化学沉淀法强化常规工艺应急去除水中的镉

在常规工艺基础上,通过投加氢氧化钠,实验进行了应急去除重金属镉的研究。实验结果表明,该方法能有效去除饮用水水源的镉,效果稳定,可进行应急处理。对pH、镉初始浓度和混凝剂投加量3个影响因素的灰色关联分析表明,3个因素对镉去除效果影响的大小排序为:滤后水pH>混凝剂投加量>镉初始浓度。在水源镉突发污染时,在原有常规水处理工艺基础上,通过控制滤后水pH可实现对重金属镉的去除,pH的控制值与水源水质有关。     

城市污水条件下ASBR厌氧氨氧化的启动与脱氮性能

采用ASBR在城市污水条件下进行厌氧氨氧化的启动与脱氮性能研究。实验接种好氧硝化污泥,在温度为(35±1)℃、HRT为24 h、pH为7.3～8.5的条件下经过130 d的培养,成功启动了厌氧氨氧化反应。实验结果表明,厌氧氨氧化反应稳定运行时,TN容积负荷平均为0.179 kg/(m3.d),NH4+-N、NO2--N和TN去除率分别达到了95.30%、91.30%和76.28%。启动期和稳定运行期NH4+-N、NO2--N去除量和NO3--N生成量的比值分别达到1∶1.54∶0.25和1∶1.27∶0.27;稳定运行期进出水pH差值由启动时的0.85下降到0.24。启动期反硝化和厌氧氨氧化反应同时存在而在稳定运行期厌氧氨氧化发展成为主导反应。MLSS和MLVSS/MLSS先减少后增加,反映了启动过程中硝化细菌、反硝化细菌的衰亡和厌氧氨氧化菌逐渐富集的过程,这与反应器的宏观运行效果相一致。     

铁屑粉煤灰组合处理含磷废水

实验研究了铁屑粉煤灰组合处理含磷废水的除磷效果.通过单因素实验,考查了铁屑粉煤灰质量比、反应时间、pH值和投加量对除磷效果的影响.实验结果表明,该法除磷的最优条件为铁屑和粉煤灰的质量比为2∶1,反应时间为20 min,pH值为6,投加量为20 g/L.在最优实验条件下磷的去除率达到了97.5％.对比了该法和粉煤灰吸附法与传统铁屑法的除磷效果.与单一粉煤灰吸附法和传统铁屑法除磷的结果相比较,铁屑粉煤灰组合除磷的方法具有明显优势.     

不同流量分配比对多级A/O工艺去除有机物及脱氮的影响

采用三级A/O工艺分段进水工艺处理低碳源生活污水,考察了进水流量分配比对系统去除有机物、硝化反硝化能力以及去除TN的影响。通过对水质指标沿程监测结果表明,不同流量分配比(4∶3∶3,5∶3∶2,6∶3∶1)对系统去除有机物及硝化效率影响不大,出水COD、氨氮分别均在30 mg/L、1 mg/L以下。但反硝化效果受流量分配比的影响较大,在流量比为5∶3∶2时,有效利用原水中碳源进行反硝化,反硝化效果最好。在流量比为5∶3∶2的情况下,TN出水为5.7 mg/L去除率为82.9%,优于流量分配比为6∶3∶1和4∶3∶3时的脱氮效果。总体而言,分段进水工艺在对碳源的有效利用及能耗节省方面优于单点进水。     

碳源类型及进水量分配对CMICAO工艺脱氮除磷的影响

研究了分别以葡萄糖和乙酸钠为碳源时多点交替进水阶式A2/O(CMICAO)工艺氮磷的去除效果,以及在不同进水C/N比时各进水量分配对脱氮除磷效果的影响.结果表明,在相同的进水COD浓度下,乙酸钠比葡萄糖更适合作为碳源,更能提高脱氮除磷效率.以葡萄糖为碳源时,COD为200 mg/L、C/N比为5、缺氧池与厌氧池进水配比为1∶2时,出水COD、TN、氨氮和TP浓度分别为28.5、10.8、2.1和0.5 mg/L,均达到国家一级A排放标准.若采用葡萄糖作为碳源,投加量以使进水C/N比为5～7.5为宜,外加碳源时缺氧池与厌氧池进水分配比可统一采用1∶1.     

