城市生活垃圾DANO发酵滚筒工业中试

通过工业中试研究了DANO发酵滚筒的结构设计及工艺运行控制参数 ,指出提高平均填充率 ,延长停留时间是结构设计的关键 ;垃圾料层堆温可作为主要工业运行控制参数。实验结果表明 :4m× 6 0m发酵滚筒处理能力为1 5 5t d ,垃圾停留时间可达到 73h ,发酵后垃圾实现了初步稳定     

连续流生物制氢反应器乙醇型发酵的运行特性

采用连续流搅拌槽式反应器(CSTR),利用厌氧活性污泥,在制糖废水产酸发酵过程的同时制取氢气.探讨了生物制氢反应器连续流稳定运行的工程控制参数.研究表明,在污泥接种量为15g/L、温度为35℃±1℃、COD容积负荷为40kg/(m³·d)、HRT为4h、系统pH、氧化还原电位(ORP)分别在4.6～4.9、-450～-470mV等条件下,可以实现连续流生物制氢反应系统乙醇型发酵的高效稳定运行.此时,液相末端发酵产物中乙醇和乙酸的含量占挥发酸总含量的80%以上,COD去除率22%～26%,气相中的氢气含量约为40%～58%,最大产氢能力为7.63m³/(m³·d).     

城市污水厂污泥高温好氧堆肥氮素转变行为研究

采用两段式高温好氧堆肥工艺 ,研究了污泥堆肥中氮素转变规律。研究表明 ,硝化作用受到温度和NH+ 4 N含量的影响显著。一次发酵中 ,堆料平均温度高于 4 0℃ ,硝化作用受到强烈抑制 ;二次发酵后期 ,由于NH+ 4 N浓度降低 ,故硝化过程减缓。不同调理剂及操作条件对氮素损失影响较大 ,利用腐熟堆肥作为调理剂可以减少氮素损失。适当降低堆料温度、增加初始含水率及适当减少初始挥发份含量等措施均可在一定程度上减少氮素损失     

不同产酸发酵菌群产氢能力的对比与分析

重点对乙醇型发酵菌群和丙酸型发酵菌群的产气及产氢能力进行了对比研究,并对发酵菌群由丙酸型演替为乙醇型过程中的产氢速率变化进行了分析.在有机负荷相同的条件下,乙醇型发酵菌群表现出较高的产氢速率和比产氢速率,最大产氢速率为14.99L/d,最大比产氢速率为3586.45mmol/(kg·d).而丙酸型发酵菌群产氢速率和比产氢速率都较低,分别为3.62L/d,196.46mmol/(kg·d)生物制氢反应器在运行中维持乙醇型发酵更有利于获得较高的氢气产量,应尽量避免丙酸型发酵的发生.     

嗜热真菌的生物转化功能与经济价值

嗜热真菌是经济微生物中极为重要的一个类群,许多兼性嗜热真菌可在常温和一般高温条件下生存,它们在有机物质的生物转化和物质循环中起着重要的作用。对嗜热真菌在蘑菇培养料的制备、废物的堆肥化处理、酒曲制作等几种常见生产过程中的生物转化作用和机理进行分析,探讨嗜热真菌在人类生产活动中的作用及经济价值。     

一株嗜碱产甲烷八叠球菌的分离鉴定与系统发育分析

在15℃条件下用产甲烷菌培养基对采自四川省红原县的牦牛粪进行富集培养,采用Hungate厌氧操作技术从富集培养物中分离得到一株在8~45℃范围生长、最适生长pH为8.5的嗜碱产甲烷菌T13.该菌株革兰氏染色阳性,细胞聚集体,在液体培养基中为肉眼可见的颗粒状物,在固体培养基上菌落为淡黄色桑葚状;可利用甲醇、乙酸盐和甲胺作为唯一碳源生长;对氯霉素和庆大霉素敏感;生长pH范围为6.5~9.5;最适NaCl浓度为0~0.15 mol L-1;最适生长温度为30℃.形态和生理生化特征以及16S rDNA序列分析表明菌株T13为梅氏产甲烷八叠球菌(Methanosarcina mazei).由于该菌最适生长pH为8.5,所以初步认为菌株T13是一株梅氏产甲烷八叠球菌的新菌株.     

