A hybrid method for quasi-three-dimensional slope stability analysis in a municipal solid waste landfill

Limited space for accommodating the ever increasing mounds of municipal solid waste (MSW) demands the capacity of MSW landfill be maximized by building landfills to greater heights with steeper slopes. This situation has raised concerns regarding the stability of high MSW landfills. A hybrid method for quasi-three-dimensional slope stability analysis based on the finite element stress analysis was applied in a case study at a MSW landfill in north-east Spain. Potential slides can be assumed to be located within the waste mass due to the lack of weak foundation soils and geosynthetic membranes at the landfill base. The only triggering factor of deep-seated slope failure is the higher leachate level and the relatively high and steep slope in the front. The valley-shaped geometry and layered construction procedure at the site make three-dimensional slope stability analyses necessary for this landfill. In the finite element stress analysis, variations of leachate level during construction and continuous settlement of the landfill were taken into account. The "equivalent" three-dimensional factor of safety (FoS) was computed from the individual result of the two-dimensional analysis for a series of evenly spaced cross sections within the potential sliding body. Results indicate that the hybrid method for quasi-three-dimensional slope stability analysis adopted in this paper is capable of locating roughly the spatial position of the potential sliding mass. This easy to manipulate method can serve as an engineering tool in the preliminary estimate of the FoS as well as the approximate position and extent of the potential sliding mass. The result that FoS obtained from three-dimensional analysis increases as much as 50% compared to that from two-dimensional analysis implies the significance of the three-dimensional effect for this study-case. Influences of shear parameters, time elapse after landfill closure, leachate level as well as unit weight of waste on FoS were also investigated in this paper. These sensitivity analyses serve as the guidelines of construction practices and operating procedures for the MSW landfill under study.     

三元复合驱采出水中悬浮固体的控制方法

采用向三元复合驱采出水中加入水质稳定剂的方法有效降低采出水中悬浮固体的质量浓度。实验结果表明,将100 g采出水依次经滤纸和孔径为0.45μm的醋酸纤维素膜过滤后,加入1.0 g WSBL-3型水质稳定剂,混合均匀后置于80℃的水浴中静置4 h,取出后再置于40℃的水浴中静置5 min,由此可将采出水中的悬浮固体质量浓度由107 mg/L降至2 mg/L。     

乌鲁木齐市工业固体废物资源化现状、趋势及建议

分析了乌鲁木齐市工业固体废物产生现状及其资源化利用情况,预测了＂十二五＂期间乌鲁木齐市工业固体废物产生量及资源化利用量。针对乌鲁木齐市工业固体废物资源化利用存在的问题,提出了实施工业固体废物资源化利用过程中,应该减少工业固体废物排放总量、扩大资源化利用途径、推进资源回收和资源化利用的产业化进程、加强工业固体废物监督管理工作等建议。     

CePO4-TiO2固溶体的NH3-SCR活性

采用共沉淀法合成了不同Ce与Ti摩尔比的CePO₄-TiO₂复合材料,利用XRD、TEM、NH₃-TPD和H₂-TPR技术对其物理化学性质进行了表征,并对其NH₃-SCR活性进行了评价。实验结果表明：随着CePO₄含量的增加,催化剂的活性提高;当Ce与Ti的摩尔比为8:2时催化剂的活性最高,230 ℃的NO转化率达到100%,且具有更广的温度窗口,优于纯CePO₄。表征结果显示,CePO₄与TiO₂形成固溶体后,颗粒尺寸较为均匀,强酸位的数量增多,氧化还原性能提升,从而提高了催化剂的SCR反应活性,同时改善了其抗水抗硫性能。     

Some happy,others sad: exploring environmental justice in solid waste management in Kinshasa,The Democratic Republic of Congo

This paper explores the concept of environmental justice (EJ) in solid waste management (SWM) in Kinshasa, the Democratic Republic of Congo (DRC). It evaluates the extent to which EJ occurs in SWM and discusses the factors accounting for this state of affairs. The paper examines the relevant theoretical framework(s) and mechanisms that would facilitate the attainment of EJ in Kinshasa. It is argued that solid waste (SW) often ends up in the poorest and least powerful communities in the cities of the DRC. A qualitative research methodology, which includes exhaustive critical review of the literature, system analysis, reflections from best practices through case studies and discussion with stakeholders, was used for this study. Findings revealed that SWM in Kinshasa is a duty entrusted to publicly-funded municipal authorities. There are evidences of a clear divide between the rich and poor neighbourhoods in the manner SW is managed. This is an inequality that has only recently begun to be recognised as injustice practices in SWM. It is argued that a politico-cultural mechanism on remedying SWM inequities could enable changes that will address EJ in Kinshasa. Such a solution will go directly against the prevailing notion “some happy, others sad”.     

