浓度（0～0.7mg/L）和低P/BOD₅值(0.78/100) 2种因素共同作用导致污泥膨胀.污泥胞外多聚糖含量越高,污泥憎水性越小,SVI也越高.通过提高溶解氧浓度和P/BOD₅值,可使污泥沉降性能得到恢复.此外,向膨胀污泥中投加多孔填料,在不降低处理效能的情况下,很快使系统免受污泥沉降性能恶化的困扰,而向膨胀污泥中投加强氧化剂NaClO并不能有效控制污泥膨胀.     

丙酸的加入对厌氧-低氧同时生物除磷脱氮系统的影响

2个实验室规模的序批式反应器（SBRs）在厌氧-低氧（0.15～0.45 mg·L^-1）条件下运行,以比较丙酸的加入对同时生物除磷脱氮系统的影响.结果表明,无论是丙酸与乙酸的混合酸（碳摩尔比为1.5/1）作为碳源（SBR1）,还是乙酸作为单独碳源（SBR2）,系统都发生同步硝化反硝化和磷的去除（SNDPR）,并且氨氮被全部氧化,系统中没有亚硝酸盐的大量累积.与SBR2相比,SBR1中厌氧阶段磷释放量少,聚羟基戊酸（PHV）合成量高,好氧末磷剩余量少,硝态氮累积少,因此SBR1中总氮和总磷的去除率（分别为68%和95%）比SBR2（分别为51%和92%）高,加入丙酸有助于SNDPR系统保持较好的除磷、脱氮效果.     

某市给水管网中铁释放现象影响因素与控制对策分析

针对某市管网水中铁浓度的变化规律进行了系统的研究,确定了管垢向管网水中释放出的铁是管网水中铁超标的主要原因.研究中发现铸铁管和镀锌钢管中管垢的主要化学组分为铁.在给水管网中,管网水的溶解氧和余氯浓度低时,对应的管网水中铁释放现象严重,其原因是还原条件使管垢表面的致密钝化层被破坏,造成二价铁的大量释放.根据试验结果提出了给水管网中铁释放和“红水”现象的控制对策.     

准好氧填埋工艺氧气浓度对甲烷与二氧化碳浓度的影响研究

构建了准好氧填埋模拟装置,在其产气相对稳定期间,测定填埋装置内不同点位的ψ(O₂),ψ(CH₄)和ψ(CO₂),并用数学模型对ψ(O₂)与ψ(CH₄)和ψ(CO₂)之间的关系进行拟合.结果表明:随着ψ(O₂)的增加,上层ψ(CH₄)呈对数规律下降,而ψ(CO₂)呈线性规律下降;中层ψ(CH₄)和ψ(CO₂)均呈指数规律下降;下层ψ(CH₄)呈指数规律下降,而ψ(CO₂)先保持在34%左右波动,当ψ(O₂)大于1.8%后呈指数规律下降.上层主要为好氧带,ψ(CH₄)低于ψ(CO₂);中层主要为兼氧带,当ψ(O₂)小于5.8%时ψ(CH₄)高于ψ(CO₂),而当ψ(O₂)大于5.8%时ψ(CH₄)低于ψ(CO₂);下层主要为厌氧带,当ψ(O₂)小于2.8%时ψ(CH₄)高于ψ(CO₂),而当ψ(O₂)大于2.8%时ψ(CH₄)低于ψ(CO₂).      

Toluene removal characteristics by a superimposed wire-plate dielectric barrier discharge plasma reactor

A superimposed wire-plate dielectric barrier discharge reactor was used to remove toluene in this study. The effects of oxygen content, gas flow rate, gas initial concentration and with/without catalyst on toluene decomposition were investigated. It was found that an optimal toluene removal was achieved when the oxygen content was about 5%. Under this condition, the highest toluene removal efficiency of 80.8% was achieved when the gas concentration was 80 mg/m^3. The toluene removal efficiency decreased with the increase of the gas flow rate and the initial concentration of toluene. In addition, the ozone concentration decreased with the increase of the initial concentration of toluene. It suggested that combining DBD （dielectric barrier discharge） with Co3O4/Al2O3/foam nickel catalyst in-situ could improve the toluene removal efficiency and suppress ozone formation. Products analysis showed that the main products were CO and CO2 when oxygen was more than 5%.     

