强化除磷型A/O-MBR工艺运行稳定性

采用缺氧/好氧膜生物反应器(A/O-MBR)处理合成的生活污水,考察了投加不同浓度的聚合氯化铝(PAC)对该工艺在除磷效能及运行稳定性方面的影响。结果表明,投加PAC可以有效降低出水TP的浓度;在投加量为150 mg/L时,TP的去除率达到最优,为90.1%,出水浓度维持0.48 mg/L左右,达到《城镇污水处理厂污染物排放标准》(GB18918-2002)的一级A标准。投加一定量的PAC可以有效提高微生物的活性;此外,可以降低污泥絮体的Zeta电位,增大污泥絮体的粒径,降低胞外聚合物(EPS)中多糖的浓度,进而有效延缓膜污染的速率。     

聚硅酸钛制备及其助凝特性

采用在活化硅酸制备过程中加入适量TiCl4的方法,试制了一种新型无机高分子助凝剂—聚硅酸钛。研究了不同/条件下制备的聚硅酸钛在固定pH值的水中分散物的粒径和Zeta电位随着活化时间的变化趋势,并与活化硅酸作比较。结果表明,在Si/Ti=20,活化48 h的条件下能制备出较为稳定的聚硅酸钛。与活化硅酸相比,聚硅酸钛在水中的分散物具有较大的粒径和更高的Zeta电位。通过对比制备的活化硅酸和聚硅酸钛的红外图谱发现,聚硅酸钛中有Ti-O-Si键,证明钛离子参与了聚合反应,新生成的化学键提高了它的聚合度和稳定性。采用硫酸铝为混凝剂,聚硅酸钛为助凝剂进行混凝除浊实验。测定了絮凝体的Zeta电位和混凝沉淀后的上清液浊度,研究了硫酸铝投加量和混凝pH对聚硅酸钛助凝效果的影响。结果表明,投加适量的聚硅酸钛助凝剂,明显提高了混凝除浊效果且拓宽了有效混凝pH值的范围。     

石灰窑烟气治理技术探讨

依据石灰窑烟气的特点,提出了一种新型的烟气治理工艺——SDS干法脱硫+布袋除尘脱硝一体化技术;分析了该技术的工艺流程、技术优势和关键系统.工程案例表明,该技术处理效果好、运行成本低,适用于我国石灰窑烟气的治理.     

改进型石灰混凝法去除城市污水二级出水中有机物的研究

将石灰混凝处理后的沉淀泥渣进行回流，对石灰混凝法进行改进，研究改进后的石灰混凝法对城市污水二级出水中有机物的去除效果。结果表明，活性泥渣回流有利于提高石灰混凝法对城市污水二级出水中有机物的去除。回流位置在石灰投加前、复合絮凝剂投加后，最佳回流量为新泥渣产生量的100％～200％，活性泥渣回流的最佳pH为11．0～11．5；活性泥渣中CaCO3、Mg(OH)2、Fe(OH)3等沉淀物以及有机高分子絮体均有助于提高其对有机物的去除效果，其中Mg(OH)2沉淀物起主导作用；含循环泥渣的活性污泥回流，对有机物的去除效果无明显影响。     

Application of a Second-Order Kinetic Model to a Complex Melt Polymerization Reaction

A novel copolymer system has been synthesized using methyl hydroquinone diacetate (MHQDA), 1,4 naphthalene dicarboxylic acid (1,4 NDCA), and polybutylene terephthalate (PBT) using the melt polymerization technique. The optimum kinetic parameters pertinent to this system are reported in this study. A simple second-order reaction sequence summarizes catalyzed and uncatalyzed reactions between MHQDA, 1,4 NDCA, and PBT. The kinetic parameters for the copolymerization reaction were determined using a new second-order model. This technique was used to compute the moles of acetic acid generated in the polymerization process. The model was compared to that of the experimentally determined data. Close comparison (percentage error of less than 5%) was obtained between the experimental and theoretical data. The kinetic data support block copolyester formation. The thermal data also supports formation of block polymers.     

