石墨气体扩散电极的制备与性能优化

电极的制备工艺及参数直接影响电极材料的活性。主要考察了C/PTFE质量比、碾压压力、煅烧温度、造孔剂NH4HCO3及稀土掺杂等因素对电极产出H2O2的影响规律。研究结果表明,电极最佳制备条件为:石墨和PTFE质量比为2∶1、石墨、造孔剂和稀土元素质量比为6∶1∶1、碾压压力10 MPa、煅烧温度330℃。在pH=3、电解质Na2SO4浓度为0.05mol/L条件下,电解2 h后,改性电极产生的H2O2从95 mg/L提高到350 mg/L,提高了268.4%。     

混凝-超滤短流程工艺处理北方水库原水简

采用混凝-超滤膜短流程工艺对大伙房水库原水进行处理,考察其除污染性能和膜污染情况,并对该短流程工艺参数进行优化。结果表明,当利用超滤膜直接过滤原水时,膜污染较重,并且对污染物质的去除率较低;而采用混凝-超滤短流程工艺时,膜污染得到一定程度上的缓解;当絮凝剂投加量为7 mg/L、膜清洗周期为30 min时,对浊度、COD_Mn和UV₂₅₄的去除率分别为95.61%、40.42%和37.12%,出水水质能够满足生活饮用水卫生标准。     

钱塘江引水降氮示范工程的构建和运行研究

针对杭州西湖钱塘江引水低碳高氮的特点,提出以改性水草塘—复合垂直流人工湿地(IVCW)相耦合的生物—生态工艺进行引水处理,对该引水降氮示范工程的构建和运行效果进行了跟踪研究。结果表明,整个稳定运行期间(2012年7月19日至11月19日),耦合工艺对COD、TN、硝酸盐氮、TP的平均去除率分别为52.27%、52.49%、53.69%、52.79%,系统出水满足《地表水环境质量标准》(GB 3838—2002)Ⅳ标准;改性水草塘和IVCW单元作为耦合工艺的两个重要组成部分,在脱氮、除磷方面优势互补,从而共同保证出水水质的稳定;在改性水草塘单元,温度与COD的去除效果呈负相关关系,进水C/N与TN去除效果呈正相关关系;而在IVCW单元,温度与COD、TN的去除效果均呈线性正相关关系,进水C/N与两者的去除效果也呈正相关关系,且对COD的影响要大于对TN的影响。     

Plutonium isotopes concentration in seawater and bottom sediment off the Pacific coast of Aomori sea area during 1991-2005

A radioactivity survey was launched in 1991 to determine the background levels of ^239+240Pu in the marine environment off a commercial spent nuclear fuel reprocessing plant before full operation of the facility. Particular attention was focused on the ²⁴⁰Pu/²³⁹Pu atom ratio in seawater and bottom sediment to identify the origins of Pu isotopes. The concentration of ^239+240Pu was almost uniform in surface water, decreasing slowly over time. Conversely, the ^239+240Pu concentration varied markedly in the bottom water and was dependent upon the sampling point, with higher concentrations of ^239+240Pu observed in the bottom water sample at sampling points having greater depth. The ²⁴⁰Pu/²³⁹Pu atom ratio in the seawater and sediment samples was higher than that of global fallout Pu, and comparable with the data in the other sea area around Japan which has likely been affected by close-in fallout Pu originating from the Pacific Proving Grounds. The ²⁴⁰Pu/²³⁹Pu atom ratio in bottom sediment samples decreased with sea depth. The land-originated Pu is not considered as the reason of the increasing ^239+240Pu concentration and also decreasing the ²⁴⁰Pu/²³⁹Pu atom ratio with sea depth, and further study is required to clarify it.     