金属冶炼进口物料的固体废物鉴别方法

建立了金属冶炼进口物料的固体废物鉴别方法,并利用该方法对海关查扣的3种金属冶炼进口物料进行了固体废物鉴别。鉴别结果显示:物料1、2和3的自然属性分别为砷含量超标铜精矿、锰阳极泥、回转窑氧化锌,产生来源分别为有害物质超标的产品、污染控制设施产生的物质、有意识加工的目标产物;物料1和2属于我国禁止进口的固体废物,物料3不属于固体废物。本文建立的固体废物鉴别方法可行,可为金属冶炼进口物料的固体废物鉴别和监管提供参考。     

生物反应器填埋的沉降加速效应

通过实验室填埋柱模拟实验,研究了生物反应器填埋操作方式对填埋层沉降的影响。结果表明：与传统卫生填埋方式相比,回灌经厌氧生物处理后渗滤液的生物反应器填埋方式能够加速填埋层的沉降,140 d内沉降提高比例达10%以上。我国填埋垃圾高含水率、高易腐有机物含量的特性,使得其填埋层的次沉降系数高于文献值。填埋垃圾有机物降解量及其引起的垃圾水分排出量与填埋层沉降有显著相关性,表明有机物降解是引起填埋层沉降的重要因素,也是造成生物反应器填埋与传统卫生填埋方式初期沉降差异的主要原因。     

The effect of recycling price uncertainty on municipal waste management choices

This paper analyzes the effect of price uncertainty and irreversible investment on the decision of municipalities to switch from landfill waste disposal to recycling by developing a model to predict recycling adoption behavior and applying it to empirical data. It is shown that uncertainty regarding the price of recycled materials may induce a risk neutral municipality to prefer landfill disposal, even when recycling is less expensive. A model is developed to describe the switching process and estimate its parameters using empirical data from 79 municipalities in Israel. The model is then used to predict municipalities' recycling adoption decisions under various assumptions regarding price uncertainty. The results support the hypothesis that price uncertainty is a major obstacle for recycling. Finally, several options for price stabilization are sketched and it is argued that these policies may be effective in establishing viable recycling markets.     

Determination of Au(III) and Pd(II) ions by flame atomic absorption spectrometry in some environmental samples after solid phase extraction

A simple and sensitive solid phase extraction method was developed for simultaneous separation and preconcentration of gold and palladium ions with N-(4-methylphenyl)-2-{[(4-phenyl-5-pyridine-4-yl-4H-1,2,4-triazol-3-yl)thio]acetyl}hydrazine carbo thioamide complex on Amberlite XAD-1180 resin before their determination by flame atomic absorption spectrometry. Some analytical parameters such as HNO₃ concentration of the sample solution, amount of complexing agent, sample volume, eluent type and volume, effects of foreign ions and adsorption capacity of the resin were investigated for quantitative recovery of gold and palladium ions. The effects of some anions and cations were also examined. Under optimum conditions, the detection limits for gold and palladium ions were found to be 0.29 and 0.19 μg L^?1, respectively. The preconcentration factor for gold and palladium was 250. After being validated by standard addition and analysis of standard reference material, the procedure was successfully applied to the analysis of sea and stream water, anodic slime, gold ore, soil and electronic waste.     

Formalising informal solid waste recycling at the Pomona dumpsite in Harare,Zimbabwe

The role of informal recycling in poverty alleviation and solid waste management in cities in developing countries has been receiving increased attention. This study explores the integration of the informal recycling sector with the Harare City Council's solid waste management system, focusing on the Pomona dumpsite. The extent of this integration was compared with interventions proposed in InteRa, a new way of evaluating the integration of informal recyclers with the waste management systems of cities in developing countries. Our results suggest that the Harare City Council, which had the vision of transforming itself into a world‐class city, failed to fully integrate the informal recycling sector. We suggest to policymakers that complete integration of the informal sector will not necessarily prevent cities from achieving such visions. Rather, addressing the neglected interventions may help in achieving their visions.