Effect of fipronil on biogas production performance during anaerobic digestion of chicken manure and corn straw

Fipronil is a broad-spectrum insecticide that has a good control effect on pests of commercial poultry. Although many studies have reported the environmental fate of fipronil, the influence of residual fipronil in poultry waste on biogas production has not been further explored yet. In this article, an experimental comparative study on anaerobic digestion (AD) of chicken manure (CM) and corn straw (CS) with different fipronil concentrations (FCs) was carried at 8% of total solid (TS) and mid-temperature (35?±?1)°C. The results showed that fipronil had a significant effect on biogas production during AD of CM and CS. When the FC is at a low level (≤10?mg·kg^?1), the biogas production rate is increased and the digestion period was shortened, while higher FC (≥ 20?mg·kg^?1) showed an inhibitory effect. During the monitoring of enzyme activity, low FC showed no significant effect on cellulase and saccharase, but the urease activity increased in the early stage. High FC showed inhibition of activity of cellulase and urease, but the saccharase activity was significantly inhibited until FC reached 40?mg·kg^?1. This study also confirms that the environment in anaerobic digester is favorable for the degradation of fipronil, and its half-life is about 15.83?days.     

Climate engineering and human rights

ABSTRACT

In this Forum, three scholars discuss how climate engineering will pose novel human rights challenges, and may well force reconsideration of how human rights are applied as a guide to action. Following a short introduction, the first section introduces three competing approaches to human rights, arguing views which emphasize fairness or attempt to maximize satisfaction are more promising than one viewing human rights as inviolable ‘side-constraints’. The second section draws lessons from climate migration that are relevant for climate engineering in terms of incorporating a human rights approach to duties, rights, and participation. The final section compares the ‘needs-based’ and ‘rights-based’ approaches to humanitarian work in the face of climate change and climate engineering, raising concerns for duty-bearers and right-holders. The Forum’s conclusion draws together points of overlap and suggests a path forward for policy and research on this topic.     

Fast,cheap, and imperfect? US public opinion about solar geoengineering

ABSTRACT

Solar geoengineering, which seeks to cool the planet by reflecting a small fraction of sunlight back into space, has drawn the attention of scientists and policymakers as climate change remains unabated. Unlike mitigation, solar geoengineering could quickly and cheaply lower global temperatures. It is also imperfect. Its environmental impacts remain unpredictable, and its low cost and immediate effects may result in ‘moral hazard,’ potentially crowding out costly mitigation efforts. There is little understanding about how the public will respond to such tradeoffs. To address this, a 1000-subject nationally representative poll focused on solar geoengineering was conducted as part of the Cooperative Congressional Election Study (CCES) of the US electorate in October–November 2016. The importance that individuals place on solar geoengineering’s speed and cost predicts their support for it, but there is little to no relationship between their concerns about its shortcomings and support for its research and use. Acquiescence bias appears to be an important factor for attitudes around solar geoengineering and moral hazard.     

Determination of microbiological contamination,antibacterial and antioxidant activities of natural plant hazelnut (Corylus avellana L.) pollen