以焦炭为填料的生物滴滤塔处理含挥发性脂肪酸臭气

在以焦炭为填料的生物滴滤塔对挥发性脂肪酸臭气的处理研究中考察了空床停留时间、臭气浓度、体积负荷以及进气温度等参数对净化效果的影响。结果表明,空床停留时间较长时对臭气降解有利。在停留时间超过97 s时,能实现完全降解;此外,净化率随臭气浓度和体积负荷的不断增加呈先增加后降低的趋势。当臭气浓度为24.29 mg/m³即臭气的体积负荷为3 g/（m³·h）时,去除率约为96%;当臭气浓度增至1 345.74 mg/m³即体积负荷增至18 g/（m³·h）,去除率达100%;然而,当臭气浓度增至4 934.38 mg/m³即体积负荷增至66 g/（m³·h）时,去除率降至73.1%。另外,进气温度对净化率也有一定程度影响。当进气温度较低时,净化效率相对较高。     

几种印染助剂对壳聚糖稳定纳米铁去除酸性品红的影响

以氯化铁为铁源,硼氢化钠为还原剂,壳聚糖为稳定剂,采用液相还原法制备壳聚糖稳定纳米铁（CS-nZⅥ）;研究了印染废水中常见助剂NaNO₃、Na₂SO₄、NaH₂PO₄、K₂Cr₂O₇、EDTA二钠盐存在下,超声波辅助CS-nZⅥ对酸性品红（AF）降解的影响。结果表明,反应15 min,0.01 g CS-nZⅥ对25 mL、100 mg/L AF的去除率高达99.9%;各种助剂的存在使得纳米铁表面不同程度失活,阻碍反应的进行,使得AF的去除率下降。NaNO₃、K₂Cr₂O₇、EDTA二钠盐与纳米铁发生反应,与AF存在明显的竞争作用。重复利用实验表明,CS-nZⅥ重复利用7次仍具有一定的反应活性。此外,CS-nZⅥ对加标（50 mg/L）实际废水中AF的去除率达到99%以上,表明CS-nZⅥ是一种潜在的环境修复材料。     

Industrial wastewater pre-treatment for heavy metal reduction by employing a sorbent-assisted ultrafiltration system

This work examined the adoption of a sorbent-assisted ultrafiltration (UF) system for the reduction of Pb(II), Cu(II), Zn(II) and Ni(II) from industrial wastewater. In such a system metals were removed via several processes which included precipitation through the formation of hydroxides, formation of precipitates/complexes among the metal ions and the wastewater compounds, adsorption of metals onto minerals (bentonite, zeolite, vermiculite) and retention of insoluble metal species by the UF membranes. At pH = 6 the metal removal sequence obtained by the UF system was Pb(II) > Cu(II) > Zn(II) > Ni(II) in mg g⁻¹ with significant amount of lead and copper being removed due to chemical precipitation and formation of precipitates/complexes with wastewater compounds. At this pH, zinc and nickel adsorption onto minerals was significant, particularly when bentonite and vermiculite were employed as adsorbents. Metal adsorption onto zeolite and bentonite followed the sequence Zn(II) > Ni(II) > Cu(II) > Pb(II), while for vermiculite the sequence was Ni(II) > Zn(II) > Cu(II) > Pb(II) in mg g⁻¹. The low amount of Pb(II) and Cu(II) adsorbed by minerals was attributed to the low available lead and copper concentration. At pH = 9 the adoption of UF could effectively reduce heavy metals to very low levels. The same was observed at pH = 8, provided that minerals were added. The prevailing metal removal process was the formation of precipitates/complexes with wastewater compounds.     

Zero-valent iron nanoparticles in treatment of acid mine water from in situ uranium leaching

Acid mine water from in situ chemical leaching of uranium (Straz pod Ralskem, Czech Republic) was treated in laboratory scale experiments by zero-valent iron nanoparticles (nZVI). For the first time, nZVI were applied for the treatment of the real acid water system containing the miscellaneous mixture of pollutants, where the various removal mechanisms occur simultaneously. Toxicity of the treated saline acid water is caused by major contaminants represented by aluminum and sulphates in a high concentration, as well as by microcontaminants like As, Be, Cd, Cr, Cu, Ni, U, V, and Zn. Laboratory batch experiments proved a significant decrease in concentrations of all the monitored pollutants due to an increase in pH and a decrease in oxidation-reduction potential related to an application of nZVI. The assumed mechanisms of contaminants removal include precipitation of cations in a lower oxidation state, precipitation caused by a simple pH increase and co-precipitation with the formed iron oxyhydroxides. The possibility to control the reaction kinetics through the nature of the surface stabilizing shell (polymer vs. FeO nanolayer) is discussed as an important practical aspect.     

钛基IrO2-SnO2电极在烟气海水脱硫恢复系统中的应用

采用浸渍-热分解法制备了含IrOx-TiO2中间层的IrO2-SnO2电极,得到的电极具有较高的析氯电催化活性和较强的稳定性,并通过电化学氧化法对Na2SO3海水脱硫模拟液进行处理,考察了电流密度、温度、pH值和电解时间等电解工艺参数对Na2SO3去除率和化学需氧量COD的影响.结果表明,在电流密度为200 mA/cm...