常减压装置自燃危险分析及对策

通过对常减压装置内介质温度和自燃点的比较分析,绘制装置自燃危险分析图,确定自燃危险的重点防护区,并提出对策措施。     

某型固体继电器储存性能退化规律研究

选用某型固体继电器在A、B、c、D等4地开展了为期131个月的库房储存试验,跟踪测试了其性能参数。应用F-检验和T-检验对其性能参数的测试数据进行了分析研究,结果表明储存131个月后,输入电流和输出接通电阻在4地有显著性的变化。通过研究4地试验样品性能参数的退化量,结果表明所有性能参数中输出接通电阻的退化量最大;4地相比,C地试验样品的输出接通电阻的退化量是最大的,A地试验样品的输出接通电阻的退化量是最小的。因此,A地最适合该型固体继电器的储存。     

高寒地区露天矿排土场稳定性分析研究*

为分析高寒地区露天排土场稳定性,以乌努格吐山铜钼矿排土场为工程背景,结合室内试验并利用GeoStudio及FLAC3D软件对边坡进行模拟计算分析,给出边坡治理有效措施。结果表明:前3次冻融循环对散体物料的抗剪强度影响显著,后期影响则趋于稳定;6个剖面的安全系数普遍大于1.2,在地下水的干扰下,各剖面安全系数普遍下降,尤其是剖面E-E,其安全系数低于1,存在滑坡风险;水对边坡的安全性影响较大,其次提出削坡治理及布置抗滑桩措施,当边坡角度削减至31°时,边坡的安全系数增至为1.383;抗滑桩增至8根时,安全系数增加至1.296,这些措施对边坡的治理皆起到积极作用。研究结果可为高寒地区矿山安全开采提供技术支持。     

Comparison of energy produced from waste by removing its different components: A case study of the waste landfill in Tehran

In developing and populated cities such as Tehran, a massive amount of municipal solid waste (MSW), both wet and dry, is transferred to landfills daily. Combustion is one of the most common methods of using mixed waste energy from the past to the present. The Dulong formula is widely used to calculate the energy released from MSW combustion. According to the constituent components of Tehran MSW, removing food waste leads to an increase in energy potential, which will be a suitable condition for energy production. In this work, the energy derived from the combustion of mixed and separated dry MSW generated in Tehran was calculated using the experimental Dulong formula and tables in Integrated Solid Waste Management (Tchobanoglous et al. 1993, McGraw‐Hill). The Dulong formula indicates that the use of Tehran mixed MSW (without separating materials for recycling) as a fuel source yields 8,966.40 KJ/kg while the use of Tchobanoglous et al. (1993) tables can generate 8,236 kJ/kg. By removing food waste and recyclable materials, the potential of energy production changes to 22,047 kJ/kg using the Dulong formula and 16,207 kJ/kg and the Tchobanoglous et al. (1993) tables. It indicates increase by 1.46 times and 46%, respectively. Regarding the 200‐ton capacity of the Tehran waste incinerator, the Dulong formula indicated generation of 4,409 MJ/day energy, and the Tchobanoglous et al. table presents 3,241 MJ/day. Therefore, considering that Tehran generates more than 4,000 tons of reject waste daily, it can easily be converted to energy rather than landfilled. This can alleviate the problem of buying land and construction of landfills and leachate generation.     

Performance of a diesel engine with water emulsified diesel prepared with optimized process parameters

An attempt has been made to produce stable water–diesel emulsion with optimal formulation and process parameters and to evaluate the performance and emission characteristics of diesel engine using this stable water–diesel emulsion. A total of 54 samples were prepared with varying water/diesel ratio, surfactant amount and stirring speed and water separation was recorded after 24 and 48 hr of emulsification. The recorded data were used in artificial neural network (ANN)-particle swarm optimization (PSO) technique to find the optimal parameters to produce water–diesel emulsion for engine testing. The predicted optimal parameters were found as 20% water to diesel ratio, 0.9% surfactant and 2200 rpm of stirrer for a water separation of 14.33% in one day with a variation of 6.54% against the actual value of water separation. Water–diesel emulsion fuel exhibited similar fuel properties as base fuel. The peak cylinder gas pressure, peak pressure rise rate and peak heat release rate for water–diesel were found higher as compared to diesel at medium to full engine loads. The improved air-fuel mixing in water–diesel emulsion enhanced brake thermal efficiency (BTE) of engine. The absorption of heat by water droplets present in water–diesel emulsion led to reduced exhaust gas temperature (EGT). With water–diesel emulsion fuel, the mean carbon monoxide (CO), unburned hydrocarbon and oxides of nitrogen (NO_x) emissions reduced by 8.80, 39.60, and 26.11%, respectively as compared to diesel.     

