废弃饱和盐水钻井液的固液分离

采用化学破胶脱稳和压滤机械分离的化学强化固液分离技术处理江汉油田废弃饱和盐水钻井液(简称废钻井液).最佳固液分离工艺为:调节废钻井液的pH为6.5左右,先加入无机破胶剂(HWJ),HWJ的加入量为15 000 mg/L,以400 r/min的转速搅拌3 min,稀释1倍后,再加入有机破胶剂(HYJ),HYJ的加入量为300 mg/L,以120 r/min的转速搅拌5min.固液分离结果表明,分离后出水率达68.2%,而泥饼湿含量只有55.8%,废钻井液的COD由67 886.8 mg/L降至8 898.9 mg/L.     

Potential utilization of riverbed sediments by hydrothermal solidification and its hardening mechanism

Hydrothermal solidification of riverbed sediments (silt) has been carried out in a Teflon (PTFE) lined stainless steel hydrothermal apparatus, under saturated steam pressure at 343–473 K for 2–24 h by calcium hydrate introduction. Tobermorite was shown to be the most important strength-producing constituent of the solidified silt. A longer curing time or a higher curing temperature was shown to be favorable to the tobermorite formation, thus promoting strength development; however, overlong curing time (24 h) seemed to affect the strength development negatively. The hardening mechanism consisted of the crystal growth/morphology evolution during the hydrothermal process. The species dissolved from the silt were precipitated first as fine particles, and then some of the particles seemed to build up the rudimental morphology of calcium silicate hydrate (CSH) gel. The CSH gel, with precipitated particles, appeared to cause some reorganization within the matrix, which made the matrix denser and thus gave an initial strength development. Tobermorite, transformed inevitably from the CSH gel, reinforced the matrix with its interlocked structure, and thus further promoted the strength development.     

Effects of arsenic on seed germination and physiological activities in wheat seedlings

The effects of arsenic(As)were investigated on seed germination,root and shoot length and their biomass and some other factors to elucidate the toxicity of As.The results showed low concentrations of As(O-1 mg/kg)stimulated seed germination and the growth of root and shoot,however,these factors all decreased gradually at high concentrations of As(5-20 mg/kg).The contents Of O2-,MDA,soluble protein and peroxidase(POD)activity all increased with increasing As concentrations.Soluble sugar content,ascorbate peroxidase(APX),and superoxide dismutase(SOD)activities decreased at low concentrations of As,and increased at high concentrations of As.While acetylsalicylic acid(ASA)and chlorophyll contents,catalase(CAT)activity displayed increasing trend when the concentrations of As was lower than 1 mg/kg,and then decreasing trend.By polyacrylamide gel electrophoresis(PAGE).As induced the expression of POD isozymes of wheat seedlings.As induced the expression of CAT isozymes but inhibited the expression of SOD isozymes of wheat seedlings at concentrations lower than 1 mg/kg.However,As inhibited the expression of CAT isozymes but induced the expression of SOD isozymes at concentrations higher than 5 mg/kg.The results indicated As could exert harmfulness in the early development stage of wheat at inappropriate concentrations.     

磁处理的除垢机理探讨

通过磁处理的实践,对磁处理除垢的机理进行探讨,认为磁处理除垢的实质是同晶异构现象生成同晶异构体,使碳酸钙生成能量较高的胶体碳酸钙和球霰石,通过水溶液传递能量,使老垢脱落.还用此机理解释磁处理的"记忆"效应.     

堆肥化过程中微生物群落的动态

通过变性梯度凝胶电泳（DGGE）和平板计数法对堆肥化过程中微生物的区系动态变化进行了研究.结果表明,在堆肥化过程中,微生物数量总的趋势是细菌的数量最多,放线菌次之,真菌的数量最少,中温微生物的数量始终高于高温微生物.当发酵结束后,中温微生物的数量低于发酵初始水平,高温放线菌和高温真菌的数量试验结束后高于初始水平,高温细菌的数量在整个堆肥化过程中变化不大.通过DGGE分析表明,发酵过程中细菌的种类发生了明显的更迭现象.发酵初期Bdellovibrio、Clostridia bacterium、Bacillus、Clostridium等占优势,中期Beta proteobacterium、Petrobacter succinimandens、Nitrospirae bacterium、Clostridium等占优势,后期Clostridium、Beta proteobacterium、Paenibacillus等占优势,而在整个堆肥化过程中Clostridium都是优势种.     

Chemically modified silica gel with 1-{4-[(2-hydroxy-benzylidene)amino]phenyl}ethanone: Synthesis, characterization and application as an efficient and reusable solid phase extractant for selective removal of Zn(II) from mycorrhizal treated fly-ash samples

1-{4-[(2-hydroxy-benzylidene)amino]phenyl}ethanone functionalized silica gel was synthesized and used as a highly efficient, selective and reusable solid phase extractant for separation and preconcentration of trace amount of Zn(II) from environmental matrices. The adsorbent was characterized by fourier transform infrared spectroscopy (FT-IR), elemental analysis,¹³C CPMAS NMR spectroscopy, scanning electron microscopy (SEM), thermogravimetric analysis (TGA) and BET surface area analysis. The dependence of zinc extraction on various analytical parameters such as pH, type and amount of eluent, sample flow rate and interfering ions were investigated in detail. The material exhibited superior adsorption efficiency for Zn(II) with high metal loading capacity of 1.0 mmol/g under optimum conditions. After adsorption, the recovery (> 98%) of metal ions was accomplished using 1.0 mol/L HNO₃ as an eluent. The sorbent was also regenerated by microwave treatment in milder acidic environment (0.1 mol/L HNO₃). The lower detection limit and preconcentration factor of the present method were found out to be 0.04 μg/L and 312.5 respectively. The modified silica surface possessed excellent selectivity for the target analytes and the adsorption/desorption process remained effective for at least ten consecutive cycles. The optimized procedure was successfully implemented for the extraction of Zn(II) from mycorrhizal treated fly ash and pharmaceutical samples with reproducible results.     