化感链霉菌6803菌株液体发酵工艺优化的研究

土壤微生物链霉菌6803菌株被证明对高等植物具有化感作用。采用单因子实验方法,研究液体发酵碳源、氮源、无机盐、发酵温度、发酵液初始pH值、摇床转速、发酵时间等对链霉菌6803菌株菌丝体产量及发酵液化感作用的影响,用均匀试验设计法优化了发酵工艺条件。结果表明：链霉菌6803菌株生长和产生化感作用的最佳发酵条件为：p（淀粉）=26．67g·L-1,p（蔗糖）=25．15g·L-1,p（NH4C1）=0．30g．L-1,黄豆饼粉浸液8．88％,所（NI-h）H2P04]=O．18g·L-1,p（FeS04．7H20）=O．002g·L-1,p（NaCl）=0．75g·L-1,pH值7．6,装量系数O．16,接种量3％,温度36℃,转速200r·min-1,发酵144h。本研究为利用微生物次生代谢产物作为天然除草剂奠定了基础。     

Effect of different gas releasing methods on anaerobic fermentative hydrogen production in batch cultures

Decreasing hydrogen partial pressure can not only increase the activity of the hydrogen enzyme but also decrease the products inhibition, so it is an appropriate method to enhance the fermentative hydrogen production from anaerobic mixed culture. The effect of biogas release method on anaerobic fermentative hydrogen production in batch culture system was compared, i.e., Owen method with intermediately release, continuous releasing method, and continuous releasing+ CO₂ absorbing. The experimental results showed that, at 35°C, initial pH 7.0 and glucose concentration of 10 g·L^-1, the hydrogen production was only 28 mL when releasing gas by Owen method, while it increased two times when releasing the biogas continuously. The cumulative hydrogen production could reach 155 mL when carbon dioxide in the gas stream was continuously absorbed by 1 mol·L^-1 NaOH. The results showed that acetate was dominated, accounting for 43% in the dissolved fermentation products in Owen method, whereas the butyrate predominated and reached 47%–53% of the total liquid end products when releasing gas continuously. It is concluded that the homoacetogenesis could be suppressed when absorbing CO₂ in the gas phase in fermentative hydrogen production system.     

Effect of illumination on the hydrogen-production capability of anaerobic activated sludge

To investigate the influence of illumination on the fermentative hydrogen production system, the hydrogen production efficiencies of two kinds of anaerobic activated sludge (floc and granule) from an anaerobic baffled reactor were detected under visible light, dark and light-dark, respectively. The 10 mL floc sludge or granular sludge was respectively inoculated to 100 mL diluted molasses (chemical oxygen demand of 8000 mg·L^-1) in a 250 mL serum bottle, and cultured for 24 h at 37°C under different illumination conditions. The results showed that the floc was more sensitive to illumination than the granule. A hydrogen yield of 19.8 mL was obtained in the dark with a specific hydrogen production rate of 3.52 mol·kg^-1MLVSS·d^-1 (floc), which was the highest among the three illumination conditions. Under dark condition, the hydrogen yield of floc sludge reached the highest with the specific hydrogen production rate of 3.52 mol·kg^-1MLVSS·d^-1, and under light-dark, light, the specific hydrogen production rate was 3.11 and 2.21 mol·kg^-1MLVSS·d^-1, respectively. The results demonstrated that the illumination may affect the dehydrogenase activity of sludge as well as the activity of hydrogen-producing acetogens and then impact hydrogen production capacity.     

Isolation and identification of a bioflocculant-producing strain and optimisation of cultural conditions via a response surface model

A bioflocculant-producing strain named MY6-2 was isolated from a mixed activated sludge by a nitrogen-free medium. Based on 16S rDNA sequence, biochemical and morphological characteristics, the strain MY6-2 was identified as Bacillus mucilaginosus. The chemical analysis indicated that the flocculant MY6-2 was mainly composed of extracellular polysaccharide. The result of the composition of the medium showed that MY6-2 was able to generate bioflocculant in a nutrient-poor medium that consisted of 5?g?L^?1 sucrose and no nitrogen source. Response surface methodology (RSM) was used to optimise the fermentation condition of MY6-2 for maximum flocculating activity by using central composite design (CCD). Based on the result, the optimum conditions were as follows: 100?mL of broth in a 250?mL Erlenmeyer flask, initial pH 8.0 and inoculum concentration 10%, respectively. The highest flocculating rate of 90% was achieved under these conditions by adding 0.5?mL fermentation supernatant to 95?mL of Kaolin suspension.