Cs, Pu concentrations and the Pu/Pu atom ratio in a sediment core from the sub-aqueous delta of Yangtze River estuary

A sediment core collected from the sub-aqueous delta of the Yangtze River estuary was subjected to analyses of ¹³⁷Cs and plutonium (Pu) isotopes. The ¹³⁷Cs was measured using γ-spectrometry at the laboratories at the Nanjing University and Pu isotopes were determined with Accelerator Mass Spectrometry (AMS), measurements made at the Australian National University. The results show considerable structure in the depth concentration profiles of the ¹³⁷Cs and ^239+240Pu. The shape of the vertical ¹³⁷Cs distribution in the sediment core was similar to that of the Pu. The maximum ¹³⁷Cs and ^239+240Pu concentrations were 16.21 ± 0.95 mBq/g and 0.716 ± 0.030 mBq/g, respectively, and appear at same depth. The average ²⁴⁰Pu/²³⁹Pu atom ratio was 0.238 ± 0.007 in the sediment core, slightly higher than the average global fallout value. The changes in the ²⁴⁰Pu/²³⁹Pu atom ratios in the sediment core indicate the presence of at least two different Pu sources, i.e., global fallout and another source, most likely close-in fallout from the Pacific Proving Grounds (PPG) in the Marshall Islands, and suggest the possibility that Pu isotopes are useful as a geochronological tool for coastal sediment studies. The ¹³⁷Cs and ^239+240Pu inventories were estimated to be 7100 ± 1200 Bq/m² and 407 ± 27 Bq/m², respectively. Approximately 40% of the ^239+240Pu inventory originated from the PPG close-in fallout and about 50% has derived from land-origin global fallout transported to the estuary by the river. This study confirms that AMS is a useful tool to measure ²⁴⁰Pu/²³⁹Pu atom ratio and can provide valuable information on sedimentary processes in the coastal environment.     

Detection of tritium sorption on four soil materials

In order to measure groundwater age and design nuclear waste disposal sites, it is important to understand the sorption behavior of tritium on soils. In this study, batch tests were carried out using four soils from China: silty clays from An County and Jiangyou County in Sichuan Province, both of which could be considered candidate sites for Very Low Level Waste disposal; silty sand from Beijing; and loess from Yuci County in Shanxi Province, a typical Chinese loess region. The experimental results indicated that in these soil media, the distribution coefficient of tritium is slightly influenced by adsorption time, water/solid ratio, initial tritium specific activity, pH, and the content of humic and fulvic acids. The average distribution coefficient from all of these influencing factors was about 0.1-0.2 mL/g for the four types of soil samples. This relatively modest sorption of tritium in soils needs to be considered in fate and transport studies of tritium in the environment.     

Depth profile of ²³⁶U/²³⁸U in soil samples in La Palma, Canary Islands

The vertical distribution of the ²³⁶U/²³⁸U isotopic ratio was investigated in soil samples from three different locations on La Palma (one of the seven Canary Islands, Spain). Additionally the ²⁴⁰Pu/²³⁹Pu atomic ratio, as it is a well establish tool for the source identification, was determined. The radiochemical procedure consisted of a U separation step by extraction chromatography using UTEVA^® Resin (Eichrom Technologies, Inc.). Afterwards Pu was separated from Th and Np by anion exchange using Dowex 1x2 (Dow Chemical Co.). Furthermore a new chemical procedure with tandem columns to separate Pu and U from the matrix was tested. For the determination of the uranium and plutonium isotopes by alpha spectrometry thin sources were prepared by microprecipitation techniques. Additionally these fractions separated from the soil samples were measured by Accelerator Mass Spectrometry (AMS) to get information on the isotopic ratios ²³⁶U/²³⁸U, ²⁴⁰Pu/²³⁹Pu and ²³⁶U/²³⁹Pu, respectively. The ²³⁶U concentrations [atoms/g] in each surface layer (∼2 cm) were surprisingly high compared to deeper layers where values around two orders of magnitude smaller were found. Since the isotopic ratio ²⁴⁰Pu/²³⁹Pu indicated a global fallout signature we assume the same origin as the probable source for ²³⁶U. Our measured ²³⁶U/²³⁹Pu value of around 0.2 is within the expected range for this contamination source.     