Response of anaerobes to methyl fluoride, 2-bromoethanesulfonate and hydrogen during acetate degradation

To use the selective inhibition method for quantitative analysis of acetate metabolism in methanogenic systems,the responses of microbial communities and metabolic activities,which were involved in anaerobic degradation of acetate,to the addition of methyl fluoride(CH3F),2-bromoethanesulfonate(BES)and hydrogen were investigated in a thermophilic batch experiment.Both the methanogenic inhibitors,i.e.,CH3F and BES,showed their effectiveness on inhibiting CH4 production,whereas acetate metabolism other than acetoclastic methanogenesis was stimulated by BES,as reflected by the fluctuated acetate concentration.Syntrophic acetate oxidation was thermodynamically blocked by hydrogen(H2),while H2-utilizing reactions as hydrogenotrophic methanogenesis and homoacetogenesis were correspondingly promoted.Results of PCR-DGGE fingerprinting showed that,CH3F did not influence the microbial populations significantly.However,the BES and hydrogen notably altered the bacterial community structures and increased the diversity.BES gradually changed the methanogenic community structure by affecting the existence of different populations to different levels,whilst H2 greatly changed the abundance of different methanogenic populations,and induced growth of new species.     

CS-EGDE/Fe3O4凝胶微球对水中重金属离子的吸附性能及机理研究

以壳聚糖为代表的天然生物质自身含有大量活性基团能选择性吸附重金属离子,为重金属废水的高效经济处理提供了可能.本实验以壳聚糖为基材,采用原位共沉淀法和乙二醇二缩水甘油醚(EGDE)交联法共同作用制得CS-EGDE/Fe_3O_4凝胶微球吸附剂,通过电子扫描显微镜(SEM)、透射电镜(TEM)、X射线能谱(EDS)、傅里叶红外光谱(FTIR)、饱和磁强分析(VSM)对样品进行了充分表征.通过静态吸附批实验及模拟固定床动态吸附实验,较系统的考察了凝胶微球在不同初始pH、接触时间和初始浓度下对多元重金属Pb(II)、Cu(II)、Zn(II)的吸附性能.结果表明:①CS-EGDE/Fe_3O_4凝胶微球内部孔隙发达,具有良好的超顺磁性;②吸附剂能够快速与重金属离子发生螯合反应,主要作用基团为-NH_3和-OH,且对重金属离子吸附符合准二级动力学,吸附过程可用Langmuir等温吸附方程描述,为单层化学吸附;③在多元吸附体系中发生拮抗作用,重金属竞争吸附顺序为Pb(II)Cu(II)Zn(II),主要是3种离子共价指数的差异导致了这一结果;④固定床在多元重金属模拟废水处理中表现出良好的去除效能,对Pb(II)、Cu(II)、Zn(II)的饱和吸附时间分别为13、8、2 h.研究显示, CS-EGDE/Fe_3O_4凝胶微球对水中重金属离子具有良好的吸附性能,有望为重金属废水处理提供一种新的研究思路和技术路线.     

秦皇岛近海养殖对潮间带微生物群落多样性的影响

潮间带微生物群落在驱动海岸带生态系统物质循环和能量流动中具有重要作用,近海养殖造成的环境问题日益凸显,但其对潮间带微生物群落结构的影响还缺乏研究。采用变性梯度凝胶电泳（DGGE）和限制性片段长度多态性（RFLP）的分子生物学技术,研究秦皇岛养殖区与旅游区潮间带沉积物中微生物多样性的差异,分析养殖区微生物的16S rRNA基因文库的组成特征。结果表明：养殖区的微生物群落结构与旅游区形成较大的差异,DGGE图谱中养殖区的特有条带主要集中于γ-变形菌纲（γ-proteobacteria）,还分布于α-变形菌纲（α-proteobacteria）,拟杆菌门（Bacteroidetes）,放线菌门（Actinobacteria）和厚壁菌门（Firmicutes）。影响潮间带微生物的群落结构的主要环境因子包括温度、盐度、pH和NO3-浓度,影响率达55.2%。对差异最大的洋河大桥南养殖区（Q1站）的微生物样品建立克隆文库分析群落结构,变形菌门（Proteobacteria）为优势菌群,占总群落的60%,其中γ-变形菌纲是主要存在的微生物纲,其余菌群包括放线菌门、拟杆菌门、蓝藻菌门（Cyanobacteria）和疣微菌门（Verrucomicrobia）的微生物。养殖区海岸带微生物群落中出现了与环境污染和赤潮密切相关的菌群,如拟杆菌门、肠杆菌属（Enterobacteriaceae）和α-变形细菌红细菌目（Roseovarius）的微生物。     

碳黑改性TiO2薄膜光催化剂的研制

通过掺杂碳黑来提高TiO2薄膜光催化剂的吸附性能，消除固定膜反应体系中经常出现的传质限制问题，使催化剂的活性由未经改性的3.2mg/L提高到4.8mg/L，相当于浓度为0.2g/L DegussaP25TiO2悬浮体系的效果，同时研究了影响催化剂活性的主要制备条件，获得的适宜制备条件为浓硝酸添加量1.0mL，热处理温度500℃，热处理时间2h，最佳涂覆次数为8次。