废弃液晶屏玻璃基板的行星式球磨工艺研究

以废弃液晶屏玻璃基板为原料,研究了球磨方式和球磨时间在球磨过程中对粉料粒径分布的影响。通过对废弃液晶屏玻璃基板的行星式球磨工艺的研究,探讨了球磨方式、球磨时间等因素对球磨效果的影响,以建立玻璃粉体细化的合理球磨方式和工艺参数。     

餐厨垃圾厌氧干发酵处理产甲烷潜力及动力学研究

研究采用中温厌氧干发酵反应器,针对餐厨垃圾厌氧干发酵过程中p H,VFA,COD和产气量的变化,结合修正Gompertz方程分析厌氧干发酵产甲烷的动力学过程。在中温厌氧干发酵系统负荷和初始条件下,分析厌氧干发酵产甲烷过程变化,建立厌氧干发酵产甲烷模型,对其预测和试验验证及误差进行分析。结果表明,在中温厌氧干发酵过程中p H先下降后上升,VFA浓度先增加后减少,COD去除率保持在76.02%~90.28%之间;修正Gompertz动力学模型,可以较好地分析餐厨垃圾厌氧干发酵产甲烷过程(决定系数R~20.99),经拟合,具有较高的产甲烷能力,且与试验结果显著相关;在检验水平a=0.05条件下,其方差分析的P值为0.938,大于0.05的显著性,表明模型能较好地预测厌氧干发酵累积产甲烷量。     

喷淋工艺处理PVC塑料生产废气

采用喷淋工艺处理PVC塑料生产废气,将专利的吸收液与改型的喷淋塔相结合,在中试成功的基础上进行了实际工业化应用。应用结果表明:采用该工艺处理某PVC塑料生产企业的生产废气,吸收液在喷淋塔循环液中所占体积分数为15%时,废气中各污染物指标的去除率达85%以上,对于难处理的苯系物也能较好地去除;处理后废气中各污染物指标的含量满足GB 14554—1993《恶臭污染物排放标准》和DB 44/27—2001《大气污染物排放限值》的要求;该工艺装置运行费用较低,仅为电费和少量药剂费用,吸收液可循环使用,设备保养及维护简单,可满足市场需求。     

硫氨基循环抑制烟气二英生成的试验研究

新型硫氨基物质对二英低温从头合成具有良好的抑制效果,但尚未在实际焚烧炉中应用.本文借助烟气循环抑制和飞灰低温热处置联用控制二英排放中试系统(500 Nm³·h^-1),开展了硫氨基循环抑制实际焚烧炉烟气二英排放的研究.试验结果表明,硫氨基抑制气氛能在该系统中循环累积,该系统对二英阻滞率达95%以上,烟气二英排放浓度低于最新国家环保标准0.1 ng·Nm^-3(以I-TEQ计).该新型硫氨基循环抑制技术对实际废物焚烧炉二英的减排控制具有重要指导价值.     

固相微萃取模拟生物法用于养殖底泥多环芳烃污染监测的研究

本研究以养殖底泥中多环芳烃(PAHs)为研究对象,采用以聚二甲基硅氧烷(PDMS)为材料测定孔隙水中PAHs自由溶解态浓度(Cfree)的固相微萃取技术,以重要海水经济底栖生物菲律宾蛤仔(Ruditapes philippinarum)为参照生物,建立了PDMS中PAHs浓度与菲律宾蛤仔脂肪标化及底泥有机碳标化的PAHs浓度间的定量关系模型,进一步证明了基于固相微萃取的模拟生物法用于养殖区域中多环芳烃监测的可能性.结果表明,孔隙水中自由溶解态PAHs浓度(Cfree)显著低于孔隙水中总PAHs浓度(Cwater),且随着环数增加,两者间的差异越大,说明Cwater忽视了生物有效性,从而会高估孔隙水中PAHs的环境风险,因此,Cfree能更好地反映底泥孔隙水中PAHs的暴露水平;菲律宾蛤仔对PAHs的富集系数(BAF)及PDMS-水分配系数(KPDMS)均与辛醇-水分配系数(Kow)呈显著线性相关,且两者斜率相近,说明菲律宾蛤仔摄取PAHs的主要途径与PDMS相似,且PDMS中PAHs的浓度与生物体内PAHs的残留浓度和底泥有机碳标化的PAHs浓度间均呈现显著相关,说明当底泥孔隙水中和PDMS膜之间达到平衡时,固相微萃取模拟生物法可以用于计算底栖生物和沉积物中有机污染物,具有应用于养殖区域中多环芳烃监测的潜力,但有机污染物在生物体内转化和底泥性质对相关关系和监测应用的影响有待进一步研究.