Effects of Acidification and its Mitigation with Lime and Wood Ash on Forest Soil Processes: A Review

Anthropogenic acid deposition causes forest soil acidification and perturbation of the soil forming processes. The impact of soil acidification on tree growth is discussed in view of the role of mycorrhizal fungi in weathering and nutrient uptake. A review has been carried out of experiments involving treatments of forest soil by lime and wood ash, where soil properties and soil solution composition have been investigated. Results from these experiments in Europe and North America are summarized. In general, the content of C in the mor layer decreased as a result of treatment due to higher microbial activity and soil respiration as well as increased leakage of DOC. In addition, the content of N in the mor layer, in general, decreased after treatment and there are occasional peaks of high NO₃concentrations in soil solution. In nearly all reviewed investigations the pH of the deep mineral soil solution decreased and Al, SO₄and NO₃concentrations increased after treatment. These effects are probably due to the high ionic strength and increased microbial activity as a consequence of the treatments. In the soil, pH, CEC and base saturation increased in the upper horizons, but decreases in the upper mineral soil are also reported. In general, there was no increase in tree growth as a result of these treatments. The positive effects of the treatments on soil processes and tree growth are therefore questionable. In view of these conclusions, an investigation was carried out on the soil and soil solution chemistry and the role of mycorrhizal fungi in a spruce stand treated with two doses of lime and another treated with lime/ash in southern Sweden. The results of this investigation is reported in this volume.     

新型聚硅氯化铁铝絮凝剂的制备及性能

以二甲基二氯硅烷为硅源,与氯化铁、氯化铝聚合制得新型的聚硅氯化铁铝（PSFAC）絮凝剂,考察了制备条件及PSFAC对含油废水和药厂废水的絮凝效果。制备PSFAC的最佳条件：nFc：nAl为0．4,nSi：n（Al＋Fe）为0．1,碱化度为2．0,C（Al,Fe）、为0．1mol／L,熟化时间为1-2d。当PSFAC加入量为10mg／L时,对含油废水、药厂废水的浊度去除率分别为84％和86％。PSFAC具有加入量少、沉降速度快、适用的pH范围较宽等优点。     

石灰-聚铁法处理硫酸厂废水的研究

对各种处理硫酸厂废水的方法者了探讨,选择了以百石灰和聚合硫酸铁为药剂去除废水中砷,硫等污染物的方法。该法工艺简单,混凝剂投加量少,运行费用低,处理后的废水可达到排放标准。     

Miscibility and Biodegradability of Poly(Butylene Succinate)/Poly(Butylene Terephthalate) Blends

As one of the biodegradable polymers, the blend of poly(butylene succinate) and poly(butylene terephthalate) is dealt with in this study. In our previous work, it was demonstrated that PBS and PBT are immiscible not only from the changes of T _g but also from logG–log G plots. It is expected that the biodegradability of the blends could be improved by enhancing the miscibility. We tried to induce the transesterification reaction between two polyesters with various time intervals to enhance the miscibility of the blends. The extent of transesterification reaction was examined by ¹H-NMR. We utilized a dynamic mechanical thermal analyzer and a rotational rheometer to investigate the changes in miscibility. We also verified the biodegradability of PBS/PBT blends after the transesterification reaction by the composting method.     

电石炉烟气趋零排放技术方案研究

电石工业作为我国重要的基础化工行业,也是高耗能、高污染的行业。由于电石炉烟气自身的特点,使其净化难度大,大量烟气及粉尘带来了严重的环境问题。将电石炉高温烟气作为石灰煅烧的燃料,再将石灰窑产生的烟气用于焦炭干燥,然后将烘干后的废气引出,作为助燃空气直接用管道输送至自备电厂,在利用热烟气中的显热的同时,在锅炉中通过燃烧去除烟气中的大部分污染物,随后烟气进入污染物控制系统中,将其中的污染物去除后排放,可使电石大气污染物达到趋零排放。