基于BP神经网络的煤层自燃预测

在全面分析影响煤层自燃因素的基础上,建立了煤层自燃预测的人工神经网络模型.应用该模型对某煤田的多个煤层样本进行了训练和预测,网络经过10次训练后,误差达到设定的最小值,6次预测测试中最大误差仅为0.027 8,最小的为0.000 1.研究表明,该模型精度较高,可用于预测煤层自燃的实际应用.     

限氧EGSB反应器内颗粒污泥性能研究

研究限氧EGSB反应器内颗粒污泥的沉淀性能、产甲烷活性、形态、抗温度和负荷冲击等特性,以分析限氧EGSB反应器长期高效稳定运行的可行性.结果表明,限氧运行使得颗粒污泥的沉速降低,但仍能保持20.07～51.86 m/h的高沉速,保证了限氧EGSB反应器内约42 g/L的高污泥浓度;加入适量氧并没有对甲烷菌产生毒害作用,反而有所提高,提高幅度为11.94%.限氧EGSB反应器内颗粒污泥表面和内部微生物没有出现明显的分区分布,中高进水浓度时没有出现甲烷八叠球菌的明显优势;限氧EGSB反应器内颗粒污泥在经历温度和COD负荷双重冲击后,COD去除率明显降低,出水VFA明显增高,产气量明显降低,甚至出现不产气的情况.COD去除率的恢复很快,仅需20 d;出水VFA和产气也逐渐恢复,但有所滞后;微生物的恢复要慢些,扫描电镜结果表明,有些颗粒污泥表面的微生物细胞仍存在收缩现象.     

鼓风机叶轮快速断裂的检测及失效分析

针对焦化厂鼓风机叶轮运行近15 d后产生穿透性裂纹、并延伸至叶轮半径2/3处的严重断裂事故,采用具有早期缺陷诊断功能的金属磁记忆新技术及其他多种手段,从宏观力学及微观机理角度对其进行综合性能评定及失效分析.研究结果表明,叶轮材料强度、韧性均过低,且韧性指标分散性大、同类型试样的韧性指标最大值与最小值之间相差3倍多;金相组织晶粒粗大,断口表现为脆性开裂.沿叶轮的断裂与非断裂面分别进行磁记忆扫描,磁场强度分析表明,断裂面内存在两处具有明显应力集中的危险源.分析表明,锻造及锻后热处理不良造成了快速疲劳断裂.最后,结合5年中3次叶轮断裂事故,对失效原因进行了相关性分析.     

含硫油品储罐腐蚀产物自燃性的研究

通过模拟储油罐中硫铁化物的生成方式, 分析和研究了H2S气体在无氧条件下,与不同相对湿度的Fe2O3、Fe3O4和Fe(OH)3反应所生成的硫铁化物的自燃性.不同相对湿度的试样经6 h硫化后,其自燃性明显不同.以Fe2O3试样为例,相对湿度为0的硫化产物氧化升温最高为256 ℃,平均升温速率为10.8 ℃/min; 相对湿度为5%、10%和15%的硫化产物,氧化升温最高温度分别为474 ℃、408 ℃和388 ℃,平均升温速率分别为20.5 ℃/min、18.3 ℃/min和13.5 ℃/min.实验结果表明, 不同相对湿度、不同物质的硫化产物,其自燃性有显著差异,样品的相对湿度对硫化产物的自燃性有重要影响.对各种干燥样品的硫化产物进行电镜分析发现,由不同物质硫化所生成的硫化产物结构不同,致使其自燃性有较大差异.硫铁化物氧化反应放热是引发油罐着火的主要因素.     

三阶段温度控制堆肥接种法对有机氮变化规律的影响

利用原生生活垃圾,通过三阶段温度控制技术进行堆肥试验,探讨在堆肥过程中有机态氮组分的动态变化规律.结果表明,全氮、酸水解有机态氮、氨基酸态氮均在堆肥的前期呈明显的下降趋势,呈较好的相关性.与CK（对照组）处理相比,在堆肥的后期,三阶段温度控制堆肥酸水解有机态氮、氨基酸态氮、氨基糖态氮及酸解未知态氮含量呈不同程度的上升趋势,增加幅度依次为：10.67%、16.17%、7.17%、22.44%.表明三阶段温度控制技术能减少堆肥中氮素的损失,堆肥产品施入土壤后,可提高土壤的供氮潜力.     

采用巯基捕收剂稳定化处理垃圾焚烧飞灰中的重金属

研究了3种巯基捕收剂,二乙基二硫代氨基甲酸钠（乙硫氮）、乙基黄原酸钾（乙基黄药）和二丁基二硫代磷酰铵（丁铵黑药）,对垃圾焚烧飞灰中重金属的稳定化效果。3种巯基捕收剂的用量均为62.5μmol?g-1飞灰。扫描电镜观察发现,飞灰经稳定化处理后,巯基捕收剂均匀地覆盖于飞灰晶体表面,使矿物晶体棱角变得模糊。利用酸浸提程序（TCLP法）和水浸提程序（水平振荡法）评价飞灰中重金属Cu、Pb、Cd、Cr和Zn的浸出毒性。在0.1mol?L-1醋酸浸提条件下,与Na2S相比,巯基捕收剂对Cu和Pb的稳定化效果较好,其中乙硫氮对Cu的稳定化比率接近100%,丁铵黑药对Pb的稳定化比率达到69.2%;在水浸提条件下,乙硫氮、乙基黄药和丁铵黑药对5种重金属的稳定化比率分别为72.6%、73.5%和76.8%,显著高于Na2S处理（52.4%）。三种巯基捕收剂对5种重金属亲和力的强弱顺序大致为Cu＞Pb＞Cr＞Cd＞Zn,并且超过60%的巯基捕收剂与酸可浸提重金属离子发生了螯合沉淀反应。重金属-巯基捕收剂絮凝物在中性和碱性条件下（pH>6）比较稳定,在酸性条件下（pH<6）可发生部分溶解。为获得较好的重金属稳定化效果,维持稳定化飞灰的高酸缓冲容量十分重要。     

浅析电子废弃物回收利用及危害解决办法

随着高科技的发展和人们需求的增长,电子产品不断推陈出新,电子废弃物成为世界上数量增长最快的垃圾."电子垃圾",主要包括各种使用后废弃的电脑、通信设备、电视机、电冰箱、洗衣机等电子电器产品.电子废弃物不规范回收处理易造成污染.电子废弃物中含有很多可回收再利用的有色金属、黑色金属、玻璃等物质.严格意义上讲,这些电子废弃物,不应称其为电子垃圾,而应称作电子旧货.伴随着电子工业的高速发展,电子废弃物污染不可避免地摆在了我们面前.电子废弃物具有危害性和可利用性.     

某简易垃圾填埋场渗滤液在场底天然土层迁移模拟与长期预测

为了解我国早期建设的简易填埋堆场底部天然土层中污染物迁移状况,作者以安徽某填埋场为例,在前期现场勘查、取样和室内测试工作基础上建立了三维有限元分析模型,对宏量有机污染物COD在土层中的迁移状况进行了模拟分析.通过拟合求参获得COD在该场底土层中扩散系数、机械弥散系数和阻滞因子等运移参数的合理取值,在此基础上开展了污染物...     

TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.