Matrix effect on the performance of headspace solid phase microextraction method for the analysis of target volatile organic compounds (VOCs) in environmental samples

Solid phase microextraction (SPME) is a fast, cheap and solvent free methodology widely used for environmental analysis. A SPME methodology has been optimized for the analysis of VOCs in a range of matrices covering different soils of varying textures, organic matrices from manures and composts from different origins, and biochars. The performance of the technique was compared for the different matrices spiked with a multicomponent VOC mixture, selected to cover different VOC groups of environmental relevance (ketone, terpene, alcohol, aliphatic hydrocarbons and alkylbenzenes). VOC recovery was dependent on the nature itself of the VOC and the matrix characteristics. The SPME analysis of non-polar compounds, such as alkylbenzenes, terpenes and aliphatic hydrocarbons, was markedly affected by the type of matrix as a consequence of the competition for the adsorption sites in the SPME fiber. These non-polar compounds were strongly retained in the biochar surfaces limiting the use of SPME for this type of matrices. However, this adsorption capacity was not evident when biochar had undergone a weathering/aging process through composting. Polar compounds (alcohol and ketone) showed a similar behavior in all matrices, as a consequence of the hydrophilic characteristics, affected by water content in the matrix. SPME showed a good performance for soils and organic matrices especially for non-polar compounds, achieving a limit of detection (LD) and limit of quantification (LQ) of 0.02 and 0.03 ng g⁻¹ for non-polar compounds and poor extraction for more hydrophilic and polar compounds (LD and LQ higher 310 and 490 ng g⁻¹). The characteristics of the matrix, especially pH and organic matter, had a marked impact on SPME, due to the competition of the analytes for active sites in the fiber, but VOC biodegradation should not be discarded in matrices with active microbial biomass.     

季节性城市生活垃圾成分分析及厌氧消化特性研究

城市生活垃圾的成分及特性随着季节和人类在不同季节的生活习惯而变化,针对我国北方城市研究了一年中不同季节的城市生活垃圾成分特点,对影响厌氧发酵过程的相关成分如总有机碳（TOC）、总氮（TN）、蛋白质、脂肪和还原糖等进行了测定分析。通过厌氧消化实验,测得不同季节城市生活垃圾pH值、日产气量、沼气甲烷含量、甲烷累积量、挥发性脂肪酸（VFAs）和氧化还原电位（ORP）等参数的变化规律,分析相应变化的影响因素。结果表明,二、三季度的含水率分别为64．81％和67．50％,高于一、四季度,一季度发酵原料中蛋白质和脂肪含量分别为12．56％和8．86％,明显高于其他3个季度。一季度甲烷累积量最高,达到17616mL,单位发酵原料的产气量为204．8mL／g,也是4个季度中最高的,说明蛋白质、脂肪等有机成分含量对厌氧发酵过程及结果影响比较明显。为进一步的城市生活垃圾厌氧消化制取生物燃气的工艺条件提供依据。     

利用废弃物衍生燃料的热化学处理法制富含氢气合成气

为了探讨利用热化学方式从城市垃圾中制取富含氢气合成气过程的要素影响,解析氢气发生特性及其与主要影响要素之间的关系。在分析了城市生活垃圾组分特性的基础上,将其加工成组分均一的废弃物衍生燃料(refuse de-rived fuel,RDF),并在700、800和900℃等3个温度条件下,分别开展了RDF的热解、气化及水蒸汽气化等实验。研究表明,RDF的加工不但可有效降低垃圾含水率,还可将垃圾热值提高近1倍。温度和添加水蒸汽是从RDF中制取富含氢气合成气过程中的关键影响要素。其中,温度对氢气生成起到至关重要的决定作用,温度的提高对促进H2浓度的提高有利,同时,在气化过程中添加水蒸汽,可有效促进CO和H2等有价气体组分生成。在900℃的高温水蒸汽气化处理过程中,可获得H2浓度最高为34.13%的合成气。另外,800℃热解过程所产生的合成气热值最高,达到14 509 kJ/Nm3。     

等离子体固态可燃物液化反应动力学分析

本文利用介质阻挡放电等离子体技术,对以煤和生物质为代表的固态可燃物液化反应机理进行研究,以期探索能源利用新途径.借助碰撞理论和Boltzman方程,对高能电子碰撞引发多种离解反应的速率常数进行数值模拟,计算结果和实验曲线对比,证明模型具有一定的适用性和可靠性.在一定的电子温度下,通过不同离解反应速率常数的对比,可以判断...     

