市政污泥热解过程颗粒物中重金属分布

以深圳市某污水处理厂的污泥为原料,研究了污泥热解过程产生的颗粒物及其中8种重金属的分布规律.结果表明,颗粒物的生成速率分别在400~600℃和1000℃保温30min的两个区间内达到峰值.8种重金属的热挥发性由大到小依次为Cd > Zn > As > Pb > Mn > Ni > Cu > Cr,而其在颗粒物中富集能力大小顺序为Pb > As > Mn > Zn > Cd > Ni > Cr > Cu.颗粒物重金属在热解气中的体积浓度随热解过程呈上升趋势,Zn和Cd则在升温阶段（1000℃以前）达到峰值后开始降低.研究表明,污泥热解颗粒物富集的重金属超标,因而污泥热解尾气颗粒物的去除装置十分必要.     

市政污泥用于矿区土壤改良的污染风险评估及配比分析

通过土柱淋溶试验,分析了市政污泥在矿山土壤改良中重金属污染风险,探讨了市政污泥用于矿区土壤改良的可行性,并确定了土壤污泥最佳混掺比例。结果表明:景山高岭土矿区土壤除速效磷含量较高外,其余养分含量分级为四—五级,即"低—很低";市政污泥除速效钾含量较低外,其余养分含量分级均远大于一级"很高";永春污水处理厂污泥为B级农用污泥,可施用于油料作物、果树、饲料作物、纤维作物,不能施用于蔬菜、粮食作物;按各处理配比进行污泥的适量施用造成地下水污染风险较小;综合考虑土壤肥力及重金属污染因素,该矿区最佳土壤、市政污泥干重混掺比为5∶2。     

死菌DNA对厌氧消化污泥中抗生素抗性基因及微生物群落分析的干扰

为评估死菌DNA对厌氧消化污泥抗生素抗性基因(ARGs)和微生物群落分析的潜在干扰,本研究对3种不同类型厌氧消化污泥进行叠氮溴化丙锭(PMA)处理,比较在PMA屏蔽死菌DNA PCR扩增情况下污泥ARGs和微生物群落分析结果与未经PMA处理情况下的差异.结果表明,经PMA处理后,剩余污泥自厌氧消化样品和高含固厌氧消化污泥样品中的ARGs丰度分别下降了41%～86%和74%～98%;污泥水解液厌氧消化15 d后的污泥样品中ARGs下降幅度相对较小,但降幅最高也达到34%.PMA处理对3个来源不同的厌氧消化污泥微生物群落组成分析结果呈现不同程度的影响,对高含固厌氧消化污泥的微生物群落结构分析影响最为显著.在经PMA处理与未经PMA处理两种情况下,厌氧消化污泥ARGs与微生物群落组成相关性分析的结果也截然不同.研究证明了死菌DNA对厌氧消化污泥ARGs和微生物群落分析的潜在干扰,采用PMA预处理能够更准确地反映厌氧消化污泥中的微生物群落及菌体携带ARGs的特征.     

南京大气臭氧浓度的季节变化及其对主要作物影响的评估

近年来,近地面O_3浓度呈不断上升趋势,高浓度O_3会影响作物的生长导致产量降低.本文利用2014~2016年南京市近地面O_3浓度的连续观测数据,分析了O_3浓度的变化特征及其对冬小麦和水稻产量与经济损失的影响.结果表明,2014~2016年南京市O_3年平均浓度分别为62.9、68.6和69.1μg·m-3,O_3浓度和超标日数均呈现逐年增加的趋势.季节平均的O_3浓度大小的顺序为:夏季、春季、秋季和冬季.四季O_3浓度的日变化均为明显的"单峰型",峰值出现在15:00~16:00,谷值出现在07:00~08:00.2014~2016年冬小麦生长季期间AOT40的数值分别为10.5、14.4和9.4μL·L~(-1)·h,水稻生长季期间AOT40的数值分别为8.5、20.0和25.6μL·L~(-1)·h.近地面O_3对冬小麦的影响要高于水稻,其中,2014~2016年O_3造成冬小麦减产范围为21.4%~32.8%,每年的经济损失达15 076.6~27 799.6万元,造成水稻减产范围为8.1%~24.3%,每年的经济损失达19 747.2~68 075.7万元.     

污泥超高温堆肥过程中DOM结构的光谱分析

为了明确超高温堆肥新工艺在促进腐殖化进程中的优势,采用三维荧光光谱(3D-EEM)等光谱学方法研究了污泥超高温堆肥过程中DOM的结构特征及其变化规律.结果表明,堆体≥80℃的超高温阶段持续5 d(最高温度90℃),50℃以上高温阶段达到22 d,反映了堆肥过程中强烈的微生物代谢活性.E253/E203、SUVA280、S275~295等9个紫外-可见光光谱(UV-Vis)指标在0~23 d变化显著,指出DOM的芳香化和堆肥腐殖化程度逐渐增强.3D-EEM光谱结合荧光区域体积积分技术(FRI)分析指出,DOM中蛋白类物质在超高温堆肥过程的0~6 d几乎完全被降解;腐殖酸和富里酸类物质在0~23 d大量形成,堆肥在高温阶段达到完全腐熟,这与种子发芽指数(GI)在23 d所指示的腐熟度评价结果(98.5%)一致.基于多种光谱学指标的相关性分析,PⅤ,n/PⅢ,n与其它光谱学均呈现较好的相关性(r≥0.68),可以作为评价超高温堆肥腐熟度的光谱学指标.上述结果证实了超高温堆肥工艺可加快堆肥腐熟进程、缩短堆肥周期至20 d左右,在有机固废资源化领域具有极大的应用潜力.     