The aim of our study is to determine microbial contamination, antibacterial and antioxidant activities of 14 pollen samples of Corylus avellana collected from different locations in Slovakia. Microbiological analysis was carried out in two steps: microbiological assays and studies of antibacterial activity of pollen extracts. The antimicrobial properties of pollen extracts were carried out with the disc-diffusion method. Methanol (70%), ethanol (70%) and distilled water were used for pollen extracts. Five strains of bacteria such as gram-negative (Salmonella enterica subsp. enterica CCM 3807, Escherichia coli CCM 2024, and Yersinia enterocolitica CCM 5671) and gram-positive (Staphylococcus aureus CCM 2461 and Bacillus thuringiensis CCM 19T) were tested. Antioxidant activity of pollen extracts was determined by the DPPH method. Bacterial analysis includes the determination of the total bacterial count ranged from 4.08 to 4.61 log CFU g^?1, mesophilic aerobic bacteria ranged from 3.40 to 4.89 log CFU g^?1, mesophilic anaerobic bacteria ranged from 3.20 to 4.52 log CFU g^?1, coliform bacteria ranged from 3.30 to 4.55 log CFU g^?1, yeasts and filamentous fungi ranged from 3.00 to 3.56 log CFU g^?1. Microscopic filamentous fungi Aspergillus spp., Alternaria spp., Penicillium spp., Cladosporium spp., Rhizopus spp., and Paecylomyces spp. were isolated from hazelnut pollen. Yersinia enterocolitica was the most sensitive strain among ethanolic and methanolic pollen hazelnut extracts. Staphylococcus aureus was the most sensitive strain against aqueous hazelnut pollen extracts. We determined the following sensitivity against ethanol pollen extracts respectively: Yersinia enterocolitica?>?Salmonella enterica?>?Staphylococcus aureus?>?Bacillus thuringiensis?>?Escherichia coli. Methanol pollen extracts had shown following sensitivity: Yersinia enterocolitica?>?Salmonella enterica?>?Escherichia coli?>?Staphylococcus aureus?>?Bacillus thuringiensis. Aqueous extracts had shown the following sensitivity: Staphylococcus aureus?>?Salmonella enterica?>?Escherichia coli?>?Bacillus thuringiensis?>?Yersinia enterocolitica. Hazelnut pollen extracts have over 82% antioxidant capacity in samples from non-urban zones. An elevated level of antioxidant potential in the pollen is determined by its biological properties conditioned by biologically active substances. DPPH method allowed characterizing pollen as a source of antioxidants.     

TiO2载体对Mn-Ce/TiO2催化剂脱硝活性的影响

以TiO₂为载体,选取过渡金属元素Mn为活性组分,稀土金属元素Ce为活性助剂,采用分步共混法制备了Mn-Ce/TiO₂催化剂（活性组分负载量16%）,系统研究了TiO₂载体的晶型和晶粒尺寸对催化剂脱硝活性的影响。实验结果表明：分别以锐钛矿型和金红石型TiO₂为载体制备的催化剂,其低温脱硝活性相差不大,活性组分均以无定型态高度分散于载体中,以金红石型TiO₂为载体制备的催化剂中部分TiO₂转变为锐钛矿型;以不同晶粒尺寸TiO₂载体制备的催化剂的低温脱硝活性相差较大,比表面积较大、晶粒尺寸较小的TiO₂载体制备的催化剂,其脱硝活性低于晶粒尺寸较大的TiO₂载体制备的催化剂。     

Performance of a small-scale solar-powered adsorption cooling system

In this study, an experimental investigation on the performance of a small-scale residential-size solar-driven adsorption (silica gel-water) cooling system that was constructed at Assiut University campus, Egypt is carried out. As Assiut area is considered as hot, arid climate, field tests for performance assessment of the system operation during the summer season are performed under different environmental operating conditions. The system consists of an evacuated tube with a reflective concentration parabolic surface solar-collector field with a total area of 36 m², a silica gel-water adsorption chiller of 8 kW nominal cooling capacity, and hot and cold water thermal storage tanks of 1.8 and 1.2 m³ in volume, respectively. The results of summer season field test show that under daily solar insolation varying from 21 to 27 MJ/m², the solar collectors employed in the system had high and almost constant thermal efficiency. The daily solar-collector efficiency during the period of system operation ranged from about 50% to 78%. The adsorption chiller performance shows that the chiller average daily coefficient of performance (COP) was 0.41 with the average cooling capacity of 4.4 kW when the cooling-water and chilled-water temperatures were about 31°C and 19°C, respectively. As the chiller cooling water is cooled by the cooling tower in the hot arid area, the cooling water is at a higher temperature than the design point of the chiller. Therefore, an experiment was carried out using the city water for cooling. The results show that an enhancement in the chiller COP by 40% and the chilling power by 17% has been achieved when the city water was 27.7°C.     

