Relationships between anaerobic consortia and removal efficiencies in an UASB reactor degrading 2,4 dichlorophenol (DCP)

To gain more insight into the interactions between anaerobic bacteria and reactor performances (chemical oxygen demand-COD, 2,4 dichlorophenol-2,4 DCP removals, volatile fatty acid-VFA, and methane gas productions) and how they depended on operational conditions the microbial variations in the anaerobic granular sludge from an upflow anaerobic sludge blanket (UASB) reactor treating 2,4 DCP was studied. The study was composed of two parts. In the first part, the numbers of methanogens and acedogens in the anaerobic granular sludge were counted at different COD removal efficiencies. The relationships between the numbers of methanogens, the methane gas production and VFA production were investigated. The COD removal efficiencies increased to 74% from 30% while the number of total acedogens decreased to 10 from 30 cfu ml(-1). The number of total methanogens and acedogens varied between 11 x 10(3) and 10 x 10(9)MPN g(-1) and 10 and 30 cfu ml(-1) as the 2,4 DCP removal efficiencies were obtained between 60% and 99%, respectively. It was seen that, as the number of total acedogens decreased, the COD removal efficiencies increased. However, the number of total methanogens increased as the COD removal efficiencies increased. Correlations between the bacterial number and with the removal efficiencies obtained in different operational conditions were investigated. From the results presented in this paper a high correlation between the number of bacteria, COD removals, methane gas percentage, 2,4 DCP removals and VFA was observed. In the second part, methanogen bacteria in the anaerobic granular sludge were identified. Microbial observations and biochemical tests were applied to identify the anaerobic microorganisms from the anaerobic granular sludge. In the reactor treating 2,4 DCP, Methanobacterium bryantii, Methanobacterium formicicum, Methanobrevibacter smithii, Methanococcus voltae, Methanosarcina mazei, Methanosarcina acetivorans, Methanogenium bourgense and Methanospirillum hungatei were identified.     

城市污水生物处理系统中微生物酶的活性及其分布

通过水解模式底物进行分光光度测定的方法,研究了城市污水生物处理系统中微生物酶的活性.选取亮氨酸氨基肽酶、β-葡萄糖苷酶、碱性磷酸酶和脂酶等胞外酶进行分析,结果发现4种胞外酶的平均活性在31.O～88.5 μmol/(L·h),其中76.9%～94.8%的酶活性分布在活性污泥中,说明绝大部分胞外酶是与细胞相连或固定在细胞外多聚絮体基质里.混合水样和出水水样中的DOC几乎相等,而各胞外酶与DOC不存在任何显著的相关关系.增加NO3-浓度可提高亮氨酸氨基肽酶和β-葡萄糖苷酶的活性,但对碱性磷酸酶和脂酶却有明显的抑制作用.     

能源物质和接种物的投量对生物沥浸改善城市污泥脱水性能的影响

选用硫粉(S0)和黄铁矿粉(Fe S2)作为复合能源物质,以生物沥浸处理城市污泥脱水。通过正交试验分析了不同能源物质和接种物配比下的污泥脱水、沉降性能。结果表明:能源物质和接种物的合理配比为S0投量2 g/L、Fe S2投量6 g/L、接种物投量20%,在该投量下进行生物沥浸试验,污泥比阻由初始的3.35×1012m/kg降至3.90×1011m/kg,降幅达88.36%,污泥沉降率由68%升至78%;沥浸过程中污泥比阻、沉降率与p H值、ORP、Fe2+、Fe3+、总Fe和SO2-4质量浓度的变化同步,表明污泥脱水和沉降性能的改善是酸化、氧化和絮凝的协同作用所致;同时,细菌总数、总大肠菌群和粪大肠菌群的灭活率均在99%以上,表明生物沥浸还可高效杀灭病原微生物。     

轧钢污泥综合利用的技术研究

阐述了一种轧钢污泥的回收处理技术,该技术可把轧钢污泥有效地分离成氧化铁粉和混合油,实现综合利用,减少铁素资源浪费,有良好的经济效益和环境效益.     