拉萨河夏季氢氧同位素空间分布特征及分析

稳定同位素示踪技术是河流水文过程研究的重要方式,可以用来判定河流补给的来源、研究河流与其它水体相互作用、示踪水文循环过程等.本文采用TC/EA-IRMS分析法对拉萨河水体的氢氧同位素进行测定,分析了 δD和δ18O的含量及空间分布特征,并分析了拉萨河的同位素效应,包括与大气降水氢氧同位素的关系、氢氧同位素的沿程变化特征...     

对氯气校正法测定高氯废水化学需氧量的方法研究

氯气校正法(HJ/T70-2001)是测定高氯废水化学需氧量的国标方法,为了减少样品测定过程带来的环境污染,研究在不改变HJ/T70-2001氧化体系及测试条件的情况下,将取样体积由20 mL减半为10 mL,试剂的使用量相应减半,对方法的检出限、相对误差、相对标准偏差等指标进行验证。结果表明,该方法的检出限符合要求,准确度较高,精密度较好,可用于高氯废水化学需氧量的测定。     

呼吸效应对矿井封闭火区氧浓度的影响分析

为避免因火区封闭导致重大安全事故发生,通过采集某矿井1 d内3个不同监测点的大气压力变化情况,建立大气压力波动模型并分析计算,同时建立火区内外压差100,750 Pa情形下的氧浓度模型进而获得火区内侧氧气浓度因呼吸效应,在不同压差、体积大小火区、风阻、瓦斯涌出量、封闭时刻等多因素耦合影响下随时间的变化规律,以评估火区危险性。研究结果表明:井下大气随地面大气周期波动,封闭火区内、外侧之间的气压差因外界大气波动呈现16 h的余弦波动和8 h的线性波动周期变化;密闭质量好的火区具有更好地抗干扰性,内侧氧浓度的降低主要依靠瓦斯稀释;密闭质量差的火区,内侧氧浓度易受到火区涌出瓦斯、外界涌入大气双重影响;火区氧浓度在2%~12%之间波动,以至火区存在发生瓦斯爆炸的可能性;火区内外压差较大时,氧浓度波动变化幅度更大,危险作用持续时间更长。结合火区氧浓度波动模型,可有效地对矿井火区采取安全的防范措施,避免瓦斯爆炸事故发生。     

Catalytic oxidation of CO over Pt/Fe3O4 catalysts: Tuning O2 activation and CO adsorption

• Strong metal-support interaction exists on Pt/Fe₃O₄ catalysts. • Pt metal particles facilitate the formation of oxygen vacancies on Fe₃O₄. • Fe₃O₄ supports enhance the strength of CO adsorption on Pt metal particles. The self-inhibition behavior due to CO poisoning on Pt metal particles strongly impairs the performance of CO oxidation. It is an effective method to use reducible metal oxides for supporting Pt metal particles to avoid self-inhibition and to improve catalytic performance. In this work, we used in situ reductions of chloroplatinic acid on commercial Fe₃O₄ powder to prepare heterogeneous-structured Pt/Fe₃O₄ catalysts in the solution of ethylene glycol. The heterogeneous Pt/Fe₃O₄ catalysts achieved a better catalytic performance of CO oxidation compared with the Fe₃O₄ powder. The temperatures of 50% and 90% CO conversion were achieved above 260°C and 290°C at Pt/Fe₃O₄, respectively. However, they are accomplished on Fe₃O₄ at temperatures higher than 310°C. XRD, XPS, and H₂-TPR results confirmed that the metallic Pt atoms have a strong synergistic interaction with the Fe₃O₄ supports. TGA results and transient DRIFTS results proved that the Pt metal particles facilitate the release of lattice oxygen and the formation of oxygen vacancies on Fe₃O₄. The combined results of O₂-TPD and DRIFTS indicated that the activation step of oxygen molecules at surface oxygen vacancies could potentially be the rate-determining step of the catalytic CO oxidation at Pt/Fe₃O₄ catalysts. The reaction pathway involves a Pt-assisted Mars-van Krevelen (MvK) mechanism.