Improving photostability and efficiency of polymeric luminescent solar concentrators by PMMA/MgO nanohybrid coatings

MgO nanocrystals were synthesized and doped with different concentrations in poly(methylmethacrylate) (PMMA) to prepare hybrid organic-inorganic coatings based on polymer nanohybrid thin films. The nanoparticles were found to be spherical with 62 nm diameter as determined by X-ray diffraction (XRD) and atomic force microscope (AFM). The coatings were characterized by spectroscopic tools such as optical absorption, transmission and fluorescence spectroscopy. The prepared nanohybrid films were spin-coated on cost-effective luminescent PMMA substrates doped with highly efficient luminescent dyes luminescent solar concentrators (LSCs). The outdoor photostability tests demonstrated enhanced protection against UVA radiation for coated LSCs compared to bare LSC substrates. The current–voltage characteristics of commercially produced LSC prototypes showed that the poor UV response of monocrystalline silicon solar cell can be improved by for LSCs coated by PMMA/MgO nanohybrid films which act as luminescent down shifting layer (LDSL).     

Techno-economic and environmental analysis of an integrated standalone hybrid solar hydrogen system to supply CCHP loads of a greenhouse in Iran

The techno-economic and environmental performance of hybrid solar hydrogen energy systems was investigated to provide combined cooling, heating and power (CCHP) demands of a standalone greenhouse in Iran to achieve sustainable agriculture based on an optimization procedure. From the environmental point of view, by deploying hybrid energy systems, 83%, to 100% of emissions can be avoided. Also a sensitivity analysis was performed on the hybrid energy systems in order to study the effect of major parameter variation on the systems justification. It was concluded that hybrid solar systems are economically competitive with conventional systems, for high solar intensity locations with high diesel fuel prices and decreased prices for PV and hydrogen storage technology.     

Comparison of the daily global solar radiation from different data sources in Northwest China climate

The solar radiation data are of high importance to the solar energy systems. Conventional methods to obtain the solar radiation data are from weather stations, solar radiation models, commercial software databases, and field measurements. In the present study, a new daily global solar radiation model is proposed, by combining the quadratic function of sunshine fraction and sine function of the day of the year. The solar radiation model calculated data are then compared with China Meteorological Data Sharing System (CMDSS) data, TRNSYS data, and field-measured data in Northwest China climate. It is found that the newly proposed solar radiation model has better performance than the other nine solar radiation models in the literature. The solar radiation model calculated data fit well with the CMDSS annually average data. The TRNSYS data are a bit larger than the CMDSS annually average data in summer half year and a little smaller than those in winter half year. The solar radiation model and the CMDSS annually average data have the best correlation, whereas the TRNSYS data and the field-measured data have the worst correlation. The solar radiation model calculated data have the best correlation with the other three data sources.     

In vivo screening to determine hazards of nanoparticles: Nanosized TiO2

A single-species laboratory test with terrestrial invertebrates was used to identify the hazard of nanosized TiO₂. Feeding parameters, weight change, mortality, and the activities of catalase and glutathione-S-transferase were evaluated after 3 or 14 days of dietary exposure. The effects of nano-TiO₂ were dependent on exposure concentration and duration, total consumed quantity, size and pre-treatment of particles. The intensity of a response was ruled by duration of exposure and not by consumed quantity of nano-TiO₂ or exposure concentration as expected. The response to nano-TiO₂ is described as threshold-like. The exposure concentrations 10-1000 μg TiO₂/g dry food (1.35-1025 μg of total consumed quantity of TiO₂/g animal wet wt.) were identified as safe for tested species after tested exposure period. We conclude that the response to nanoparticles is different from that of soluble chemicals therefore these two types of data should be interpreted and processed differently.