固定化微生物脱氮技术

在废水生物脱氮中 ,利用载体固定、形成颗粒污泥等固定化微生物技术可在增加生物脱氮速度、节省碳源、减少后曝气等方面提供有效的方法 ,并实现单级生物脱氮     

高密度沉淀池技术概述

高密度沉淀池(Densadeg)以其结构紧凑、处理效率高、出水水质稳定等特点,越来越多地被应用于城市污水一级强化处理和深度处理。本文主要介绍了高密度沉淀池的三种基本类型,重点阐述了RL型高密度沉淀池的工作原理及组成,以及污泥外部循环系统、高效斜板设置的特点;同时介绍了Densadeg的另一种运行方式:超高速沉淀池(ACTIFLO工艺),展望了高密度沉淀池的应用前景。     

污水处理系统剩余污泥碱处理融胞效果研究

研究了碱处理对污水生物处理系统剩余污泥的融胞效果及其影响因素.结果表明,碱处理能够使污泥细胞中有机物溶出,成为溶解性物质,从而使污泥液相的溶解性化学需氧量增加.pH值高于11.0时,污泥的絮体和细胞2种结构被破坏,而pH值低于11时,仅能破坏其絮体结构.碱处理过程中,起作用的是OH^-离子,但同时加入的金属离子也会影响污泥融胞的效果.碱处理能减小污泥的重量,VS的最大去除率可达48.01%(TS约为40.40%,pH值13.0左右时).污泥粒径随着碱处理pH值的升高而减小.污泥浓度、pH值和处理时间均是影响碱处理效果的重要因素,正交试验表明,在高pH值下,污泥浓度越高,碱处理污泥融出的SCOD总量越多,但折算为相同pH值下,单位污泥融出的SCOD基本不变.     

UASB-SBR-絮凝工艺处理地沟油制生物柴油废水

采用UASB-SBR-絮凝工艺处理地沟油制生物柴油废水,考察了各个阶段的废水处理效果。实验结果表明：UASB稳定运行阶段进水COD约为15000mg/L时,COD去除率约为87%,出水COD在2500mg/L以下,出水挥发性脂肪酸（VFA）浓度为4~6mmol/L,最佳容积负荷为15.0kg/（m3·d）;采用SBR处理UASB出水,当容积负荷为1.5kg/（m3·d）时,出水COD在200mg/L以下,COD去除率在83%以上,ρ（NH₃-N）在5mg/L以下,TP约为25mg/L。向SBR出水中加入质量分数为5%的聚合氯化铝进行化学除磷,加入量为5mL/L,处理后废水TP为4~6mg/L。处理后废水的COD,ρ（NH₃-N）,TP均达到CJ343-2010《污水排入城市下水道水质标准》的A类要求。     

Mo6+对活性污泥系统反硝化性能的影响

采用对比实验的方法,在不同初始硝酸盐氮和COD质量浓度的条件下,对人工模拟的活性污泥系统投加不同质量浓度的Mo6 ,以此考察Mo6 对活性污泥系统反硝化性能的影响。结果发现,Mo6 的质量浓度小于5mg?L-1以下时能够促进硝酸盐氮的去除,质量浓度为1mg?L-1时促进效果最好。Mo6 的质量浓度在4mg?L-1以下时,可以使COD去除效率增加,质量浓度为2mg?L-1时有最佳促进作用。Mo6 的质量浓度小于1g?L-1时可提高反硝化活性污泥的TTC-脱氢酶活性,过高质量浓度则表现出抑制作用。综合Mo6 的对硝酸盐氮和COD去除的影响规律以及对活性污泥TTC-脱氢酶活性的影响,认为Mo6 在质量浓度为1mg?L-1时对反硝化的促进作用最强。     

Co-treatment of fruit and vegetable waste in sludge digesters. An analysis of the relationship among bio-methane generation,process stability and digestate phytotoxicity

The co-digestion of a variable amount of fruit and vegetable waste in a waste mixed sludge digester was investigated using a pilot scale apparatus. The organic loading rate (OLR) was increased from 1.46 kg VS/m³ day to 2.8 kg VS/m³ day. The hydraulic retention time was reduced from 14 days to about 10 days. Specific bio-methane production increased from about 90 NL/kg VS to the maximum value of about 430 NL/kg VS when OLR was increased from 1.46 kg VS/m³ day to 2.1 kg VS/m³ day. A higher OLR caused an excessive reduction in the hydraulic retention time, enhancing microorganism wash out. Process stability evaluated by the total volatile fatty acids concentration (mg/l) to the alkalinity buffer capacity (eq. mg/l CaCO₃) ratio (i.e. FOS/TAC) criterion was <0.1 indicating high stability for OLR <2.46 kg VS/m³ day. For higher OLR, FOS/TAC increased rapidly. Residual phytotoxicty of the digestate evaluated by the germination index (GI) (%) was quite constant for OLR < 2.46 kg VS/m³ day, which is lower than the 60% limit, indicating an acceptable toxicity level for crops. For OLR > 2.46 kg VS/m³ day, GI decreased rapidly. This corresponding trend between FOS/TAC and GI was further investigated by the definition of the GI ratio (GIR) parameter. Comparison between GIR and FOS/TAC suggests that GI could be a suitable criterion for evaluating process stability.