A hybrid method for quasi-three-dimensional slope stability analysis in a municipal solid waste landfill

Limited space for accommodating the ever increasing mounds of municipal solid waste (MSW) demands the capacity of MSW landfill be maximized by building landfills to greater heights with steeper slopes. This situation has raised concerns regarding the stability of high MSW landfills. A hybrid method for quasi-three-dimensional slope stability analysis based on the finite element stress analysis was applied in a case study at a MSW landfill in north-east Spain. Potential slides can be assumed to be located within the waste mass due to the lack of weak foundation soils and geosynthetic membranes at the landfill base. The only triggering factor of deep-seated slope failure is the higher leachate level and the relatively high and steep slope in the front. The valley-shaped geometry and layered construction procedure at the site make three-dimensional slope stability analyses necessary for this landfill. In the finite element stress analysis, variations of leachate level during construction and continuous settlement of the landfill were taken into account. The "equivalent" three-dimensional factor of safety (FoS) was computed from the individual result of the two-dimensional analysis for a series of evenly spaced cross sections within the potential sliding body. Results indicate that the hybrid method for quasi-three-dimensional slope stability analysis adopted in this paper is capable of locating roughly the spatial position of the potential sliding mass. This easy to manipulate method can serve as an engineering tool in the preliminary estimate of the FoS as well as the approximate position and extent of the potential sliding mass. The result that FoS obtained from three-dimensional analysis increases as much as 50% compared to that from two-dimensional analysis implies the significance of the three-dimensional effect for this study-case. Influences of shear parameters, time elapse after landfill closure, leachate level as well as unit weight of waste on FoS were also investigated in this paper. These sensitivity analyses serve as the guidelines of construction practices and operating procedures for the MSW landfill under study.     

三元复合驱采出水中悬浮固体的控制方法

采用向三元复合驱采出水中加入水质稳定剂的方法有效降低采出水中悬浮固体的质量浓度。实验结果表明,将100 g采出水依次经滤纸和孔径为0.45μm的醋酸纤维素膜过滤后,加入1.0 g WSBL-3型水质稳定剂,混合均匀后置于80℃的水浴中静置4 h,取出后再置于40℃的水浴中静置5 min,由此可将采出水中的悬浮固体质量浓度由107 mg/L降至2 mg/L。     

乌鲁木齐市工业固体废物资源化现状、趋势及建议

分析了乌鲁木齐市工业固体废物产生现状及其资源化利用情况,预测了＂十二五＂期间乌鲁木齐市工业固体废物产生量及资源化利用量。针对乌鲁木齐市工业固体废物资源化利用存在的问题,提出了实施工业固体废物资源化利用过程中,应该减少工业固体废物排放总量、扩大资源化利用途径、推进资源回收和资源化利用的产业化进程、加强工业固体废物监督管理工作等建议。     

高效液相色谱-串联质谱法同时检测地表水中13种药物及个人护理品

采用高效液相色谱-串联质谱(HPLC-MS/MS)检测,建立了地表水中13种药物及个人护理品的测定方法。水样用盐酸与氢氧化钠溶液调p H值至7.0左右,过固相萃取小柱进行富集,用14 m L甲醇洗脱。以C18柱为分离柱,0.01%甲酸的甲醇-0.01%甲酸水溶液为流动相,目标物在10 min内分离,在0.50~250μg/L范围内,13种化合物峰面积与内标物质峰面积之比与质量浓度的线性关系良好(0.99),检出限在0.05~0.5 ng/L范围内。基质加标实验结果表明,13种化合物在水中的回收率分别在56.2%~123.2%之间(加标水平5 ng/m L)和58.0%~107.8%(加标水平50 ng/m L),相对标准偏差在1.60%~19.9%(n=6)之间。应用该方法测定了从2条纳污河流采集的10份水样,结果表明,除美托诺尔和普洛萘尔未被检出外,其余11药物的检出频率在30%~100%之间。在13种目标物质中,咖啡因的检测浓度最高达287.5ng/L,舒必利次之,为277.5 ng/L。本方法快速、准确,适用于地表水中PPCPs类的快速测定。     

酸碱度对生活垃圾焚烧厂沥滤液蒸发处理效果的影响

采用蒸发法处理城市生活垃圾焚烧厂垃圾沥滤液,着重考察了不同沥滤液初始pH值对蒸发去除COD和氨氮效果的影响,并采用GC-MS对蒸发冷凝液中有机物成分进行了分析鉴定.结果表明,生活垃圾沥滤液的初始pH对冷凝液中COD、氨氮含量及有机污染物分布产生了决定性的影响.沥滤液在酸性条件下(pH≤6)蒸发,随着pH的增加,冷凝液中COD的含量线性降低,而氨氮的含量线性增加.当沥滤液的初始pH值从6增加到11,冷凝液中COD的含量呈对数函数降低,而氨氮的含量表现出显著增加趋势.从冷凝液中鉴定出38种有机污染物,多为沸点较低的醇、酸、酚和酯类.在酸性条件下(pH=3),冷凝液中挥发性有机酸和低碳醇的相对丰度接近90％.在近中性条件下(pH=6.2),冷凝液中的有机污染物以酚、酸和杂环类化合物为主.在碱性条件下(pH =11),冷凝液中酚和杂环类化合物占比较高,而酸的含量极少.     

响应面法优化黄粉虫幼虫处理餐厨垃圾饲养条件的研究

研究了黄粉虫幼虫处理餐厨垃圾的方法.首先在饲养温度、饲料含水量和饲养密度等条件下进行单因素实验,然后,以利用率为指标,运用响应面法优化了黄粉虫幼虫处理餐厨垃圾的饲养条件,结果表明,最佳饲养条件为饲养温度26.7℃、饲料含水量14.5％、饲养密度4.1头/cm2.在此饲养条件下,黄粉虫对餐厨垃圾利用率理论值为38.72％,实际餐厨垃圾利用率为38.88％,相对误差为0.41％,说明利用黄粉虫幼虫处理餐厨垃圾具有较好的效果.