An occupational exposure assessment of polychlorinated dibenzo-p-dioxin and dibenzofurans in firefighters

Polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) are unintentional byproducts of combustion and industrial processes. Firefighters face the risk of occupational exposure to PCDD/Fs. Congener-specific analyses of 17 PCDD/Fs were performed on 20 serum samples collected from firefighters and fire scene investigators, and four soot samples that had deposited on the surfaces of the fire helmets and were collected after the firefighters had fought fires. The PCDD/F concentrations on the helmets that were contaminated by being worn at the fire scenes were 63-285 times higher than those on a clean helmet. The median serum PCDD/F concentration of the 16 firefighters (12 pg WHO₂₀₀₅-TEQ g⁻¹ lipid) was not different from those of the males from the general Taiwanese population (9.4 pg WHO₂₀₀₅-TEQ g⁻¹ lipid). However, the median PCDD/F level in the four fire scene investigators (15 pg WHO₂₀₀₅-TEQ g⁻¹ lipid) was higher than those in the male from the general Taiwanese population (Mann-Whitney U test, p < 0.01). Furthermore, the serum samples from the firefighters and fire scene investigators, and the soot samples from the fire scenes presented similarly distinctive PCDD/F profiles that had elevated proportions for 10 PCDF congeners. Limited data indicated that the fire scene investigators were occupationally exposed to PCDD/Fs at the fire scenes. We suggested that the firefighters were not occupationally exposed to PCDD/Fs at the fire scenes due to appropriate protection. However, the fire scene investigators may have had more occupational exposure to PCDD/Fs due to poor protection, and further research must be performed to confirm this.     

Global Urban Growth and the Geography of Water Availability,Quality, and Delivery

Globally, urban growth will add 1.5 billion people to cities by 2030, making the difficult task of urban water provisions even more challenging. In this article, we develop a conceptual framework of urban water provision as composed of three axes: water availability, water quality, and water delivery. For each axis, we calculate quantitative proxy measures for all cities with more than 50,000 residents, and then briefly discuss the strategies cities are using in response if they are deficient on one of the axes. We show that 523 million people are in cities where water availability may be an issue, 890 million people are in cities where water quality may be an issue, and 1.3 billion people are in cities where water delivery may be an issue. Tapping into groundwater is a widespread response, regardless of the management challenge, with many cities unsustainably using this resource. The strategies used by cities deficient on the water delivery axis are different than for cities deficient on the water quantity or water quality axis, as lack of financial resources pushes cities toward a different and potentially less effective set of strategies.     

Salting-out phenomenon and 1-octanol/water partition coefficient of metalaxyl pesticide

In this paper, we present the effect of inorganic cations such as Na⁺, K⁺, Ca²⁺, Mg²⁺ on the salting-out phenomenon of metalaxyl from pure water to aqueous salt solutions. Moreover the 1-octanol/water partition coefficient in pure water is presented. To accomplish this, aqueous solubility of metalaxyl was determined in pure water, in different salt solution (NaCl, KCl, CaCl₂ and MgCl₂), and at different concentration level ranging from 0.01 to 1.5 M. The 1-octanol/water partition coefficient was determined using the static shake-flask method. Solubility was determined using dynamic saturation method for pure water in the range of 298.15-325.15 K and at 298.15 K for different salt solutions. The solubility value in pure water for studied interval was found constant (m = 3.118 × 10⁻² mol kg⁻¹).Solubility values were used to calculate the standard molar Gibbs free energy of dissolution (Δ_solG°) and transfer (Δ_trG°) at 298.15 K. The values of Δ_trG° from pure to all studied aqueous salt solutions did not exceed 2 kJ mol⁻¹, the value of Δ_solG° of dissolution is 18.5 ±0.72 kJ mol⁻¹. The 1-octanol/water partition coefficient in pure water log K_o/w is equal to 1.69. The obtained results confirm the classification of the neutral metalaxyl as a slightly hydrophobic molecule.