林可霉素菌渣堆肥微生物群落多样性分析

本试验以林可霉素菌渣-猪粪为原料、污泥-猪粪堆肥作对照,研究了林可霉素菌渣堆肥过程中残留林可霉素的降解情况,并基于Illumina Mi Seq高通量测序分析了林可霉素菌渣堆肥过程中微生物菌群的变化.结果表明:通过堆肥处理可以大幅度降解林可霉素菌渣中残留的林可霉素,经过33 d的堆肥处理后,林可霉素的残留量从最初的1 800 mg·kg-1降到483mg·kg-1,降解率高达73%.同时高通量测序结果表明,由于高含量的林可霉素残留,在堆肥初期和高温期林可霉素菌渣堆肥中细菌群落的分布丰度和多样性指数均低于污泥-猪粪堆肥,但真菌群落丰度和多样性均高于污泥-猪粪堆肥.林可霉素菌渣堆肥中细菌主要以Paucisalibacillus、Cerasibacillus、Bacillus、Virgibacillus、Ureibacillus、Paenibacillus、Sinibacillus属为主,而污泥-猪粪堆肥中主要以Truepera、Actinomadura、Pseudosphingobacterium、Pseudomonas、Luteimonas、Ureibacillus属为主,两者堆肥中微生物群落结构存在显著差异.随着堆肥进入腐熟期,林可霉素残留大幅度降解,抗生素对微生物的胁迫减小或解除,林可霉素菌渣-猪粪堆肥和污泥-猪粪堆肥相比,无论是细菌还是真菌,其微生物群落已逐渐趋同.表明堆肥处理可以大幅降解林可霉素残留,增加微生物多样性,有利于实现林可霉素菌渣无害化处理和资源化利用.     

长期储存亚硝化絮状污泥活性的恢复

为探究长期储存亚硝化絮状污泥的脱氮性能,采用CSTR反应器,接种4℃下储存了10个月的亚硝化絮状污泥,考察其活性恢复性能,并采用Mi Seq高通量测序技术分析了污泥中微生物菌群结构的变化情况.结果表明,控制DO为0.4~0.8mg·L~(-1)、pH值8左右、温度为(30±1)℃等条件,长期储存亚硝化絮状污泥的活性可以在15 d内迅速恢复,氨氮去除率和亚硝积累率均达到90%以上;此外,污泥颜色由接种初期的灰黑色迅速恢复至棕黄色,SVI值显著降低,MLVSS/MLSS升高,EPS含量明显增加.随着亚硝化性能的恢复,厌氧、发酵微生物被洗脱,Nitrosomonas等氨氧化细菌相对丰度显著增加,同时,Nitrospria等硝化菌的生长得到了有效抑制.经历长期储存的亚硝化絮状污泥可作为实现短程硝化快速启动的接种污泥,更有利于短程硝化工艺的实际应用.     

Application of nanoparticle tracking analysis for characterising the fate of engineered nanoparticles in sediment-water systems

Novel applications of nanotechnology may lead to the release of engineered nanoparticles (ENPs), which result in concerns over their potential environmental hazardous impact. It is essential for the research workers to be able to quantitatively characterise ENPs in the environment and subsequently to assist the risk assessment of the ENPs. This study hence explored the application of nanoparticle tracking system (NTA) to quantitatively describe the behaviour of the ENPs in natural sediment-water systems. The NTA allows the measurement of both particle number concentration (PNC) and particle size distribution (PSD) of the ENPs. The developed NTA method was applied to a range of gold and magnetite ENPs with a selection of surface properties. The results showed that the positively-charged ENPs interacted more strongly with the sediment than neutral and negatively-charged ENPs. It was also found that the citrate coated Au ENPs had a higher distribution percentage (53%) than 11-mercaptoundecanoic acid coated Au ENPs (20%) and citrate coated magnetite ENPs (21%). The principles of the electrostatic interactions between hard (and soft) acids and bases (HSAB) are used to explain such behaviours; the hard base coating (i.e. citrate ions) will interact more strongly with hard acid (i.e. magnetite) than soft acid (i.e. gold). The results indicate that NTA is a complementary method to existing approaches to characterise the fate and behaviour of ENPs in natural sediment.     

Investigation on mechanism of phosphate removal on carbonized sludge adsorbent

For the removal of phosphate (PO₄^3 -) from water, an adsorbent was prepared via carbonization of sewage sludge from a wastewater treatment plant: carbonized sludge adsorbent (CSA). The mechanism of phosphate removal was determined after studying the structure and chemical properties of the CSA and its influence on phosphate removal. The results demonstrate that phosphate adsorption by the CSA can be fitted with the pseudo second-order kinetics and Langmuir isotherm models, indicating that the adsorption is single molecular layer adsorption dominated by chemical reaction. The active sites binding phosphate on the surface are composed of mineral particles containing Si/Ca/Al/Fe. The mineral containing Ca, calcite, is the main factor responsible for phosphate removal. The phosphate removal mechanism is a complex process including crystallization via the interaction between Ca^2 + and PO₄^3 -; formation of precipitates of Ca^2 +, Al^3 +, and PO₄^3 -; and adsorption of PO₄^3 - on some recalcitrant oxides composed of Si/Al/Fe.